• Journal of the Korean Society for Railway
• /
• v.7 no.4
• /
• pp.412-417
• /
• 2004

In urban rail transit systems, ground faults in the DC traction power supply system are currently detected by the potential relay, 64P. Though it detects the fault it cannot identify the faulted region and therefore the faulted region could not be isolated properly. Therefore it could cause a power loss of the trains running on the healthy regions and the safety of the passengers in the trains could be affected adversely. Two new ground fault protective relay schemes that can identify the faulted region are presented in this paper. A current limiting device, called Device X, is newly introduced in both system, which enables large amount of ground fault current flow upon the positive line to ground fault. One type of the relaying schemes is called directional and differential ground fault protective relay which uses the current differential scheme in detecting the fault and uses the permissive signal from neighboring substation to identify the faulted region correctly. The other is called ground over current protective relay. It is similar to the ordinary over current relay but it measures the ground current at the device X not at the power feeding line, and it compares the current variation value to the ground current in Device X to identify the correct faulted line. Though both type of the relays have pros and cons and can identify the faulted region correctly, the ground over current protective relaying scheme has more advantages than the other.

• Journal of Environmental Health Sciences
• /
• v.35 no.6
• /
• pp.454-460
• /
• 2009

The subway is the major public transportation system in Seoul with 2.2 million people using it everyday. Indoor air pollution in the subway can be a significant part of population exposure because of the number of people using the subway, time spent in transit and potentially high exposure for certain pollutants. The Korea Ministry of Environment has established the level 2 of recommended standards of $PM_{10}$ and $CO_2$ in subway trains. The aims of this study were to determine the airborne levels of $PM_{10}$, $CO_2$ and any correlation between pollutant levels and number of passenger in a subway train. The airborne $PM_{10}$ and $CO_2$ were measured on the inside of trains on line #4 for 4 different days from October to November in 2008. Average $PM_{10}$ and $CO_2$ levels were $113{\pm}25{\mu}g/m^3$ and $1402{\pm}442$ ppm, respectively. These levels did not exceed the level 2 of recommended standards of $250{\mu}g/m^3$ for $PM_{10}$ and 3500 ppm for $CO_2$. $PM_{10}$ level was not correlated with the number of passengers, while $CO_2$ levels were positively correlated with the number of passengers. The findings suggested that $PM_{10}$ in subway trains may have sources other than those directly associated with the number of passengers.

• Journal of the Korean Society for Railway
• /
• v.16 no.2
• /
• pp.144-150
• /
• 2013

This paper presents an analysis of door design for the Ui LRT based on experiments to predict doorway flow-time and their analyses results. A similar railway vehicle (from Gimhae LRT) and operational conditions are utilized to assess the doorway flow-time through repetitive experiments. Design of the experiments consists of four scenarios, and the experiments are repeated 39 times in total. We use the results of the experiments to verify the design of doors of Ui LRT (e.g. the required number of doors and their width). Various statistical analyses are carried out for the flow-time with respect to the number of boarding/alighting passengers. We make three category levels of boarding/alighting passengers, and analyze the mean and variance for each category, and then carry out One-Way ANOVA to analyze how the number of boarding/alighting and onboard passengers impact flow-time. The results of this paper can be used for making decisions about doors of the LRT vehicle.

• Convergence Security Journal
• /
• v.20 no.4
• /
• pp.217-225
• /
• 2020

In recent years, the "social distance" has drastically reduced overseas travelers. On the other hand, for personal safety and security, it is expected that interest and demand for CCTV, electric alarm and signaling devices, electric diagnostics and medical devices will increase significantly. The purpose of this paper is to find out the effect of airport transfer passengers and exports of CCTV, electrical diagnostics and medical devices, electrical alarms and signaling devices on exports to Korea, and the synchronism of each variable. To this end, this study used a total of 231 monthly data from January 2000 to April 2020 in the National Statistics Service. As a result of empirical analysis, CCTV and electrical diagnostics and medical devices showed relatively high synchronization with respect to exports to Korea. Electric alarms & signaling devices and transit passengers also showed a certain level of synchronization with exports, but were relatively weak.

• Journal of Korean Society of Transportation
• /
• v.25 no.3
• /
• pp.137-144
• /
• 2007

This study involves an analytical approach to determine transit dispatching schedules (headways) Determining a time schedule is an important process in transit system planning. In general, the transit headway should be shorter during the peak hour than at non-peak hours for demand-responsive service. It allows passengers to minimize their waiting time under inelastic, fixed demand conditions. The transit headway should be longer as operating costs increase, and shorter as demand and waiting time increase. Optimal headway depends on the amount of ridership. and each individual vehicle dispatching time depends on the distribution of the ridership. This study provides a theoretical foundation for the dispatching scheme consistent with common sense. Previous research suggested a dispatching scheme with even headway. However, according to this research, that is valid for a specific case when the demand pattern is uniform. This study is a general analysis expanding that previous research. This study suggests an easy method to set a time table without a complex and difficult calculation. Further. if the time axis is changed to the space axis instead, this study could be expanded to address the spacing problems of some facilities such as roads. stations, routes and others.

• Journal of Korean Society of Transportation
• /
• v.30 no.1
• /
• pp.125-133
• /
• 2012

This paper deals with the passenger transfer trips counted from smart bus-card data from Seoul transit network to understand the current operational condition of the system. Objective of this study is to relocate the location of the transit transfer centers. It delivers a bi-level programing model. The upper model is a linear 0-1 binary integer program having the objective of total travel cost minimization constrained by the number of transfer centers and the total construction budget. The lower model is an user equilibrium assignment model determining the passengers' route choice according to the transfer center locations. The proposed bi-level programming model was tested in an example network. The result showed that the proposed was able to find the optimal solution.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.11 no.6
• /
• pp.255-260
• /
• 2011

The security issue in urban transit system has been widely considered as the common matters. The safe urban transit system is highly demanded because of the vast number of daily passengers, and providing safety is one of the most challenging projects. We introduced a test model for integrated security system for urban transit system and built it at a subway station to demonstrate its performance. This system consists of cameras, sensor network and central monitoring software. We described the smart camera functionality in more detail. The proposed smart camera includes the moving objects recognition module, video analytics, video encoder and server module that transmits video and audio information. We demonstrated the system's excellent performance.

• The Korean Journal of Applied Statistics
• /
• v.26 no.4
• /
• pp.623-634
• /
• 2013

In this study, we provide empirical evidence of whether a spatial correlation among mode choices at the TAZ(Traffic Analysis Zone) level exists based on transit smart card data observed in Seoul, Korea. The results show that the areas with a higher probability that passengers choose to take a bus are clustered and that those regions have fewer metro stations than bus stations. We also found that the spatial correlation turned out to be statistically meaningful and provided an opportunity for the potential use of the spatial correlation in modeling mode choices. A reliable spatial interaction would constitute valuable information for transportation agencies in terms of their route planning and scheduling based on the transit smart card data.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.19 no.5
• /
• pp.82-96
• /
• 2020

The Demand Responsive Transit (DRT) system is the flexible public transport service that determines the route and schedule of the service vehicles according to users' requests. With increasing importance of public transport systems in urban areas, the development of stable and fast routing algorithms for DRT has become the goal of many researches over the past decades. In this study, a new heuristic method is proposed to generate fast and efficient routes for multiple vehicles using demand clustering and destination demand priority searching method considering the imbalance of users' origin and destination demands. The proposed algorithm is tested in various demand distribution scenarios including random, concentration and directed cases. The result shows that the proposed method reduce the drop of service ratio due to an increase in demand density and save computation time compared to other algorithms. In addition, compared to other clustering-based algorithms, the walking cost of the passengers is significantly reduced, but the detour time and in-vehicle travel time of the passenger is increased due to the detour burden.

• Journal of Korean Society of Transportation
• /
• v.23 no.2
• /
• pp.151-160
• /
• 2005

In case of public transit such as bus system, the probability concept is used to evaluate the Level-of-Service of the operations. And each levels could be classified according to the linear probability value. (TCQSM: Transit Capacity and Quality of Service Manual-2nd Edition, TRB, Washington DC., 2003) In this case, the drivers or passengers wouldn't think that the service level isn't equivalent to the linear probability value. Thus the linear probability value doesn't exactly reflect the service level. This study shows the problems of using the linear probability value in classifying the service level through the case of evaluation of bus operation's punctuality, presented in TCQSM. To make up for the problems of such case, two methodologies are presented in this study. The method of determining Level-of-Service criteria using probability density of headway variation's distribution, presented in this paper, adequately reflects passenger's expected waiting time. According to the application result to real bus operation data, it tis better than the method of TCQSM to evaluate the reliability of bus operations. However further research about the relations between utility difference and passenger feeling of service level in necessary to apply the method that uses the utility function. It remains as the limitation of this paper.