• Journal of the Korean Institute of Gas
• /
• v.14 no.6
• /
• pp.44-50
• /
• 2010

Vibration responses of a centrifugal pump required dynamic analysis for seismic qualification, were calculated by using spectrum analysis, which is known to be very simple compared with time domain analysis. Modal analysis was performed and the results were utilized in the spectrum analysis. The vibration responses calculated from the spectrum analysis were more conservative than those from the time domain analysis, that is, the former can be used as safer in design process. The pump was qualified for the specified seismic service conditions as specified in IEEE 344-1987. The maximum stresses were less than allowable stress limits. Based on the analysis results, it is concluded that the pump meets all the dynamic requirements of the applicable codes, standards, and technical specification.

• Journal of the Society of Naval Architects of Korea
• /
• v.31 no.2
• /
• pp.65-77
• /
• 1994

This paper presents a derailed application procedure of the linear quadratic(LQ) theory for a SWATH heave and pitch control. A time domain model of coupled, linear time-invariant second order differential equations is derived from the frequency response model with the frequency dependent added mass and damping approximated as constant values at the heave natural frequency. Wave exciting forces are modeled as a sum of sinusoids. A systematic selection procedure of state and control weighting matrices is presented to obtain good transient behavior and acceptable fin movement. The validity of this controller design process is throughly investigated by simulations both in time domain and frequency domain and singular value plots of transfer function matrices. The finally designed control system shows good overall performances revealing that the applicability of the present study is proved successful.

• Structural Engineering and Mechanics
• /
• v.10 no.1
• /
• pp.17-26
• /
• 2000

This paper presents a case study with a multi-degree-of-freedom (MDOF) system where the Floor Response Spectra (FRS) have been derived from a large ensemble of ground motion accelerograms. The FRS are evaluated by the frequency response function which is calculated numerically. The advantage of this scheme over a repetitive time-history analysis of the entire structure for each accelerogram of the set has been highlighted. The present procedure permits generation of FRS with a specified probability of exceedence.

• Structural Engineering and Mechanics
• /
• v.17 no.3_4
• /
• pp.281-290
• /
• 2004

A review of current procedures being used in engineering practice to analyze the response of structure/foundation systems subjected separately to different types of dynamic excitation, such as earthquake, sea-wave action, wind, or moving wheel loads, is presented. Separate formulations are given for analyzing systems in the time and frequency domains. Both deterministic and stochastic forms of excitation are treated. A distinction is made between demand and capacity analyses.

• 제어로봇시스템학회:학술대회논문집
• /
• 1986.10a
• /
• pp.576-579
• /
• 1986

In this paper, a design method of an optimal output PIM(Proportional-Integral-Measurable) controller is presented so that the closed-loop output response of the switching regulator closely match to that of ideal model system satisfying the time domain specifications. The computer simulation for a design example is given to show the usefulness of the proposed technique.

• Journal of the Korean Society for Precision Engineering
• /
• v.9 no.1
• /
• pp.126-136
• /
• 1992

In this paper, a simple structured feedback compensation scheme for a electro-hydraulic servo system to keep the response characteristics unchanged regardless of the load variation is proposed. In electro-hydraulic servo system, servovalve is most important control element. But the relation between input corrent and output flowrate of the servovalve has properties as follows; firstly, in spite of constant input current, output flowrate decreases as load pressure increases, secondly, according to frequency response of typical servovalve, the characteristics of gain and phase shift is something like 2'nd order system. Load pressure feedback compensation method has been applied to eliminate the first influence, the second influence has been improved by phase lead compensation method. As a result of above compensation methods, regardless of variation load condition, spring and inertia load, the compensation scheme has been verified to be effective within the range of frequency less than 25Hz by static response and dynamic response in time domain and frequency domain through experiments.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.31A no.10
• /
• pp.39-47
• /
• 1994

In this paper, by modeling the Multilayer-Multiconductor Transmission Line(MMTL) with the characteristic parameters-effective dielectric constant, eigen modal voltages, characteristic impedances at each mode, pulse propagation characteristics of MMTL network are simulated. Transmission line modelling is performed in frequency domain, then time domain resposes are obtained by transforming the frequency domain response using fast Fourier transform.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.4B
• /
• pp.379-387
• /
• 2002

In this paper, we present a procedure to obtain the transient scattering response from three-dimensional arbitrarily shaped and closed conducting bodies using time-domain magnetic field integral equation (TD-MFIE) with triangular patch functions. This approach results in accurate and comparably stable transient responses from conducting scatterers. Detailed mathematical steps are included, and several numerical results are presented and compared with results from a time-domain electric field integral equation (TD-EFIE) and the inverse courier transform solution of the frequency domain results.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2002.05a
• /
• pp.259-262
• /
• 2002

This paper provides the experimental verification of a non-destructive time domain approach to examine structural damage. Time histories of the vibration response of structure were used to identify the presence of damage. Damage in a structure cause changes in the physical coefficients of mass density, elastic modulus and damping coefficient. This paper examines the use of beam like structures with PVDF sensor and PZT actuator to perform identification of those physical parameters, and hence to detect the damage. Experimental results are presented from tests on cantilevered composite beams damaged at different location and with damage of different dimensions. It is demonstrated that the method can sense the presence of damage, and characterize the damage to a satisfactory precision.

• Proceedings of the Korea Committee for Ocean Resources and Engineering Conference
• /
• 2000.04a
• /
• pp.18-22
• /
• 2000

This paper is transient motions of a very large floating structure subjected to dynamic load induced by wave. A time domain method is applied to the hydroelasticity problems for this purpose. The method is based on source-dipole and FEM scheme and on Newmark $\beta$ method to pursuit time step process taking advantage of the memory effect. The present method is appied to hydroelastic response analysis in regular waves and impact responses due to dropping aircraft.