• 터널과지하공간
• /
• 제1권2호
• /
• pp.158-167
• /
• 1991

• 터널과지하공간
• /
• 제4권2호
• /
• pp.156-169
• /
• 1994

• 한국터널지하공간학회 논문집
• /
• 제21권3호
• /
• pp.363-375
• /
• 2019

복층터널은 도심지에서 대심도로 시공되는 특성이 있으므로 복층터널용 수직구는 급기 및 배기구, 대피통로 계단, 엘리베이터, 배전시설, 접속터널 등의 설치공간의 확보가 필요하다. 또한 복층터널용 수직구는 도심지에 시공되는 특성상 공사영향 최소화를 위하여 터널굴착 완료 후 수직구 내부 콘크리트 구조물의 급속시공이 필요하다. 따라서 수직구 내부 슬래브 및 계단용 콘크리트 시공의 프리캐스트화가 필요하며 이러한 수직구 내부 프리캐스트 구조물 지지를 위한 브래킷의 급속시공기술이 필요하다. 브래킷 형태 사례조사 결과 현장타설 방식, 프리캐스트 방식, 철재브래킷 방식 등이 있는데 본 연구에서는 시공속도 향상을 고려하여 경제성이 양호하고 시공성이 우수한 철재브래킷을 개선한 새로운 브래킷에 대하여, 직선형 매립 앵커볼트와 꺾임형 매립 앵커볼트에 대한 구조성능시험결과 소요하중 지지능력을 확보하는 것을 확인하였고 꺾임형 매립 앵커볼트의 하중지지능력이 보다 큰 것을 확인하였다.

• 한국지반공학회논문집
• /
• 제28권2호
• /
• pp.23-31
• /
• 2012

본 연구에서는 사질토 지반에 설치한 원형수직터널에서 아칭효과를 고려한 토압의 거동 특성을 분석하기 위해 실제의 응력상태를 재현할 수 있는 원심모형실험(centrifuge model test)을 수행하였다. 이를 위해 직경 6.0m, 높이 15.0m의 원형수직터널을 대상으로 축소모형 실험체를 제작하였으며, 중력장 75G를 가속하여 2회 반복실험을 수행하였다. 더불어, 지반굴착에 따른 토압의 거동특성과 크기를 분석하기 위하여 모형 수직터널 벽체를 2단으로 분리하여 굴착효과를 모사하였으며, 그 결과를 선행연구에서 제안한 이론토압식과 비교하였다. 실험결과, 원형수직터널에 작용하는 토압은 기존의 2차원(Ko) 토압에 비해 약 70% 가까이 전토압이 저감되는 효과가 관찰되었으며, 이는 3차원 아칭효과에 의해 토압이 경감된 것으로 판단된다.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2001년도 춘계학술대회논문집E
• /
• pp.341-348
• /
• 2001

The purpose of present study is to investigate for reducing pressure fluctuations in the case of installing the air-shafts on the side wall of the tunnel with small cross-sectional area on conventional line. Experiments were performed with a 1/61-scale moving model rig for the tunnel of 0.764 km length in the condition of tunnel cross-section area of $28 m^2$. According to the results, the maximum pressure fluctuation is reduced by 45 % for 19 air-shafts. This results have the speed-up effects of about 33.4 km/h for the train running in tunnel.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2001년도 추계학술대회논문집B
• /
• pp.578-584
• /
• 2001

Purpose of the present study is to investigate the aerodynamic performances of air-shafts with different inner diameters in a single track tunnel for reducing pressure fluctuations and micro pressure waves. Three configurations of air-shafts with different inner diameters were examined for comparison of aerodynamic performances. Experiments were performed with a 1/61-scale moving model rig for the tunnel of 0.764 km length and the train of 4 cars per 1 unit. The results showed the reduction effect of the maximum pressure fluctuations in tunnel and micro-pressure waves radiating towards the surroundings from the tunnel exit according to the increase of the diameter of 10 air-shafts spaced equally.

• 한국안전학회지
• /
• 제33권4호
• /
• pp.119-126
• /
• 2018

In recent years, as flood damage caused by heavy rains increased, the great-depth tunnel using urban underground space is emerging as a countermeasure of urban inundation. The great-depth tunnel is used to reduce urban inundation by using the underground space. The drainage efficiency of great-depth tunnel depends on the intake design, which leads to increase discharge into the underground space. The spiral intake and the tangential intake are commonly used for the inlet facility. The spiral intake creates a vortex flow along the drop shaft and reduces an energy of the flow by the wall friction. In the tangential intake, flow simply falls down into the drop shaft, and the design is simple to construct compared to the spiral intake. In the case of the spiral intake, the water level at the drop shaft entrance is risen due to the chocking induced by the flowrate increase. The drainage efficiency of the tangential intake decreases because the flow is not sufficiently accelerated under low flow conditions. Therefore, to compensate disadvantages of the previously suggested intake design, the multi-stage intake was developed which can stably withdraw water even under a low flow rate below the design flow rate. The hydraulic characteristics in the multi-stage intake were analyzed by changing the flow rate to compare the drainage performance according to the intake design. From the measurements, the drainage efficiency was improved in both the low and high flow rate conditions when the multi-stage inlet was employed.

• Geomechanics and Engineering
• /
• 제35권6호
• /
• pp.603-615
• /
• 2023

Population growth and urbanization prompted engineers to propose more sophisticated and efficient transportation methods, such as underground transit systems. However, due to limited urban space, it is necessary to construct these tunnels in close proximity to existing infrastructure like high-rise buildings and bridges. Battered piles have been widely used for their higher stiffness and bearing capacity compared to vertical piles, making them effective in resisting lateral loads from winds, soil pressures, and impacts. Considerable prior research has been concerned with understanding the vertical pile response to tunnel excavation. However, the three-dimensional effects of tunnelling on adjacent battered piled foundations are still not investigated. This study investigates the response of a single battered pile to tunnelling at three critical depths along the pile: near the pile shaft (S), next to the pile (T), and below the pile toe (B). An advanced hypoplastic model capable of capturing small strain stiffness is used to simulate clay behaviour. The computed results reveal that settlement and load transfer mechanisms along the battered pile, resulting from tunnelling, depend significantly on the tunnel's location relative the length of the pile. The largest settlement of the battered pile occurs in the case of T. Conversely, the greatest pile head deflection is caused by tunnelling near the pile shaft. The battered pile experiences "dragload" due to negative skin friction mobilization resulting from tunnel excavation in the case of S. The battered pile is susceptible to induced bending moments when tunnelling occurs near the pile shaft S whereas the magnitude of induced bending moment is minimal in the case of B.

• 한국화재소방학회논문지
• /
• 제18권2호
• /
• pp.49-56
• /
• 2004

지하철은 다른 구조물과 비교하여 화재발생 시 화재진압 및 인명구조에 본질적으로 취약한 구조적 특성을 내포하고 있다. 국내의 경우, 지하철 승강장 제연설비는 전용설비로 구축되어 있지 않고 화재발생 시 승강장환기설비 및 본선터널부의 환기설비를 제연모드로 절환하여 운영되고 있다. 제연효과는 이러한 까닭으로 환기설비의 위치, 용량 및 급배기방식에 종속된다. 본 연구에서는 지하철 승강장에서 열차 화재 발생 시, 승객의 안전한 대피로 확보가 가능한 선로부 환기기의 제연운전 효과의 실효성에 대한 검증을 목표로 한다. 따라서 지하승강장을 대상으로 승강장 내 기류해석 및 3차원 화재시뮬레이션을 수행하여 열차화재에 따른 승강장내 열 및 물질이동특성해석으로부터 선로부 배연운전모드에 따른 특성을 규명함으로서 승객안전성 확보에 목표를 둔다.

• Geomechanics and Engineering
• /
• 제11권3호
• /
• pp.421-438
• /
• 2016

Explosions inside transportation tunnels might result in failure of tunnel structures. This study investigated the failure mechanisms of circular cast-iron tunnels in saturated soil subjected to medium internal blast loading. This issue is crucial to tunnel safety as many transportation tunnels run through saturated soils. At the same time blast loading on saturated soils may induce residual excess pore pressure, which may result in soil liquefaction. A series of numerical simulations were carried out using Finite Element program LS-DYNA. The effect of soil liquefaction was simulated by the Federal Highway soil model. It was found that the failure modes of tunnel lining were differed with different levels of blast loading. The damage and failure of the tunnel lining was progressive in nature and they occurred mainly during lining vibration when the main event of blast loading was over. Soil liquefaction may lead to more severe failure of tunnel lining. Soil deformation and soil liquefaction were determined by the coupling effects of lining damage, lining vibration, and blast loading. The damage of tunnel lining was a result of internal blast loading as well as dynamic interaction between tunnel lining and saturated soil, and stress concentration induced by a ventilation shaft connected to the tunnel might result in more severe lining damage.