• 대한수학회지
• /
• 제53권1호
• /
• pp.201-215
• /
• 2016

In this paper, we consider the following $Schr{\ddot{o}}dinger$-Kirchhoff-type equations $\[a+b\({\int}_{{\mathbb{R}}^N}({\mid}{\nabla}u{\mid}^2+V(x){\mid}u{\mid}^2)dx\)\][-{\Delta}u+V(x)u]=f(x,u)$, in ${\mathbb{R}}^N$. Under certain assumptions on V and f, some new criteria on the existence and multiplicity of nontrivial solutions are established by the Morse theory with local linking and the genus properties in critical point theory. Some results from the previously literature are significantly extended and complemented.

• 한국반도체및디스플레이장비학회:학술대회논문집
• /
• 한국반도체및디스플레이장비학회 2007년도 춘계학술대회
• /
• pp.179-182
• /
• 2007

Polycrystaline (poly) 3C-SiC thin film on n-type and p-type Si were deposited by APCVD using HMDS, $H_2$, and Ar gas at $1180^{\circ}C$ for 3 hour. And then the schottky diode with Au/poly 3C-Sic/Si(n-type) structure was fabricated. Its threshold voltage ($V_d$), breakdown voltage, thickness of depletion layer, and doping concentration ($N_D$) value were measured as 0.84 V, over 140 V, 61nm, and $2.7{\times}10^{19}\;cm^3$, respectively. The p-n junction diode fabricated by poly 3C-SiC was obtained like characteristics of single 3C-SiC p-n junction diode. Therefore, its poly 3C-SiC thin films are suitable MEMS applications in conjuction with Si fabrication technology.

• 대한설비공학회:학술대회논문집
• /
• 대한설비공학회 2009년도 하계학술발표대회 논문집
• /
• pp.1348-1354
• /
• 2009

The purpose of the present study is to investigate the flow resistance and the heat transfer characteristics of V type circular fin-tube heat exchanger. Four kinds of V type fin having the same fin area and the different span wise angle tested numerically. Test data for the heat transfer, pressure drop and fin temperature were shown and discussed. The pressure drop and heat transfer increased for decreasing the span wise angle up to 58% and 25% respectively.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2002년도 하계종합학술대회 논문집(3)
• /
• pp.17-20
• /
• 2002

This paper proposes a new 75 fuzzy model approximation method which reduces error in nonlinear fuzzy model approximation over the V-type decision rules. Employing rational Bezier curves used in computer graphics to represent curves or surfaces, the proposed method approximates the decision rule by constructing a tractable linear equation in the highly non-linear fuzzy rule interval. This algorithm is applied to the self-adjusting air cushion for spinal cord injury patients to automatically distribute the patient's weight evenly and balanced to prevent decubitus. The simulation results indicate that the performance of the proposed method is bettor than that of the conventional TS Fuzzy model in terms of error and stability.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 1997년도 가을 학술발표회 논문집
• /
• pp.117-124
• /
• 1997

In this study, mechanical properties of type V cement concrete with different curing temperature were investigated. The tests for mechancial properties, i.e., compressive strength and modulus of elasticity, were carried out on two kinds of type V cement concrete mixes. concrete cylinders cured at 10, 23, 35 and 50℃ were tested at 1, 3, 7 and 8 days. The 'rate constant model' was used to described the combined effects of time and temperature on compressive strength development. Test results show that concrete subjected to high temperature at early age attains greater strength than concrete to low temperature but eventually attains lower later-age strength than that. With type V cement concrete, the linear and Arrhenius rate constant models both accurately describe the development of relative strength as afunction of the equivalent age.

• E2M - 전기 전자와 첨단 소재
• /
• 제10권10호
• /
• pp.1022-1028
• /
• 1997

In this paper we present the construction details and output characteristics of a diaphragm-type pressure sensor with Cu-Ni(53:47) thin-film strain gauges. In order to improve the sensitivity and the temperature compensation two circumferential gauges are placed near the center of the diaphragm and two radial gauges are located near the edge. For all the gauges the relative change in resistance ΔR/R with pressure is of the order 10$^{-3}$ for the maximum pressure. The output is found to be linear over the entire pressure range(0-30kfg/cm$^2$)and the output sensitivity obtained is 1.6mV/V. The maximum nonlinearity observed in output characteristics is 0.35%FS for 5V excitation and the hysteresis is less than 0.1%FS.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2001년도 하계학술대회 논문집 A
• /
• pp.479-481
• /
• 2001

Traditionally, instrument transformer of the ferromagnetic core type have been used for measuring current in GIS(Gas Insulated Switchgear). Recently, with the introduction of digital technology at the protection relay or measurement device level, the use of new current sensor can be foreseen. Current measurement by means of Rogowski coil is just one illustration of this. This paper describes the progress of development of Rogowski-coil type CT for application in 170kV GIS.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2008년도 하계학술대회 논문집 Vol.9
• /
• pp.481-482
• /
• 2008

We have designed a Marx Generator, named EMD Pulse Generator(EPG), which makes steep front high voltage, 50ns rise time and 200kV high. It was designed as coaxial type and in small size, 70cm high and 20cm in diameter. The firing system is trigatron type and the spark gap switches in each stage are coaxial with the axis of the system. In this paper we mention about the characteristics of EPG and several experimental data.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2000년도 추계학술대회 논문집
• /
• pp.287-290
• /
• 2000

We give pressure stimulation into organic thin films and then manufacture a device under the accumulation condition that the state surface pressure is 20[mN/m]. LB layers of Arac. acid deposited by LB method were deposited onto y-type silicon wafer as x, y, z-type film. In processing of a device manufacture, we can see the process is good from the change of a surface pressure for organic thin films and transfer ratio of area per molecule. The structure of manufactured device is Au/arachidic acid/Al, the number of accumulated layers. Also, we then examined of the MIM device by means of I-V. The I-V characteristic of the device is measured from 0 to +2[V].

• 대한수학회보
• /
• 제59권5호
• /
• pp.1255-1268
• /
• 2022

We consider the Schrödinger type operator 𝓛 = (-𝚫_ℍⁿ)² + V² on the Heisenberg group ℍⁿ, where 𝚫_ℍⁿ is the sub-Laplacian and the non-negative potential V belongs to the reverse Hölder class RH_s for s ≥ Q/2 and Q ≥ 6. We shall establish the (L^p, L^q) estimates for the Riesz transforms T_𝛼,𝛽,j = V^2𝛼𝛁^j_ℍⁿ𝓛^-𝛽, j = 0, 1, 2, 3, where 𝛁_ℍⁿ is the gradient operator on ℍⁿ, 0 < α ≤ 1-j/4, j/4 < 𝛽 ≤ 1, and 𝛽 - 𝛼 ≥ j/4.