• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2003년도 봄 학술발표회 논문집
• /
• pp.273-280
• /
• 2003

Tunneling in difficult geological conditions is often inevitable especially in urban areas. Ground improvement and reinforcement techniques are often required to guarantee safe tunnel excavations and/or to prevent damage to adjacent structures. The steel pipe-reinforced multi-step grouting method has been recently applied to tunnel sites in Korea as an auxiliary technique. In this study, the face stability with steel pipe-reinforced multi-step grouting was evaluated by simultaneously considering two factors: one is the effective stress acting on the tunnel face calculated by limit theorem and limit equilibrium method; the other is the seepage force obtained by means of numerical analysis. The study revealed that the influence of the steel pipe-reinforced multi-step grouting on the support pressure in dry condition is not significant while there is relatively a large amount of reduction in seepage forces by adopting the technique in saturated condition. The effect of the anisotropy of permeability on the seepage force acting on the tunnel face was also estimated by conducting the coupled analysis. It was found that a higher horizontal permeability compared with the vertical one causes reduction in the seepage force acting on the tunnel face.

• 대한기계학회논문집B
• /
• 제26권12호
• /
• pp.1674-1680
• /
• 2002

An experimental study was made of a large-scale vortical structure over a backward-facing step. The Reynolds number based on the step height was R $e_{H}$ =33,000. To recognize the large-scale vortex, three components of velocity were measured. The measurements were performed in the recirculation zone (x/H=4.0) and the reattachment zone(x/H=7.5). To measure the wall pressure fluctuations in a turbulent flow over a backward-facing step, a 32-channel microphone array was installed beneath the wall in the streamwise and spanwise directions. From the measured pressure field, the size of large-scale vortex was obtained. As a detailed study, a conditionally-averaging technique was employed to characterize the coherent structure of the large-scale vortex. To see the relationship between the flow field and the relevant spatial mode of the pressure field, the spatial box filtering (SBF) was examined. A cross-correlation between velocity and pressure fluctuations was performed to identify the structure and the length scale of the large-scale vortex.x.

• International Journal of Naval Architecture and Ocean Engineering
• /
• 제2권1호
• /
• pp.14-23
• /
• 2010

A numerical model was developed for simulating a three-dimensional multilayer hydrodynamic and thermodynamic model in domains with irregular bottom topography. The model was designed for examining the interactions between flow and topography. The model was based on the three-dimensional Navier-Stokes equations and was solved using the fractional step method, which combines the finite difference method in the horizontal plane and the finite element method in the vertical plane. The numerical techniques were described and the model test and application were presented. For the model application to the northern part of Ariake Sea, the hydrodynamic and thermodynamic results were predicted. The numerically predicted amplitudes and phase angles were well consistent with the field observations.

• 한국운동역학회지
• /
• 제21권1호
• /
• pp.97-105
• /
• 2011

The purpose of this study was to investigate the kinetic factors of Stefan holm's take-off motion and provide the technical data. Collected data of the subject(height: 181 cm, weight: 71 kg, record: 230 cm) were used for the last two strides and take-off phase. The results were as follows: The vertical impulse force was 2044.8 N which was 2.49 times and the anterior-posterior impulse force was -1306.4 N which was 1.88 times of the subject's weight. The take-off leg angular velocities($\omega_x,\;\omega_y$) were switched drastically from clockwise to count clockwise direction between two-step touchdown and take-off. The highest jerk of the take-off foot was 368.97 m/s3 during the two step take-off and the take-off foot made an impact to the ground with 1225.07 m/s3 during the one step touchdown.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1997년도 추계학술대회 논문집 학회본부
• /
• pp.618-620
• /
• 1997

A $50{\times}50{\mu}m^2$ aluminum micromirror array is fabricated using shadow evaporation process. The fabrication process is very simple with use of shadow evaporation process, and the micromirror array has a high fill-factor. The static and dynamic characteristics such as deflection angle vs. applied voltage, step response, and frequency response are measured using a contact free optical measurement technique. The downward threshold voltage was 8 V, step response time was $13.5{\mu}s$ when 32 V step voltage applied, and a resonance observed at 11kHz. The lifetime of micromirror with anti-stiction coating was tested and micromirror operated successfully over 200 million cycles of touch-down operations.

• 한국안전학회지
• /
• 제32권2호
• /
• pp.112-116
• /
• 2017

Present study investigated the influence of time step size, turbulent eddy viscosity, and the number of layer on rapid and unsteady propagation of dam break flow. When the time step size had a value such that it resulted in Cr of 0.89, a significant numerical oscillation was observed in the vicinity of the wave front. Higher turbulent viscosity ensured smooth and mild slope of velocity and water stage compared with the flow behavior by no viscosity. The vertical velocity at the lower layer positioned near the bottom showed lower velocity compared with other layers.

• Geomechanics and Engineering
• /
• 제5권6호
• /
• pp.519-540
• /
• 2013

This paper presents an optimal design method for determining pile lengths of piled raft foundations. The foundation settlement is evaluated by taking into account the raft-pile-soil interaction. The analysis of settlement is simplified by using Steinbrenner's equation. Then the total pile length is minimized under the settlement constraint. An extended sequential linear programming technique combined with an adaptive step-length algorithm of pile lengths is used to solve the optimal design problem. The accuracy of the simplified settlement analysis method and the validity of the obtained optimal solution are investigated through the comparison with the actual measurement result in existing piled raft foundations.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2006년도 하계학술대회 논문집 Vol.7
• /
• pp.184-185
• /
• 2006

Two-step growth to incorporate the Mg atoms in the ZnO nanorods fabricate by thermal evaporation process and also utilized the ZnO film as a template. In the first step of low temperature, Zn seed metals with low melting temperature formed the droplet, and then MgZnO ternary nanorods were grown by injecting oxygen and evaporating Mg atoms in high temperature process of the second step. The vertical growth of the MgZnO nanorods with large-area distribution and uniformity was successfully performed on the ZnO template. We investigated the shape of the vertically grown 1-D MgZnO nanorods and characterized the optical and crystal properties. We confirmed the incorporation of Mg atoms by the EDS and PL spectrum.

• Journal of Korean Society for Atmospheric Environment
• /
• 제22권E2호
• /
• pp.78-88
• /
• 2006

In order to study the characteristics of cloud, a real-scale experiment for cloud generation was carried out using an extinct vertical mine (430 m height) located in the northeastern Honshu, Japan. The dry particles generated from the three-step concentrations of NaCl solutions were used for cloud generation. The number size distributions of initial dry particles and cloud droplets were monitored by Scanning Mobility Particle Sizer (SMPS) and Forward Scattering Spectrometer Probe (FSSP) at bottom and upper sites of pit, respectively. The polymeric water absorbent film (PWAF) method was employed to measure liquid water content ($W_L$) as a function of droplet size. Moreover the chemical properties of individual droplet replicas were determined by micro-PIXE. The CCN number concentration shows the lognormal form in dependence of the particle size, while the number size distributions of droplets are bimodal showing the peaks around $9{\mu}m$ and $20{\mu}m$ for every case. In comparison to background mineral particles, right shifting of size distribution line for NaCl particles was occurred. When NaCl solutions with three-step different concentrations were neulized, $W_L$ shows the strong droplet size dependence. It varied from $10.0mg\;m^{-3}$ up to $13.6mg\;m^{-3}$ with average $11.6mg\;m^{-3}$. A good relationship between $W_L$ and cloud droplet number concentration was obtained. Both chemical inhomogeneities (mixed components with mineral and C1) and homogeneities (only mineral components or C1) in individual droplet replicas were obviously observed from micro-PIXE elemental images.

• The Journal of Korean Physical Therapy
• /
• 제26권3호
• /
• pp.147-155
• /
• 2014

Purpose: This study was to determine the effects of before and after application of silicone sleeve on balance and muscle strength in anterior cruciate ligament (ACL) reconstruction patients. Methods: 13 subjects who had one or more months after ACL surgery were involved. Dynamic balance, timed up and go (TUG), stair step, vertical jump, proprioception and isokinetic knee strength were measured while subjects under taped, untapped and silicone sleeve conditions. Results: For 30 seconds one-leg standing, there was a significant improvement under silicone sleeve on operated side with eyes open and both taping and silicone sleeve revealed similar effects with eyes closed (p<0.01). Application of silicone sleeve showed significant effects in proprioceptive function on the operated side compared to both taping and none (p<0.05). For stair step test, TUG and vertical jump was a tendency to improve after application of silicone sleeve, but no significant different. Muscle strength on operated side of quadriceps and hamstring was significantly improved compared with none or taping(p<0.05). Conclusion: Silicone sleeve application for ACL reconstruction patients was effective immediately on improving strength and balance. Therefore, depending on the intended use and the disease is considered appropriate use of silicone sleeve will be able to help prevention and functional movement.