• International Journal of Highway Engineering
• /
• v.15 no.3
• /
• pp.31-36
• /
• 2013

PURPOSES: This study is to investigate a generated traffic noise when vehicle pass over a transverse rumble strip at toll plaza of highway. METHODS: To investigate traffic noise at toll plaza of highway, Pass-by method which is the most common used for measuring traffic noise was adopted and the traffic noise at toll plaza was measured for 10 min per hour for 11hours(13:00~24:00). RESULTS: The measured traffic noise by pass-by method was changed as function of the transverse rumble strip configuration. Generally, the maximum difference among three noise measurement sections was 7 dB(A). It might be related with traffic speed. Also, the measured traffic noise was strongly generated from a passenger car which was 2 axle. It means that the most of traffic noise on the road is generated at tire/pavement interface of the passenger car. CONCLUSIONS: The traffic noise was strongly related with vehicle speed and transverse rumble strip configuration on the road. For driver safety, the transverse rumble strip is definitely necessary. However, the complaints from residents near highway was increased by traffic noise from transverse rumble strip. Therefore, To satisfy both safety and reduction of traffic noise, the development of configuration of transverse rumble strip is necessary in the further study.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.4 no.3 s.8
• /
• pp.23-31
• /
• 2005

It is essential that is the collection of more accurate data to provide reliable traffic information. Currently collection of traffic information which uses the taxi or the passenger car by the probe vehicle is low reliability. If it develops the model which estimates car travel-time by using bus travel-time, it means that the sheep or duality of information using the passenger car and the taxi by the probe vehicle than will improve. Consequently the research which develops to each situation in accordance withtraffic volume and bus whole aspect car execution yes or no and bus stand form.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.26 no.6_spc
• /
• pp.729-735
• /
• 2016

According to the survey for working environment of the cashiers in highway tollbooths, workers replied that noise was the most harmful substances next to air pollutant in the tollbooth. Researches on the noise levels exposed to cashiers in the highway tollbooth scarcely have been performed. Therefore, the aim of this study was to acquire baseline data to prevent health impairments of the cashiers by evaluating noise level exposed to them. Noise dosimeters were used for monitoring workers' noise exposure level in the tollbooths at 8 different highway tollgates. The noise levels of tollbooths did not exceed noise exposure limit of the ministry of labor, 90 dB(A). The average TWA inside of the tollbooths was 55.4 dB(A) and the average TWA outside of tollbooths was 58.3 dB(A). The average TWA outside of tollbooths was slightly higher than that of inside of tollbooths. However, the significance probability(p-value) was 0.255 which means statistically not significant. The noise levels inside and outside of tollbooth were statistically significant to both mean traffic volume per day and traffic volume of passenger car.

• Journal of Environmental Science International
• /
• v.21 no.9
• /
• pp.1149-1162
• /
• 2012

The impact of a considerable increase in traffic volume on the emission and concentrations of air pollutants was investigated at three beaches (Haeundae (HB), Gwanganri (GB), and Songjeong (SB)) in Busan during beach opening period (BOP) in 2011. During the BOP, passenger car was the major vehicle type, followed by taxi, and van. CO was the major contributor of total air pollutant emissions followed by NOx, VOC, and $PM_{10}$. For the temporal variation of the emission of air pollutants during the BOP, it was generally the highest in the afternoon followed by the evening and morning, except for SB. For the spatial variation of their emission, it was the highest at GB followed by SB and HB. The emissions of air pollutants during the BOP were generally higher than those during the Non-BOP, except for HB. In contrast, the significant impact of the traffic volume increase on the concentrations of air pollutants at monitoring sites near the three beaches during the BOP were not found compared to the Non-BOP due to the significant distances between monitoring sites of air pollutants and monitoring sites of traffic volume at the beaches.

• Journal of Environmental Health Sciences
• /
• v.25 no.3
• /
• pp.51-57
• /
• 1999

This study was carried out to investigate the concentrations of Ni, Cr and Cu, to analyze the correlations among those, and between concentrations and traffic volumes by type of car in roadside ambient air at Chongro-, Chungkechon- and Kangnam terminal- area in Seoul from October 1st to October 31st in 1997. The results were as follows ; 1. The means of concentrations of Ni in roadside ambient air were 34.1, 25.1 and 23.6 ng/m$^3$ at Chungkechon, Kangnam terminal and Chongro area, respectively. The highest concentrations of Ni by time were 26.8 in the evening, 45.5 in the evening and 49.4 ng/m$^3$ in the forenoon at Chongro, Chungkechon and Kangnam terminal area, respectively. 2. The means of concentrations of Cr in road side ambient air were 97.7, 80.1 and 70.9 ng/m$^3$ at Chong, Chungkechon and Kangnam terminal area, respectively. The highest concentrations of Cu by time were 205.3 in the evening, 114.4 in the evening and 92.3 ng/m$^3$ in the forenoon at Chongro, Chungkechon and Kangnam terminal area, respectively. 4. The tendencies of concentrations of Ni and Cr by time were similar to each other. Especially, at Kangnam terminal area, correlation coefficients between concentrations of Ni and Cr and the traffic volume of bus were high(r=0.997,0.975). 5. The tendency of concentration of Cu and the traffic volume of passenger car at each area were high(r=0.832, 0.968) 6. Correlation coefficients between Cu and Zn, and between Ni and Cr were 0.762 and 0.842, respectively. This means that the possibility of co-existence of Cu-Zn or Ni-Cr is very high.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.11 no.2
• /
• pp.57-66
• /
• 2012

This study intended to evaluate the operational performance change from the introduction of the bus signal priority system using the field data. To complete the objective, travel time and volume data were collected from the before and after study, then the distribution of individual vehicle's travel time and the difference of travel time and traffic volume were compared respectively. Analysis results showed that no significant volume change was observed from both passenger vehicle and bus for the major and cross streets. It was identified that the quality of travel time distributions of passenger vehicle and bus was improved after introducing the bus signal priority system. In terms of average speed, passenger car in a major direction increased by 6.5% and bus increased by 10.5% in general. Statistical tests showed that those speed differences were statistically significant at the 95% of confidence level. The results of this paper will be a good source for further research in the area of bus signal priority control.

• The Journal of the Acoustical Society of Korea
• /
• v.27 no.8
• /
• pp.403-410
• /
• 2008

The noise problem became more serious by the rapid urban population growth and traffic. This study estimates the noise level considering actual traffic volume and building shape and location. Based on the state of the arts noise level, changing amount of noise that was controlled by the speed control and truck and passenger car restriction is calculated. Some conclusion is found out. The 2-D type more than 3-D type is more than over standard of noise pollution and night time's over rate is larger than day time. And in the case of various solutions are used instead of applying one solution, noise pollution is effectively reduced.

• International Journal of Highway Engineering
• /
• v.15 no.5
• /
• pp.135-144
• /
• 2013

PURPOSES : The purpose of this paper is to develop a methodology to estimate level of service of arterial including Exclusive Median Bus Lanes. METHODS : On 6 Exclusive Median Bus Lanes routes in Seoul, bus travel time and number of bus-stop per km were investigated. Also whether or not passing lane exists at bus-stop was checked. Based on the data from sites, bus travel time was estimated according to length of segment, number of bus-stop per km and whether or not passing lane exists at bus-stop. RESULTS : A bus travel time table was developed according to length of segment, number of bus-stop per km and whether or not passing lane exists at bus-stop. After bus travel speed and passenger car travel speed is estimated based on each travel time table and length of segment, two speeds are combined with weighted average speed using traffic volume of each lane group. Then weighted average speed is a measure of effectiveness of arterial including Exclusive Median Bus Lanes. CONCLUSIONS : It can be concluded that the proposed methodology can estimate level of service of arterial including Exclusive Median Bus Lanes considering the operation characteristics of Exclusive Median Bus Lanes.

• International Journal of Highway Engineering
• /
• v.13 no.3
• /
• pp.195-202
• /
• 2011

The purpose of this study is to estimate the capacity of two-lane freeway work zone blocking one lane using traffic flow models of each vehicle-type. Firstly, three traffic flow models of three different vehicle-types were developed using the data collected from each at the beginning and the ending point of the work zone. For each model, the maximum flow rate of three vehicle-types were calculated respectively. Maximum flow rate at the work zone was recalculated using passenger car equivalent value and percentage of vehicle-type. Secondly, traffic flow model using passenger car equivalent volume data was developed using the data collected from each at the beginning and the ending point of the work zone. Maximum flow rate for the work zone was calculated along. Two values of maximum flow rates through the work zone were compared and evaluated as the capacity of the work zone. This study found that the maximum flow rate of the work zone at the beginning point was less than that at the ending point because of impedance such as lane changing behaviors before entering the work zone. The capacity of two-lane freeway work zone blocking one lane was estimated 1,800pcphpl.

• International Journal of Highway Engineering
• /
• v.15 no.2
• /
• pp.159-167
• /
• 2013

PURPOSES : In this study, the effects of when median exclusive bus lanes were applied to Daejeon trunk road (Wolpyeng crossway~Seodaejeon crossway, 6.3km) and (Daeduck Bridge 4~Kyeryong 4, 2.6km) by Microscopic Simulation VISSIM (5.0) was studied. The median exclusive bus lanes are one of the measures of transportation system manage techniques that can especially improve the efficiency of public transportation facilities. METHODS : According to the analysis of VISSIM on the Gyerong mainroad and Daedeok mainroad, when the median exclusive bus lanes were applied unlike when the roadside bus-only lanes were applied, the average travel speed of vehicles decreased but the average delay time and travel time increased. This arised from the changes in the geometric structure of the road which occurred the reduction of vehicle lane in the center of the road. RESULTS : In the case of bus, on the other hand, the average travel speed increased but the average delay time and travel time decreased. This is because the problems such as illegal parking and stopping, secondary road in out vehicle, and conflict of intersection right turn that roadside bus-only lanes occurred was solved. CONCLUSIONS : Although the introduction of median exclusive bus lanes will have a negative effect on general traffic flow due to the aggravation of travel, decrease of passenger car usage will lead to decrease of traffic volume. Therefore, smooth vehicle travel is expected.