• 태양에너지
• /
• 제12권2호
• /
• pp.1-8
• /
• 1992

본 연구는 동계 외기온 데이타의 시각별 변동특성을 파악하기 위하여 연변동 성분 및 기간변동 성분을 제거한 일변동 성분의 매 시각별 외기온 데이타에 대해서 일교차의 발생요인에 대해서 분석하였다. 또한 동계시각별 외기온의 주파수 특성에 대해서 검토하였으며 외기온 데이타의 수식화의 가능성을 제시하였다.

• 한국정밀공학회지
• /
• 제14권4호
• /
• pp.136-144
• /
• 1997

The characteristics of fatigue crack growth subject to out-of-plane bending fatigue are studied in terms of crack opening behavior by using pre-cracked smooth specimens. Crack opening stress is measured by an elastic compliance method which may precisely and continuously provide many date using strain gages during experiment. The results of the short crack and the long crack arranged by crack closure concept show that the effective stress gange ratio of short crack is grester than that of long crack, and ano- malous growth behavior of short crack may be elucidated by the variation of crack opening stress. When the variation of fatigue crack growth rate is arranged versus effective stress intensity factor range. Iinear relation is held also for the short crack. It shows that growth behavior of short crack can be quantitatively represent- ed by the fracture mechanics parameter using effective stress intensity factor range.

• 한국통신학회논문지
• /
• 제16권11호
• /
• pp.1132-1142
• /
• 1991

본 논문에서는 이동물체의 형태정보를 분석을 위한 이동물체의 특징파라미터를 추출하는 기법을 제안하였다. 이차원 영상에서 이동물체의 추출은 차영상 기법을 이용하였다. 이동물체의 특징 파라미터는 면적과 둘레, 면적과 둘레의 비(A/P ratio), 굴곡점(Vertex), 종횡비(X/Y ratio)로 하였다. 휘도 변화를 600 Lux${\sim}$1400 Lux로 가변시켜 휘도변화에 대한 각 특징파라미터의 오차 허용범위를 결정하였다. 제안된 방법의 타당성을 입증하기 위하여 모형 자동차를 이용하여 동일성을 판별한 결과 판정오류는 6%미만이었다.

• 대한기계학회논문집A
• /
• 제26권11호
• /
• pp.2287-2296
• /
• 2002

Most cracks in the structure occur under mixed mode loading and those fatigue crack propagation behavior heavily depends on the stress ratio. So, it is necessary to study the fatigue behavior under mixed mode loading as the stress ratio changes. In this paper, the fatigue crack propagation behavior was respectively investigated at stress ratio 0.1, 0.3, 0.5, 0.7 and we changed the loading application angle into 0$^{\circ}$, 30$^{\circ}$, 60$^{\circ}$ to apply various loading mode. The mode I and II stress intensity factor of CTS specimen used in this study was calculated by the displacement extrapolation method using FEM (ABAQUS). Using both the experiment and FEM analysis, we have concluded the relationship between crack propagation rate and stress intensity factor range at each loading mode due to the variation of stress ratio. Also, when the crack propagated under given stress ratio and loading mode condition, we have concluded the dominant factors of the crack propagation rate at each case.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2001년도 추계학술대회논문집A
• /
• pp.286-291
• /
• 2001

Most cracks in the structure occur under mixed mode loadings and those propagation depend on the stress ratio very much. So, it is necessary to study the fatigue behavior under mixed mode loading as stress ratio changes. In this paper, fatigue crack propagation behavior was investigated respectively at stress ratio 0.1, 0.3, 0.5, 0.7 and we change loading application angle to $0^{\circ},\;30^{\circ},\;60^{\circ}$ to apply various loading. mode. The mode I and II stress intensity factors of CTS specimen used in this study were calculated by displacement extrapolation method using FEM(ABAQUS). Using both the study through the experiment and the theoretical study through FEM analysis, we studied the relation between crack propagation rate and stress intensity factor range at each loading mode due to the variation of stress ratio. Also, when the crack propagated under given stress condition and given loading mode condition, we studied what the dominant factors of the crack propagation rate were at each case.

• 대한기계학회논문집B
• /
• 제39권8호
• /
• pp.669-675
• /
• 2015

자동차용 터보차저 원심압축기의 재순환케이싱처리(RCT)부의 높이변화가 압축기의 성능에 미치는 영향이 조사되었다. 연구대상 RCT 부의 높이는 1.2mm, 1.5mm, 1.8mm 의 세가지이며, 회전수 범위는 90,000 - 150,000 rpm, 유량 범위는 0.015 kg/s - 0.08 kg/s 이다. 전압력비와 등엔트로피 효율 비교 결과, 본 수치계산은 실제압축기의 성능 제원과 최대오차 0.7%의 범위 내에서 잘 일치하였다. 해석결과, RCT 부 높이 1.2mm, 1.8mm, 1.5mm 순서로 균일 압력분포, 높은 압력비, 넓은 작동범위를 얻었다. 이들 세가지 경우 모두, 회전수가 증가할수록 이들의 압력비는 높아지나 운전범위는 좁아지는 전형적인 압축기 맵의 특성을 보여주었다.

• 국제초고층학회논문집
• /
• 제1권1호
• /
• pp.1-13
• /
• 2012

The importance of appropriate use of damping evaluation techniques and points to note for accurate evaluation of damping are first discussed. Then, the variation of damping ratio with amplitude is discussed, especially in the amplitude range relevant to wind-resistant design of buildings, i.e. within the elastic limit. The general belief is that damping increases with amplitude, but it is emphasized that there is no evidence of increasing damping ratio in the very high amplitude range within the elastic limit of main frames, unless there is damage to secondary members or architectural finishings. The damping ratio rather decreases with amplitude from a certain tip drift ratio defined as "critical tip drift ratio," after all friction surfaces between primary/structural and secondary/non-structural members have been mobilized.

• 설비공학논문집
• /
• 제10권2호
• /
• pp.173-179
• /
• 1998

An experimental study was conducted on the effect of compressor capacity control range of heat pump on the seasonal energy efficiency ratio with variation of the maximum and minimum compressor input frequencies. To obtain seasonal energy efficiency ratio, steady state test at the maximum, minimum and intermediate compressor speed and cyclic test at the minimum compressor speed should be conducted. Maximum input frequency was varied to 95Hz, 105Hz, and 115Hz, and the minimum input frequency was varied to 35Hz, 45Hz, and 55Hz. The seasonal energy efficiency ratio increased as the input frequency of the compressor decreased. The maximum input frequency had only slight effects on the SEER.

• 한국수산과학회지
• /
• 제17권5호
• /
• pp.391-397
• /
• 1984

The seasonal and portional variation in the composition of uronic acid of alginic acid from Eckionia cava was investigated. The sample was collected from the coast of Ieechun Illkwangmyun, Yangsangun, Kyungnam, Korea, in the period of January to December in 1982. In seasonal variation of the content of alginic acid, the range of variation was larger in the frond than in the stipe, It was the highest content in between February to April, and the lowest in between August to October, and the content was more in the stipe than in the frond. The uronic acid ratio(M/G ratio) was varied seasonaly in a relationship with the variation of the alginic acid content. The maximum M/G ratio appeared in the period of December to March and minimum May to August, and the average values of the M/G ratios in the periods were 3.08, 2.64 in the frond and 2.91, 1.39 in the stipe, respectively. Additively a year mean values were 3.22 in the frond and 2.18 in the stipe.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2002년도 학술대회지
• /
• pp.255-258
• /
• 2002

Liquid rocket engines using liquefied natural gas (LNG) or methane as a fuel is known to have several good characteristics, such as high specific impulse compared to other hydrocarbon fuels, environment-friendly exhaust gas, low production cost, and re-usability with low soot generation in the cooling channel. In this study, experimental combustion chambers capable of using LNC and $CH_{4}$ are being researched through experimental firing tests, and within easy range of eyes' inspection, there are the periodical existence of soot or discoloration in the chamber wall surface. This result means that mixture ratio of oxidizer and fuel fluctuates periodically between outer-row injectors in the mixing head in the circumferential direction. Therefore, based on this phenomenon, the variation of mixture ratio near the chamber wall caused by the spill pattern of a shear coaxial injector was analyzed quantitatively and the thermal heat flux Into the cooling channel is modified. Then, the calculated and modified results are compared with the measured ones.