• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.7 no.2
• /
• pp.56-61
• /
• 2008

Diversity antenna system against multi-fading environment is strongly required for WiBro service of vehicle. In general, high isolation performance between antennas leads to good diversity gain. In this paper, a polarization diversity antenna is presented, which has orthogonal polarizations and good isolation characteristic. In addition, by simulation and measurement, it is certified that HWLLA (Half Wave Length Loaded Antenna) improves polarization purity on common ground. In isolation between two antennas, HWLLA can provide better isolation over 12dB than conventional PIFA (Planar Inverted F Antenna).

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2016.05a
• /
• pp.87-88
• /
• 2016

In this paper, a digital terrestrial TV reception antenna which can be applied to the house and vehicle windows was designed and investigated. The proposed antenna was configured for a monopole antenna structure with $230mm{\times}430mm{\times}3mm$, and the antenna parameters are calculated by using the OpenFDTD simulator. The proposed antenna can be used to the receiver for domestic digital broadcast in UHF.

• Proceedings of the KIEE Conference
• /
• 1999.11d
• /
• pp.1120-1122
• /
• 1999

In the design of vehicle glass antenna system, it is essential to use preamplifier between the glass antenna and the TV set, since glass antenna has low gain. In this paper, the preamplifier has been designed in the frequency range from 50MHz to 900MHz with the gam of 10dB. A negative feedback technique has been employed for the wideband characteristics of the amplifler. A DC block capacitor is also used to obtain flat gain response in the wide frequency range. The experimental result shows 1dB ripple in 9dB gain and 0.5dB ripple in 3dB noise figure. The test results were compared with those of the performed by the EEsof-touchstone.

• The Transactions of the Korean Institute of Electrical Engineers D
• /
• v.50 no.2
• /
• pp.72-79
• /
• 2001

In the GPS/DR integrated system, the GPS position(or velocity) is used to compensate the DR output and to calibrate errors of the DR sensor. This synergistic relationship ensures that the calibrated DR accuracy can be maintained even when the GPS signal is blocked. Because of the observability problem, however, the DR sensors are not sufficiently calibrated when the vehicle speed is low. This problem can be solved if we use a multi-antenna GPS receiver for attitude determination instead of conventional one. This paper designs a two-antenna GP receiver integrated with DR sensors. The proposed integration system has three remarkable features. First, the DR sensor can be calibrated regardless of the vehicle speed with the aid of two-antenna GPS receiver. Secondly, the search space of integer ambiguities in GPS carrier-phase measurements is reduced to a part of the surface of the sphere using DR heading. Thirdly, the detection resolution of cycle-slips in GPS carrier-phase measurements is improved with the aid of DR heading. From the experimental result, it is shown that the search space is drastically reduced to about 3/20 of the non-aided case and the cycle-slips of 1 or half cycle can be detected.

• ETRI Journal
• /
• v.43 no.3
• /
• pp.400-413
• /
• 2021

This paper theoretically and empirically explores the reliability gain that can be obtained by installing multiple antennas in on-vehicle broadcasting receivers. Analytical derivations reveal that maximal-ratio-combining-based diversity allows a multi-antenna receiver (MR) to achieve significantly better coverage probability than a single-antenna receiver (SR). In particular, the notable MR gains for low-power reception and high-throughput services are highlighted. We also discuss various aspects of mobile MRs, including geometric coverage, volume of the users served, and impact of receiver velocity. To examine the feasibility of MRs in the real world, extensive field experiments were conducted, particularly with on-air ATSC 3.0 broadcast transmissions. Relying on the celebrated erroneous second ratio criterion, MRs with two and four antennas were verified to achieve notable reliability gains over SRs in practice. Furthermore, our results also prove that layered-division multiplexing can cope better with receiver mobility than traditional time-division multiplexing when multiple services are intended in the same radio frequency channel.

• Proceedings of the KIEE Conference
• /
• 2001.11c
• /
• pp.53-56
• /
• 2001

In this paper we discuss a direct satellite broadcasting system for vehicle. The proposed satellite-steering algorithm and controller based on it are designed for a communication and broadcasting system which uses the Mugungwha satellite. The Mugungwha satellite that the proposed system should steer is a geostationary orbit device. The satellite-steering algorithm computes azimuth and elevation with reference to a stationary point on earth. This is extended to a real satellite steering algorithm that considers position and attitude. Real moving position and attitude are represented by latitude, longitude, roll, pitch and yaw. To apply these five pieces of information to the reference satellite steering algorithm, we introduce Euler's degree coordinates that express independently the rotation of each axis relative to an axis. There are two ways a basic algorithm of the antenna of a vehicle can track and orient to satellite. One way is a feedback loop method for broadcasting gain, while the other is a feedback loop method for position and attitude of a vehicle. In the present paper, we design a controller of satellite broadcasting system for a vehicle using an algorithm that combines the two methods. We performed a simulation and experiment to prove effectiveness.

• Proceedings of the KSRS Conference
• /
• 2008.10a
• /
• pp.441-444
• /
• 2008

This paper describes the development of a circularly polarized microstrip antenna, as a part of the Circularly Polarized Synthetic Aperture Radar (CP-SAR) sensor which is currently under developed at the Microwave Remote Sensing Laboratory (MRSL) in Chiba University. CP-SAR is a new type of sensor developed for the purpose of remote sensing. With this sensor, lower-noise data/image will be obtained due to the absence of depolarization problems from propagation encounter in linearly polarized synthetic aperture radar. As well the data/images obtained will be investigated as the Axial Ratio Image (ARI), which is a new data that hopefully will reveal unique various backscattering characteristics. The sensor will be mounted on an Unmanned Aerial Vehicle (UAV) which will be aimed for fundamental research and applications. The microstrip antenna works in the frequency of 1.27 GHz (L-Band). The microstrip antenna utilized the proximity-coupled method of feeding. Initially, the optimization process of the single patch antenna design involving modifying the microstrip line feed to yield a high gain (above 5 dBi) and low return loss (below -10 dB). A minimum of 10 MHz bandwidth is targeted at below 3 dB of Axial Ratio for the circularly polarized antenna. A planar array from the single patch is formed next. Consideration for the array design is the beam radiation pattern in the azimuth and elevation plane which is specified based on the electrical and mechanical constraints of the UAV CP-SAR system. This research will contribute in the field of radar for remote sensing technology. The potential application is for landcover, disaster monitoring, snow cover, and oceanography mapping.

• Progress in Superconductivity and Cryogenics
• /
• v.16 no.3
• /
• pp.21-25
• /
• 2014

As wireless power transfer (WPT) technology using strongly coupled electromagnetic resonators is a recently explored technique to realize the large power delivery and storage without any cable or wire, this technique is required for diffusion of electric vehicles (EVs) since it makes possible a convenient charging system. Typically, since the normal conducting coils are used as a transmitting coil in the CPT system, there is limited to deliver the large power promptly in the contactless EV charging system. From this reason, we proposed the combination CPT technology with HTS transmitting antenna, it is called as, superconducting contactless power transfer for EV (SUWPT4EV) system. As the HTS coil has an enough current density, it can deliver a mass amount of electric energy in spite of a small scale antenna. The SUCPT4EV system has been expected as a noble option to improve the transfer efficiency of large electric power. Such a system consists of two resonator coils; HTS transmitting antenna (Tx) coil and normal conducting receiver (Rx) coil. Especially, the impedance matching for each resonator is a sensitive and plays an important role to improve transfer efficiency as well as delivery distance. In this study, we examined the improvement of transmission efficiency and properties for HTS and copper antennas, respectively, within 45 cm distance. Thus, we obtained improved transfer efficiency with HTS antenna over 15% compared with copper antenna. In addition, we achieved effective impedance matching conditions between HTS antenna and copper receiver at radio frequency (RF) power of 370 kHz.

• Journal of Aerospace System Engineering
• /
• v.16 no.5
• /
• pp.86-93
• /
• 2022

Generally, a deployable solar panel is used primarily to achieve sufficient power output to perform the mission. However, temperature distribution on the antenna reflector may increase due to the shading effect induced by the presence of the deployable solar panels. Appropriate thermal design is critical to minimize the thermal deformation of the mesh antenna reflector in harsh on-orbit thermal environments to ensure remote frequency (RF) performance. In this paper, we proposed a dual-surface primary reflector consisting of a mesh antenna and a flexible fabric membrane sheet. This design strategy can contribute to thermal stabilization by using a flexible solar panel on the rear side of membrane sheet to reduce the temperature distribution caused by the deployable solar panel. The effectiveness of the mesh antenna design strategy investigates through on-orbit thermal analysis.

• Journal of Advanced Navigation Technology
• /
• v.20 no.3
• /
• pp.218-225
• /
• 2016

Null steering and beam steering are known well as anti-jamming methods in GPS anti-jamming system. Null steering gets a noise attenuation effect for the direction of jamming and beam steering earns additional gain synthesis for the direction of satellite signals. According to the research in the article for signal processing, it expresses that the N array antenna is effective for N-1 number of jamming signal by math public interest, however, the two algorithms analysis is not unknown for the operating condition of the realistic vehicle. In this paper, we modeled anti-jamming system using 4 and 7 array antenna and showed the two algorithms performance (PM, LCMV) when considering the number of antenna array, jammers and vehicle position (horizontal, vertical). In result, we showed that the case of vertical position of the vehicle which has large tilt angle for the relative position of satellites and jammers, has about 10 dB gain more in comparison with one of vertical position in spite of same JSR condition.