• Journal of Advanced Navigation Technology
• /
• v.19 no.2
• /
• pp.168-174
• /
• 2015

Wireless communication system for firefighters has an important role as the last communication method between the commander and the firefighters in disaster sites like fire. But the operation of Gyeongnam wireless communication system is installed, and maintained and controlled without criteria for the selection of a transmitting station and the analysis of propagation environment because of the lack of budget and the absence of professional personnel. To improve the performance of the radio station, this paper theoretically calculated free space loss of UHF 400 MHz band used by all firefighters in Gyeongnam and diffractions caused by single and multiple obstacles and computed the error after comparing the results of the actual measurement to those of simulation with FRAS operated by KFL. In the results, Deygout model was the most consistent with the actual measurement for 400MHz band in Kimhae site.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.14 no.2
• /
• pp.222-231
• /
• 2011

In this paper, we have proposed a method which can make it possible to stably transmit and receive data like the ARC-164 radio frequency hopping environment as a S/W packet modem with PSK modulation. This is a method that the S/W packet modem with PSK digital modulation and the use of PC sound cards change over from data to voice signals and then transmit/receive data. We confirmed not only that it is possible to solve the slow speed communication with the use of sending data through multi-channels and PSK modulation that has the ability to methodically improve transmission rates, but also that it is possible to send the state of frequency hopping stably. In conclusion, we've confirmed both tactical values that though the transmission rate may be a tad slow, a state of frequency hopping of more than 94% confidence plus voice and data can be sent via radio at the same time. In this paper, the proposed S/W packet modem is only an implemented S/W component, so when we apply it to aircraft that we don't consider EMC problems with, then we have the advantage of a wider use of conventional UHF/VHF/HF radio that is possible to voice communication. If we recognize these operational requirements, we can apply for a lot of field equipment efficiently.

• Journal of Electrical Engineering and Technology
• /
• v.10 no.1
• /
• pp.344-354
• /
• 2015

In order to study the development of partial discharge (PD) under typical protrusion defects in gas-insulated switchgear, we applied step voltages on the defect and obtained the ${\varphi}-u$ and ${\varphi}-n$ spectrograms of ultra-high frequency (UHF) PD signals in various PD stages. Furthermore, we extracted seven kinds of features to characterize the degree of deterioration of insulation and analyzed their values, variation trends, and change rates. These characteristics were inconsistent with the development of PD. Hence, the differences of these features could describe the severity of PD. In addition, these characteristics could provide integrated characteristics regarding PD development and improve the reliability of PD severity assessment because these characteristics were extracted from different angles. To explain the variation laws of these seven kinds of parameters, we analyzed the relevant physical mechanism by considering the microphysical process of PD formation and development as well as the distortion effect generated by the space charges on the initial field. The relevant physical mechanism effectively allocated PD severity among these features for assessment, and the effectiveness and reliability of using these features to assess PD severity were proved by testing a large number of PD samples.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.14 no.2
• /
• pp.275-282
• /
• 2019

Clusters generated by features such as mountains or buildings are considered as the contaminated data that are independent of atmospheric phenomena. The basic way to reduce the clutter signal is to install a clutter fence around the wind profiler. In order to investigate the effect of clutter fence on the wind profiler data, the wind vector collection rate and wind vector accuracy of wind profiler was investigated before and after clutter fence installation. The clutter fence of wind profiler contributed to improve the data quality as well as the data collection rate.

• Journal of Broadcast Engineering
• /
• v.18 no.4
• /
• pp.572-588
• /
• 2013

In this paper, 4K-UHDTV or 8K-UHDTV and UHD-3DTV that the next generation broadcasting implementation and the possibility of direct receiving environment construction is analyzed on the terrestrial broadcasting. Particularly, we investigated the possibility by analyzing the previous and related works with regard to UHDTV transmission by DVB-T2 that is one of the best commercialized transmission mode. In order that the UHDTV broadcasting succeeds once again after completion of digital terrestrial switch over at the end of 2012, the ultra high resolution image transfer is important. However, the direct, the indoor and ubiquitous receiving environment is important in not only TV but also the personal type multimedia terminal in the sense of UHDTV service penetration. Therefore, in this paper, by using SFN and high error-correcting mode in DVB-T2 standard, the efficient frequency utilization and effective reception environment construction is illustrated. Particularly, SFN network constitution by 2 mutually different frequencies including the VHF bandwidth and UHF band, and etc. is shown. And the method that builds the free wireless receive environment by using SFN low power radio repeater and for home use gap filler is proposed. And the effect and frequency amount required are presented, when UHDTV broadcasting use 10MHz bandwidth.

• Investigative Magnetic Resonance Imaging
• /
• v.24 no.3
• /
• pp.95-122
• /
• 2020

In this article, we evaluated the performance of radiofrequency (RF) coils in terms of the signal-to-noise ratio (S/N) and homogeneity of magnetic resonance images when used for ultrahigh-frequency (UHF) 7T magnetic resonance imaging (MRI). High-quality MRI can be obtained when these two basic requirements are met. However, because of the dielectric effect, 7T magnetic resonance imaging still produces essentially a non-uniform magnetic flux (|B₁|) density distribution. In general, heterogeneous and homogeneous RF coils may be designed using electromagnetic (EM) modeling. Heterogeneous coils, which are surface coils, are used in consideration of scalability in the |B₁| region with a high S/N as multichannel loop coils rather than selecting a single loop. Loop coils are considered state of the art for their simplicity yet effective |B₁|-field distribution and intensity. In addition, combining multiple loop coils allows phase arrays (PA). PA coils have gained great interest for use in receiving signals because of parallel imaging (PI) techniques, such as sensitivity encoding (SENSE) and generalized autocalibrating partial parallel acquisition (GRAPPA), which drastically reduce the acquisition time. With the introduction of a parallel transmit coil (pTx) system, a form of transceiver loop arrays has also been proposed. In this article, we discussed the applications and proposed designs of loop coils. RF homogeneous coils for volume imaging include Alderman-Grant resonators, birdcage coils, saddle coils, traveling wave coils, transmission line arrays, composite right-/left-handed arrays, and fusion coils. In this article, we also discussed the basic operation, design, and applications of these coils.

• Journal of Korea Multimedia Society
• /
• v.15 no.3
• /
• pp.364-371
• /
• 2012

Currently, CMMB(China Mobile Multimedia Broadcasting) and the conventional analog TV broadcasting have transmitted by using UHF(Ultra High Frequency : 474MHz~754MHz) band. Normally, the transmission power of the digital TV broadcasting is lower than the conventional analog TV broadcasting to protect the reception quality of the conventional analog TV broadcasting. The reception sensitivity of CMMB receiver has severely deteriorated due to adjacent the conventional analog TV broadcasting signals which called ACI (Adjacent Channel Interference). To improve the reception sensitivity of a CMMB receiver on ACI environment, this paper proposed a simple method which is tuning a cut off frequency of LPF (Low Pass Filter). From the experiment, the reception sensitivity of CMMB receiver was improved as 11.3dB.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2016.02a
• /
• pp.341-341
• /
• 2016

The discovery of light emission in nanostructured silicon has opened up new avenues of research in nano-silicon based devices. One such pathway is the application of silicon quantum dots in advanced photovoltaic and light emitting devices. Recently, there is increasing interest on the silicon quantum dots (c-Si QDs) films embedded in amorphous hydrogenated silicon-nitride dielectric matrix (a-SiNx: H), which are familiar as c-Si/a-SiNx:H QDs thin films. However, due to the limitation of the requirement of a very high deposition temperature along with post annealing and a low growth rate, extensive research are being undertaken to elevate these issues, for the point of view of applications, using plasma assisted deposition methods by using different plasma concepts. This work addresses about rapid growth and single step development of c-Si/a-SiNx:H QDs thin films deposited by RF (13.56 MHz) and ultra-high frequency (UHF ~ 320 MHz) low-pressure plasma processing of a mixture of silane (SiH4) and ammonia (NH3) gases diluted in hydrogen (H2) at a low growth temperature ($230^{\circ}C$). In the films the c-Si QDs of varying size, with an overall crystallinity of 60-80 %, are embedded in an a-SiNx: H matrix. The important result includes the formation of the tunable QD size of ~ 5-20 nm, having a thermodynamically favorable <220> crystallographic orientation, along with distinct signatures of the growth of ${\alpha}$-Si3N4 and ${\beta}$-Si3N4 components. Also, the roles of different plasma characteristics on the film properties are investigated using various plasma diagnostics and film analysis tools.

• Journal of Electrical Engineering and Technology
• /
• v.9 no.5
• /
• pp.1686-1693
• /
• 2014

In this paper, oil-paper samples composed of transformer windings were used to investigate the insulation degradation process subjected to partial discharge (PD), with artificial defects inside to simulate the PD induced insulation degradation. To determine appropriate test voltages, the breakdown time obtained through a group of accelerated electrical degradation tests under high voltages was firstly fitted by two-parameter Weibull model to acquire the average breakdown time, which was then applied to establish the inverse power law life model to choose advisable test voltages. During the electrical degradation process, PD signals were synchronously detected by an ultra-high frequency (UHF) sensor from inception to breakdown. For PD analysis, the whole degradation process was divided into ten stages, and chaos theory was introduced to analyze the variation of three chaotic parameters with the development of electrical degradation, namely the largest Lyapunov exponent, correlation dimension and Komogorov entropy of PD amplitude time series. It is shown that deterministic chaos of PD is confirmed during the oil-paper degradation process, and the obtained results provide a new effective tool for the diagnosis of degradation of oil-paper insulation subjected to PD.