• Proceedings of the KIEE Conference
• /
• 2005.11b
• /
• pp.350-352
• /
• 2005

Recently, electrical demands increase rapidly in metropolitan areas according to the extension of urban areas. Therefore underground transmission lines are getting expanded. This paper presents the rapid and accurate algorithm for fault discrimination and fault location in underground transmission lines. This paper uses fuzzy logic method using voltage and zero sequence for fault discrimination. And this paper uses travelling wave and wavelet transform for fault location. To prove the performance of the algorithm, it test algorithm with signal obtained from ATPDraw simulation.

• Proceedings of the KIEE Conference
• /
• 2002.07a
• /
• pp.145-147
• /
• 2002

In this paper, the improved fault locating method using distributed parameter which calculating the reduced voltage and current according to the ground capacitance in long transmission line was proposed. For the purpose of the fault locating algorithm non influenced source impedance, the loop method was used in the system modeling analysis. To enhance the fault locating, zero sequence of the fault current which is variable according to ground capacitance was not used but positive and negative sequence. System model was simulated using EMTP software. To verify the accuracy of proposed method, in different cases 64 sampled data per cycle was used and 160km and 300km long transmission line has fault resistance $0{\Omega}\;and\;100{\Omega}$ respectively was compared.

• The Transactions of the Korean Institute of Electrical Engineers A
• /
• v.51 no.10
• /
• pp.525-533
• /
• 2002

It is common to install multiple lines in the same route. Recently, excessive sheath circulating current was partially measured in underground cable systems of KEPCO. Especially, the installation type, unbalance section length between joint boxes and zero sequence current by distribution cable have an effect on the rising of sheath circulating current in the underground transmission system. If excessive current flows in sheath, sheath loss which is reduced the transmission capacity is produced. This paper describes the relation analysis of sheath circulating current and burying types. And also, a detailed analysis on rising cause and characteristic of sheath circulating current by considering various unbalanced conditions presents using analysis and measurement regarding cable systems which have the problem of excessive sheath circulation current.

• Proceedings of the KIEE Conference
• /
• 2001.07a
• /
• pp.336-339
• /
• 2001

Transmission line data are very important for studying loadflow. Short circuit data(positive sequence, zero sequence) of 345kV and 154kV line were calulated and compared with KEPCO's line characteristics data. This Paper presents method of verification and complement of line data in PSS/E loadflow data using TMLC (Transmission Line Characteritics) program.

• Proceedings of the KIEE Conference
• /
• 1994.07a
• /
• pp.91-93
• /
• 1994

Recently, for improving the power supply reliability and for rationslizing maintenance, new maintenance and monitoring systems are stornagly desired for use in the field of electric power transmission. In this paper, we describes the optical fault detecting method of underground power transmission lines using bareearth doped YIG Faraday sensors which are very light, small size and fast response. As regarding, we use the zero phase current detecting algorithm at insulated joints.

• Journal of electromagnetic engineering and science
• /
• v.13 no.4
• /
• pp.263-266
• /
• 2013

A novel compact and low-loss VHF bandpass filter is presented with enhanced stopband performance using metamaterial zeroth order resonator (ZOR) characteristics. An in-line ZOR filter is initially suggested and changed to have transmission zeros (TZs) due to source-load coupling for effective improvement of the isolation from UHF wireless channels. The proposed filter is smaller than 1/10 of the conventional filters in terms of size and has relatively very low insertion loss (< 1 dB for the electromagnetic (EM) simulation and < 3 dB for the measurement) and return loss (<-20 dB) in the passband due to the approximately 80% size reduction and the higher isolation in the stopband due to the TZs. The circuit and EM simulation are in good agreement with the measurements.

• Proceedings of the KIEE Conference
• /
• 2003.07a
• /
• pp.46-49
• /
• 2003

This paper proposes a method to solve expansion problem for a transmission network, given future generation and load strategy, and alternative types of lines available, subject to load, reliability and right of way constraints, the problem is formulated as a series of zero one integer programs which are solved by an efficient branch and bound algorithm A study test result on the 63-buses test system shows that the proposed method is practical and efficiently applicable to the transmission expansion planning.

• The Transactions of the Korean Institute of Electrical Engineers A
• /
• v.50 no.9
• /
• pp.417-423
• /
• 2001

This paper proposes a technique for fault detection and classification for both LIF(Low Impedance Fault)s and HIF(High Impedance Fault)s using Adaptive Network-based Fuzzy Inference System(ANFIS). The inputs into ANFIS are current signals only based on Root-Mean-Square(RMS) values of 3-phase currents and zero sequence current. The performance of the proposed technique is tested on a typical 154 kV Korean transmission line system under various fault conditions. Test results show that the ANFIS can detect and classily faults including (LIFs and HIFs) accurately within half a cycle.

• Proceedings of the KIEE Conference
• /
• 2005.07c
• /
• pp.2383-2385
• /
• 2005

In this paper we discuss the design and fabrication of two millimeter wave filters, in bandpass and bandstop topologies for wireless communications applications. The filters are made using a high Q MMIC transmission line, which consists of a 100 micrometers tall, surface micromachined, air filled inverted microstrip structure on a quartz substrate, made by using a JSR THB-151N negative photoresist sacrificial layer mold and electroplating technology. The filter topologies include a new, very compact, four pole, cross-coupled filter, that presents a single transmission zero at the lower side of the passband, which provides a very sharp out of passband rejection at this region.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.21 no.9
• /
• pp.2328-2340
• /
• 1996

Until now, the transmission of data for VOD(Video on Demenad) was based on a real time modelling of video data. Markow Modulated Fluid Sources(MMFS) and Markow Modulated Poisson Sources(MMPS) are the most widely used modelling methods. But the charactersitics of the VBR(Variable Bit Rate) signal prevents modelling from actually being "real-time". Also these methods call for the use of large buffers for the abolishment of cell loss. These modelling methods are, of course, useful i case of teleconferences where a real time modelling of video traffic is inevitable, but they are insufficient in cases where the characteristic infomation of video traffic can be obtained beforehand-cases such as VOD. Video data is speial in that if one file is preprocessed all other products can simply be copied from that onepreprocessed file. This characteristic helps reduce the overhead arising from the job of drawing out characteristic information to almost zero. But still, compared to the existing real time modelling method data transmission using characteristic information succeeds in raising the efficiency of data transmission. In tis paper we will outline a method of dta transmission which use the characteristic information of each video stream, and evaluate this method through some experiments.periments.