• 전력전자학회논문지
• /
• 제9권2호
• /
• pp.97-104
• /
• 2004

회생차량에서 직류전원단으로 회생되는 에너지를 교류전원측으로 반환하여 활용하기 위한 장치로서 사이리스터 인버터가 널리 사용되고 있다 기존의 사이리스터 인버터는 단방향의 위상제어방식으로 출력의 역률제어가 불가능하고, 고조파 함유율이 높아 별도의 필터를 필요로 한다. 본 연구에서는 이러한 문제점을 해결하고자 스위칭 소자로서 양방향 제어가 가능한 IGBT를 채용하여 Space vector PWM 제어를 함으로서 유효전력 및 무효전력 제어가 가능한 인버터를 개발하였다. 개발한 인버터는 상업용으로 실계통에 바로 적용이 가능하도록 경제성 및 신뢰성을 제고하여 전체 제어시스템을 디지털 형식으로 구현하였고, 저대역 필터를 내장하여 고조파 발생을 억제하였으며, 전체 부피를 콤팩트하게 하였다. 본 논문에서는 전기철도 직류급전계통에 적합한 회생 인버터의 설계기준, 기술사양, 전력회로, 인버터 및 계통연계 제어기법, 개발시스템, 시험결과 및 특성 등을 기술하였다.

• 전기학회논문지
• /
• 제62권7호
• /
• pp.950-955
• /
• 2013

This paper proposes a new low-cost current detection method to implement vector-controlled inverter of 3-phase induction motor or permanent-magnet synchronous motor using 2 shunt resistors instead of expensive Hall current sensors. The proposed method can detect perfect phase currents without current-immeasurable area in all operating conditions of motor. This method uses 2 shunt resistors in Hall current sensor positions conventionally used to detect phase currents. Therefore, it requires accurate analog differential amplifiers to detect voltages across shunt resistors at high electric potential to ground. We show the good solutions which are implemented by voltage-divider resistors networks and the instrumentation amplifiers using several Op Amps at cheap price. Computer simulations and experiments were performed to confirm the effectiveness of proposed method. These results show that proposed method can perfectly detect phase currents without current-immeasurable area in all operating conditions of motor.

• Journal of Power Electronics
• /
• 제2권2호
• /
• pp.77-87
• /
• 2002

The purpose of this paper is to improve power conversion efficiency of three-phase soft-switching voltage-source inverter with an auxiliary resonant dc link (ARDCL) snubber circuit. Firstly, the operation principle of ARDCL snubber circuit is described. Secondly, this paper proposes an effictive generation method of zero voltage vector for three-phase voltage-source soft-switching inverter in power losses in which power losses in the ARDCL snubber circuit can be reduced. In particular, zero voltage holding interval in the inverter DC busline can be controlled due to the new generation scheme of zero voltage vector. Thirdly, a simulator for power loss analysis for power loss characteristics based on actual system, is developed. the validity of developed. The validity of developed simulator of proved with experimental results. Finally, power efficency of three-phase inverter is estimated according to high carrier frequency by using the simulatior.

• Journal of Power Electronics
• /
• 제10권2호
• /
• pp.155-164
• /
• 2010

This paper presents a voltage control algorithm for a hybrid multilevel inverter based on a staged-perception of the inverter voltage vector diagram. The algorithm is applied to control a three-stage eighteen-level hybrid inverter, which has been designed with a maximum number of symmetrical levels. The inverter has a two-level main stage built using a conventional six-switch inverter and medium- and low- voltage three-level stages constructed using cascaded H-bridge cells. The distinctive feature of the proposed algorithm is its ability to avoid the undesirable high switching frequency for high- and medium- voltage stages despite the fact that the inverter's dc sources voltages are selected to maximize the number of levels by state redundancy elimination. The high- and medium- voltage stages switching algorithms have been developed to assure fundamental switching frequency operation of the high voltage stage and not more than few times this frequency for the medium voltage stage. The low voltage stage is controlled using a SVPWM to achieve the reference voltage vector exactly and to set the order of the dominant harmonics. The inverter has been constructed and the control algorithm has been implemented. Test results show that the proposed algorithm achieves the desired features and all of the major hypotheses have been verified.

• Journal of Power Electronics
• /
• 제11권1호
• /
• pp.28-36
• /
• 2011

In this paper, a three phase cycloconverter type high frequency AC link inverter is discussed. The configuration consists of a high frequency full-bridge inverter and a high frequency transformer followed by a three phase cycloconverter whose switch is composed of anti-series connected MOSFETs with a common source. A simple digital control strategy based on space vector modulation (SVM) and repetitive control for the cycloconverter is proposed although its input voltage is a high frequency AC pulse. The operation principle of the proposed control strategy is analyzed and the equivalent working modes during one interval are also presented. The effectiveness of the proposed control strategy is verified through Matlab/Simulink simulations and experiments on a 1.45kW prototype.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2007년도 하계학술대회 논문집
• /
• pp.403-405
• /
• 2007

This paper presents the over-modulation strategy and indirect vector control drive of NPC type PWM inverter. NPC inverter has three level phase voltage output.It can perform in high voltage through assembling switching components. It has less harmonics and surge voltage stress at motor terminals than the 2 level inverter in same switching frequency through 3 level voltage. The conventional railway vehicle has used the vector control to MI=0.907 and the slip-frequency control from MI=0.907 to six-step mode. The slip-frequency control has bad motive power and slow torque control response. But vector control has good motive power and can instant torque control. In this paper, output voltage is controlled linearly from linear region to six-step mode by using over-modulation strategy. And NPC inverter is used.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2003년도 추계학술대회 논문집
• /
• pp.275-278
• /
• 2003

Conventional vector control inverter is usually used for blower of air-accord equipment. In this paper, it is proposed that inverter is controlled by instantaneous following PWM controller. This controller compensate and follow for output voltage of inverter within one switching cycle as an error that compared output voltage of rectifier included much ripples with reference voltage of sine wave. It has not speedy response like vector controller, but the circuit is very simple as using analog integer. And it has advantages that develop input power factor, built small-capacity and low-cost because huge capacitor of voltage type inverter removed.

• 전력전자학회논문지
• /
• 제12권4호
• /
• pp.310-317
• /
• 2007

본 논문에서는 평형 2상유도전동기에 대한 시스템 방정식을 유도하고 해석하였으며, 동기좌표계에서 평형 2상유도전동기의 속도제어 특성을 분석하였다. 3상 교류 전동기의 속도제어에 범용적으로 적용하는 벡터제어이론을 "2상 인버터 구동 2상 유도전동기 시스템"에 수정하여 적용하였으며, 이 때 2상 유도전동기 시스템은 수정된 간접 벡터제어이론에 의해 속도 제어하였다. 2상 유도기의 벡터제어의 특성과 근사함을 보여주기 위해 제안 시스템을 시뮬레이션하였다. 최종적으로 실험을 통해서 제안 시스템이 벡터제어에 확실히 적응하는 것을 확인하였다.

• 전기학회논문지
• /
• 제64권8호
• /
• pp.1186-1192
• /
• 2015

This paper proposes an economical method that the phase currents can be measured and reconstructed by means of the leg-shunt resistors in the 3-leg 2-phase vector-controlled inverter for 2-phase induction motor. In general, the phase currents of 2-phase induction motor have been measured using two Hall current sensors. However, because Hall current sensors are expensive, economically disadvantageous to apply in low power applications. The proposed method is verified by computer simulations and experiments to show the good performance of the vector control.

• 한국철도학회논문집
• /
• 제10권1호
• /
• pp.51-56
• /
• 2007

In this paper, control schemes are developed for a propulsion system(Converter/Inverter) in electrical train. A robust controller for PWM converter is proposed. The converter controller consists of a PI controller for DC output voltage and a current controller using error-space approach for maintaining the sinusoidal current waveform and unity power factor. This proposed method is based on characteristic ratio assignment(CRA) method which has the advantage to design the optimal gain to meet the referenced response and overshoot within the limit range. Inverter system is controlled by vector control and slip frequency control. At low speed region, vector control scheme is applied to control instantaneous torque and slip frequency control is performed under overmodulation region and one pulse mode. Because output voltage of converter contains harmonics ripple at twice input ac line frequency, control scheme is developed to reduce the pulsating torque current. The performance of propulsion system will be verified by simulation and prototype experimental results.