• Journal of the Korean Society for Heat Treatment
• /
• v.11 no.1
• /
• pp.46-53
• /
• 1998

The variation of the mechanical properties, microstructures and the formation of retained austenite with heat treatment conditions in austempered ductile cast iron has been investigated. In the case of austempered ductile cast iron below 25mm diameter, it has been found that a pearlite structure are not obtained under a super cooled condition at range of $0.05^{\circ}C/sec{\sim}10^{\circ}C/sec$, and the matrix is precipitated in graphite, bainite and retained austenite. After austempering treatment the retained austenite is increased with decreasing cooling rate. The elongation increases with decreasing super cooling rate, and the optimum result has been shown to be the elongation of 15.6% at super cooling rate of $0.05^{\circ}C/sec$. The optimum result has been shown to be the tensile strength-elongation balance of $1656kgf/mm^2.%$ and it is more than doubled to as the casting state and continuous cooling condition.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2004.07a
• /
• pp.110-113
• /
• 2004

ZnO varistor ceramics which were fabricated with variation of added of $0.5{\sim}1.0mol%\;Co_3O_4$ sintered at $1150^{\circ}C$. In the specimen added $0.7mol%\;Co_3O_4$, sintered density was $6.03g/cm^3$ and electrical peoperties were superior to any other components. The nonlinear coefficient a was 83, and clamping voltage ratio was 1.35. But, endurence surge current in the specimen added $0.5mol%\;Co_3O_4$ was $7000A/cm^2$, and deviation of varistor voltage was ${\Delta}-3.23%$. As P.C.T and T.C.T environment test were succeed in all specimens, and deviation of varistor voltage in the specimen added $0.6mol%\;Co_3O_4$ was ${\Delta}-0.81%$. All specimens showed a good leakage current property in the High Temperature Continuous Load Test for 1000hr, at $85^{\circ}C$, and variation rate of the varistor voltage was ${\Delta}-2%$.

• Food Science of Animal Resources
• /
• v.29 no.3
• /
• pp.310-316
• /
• 2009

In this study, the influence of pressure assisted mild thermal inactivation (PAMTI) on E. coli ATCC 10536 was examined at 200 MPa and temperature range of $20-50^{\circ}C$. Inactivation rate significantly increased (p<0.05) as temperature and time increased at 200 MPa. The maximum inactivation (7.91 log reduction) was obtained at $50^{\circ}C$ for 30 min under 200 MPa, which meant the complete inactivation of E. coli ATCC 10536. Inactivation kinetics were evaluated with the first order inactivation rate (k), activation energy ($E_a$), thermal death time (TDT), and z value. Kinetic parameters were significantly (p<0.05) influenced by variation temperature of PAMTI. In this study, the synergistic effect of pressure and temperature were found in the inactivation of E. coli ATCC 10536 through PAMTI.

• Particle and aerosol research
• /
• v.8 no.4
• /
• pp.173-180
• /
• 2012

SiC particles, 8.3 ${\mu}m$ in volume average diameter, were chlorinated in an alumina tubular reactor, 2.4 cm in diameter and 32 cm in length, with reactor temperature varied from 100 to $1200^{\circ}C$. The flow rate of the gas admitted to the reactor was held constant at 300 cc/min, the mole fraction of chlorine in the gas at 0.1 and the reaction time at 4 h. The chlorination was negligibly small up to the temperature of $500^{\circ}C$. Thereafter, the degree of chlorination increased remarkably with increasing temperature until $900^{\circ}C$. As the temperature was increased further from 900 to $1200^{\circ}C$, the increments in chlorination degree were rather small. At $1200^{\circ}C$, the chlorination has nearly been completed. The surface area of the residual carbon varied with chlorination temperature in a manner similar to that with the variation of chlorination degree with temperature. The surface area at $1200^{\circ}C$ was 912 $m^{2}/g$. A simple model was developed to predict the conversion of a SiC under various conditions. A Langmuir-Hinshelwood type rate law with two rate constants was employed in the model. Assuming that the two rate constants, $k_{1}$ and $k_{2}$, can be expressed as $A_{1e}^{-E_{1}/RT}$ and $A_{2e}^{-E_{2}/RT}$, the four parameters, $A_{1}$, $E_{1}$, $A_{2}$, and $E_{2}$ were determined to be 32.0 m/min, 103,071 J/mol, 2.24 $m^{3}/mol$ and 39,526 J/mol, respectively, through regression to best fit experimental data.

• Korean Journal of Food Science and Technology
• /
• v.12 no.1
• /
• pp.18-23
• /
• 1980

Rheological behaviors of red pepper paste acre investigated with rotational viscometer at $25{\sim}55^{\circ}C$ and the following results were obtained. 1. At shear rate of $0.323{\sim}1.653\;sec^{-1}$, red pepper paste was found to be a thixotropic food product which showed pseudoplastic proper ties and also exhibited a yield stress and time dependent characteristics. 2. At a shear rate of 0.978 $sec^{-1}$, flow behavior index, consistency index and yield stress were 0.597, 192.3 dyne $sec^s/cm^{2}$, and 91 dyne/$cm^{2}$ respectively. 3. Variation of consistency of red pepper paste with time was found to be decayed by a second order kinetic equation and thereafter nearly time independent. 4. Variation of consistency of red pepper paste with temperature was found to follow Andrade's equation and the activation energy as calculated on the basis of this equation was $1.03\;kcal/g{\cdot}mole$.

• Proceedings of the SAREK Conference
• /
• 2007.11a
• /
• pp.322-327
• /
• 2007

Dedicated outdoor air-conditioning(DOA) system that utilizes pre-cooling and desiccant dehumidification can be superior to conventional cooling and reheating system with respect to energy consumption and indoor thermal comfort. In this work, simulation has been conducted to study various factors that affect the performance of DOA. Dynamic simulation shows the transient variation of temperature and humidity as the on/off control logic is imposed. Exit humidity of process air and flow rate are varied to study the effect on exit temperature of process air, dehumidification quantity, required regeneration temperature and exit humidity of regeneration air. For an outdoor air condition of $28.5^{\circ}C$ temperature, 16 g/kg humidity ratio and 2000 cmh flow rate, the dehumidification efficiency is increased by 4.6% as the flow rate is doubled.

• Journal of Life Science
• /
• v.20 no.4
• /
• pp.481-486
• /
• 2010

The rates of synonymous and nonsynonymous nucleotide substitutions were studied for sequences of nuclear and chloroplast genes in Sorbus aucuparia. Results suggested that DNA evolution in this species had taken place, on average, at a slower rate in the chloroplast genes than in the nuclear genes: a rate variation pattern similar to those observed in eudicot plants. Within the nucleus, the synonymous substitution rates (Ks) (2.45-2.60) were two-fold higher than nonsynonymous substitution rates (Ka) (1.15-1.30). More notably, the values of Ks (1.20-1.26) were about six-fold higher than those of Ka (0.26-0.42) within the chloroplast genome. Ka/Ks ratios for nuclear and chloroplast genes of S. aucuparia had mean values of 0.178 and 0.056, respectively. A Ka/Ks ratio < 1 indicated negative (purifying) selection. The chloroplast genes had a lower effective number of codons (ENC) values (22.4-32.2) than those of nuclear genes (35.8-38.7). The analysis of the G+C content indicated that the chloroplast genes in this investigation had a higher preference for synonymous codons ending with A and T (G+C content range, 28.4-29.1%) where there was a slight bias toward codons ending with G+C (63.2-64.2%) in the nuclear genome.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.13 no.9
• /
• pp.735-744
• /
• 2000

The electrical procerties and stability of ZnO-Pr$_{6}$O$_{11}$-CoO-Cr$_2$O$_3$-Er$_2$O$_3$ (ZPCCE) based varistors were investigated in the Er$_2$O$_3$content range of 0.0 to 4.0 mol%. ZPCCE ceramics containing 2.0 mol% Er$_2$O$_3$ exhibited the highest density of 5.74 g/㎤ corresponding to 99.3% of theoretical density. The varistors with 0.5 mol% and 2.0 mol% Er$_2$O$_3$exhibited a relatively satisfying nonlinearity, which the nonlinear exponent is 40.50 and 47.15, respectively and the leakage current is 2.66 $mutextrm{A}$, respectively. Under more severe d.c. stress, such as (0.80 V$_{1mA}$/9$0^{\circ}C$/12h)+(0.85 V$_{1mA}$115$^{\circ}C$/12h)+(0.90 V$_{1mA}$12$0^{\circ}C$/12h)+(0.95 V$_{1mA}$1$25^{\circ}C$12h), they showed a very excellent stability, which the variation rate of the variator voltage is -0.89% and -0.15%, the variation rate of the nonlinear coefficient is -4.67% and -3.56%, and the variation rate of leakage current is -6.02% and -19.56%, respectively. It is surely bellived that ZnO-0.5 mol% Pr$_{6}$O$_{11}$-1.0 mol% CoO-0.5 mol% Cr$_2$O$_3$-x mol% Er$_2$O$_3$(x=0.5, 2.0) based varistors will be greatly contributed to develop the advanced Pr$_{6}$O$_{11}$-based ZnO varistors in future.uture. future.uture.

• Carbon letters
• /
• v.10 no.3
• /
• pp.181-189
• /
• 2009

Activated carbon spheres (ACS) were prepared at different heating rates by carbonization of the resole-type phenolic beads (PB) at $950^{\circ}C$ in $N_2$ atmosphere followed by activation of the resultant char at different temperatures for 5 h in $CO_2$ atmosphere. Influence of heating rate on porosity and temperature on carbon structure and porosity of ACS were investigated. Effect of heating rate and temperature on porosity of ACS was also studied from adsorption isotherms of nitrogen at 77 K using BET method. The results revealed that ACS have exhibited a BET surface area and pore volume greater than $2260\;m^2/g$ and $1.63\;cm^3/g$ respectively. The structural characteristics variation of ACS with different temperature was studied using Raman spectroscopy. The results exhibited that amount of disorganized carbon affects both the pore structure and adsorption properties of ACS. ACS were also evaluated for structural information using Fourier Transform Infrared (FTIR) Spectroscopy. ACS were evaluated for chemical composition using CHNS analysis. The ACS prepared different temperatures became more carbonaceous material compared to carbonized material. ACS have possessed well-developed pores structure which were verified by Scanning Electron Microscopy (SEM). SEM micrographs also exhibited that ACS have possessed well-developed micro- and meso-pores structure and the pore size of ACS increased with increasing activation temperature.

• Composites Research
• /
• v.19 no.4
• /
• pp.1-6
• /
• 2006

The effects of aging on fatigue of PSF/AS4 laminates tvas studied using the new energy release rate analysis. The analysis by the variational mechanics has been useful in providing fracture mechanics interpretation of matrix microcracking in cross-ply laminates. This paper describes the changes of the critical energy release rate ${\Delta}Gmc$(microcracking toughness) about the variation of the aging period during fatigue loading. The master plot by modified Pans-law gives a characterization of a material system's resistance to microcrack formation. PSF/AS4 $[0/902]_s$ laminates were aged at four different temperatures based on the glass transition temperature for 60 days. At all temperatures, the toughness decreased with aging time. The decrease of the toughness at higher temperature was faster than at lower temperature. To assess the effects of aging on fatigue, the unaged laminates were compared with the laminates which were aged for 60 days at $170^{\circ}C$ near $180^{\circ}C\;T_g$. The slope of dD/dN versus A 6u, of the aged laminates was lower than that of the unaged laminates. There was a significant shift of the aged data to formation of microcracks at the lower values of ${\Delta}G_m$.