• 생물환경조절학회지
• /
• 제5권2호
• /
• pp.152-159
• /
• 1996

Experiment was performed in a newly developed wind tunnel with light system to determine the aerodynamic resistance and eddy diffusivity above the plug stand under artificial light. Maximum air temperature appeared near the top of the plug stand under artificial light. Since Richardson number was ranged from -0.07 to +0.01, the atmosphere above the plug stand in wind tunnel was in an unstable or near- neutral stability state. The average aerodynamic resistance at rear region of plug stand was 25 % higher than that at middle region. Eddy diffusivity($K_{M}$) linearly increased with the increasing air current speed. $K_{M}$ at air current speed of 0.9 m.$s^{-1}$ was about two times as many as that at air current speed of 0.3 m.$s^{-1}$. And average $K_{M}$ at the rear region was 15% lower than that at the middle region. These results indicated that the diffusion of heat and mass along the direction of air current inside the plug stand was different. It might cause the lack of uniformity in the growth and quality of plug seedlings. The wind tunnel developed in this study would be useful to investigate the effects of air current speed on microclimates and the growth of plug seedlings under artificial light in a semi- closed ecosystem.

• 설비공학논문집
• /
• 제5권4호
• /
• pp.235-242
• /
• 1993

The flow characteristics of developing turbulent pulsating flows are investigated experimentally in the entrance region of a square duct ($40mm{\times}40mm$ and 4,000mm). Mean velocity profiles, turbulence intensity and entrance length are measured by using a hot-wire anemometer system together with data acquisition and processing systems. It is found that the velocity waveforms are not changed in the fully developed flow region where that $x/Dh{\geq}40$. For turbulent pulsating flow, the turbulent components in the velocity waveforms increase as the dimensionless transverse position approaches the wall. Mean velocity profiles of the turbulent steady flows follow the one-seventh power law profile in the fully developed flow region. Turbulence intensity increases as the dimensionless transverse position increases from the center to the wall of the duct, and is slightly smaller in the accelerating phase than in the decelerating phase for the turbulent pulsating flows. The entrance length of the turbulent pulsating flow is about 40 times as large as the hydraulic diameter under the present experimental conditions.

• 한국자동차공학회논문집
• /
• 제9권2호
• /
• pp.99-106
• /
• 2001

NHTSA has been conducting biomechanical studies to reduce inujuries sustained sustained during automotive collision. Furthermore, NHTSA added the regulation to the FMVSS 201, limiting the equivalent HIC(Head Injury Criterion) value under 1000. In the presont work, a methodology was developed for the optimum design of the A-pillar trim with rib-structures. The design variables for the rib-strucrures were the transverse spacing, the longitudinal spacing, and the thickness. The required sets of the design varibles were decided based on the design of experiments. The head impact simulations were carried out using the LS-DYNA3D, and the HIC(d) values were computed using the resulrs of the head impact simulation. The objective function was constructed using the response surface methed (RSM). When the obtained optimum values were not inside the region of interest, the design proceduers were repeated by changing the region of interest. Finally, an A-pillar trim with rib-structures, which resulred in HIC(d) value under 850 for 15 mph head-trim impact, was developed.

• Journal of Microbiology and Biotechnology
• /
• 제13권3호
• /
• pp.400-405
• /
• 2003

A gene (hpkA), encoding a histidine protein kinase homolog, has been identified in the upstream region of the espAB operon in Myxococcus xanthus. It encodes a 333 amino acid (35,952 Da) protein with a histidine protein kinase domain in the region from amino acid 90 to 317. Null mutations in the hpkA gene caused formation of loose irregular fruiting bodies, while wild-type strains developed tight hemispherical fruiting bodies under developmental conditions. Sporulation of the hpkA mutant was delayed by at least 12 h compared to that of the wild-type. It appeared that the hpkA mutation increased the expression of the espAB operon by more than 2-fold compared with the wild-type under developmental conditions. Expression of the hpkA gene was low under vegetative conditions, but was highly induced under developmental conditions.

• Journal of Advanced Marine Engineering and Technology
• /
• 제23권3호
• /
• pp.300-310
• /
• 1999

A constant-volume combustion chamber is developed to measure the burnt gas temperature over the wide ranges of equivalence ratio from 1.5 to 2.7 and pressure from 0.1 to 2.7 and pressure from 0.1 to 6 MPa by two-color method. The combustion temperature is also calculated by the conventional two-region model. The premixed fuel rich propane-oxygen-inert gas mixtures under high pressures are simultaneously ignited by eight spark plugs located on the circumference of combustion chamber with 45 degree intervals. The eight converging flames compress the end gases to high pressures. The transmissiv-ity in the chamber center during the final stage of combustion at the highest pressure is measured by in situ laser extinction method. Comparisons are made with the combustion temperatures between two-color method and two-region model. It is found that the burnt gas temperature mea-sured by two-color method is higher than that calculated by two-region model because of being the negative temperature gradient on the calculation and the temperature distribution of light path-length on the measurement and the burnt gas temperature for the turbulent combustion is higher than that of the laminar combustion under the same conditions because the heat loss for turbulent combustion is lower due to the shorter combustion period.

• 대한전기학회논문지
• /
• 제43권3호
• /
• pp.478-484
• /
• 1994

Facing target dc sputtering system developed by Hoshi et al. has simple configuration and high deposition rate under moderate substrate temperature in the range of pressure 5x10S0-4T - 1x10S0-2T torr. In this system, magnetic field should be applied perpendicular to the target surface in order to confine high energy secondary electrons between two targets. Because of this magnetic field, the glow discharge characteristics are very different from dc planar diode system showing some unstable discharge region. In this paper, the glow discharge characteristics of this system have been studied under the condition of Ti targets with Ar-NS12T(10%) as working gas. It is found that this system has stable discharge region under the discharge current density of 15-30(mA/cmS02T). The plasma density and electron temperature are in the range of 10S010Y - 10S011T(CMS0-3T) and 2.5-5(eV), respectively.

• Journal of the Korean Statistical Society
• /
• 제28권4호
• /
• pp.443-455
• /
• 1999

A simulation-based approach to estimating the probability of an arbitrary region under a multivariate normal distribution is developed. In specific, the probability is expressed as the ratio of the unrestricted and the restricted multivariate normal density functions, where the restriction is given by the region whose probability is of interest. The density function of the restricted distribution is then estimated by using a sample generated from the Gibbs sampling algorithm.

• 토지주택연구
• /
• 제3권4호
• /
• pp.307-314
• /
• 2012

1980년대 이후 본격적으로 추진된 낙후지역 개발정책은 수도권 집중을 완화하고 전 국토의 균형발전을 목표로 하였으나 지방을 종합적 체계적으로 육성하기보다는 중앙부처별로 소관업무를 분산하여 추진함으로써 지역특성이 반영되고 지역주민이 주도하는 수요자 맞춤형 개발이 이루어지지 못한 문제를 안고 있다. 이러한 문제인식 하에 본 연구는 현재 각 부처별로 시행되고 있는 주요 낙후지역 개발정책들에 대하여 지방자치단체 공무원들이 인식하는 다양한 문제점과 개선대책에 대한 조사를 통해 지역 현장에서 활용가능한 정책적 시사점을 도출하고자 하였다. 첫째, 각 중앙부처별로 분산적 개별적으로 추진되고 있는 낙후지역 개발정책의 통합 조정을 통한 지역개발사업의 계획 일관성 및 사업추진의 효율성을 제고할 필요가 있다. 둘째, 낙후지역 개발사업을 위한 재정 확충 및 운용시스템 개선 등 국고지원을 위한 기준의 합리적 설정이 필요하다. 셋째, 효율적인 지역개발사업 추진체계를 구축하여 사업간의 연계협력 강화와 맞춤형 사업 발굴 및 집행을 지원할 수 있는 제도적 보완이 필요하다.

• 한국지진공학회:학술대회논문집
• /
• 한국지진공학회 2000년도 추계 학술발표회 논문집 Proceedings of EESK Conference-Fall 2000
• /
• pp.440-447
• /
• 2000

In order to evaluate the cost effectiveness of seismic isolation for bridges in low and moderate seismic region, a method of calculation minimum life-cycle cost of seismic-isolated bridges under specific acceleration level and soil condition is developed. Input ground motion is modeled as spectral density function compatible with response spectrum for combination of acceleration coefficient and site coefficient. Failure probability is calculated by spectrum analysis based on random vibration theories to simplify repetitive calculations in the minimization procedure. Ductility of piers and its effects on cost effectiveness are considered by stochastic linearization method. Cost function and cost effectiveness index are defined by taking into consideration the characteristics of seismic isolated bridges. Limit states for calculation of failure probability are defined on superstructure, isolator and pier, respectively. The results of example design and analysis show that seismic isolation is more cost-effective in low and moderate seismic region than in high seismic region.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2004년도 학술대회지
• /
• pp.801-803
• /
• 2004

The current drive in an MOSFET is limited by the intrinsic channel resistance. All the other parasitic elements in a device structure playa significant role and degrade the device performance. These other resistances need to be less than $10{\%}-20{\%}$ of the channel resistance. To achieve the requirements, we should investigate the methodology of separation and quantification of those resistances. In this paper, we developed the extraction method of resistances using calibrated TCAD simulation. The resistance of the extension region is also partially determined by the formation of a surface accumulation region that forms under the gate in the tail region of the extension profile. This resistance is strongly affected by the abruptness of the extension profile because the steeper the profile is, the shorter this accumulation region will be.