• 한국전산유체공학회:학술대회논문집
• /
• 2008.03b
• /
• pp.656-657
• /
• 2008

The droplet dynamics in a hydrophilic/hydrophobic microchannel, which is applicable to a typical proton exchange membrane fuel cell (PEMFC), is studied numerically by solving the equations governing conservation of mass and momentum. The liquid-gas interface or droplet shape is determined by a level set method which is modified to treat contact angles. The matching conditions at the interface are accurately imposed by incorporating the ghost fluid approach based on a sharp-interface representation. The effects of contact angle, inlet flow velocity, droplet size and side wall on the droplet motion are investigated parametrically. Based on the numerical results, the droplet dynamics including the sliding and detachment of droplets is found to depend significantly on the contact angle. Also, a droplet removal process is demonstrated on the combination of hydrophilic and hydrophobic surfaces.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2011.04a
• /
• pp.113-118
• /
• 2011

Many kinds of dynamic absorbers have been used to reduce the vibration of machineries and structures. In the typical ones, however low damping capacity, durability and limited install condition restrict their application. In this study, high damped dynamic absorber was proposed for diesel generator set. Developed absorber is composed with mass and coil springs. Silicone oil was filled inside the narrow gap between mass and casing. Viscous damping of silicon oil act as additional damping so that proposed dynamic absorber is suitable for D/G set which have adjacent resonance frequency to operation speed. The performance of the dynamic absorber was confirmed through the actual test on diesel engine generator set.

• Current Optics and Photonics
• /
• v.1 no.2
• /
• pp.113-117
• /
• 2017

With the increasing use of high-power laser diode bars (LDBs) and stacked LDBs, the issue of thermal control has become critical, as temperature is related to device efficiency and lifetime, as well as to beam quality. To improve the thermal resistance of an LDB set, we propose and analyze a bypass heat sink with a top canopy structure for an LDB set, instead of adopting a thick submount. The thermal bypassing in the top-canopy structure is efficient, as it avoids the cross-sectional thermal saturation that may exist in a thick submount. The efficient thickness range of the submount in a typical LDB set is guided by the thermal resistance as a function of thickness, and the simulated bypassing efficiency of a canopy is higher than a simple analytical prediction, especially for thinner canopies.

• Korean Journal of English Language and Linguistics
• /
• v.1 no.1
• /
• pp.101-117
• /
• 2001

In English, whether or not wh-movement creates weak crossover effects depends upon the type of wh-phrases that cross over. A bare interrogative like who shows a typical weak crossover effect whereas which N type (e.g. which girl) and partitive type (e.g. which of these girls) wh-phrases would show mere weaker and weakest crossover effects, respectively. Previous approaches to English crossover phenomena that resort to a binary notion of specificity or D-linking cannot account for the three-way contrast the three different types of wh-phrases show. To overcome this problem, I argue in this paper that specificity should be a non-binary set-theoretic notion and propose the following subset principle and optimal binding relation: Between two lexical nominal expressions A and B, A is regarded as more specific than B iff the denotation of A comes from a more narrowly defined non-singleton set than B. Between two lexical nominal expressions A and B, if A locally binds B, then the non-singleton set from which the denotation of A comes should be a subset of the set from which the denotation of B comes (i.e. B cannot be more specific than A). The smaller the subset (i.e. the wider the specificity gap between binder and binder), the more optimal the local binding relation is. A locally binds B iff A is coindexed with B, and A c-commands B, and there is no such C that does not bind A but binds B. Finally, I show that partitivity functions to carve out a smaller subset and thus make partitive wh-phrases more specific than simple which N type wh-phrases.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.48 no.9
• /
• pp.50-57
• /
• 2011

Conventional bus system architectures are composed of several components such as master, arbiter, decoder and slave modules. The arbiter plays a role in bus arbitration according to the selected arbitration method, since several masters cannot use the bus concurrently. Typical priority strategies used in high performance arbiters include static priority, round robin, TDMA and lottery. Typical arbitration algorithms always consider the bus priority primarily, while the bus utilization is always ignored. In this paper, we propose an arbitration method using bus utilization for the operating block of each master. We verify the performance compared with the other arbitration methods through the TLM(Transaction Level Model). Based on the performance verification, the conventional fixed priority and round-robin arbitration methods cannot set the bus utilization. Whereas, in the case of the conventional TDMA and lottery arbitration methods, more than 100,000 cycles of bus utilization can be set by the user, exhibiting differences of actual bus utilization up to 50% and 70%, respectively. On the other hand, we confirm that for the proposed arbitration method, the matched bus utilization set by the user was above 99% using approximately 1,000 cycles.

• Proceedings of the SAREK Conference
• /
• 2007.11a
• /
• pp.510-515
• /
• 2007

A Study on Typical Rates of Water-use for School Facilities has been carried out in this work. Water supply system is given much weight in school facilities. Therefore, it set up a basis efficiency using of water sources to calculate typical rates of water use. The results are summarized as follows ; 1) On the whole, typical rates of water-use was founded out 15 L / stu. d in pirmary school, 10 L / stu. d in middle school and 30L / stu. d in high school smaller than the existing it. It was rate of water-use change as season and Max. Rates of water-use was July. 2) I deem that school hours are 5 hour's in primary school, 7 hour's in middle school and 8 hour's in high school. It the concept of 1 hour that is lesson time 40 minutes and resting time 10 minutes in primary school, lesson time 45 minutes and resting time 10 minutes in middle school and lesson time 50 minutes and resting time 10 minutes in high school. 3) It is desired that we calculate the volume of pump and water tank throughout this concept and the size of water tank should be 1.5 times with taking pick load into consideration by this study on typical rate of water-use. 4) The amount of using water increases in gradually and I consider the life cycle of facilities is more than 10 years. As a result, I can forecast that the size will be insufficiency but I deem that if we devise a plan about parallel pumping on water tank space, we can cope with it. Also, it is expected that we can cut back the transport energy by controlling pump volume.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.22 no.4
• /
• pp.100-106
• /
• 2008

Typical household load have nonlinear loads including a personal computer, video, refrigerator, microwave oven, TV, and audio set. These nonlinear loads generate harmonic currents and create distortions on the sinusoidal voltage of the power system. Harmonic field measurements have shown that the harmonic contents of a waveform varies with time. A cumulative probablistic approach is the most commonly used method to solve time varying harmonics. This paper provides in depth analysis on harmonics field measurement of the typical household loads and harmonics simulation using EDSA program for the case study.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.22 no.5
• /
• pp.95-102
• /
• 2008

Typical household loads have nonlinear loads including a personal computer, video, refrigerator, microwave oven, TV, and audio set. These nonlinear loads generate harmonic currents and create distortions on the sinusoidal voltage of the power system. Harmonic field measurements have shown that the harmonic contents of a waveform varies with time. A cumulative probablistic approach is the most commonly used method to solve time varying harmonics. This paper provides in depth analysis on harmonics field measurement of the typical household loads for one year period and the survey is conducted with the objectives to identify the trends of harmonic distortion level present and indentify the future trends of metering in the presence of nonsinusoidal current and voltage waveforms in the system.

• Structural Engineering and Mechanics
• /
• v.39 no.3
• /
• pp.411-425
• /
• 2011

This paper illustrates the results of a seismic vulnerability study aimed to derive the fragility curves for typical Algerian reinforced concrete bridge piers using an analytical approach. Fragility curves express the probability of exceeding a certain damage state for a given ground motion intensity (e.g., PGA). In this respect, a set of 41 worldwide accelerometer records from which, 21 Algerian strong motion records are included, have been used in a non-linear dynamic response analyses to assess the damage indices expressed in terms of the bridge displacement ductility, the ultimate ductility, the cyclic loading factor and the cumulative energy ductility. Combining the damage indices defined for 5 damage rank with the ground motion indices, the fragility curves for the bridge piers were derived assuming a lognormal distribution.

• Journal of International Society for Simulation Surgery
• /
• v.2 no.2
• /
• pp.64-66
• /
• 2015

Purpose : In this paper we proposed cascade feature filter and projection method for rapid human face recognition for the large-scale high-dimensional face database. Materials and Methods : The relevant features are selected from the large feature set using Fast Correlation-Based Filter method. After feature selection, project them into discriminant using Principal Component Analysis or Linear Discriminant Analysis. Their cascade method reduces the time-complexity without significant degradation of the performance. Results : In our experiments, the ORL database and the extended Yale face database b were used for evaluation. On the ORL database, the processing time was approximately 30-times faster than typical approach with recognition rate 94.22% and on the extended Yale face database b, the processing time was approximately 300-times faster than typical approach with recognition rate 98.74 %. Conclusion : The recognition rate and time-complexity of the proposed method is suitable for real-time face recognition system on the large-scale high-dimensional face database.