• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.43 no.12 s.354
• /
• pp.16-23
• /
• 2006

This paper presents the development of the fast Direction Finder using direct conversion method, which can intercept for short pulse signal of less' than 1 msec. in RF Down Converter, and CVDF(Correlative Vector Direction Finding) algorithm, which estimates DoA (Direction of Arrival). The configuration and characteristics of direction finder using 5-channel equi-spaced circular array antenna are presented and the direct conversion techniques for removing tuning time using I/Q demodulator are described. The CRLB of our model is derived, the principles of 2 kind of CVDF algorithm are explained and their characteristics are compared with CRLB w.r.t the number of samples and spacing ratio. The RF Down Converter prototype using direct conversion method is manufactured, the 2 kind of CVDF algorithm are applied and their performance are analyzed. Finally it is confirmed the LSE based CVDF algorithm is better than correlation-coefficient based except for ambiguity protection capabilities.

• Journal of Biomedical Engineering Research
• /
• v.39 no.6
• /
• pp.243-249
• /
• 2018

The indoor radon concentration was measured in the lecture room of the university and the radon concentration was converted to the amount related to the radon exposure using the dose conversion convention and compared with the reference levels for the radon concentration control. The effect of indoor radon inhalation was evaluated by estimating the life effective dose and the risk of exposure. To measure the radon concentration, measurements were made with a radon meter and a dedicated analysis Capture Ver. 5.5 program in a university lecture room from January to February 2018. The radon concentration measurement was carried out for 5 consecutive hours for 24 hours after keeping the airtight condition for 12 hours before the measurement. Radon exposure risk was calculated using the radon dose and dose conversion factor. Indoor radon concentration, radon exposure risk, and annual effective dose were found within the 95% confidence interval as the minimum and maximum boundary ranges. The radon concentration in the lecture room was $43.1-79.1Bq/m^3$, and the maximum boundary range within the 95% confidence interval was $77.7Bq/m^3$. The annual effective dose was estimated to be 0.20-0.36 mSv/y (mean 0.28 mSv/y). The life-time effective dose was estimated to be 0.66-1.18 mSv (mean $0.93{\pm}0.08mSv$). Life effective doses were estimated to be 0.88-0.99 mSv and radon exposure risk was estimated to be 12.4 out of 10.9 per 100,000. Radon concentration was measured, dose effective dose was evaluated using dose conversion convention, and degree of health hazard by indoor radon exposure was evaluated by predicting radon exposure risk using nominal hazard coefficient. It was concluded that indoor living environment could be applied to other specific exposure situations.

• Transactions of the Korean hydrogen and new energy society
• /
• v.23 no.4
• /
• pp.337-345
• /
• 2012

To check effects of operating variables on reaction characteristics of WGS catalyst for SEWGS process, water gas shift reaction tests were carried out in a pressurized fluidized bed reactor using commercial WGS catalyst and sand(as a substitute for $CO_2$ absorbent) as bed materials. Simulated syngas(mixed with $N_2$) was used as a reactant gas. Operating temperature was $210^{\circ}C$ and operating pressure was 20 bar. WGS catalyst content, steam/CO ratio, gas velocity, and syngas concentration were considered as experimental variables. CO conversion increased as the catalyst content and steam/CO ratio increased. CO conversion at fluidized bed condition was higher than that of fixed bed condition. However, CO conversion were maintained almost same value within the fluidized bed condition. CO conversion decreased as the syngas concentration increased. The optimum operation condition was confirmed and long time water gas shift reaction test up to 24 hours at the optimum operating conditions was carried out.

• Proceedings of the IEEK Conference
• /
• 1998.10a
• /
• pp.735-738
• /
• 1998

To develop an effective virtual prototyping methodology for the PLC(Programmable Logic Controller) based real-time systems, a conversion algorithm from RLL(Relay Ladder Logic) to statechart is presented in this paper. The RLL is the main programming language to represent the operation of the PLC, and the statechart is the most widely used tool in the field of virtual prototyping in order to represent the behaviour of real-time systems. A virtual prototyping for an example case is implemened to evaluate the benefit of the proposed algorithm.

• Journal of IKEEE
• /
• v.22 no.2
• /
• pp.408-412
• /
• 2018

In this paper, a 26GHz variable gain amplifier fabricated using a 40nm CMOS process is studied. In the case of an automobile radar using 79 GHz, it is advantageous in designing and driving to drive down to a low frequency band or to use a low frequency band before up conversion rather than designing and matching the entire circuit to 79 GHz in terms of frequency characteristics. In the case of a Phased Array System that uses time delay through TTD (True Time Delay) in practice, down conversion to a lower frequency is advantageous in realizing a real time delay and reducing errors. For a VGA (Variable Gain Amplifier) operating in the 26GHz frequency band that is 1/3 of the frequency of 79GHz, VDD : 1V, Bias 0.95V, S11 is designed to be <-9.8dB (Mea. High gain mode) and S22 < (Mea. high gain mode), Gain: 2.69dB (Mea. high gain mode), and P1dB: -15 dBm (Mea. high gain mode). In low gain mode, S11 is <-3.3dB (Mea. Low gain mode), S22 <-8.6dB (Mea. low gain mode), Gain: 0dB (Mea. low gain mode), P1dB: -21dBm (Mea. Low gain mode).

• Bulletin of the Korean Chemical Society
• /
• v.32 no.8
• /
• pp.2743-2750
• /
• 2011

Lanthanide(III)-cored complex as a wavelength conversion material has been successfully designed and synthesized for highly efficient dye-sensitized solar cells, for the first time, since light with a short wavelength has not been effectively used for generating electric power owing to the limited absorption of these DSSCs in the UV region. A black dye (BD) was chosen and used as a sensitizer, because BD has a relatively weak light absorption at shorter wavelengths. The overall conversion efficiency of the BD/WCM device was remarkably increased, even with the relatively small amount of WCM added to the device. The enhancement in $V_{oc}$ by WCM, like DCA, could be correlated with the suppression of electron recombination between the injected electrons and $I_3{^-}$ ions. Furthermore, the short-circuit current density was significantly increased by WCM with a strong UV light-harvesting effect. The energy transfer from the Eu(III)-cored complex to the $TiO_2$ film occurred via the dye, so the number of electrons injected into the $TiO_2$ surface increased, i.e., the short-circuit current density was increased. As a result, BD/WCM-sensitized solar cells exhibit superior device performance with the enhanced conversion efficiency by a factor of 1.22 under AM 1.5 sunlight: The photovoltaic performance of the BD/WCM-based DSSC exhibited remarkably high values, $J_{sc}$ of 17.72 mA/$cm^2$, $V_{oc}$ of 720 mV, and a conversion efficiency of 9.28% at 100 mW $cm^{-2}$, compared to a standard DSSC with $J_{sc}$ of 15.53 mA/$cm^2$, $V_{oc}$ of 689 mV, and a conversion efficiency of 7.58% at 100 mW $cm^{-2}$. Therefore, the Eu(III)-cored complex is a promising candidate as a new wavelength conversion coadsorbent for highly efficient dye-sensitized solar cells to improve UV light harvesting through energy transfer processes. The abstract should be a single paragraph which summaries the content of the article.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.21 no.5
• /
• pp.893-898
• /
• 2017

A TDC(Time-to-Digital Converter) of counter-type is designed by $0.18{\mu}mCMOS$process and the supply voltage is 1.5 volts. The converted error of maximum $T_{CK}$ is occurred by the time difference between the start signal and the clock when the period of clock is $T_{CK}$ in the conventional TDC. And the converted error of -$T_{CK}$ is occurred by the time difference between the stop signal and the clock. However in order to compensate the disadvantage of the conventional TDC the clock is generated within the TDC circuit and the clock is synchronized with the start and stop signals. In the designed TDC circuit the conversion error is not occurred by the difference between the start signal and the click and the magnitude of conversion error is reduced (1/2)$T_{CK}$ by the time difference between the stop signal and the clock.

• Cross-Cultural Studies
• /
• v.34
• /
• pp.43-68
• /
• 2014

This writing, focused on by Tarkovsky and by Song, Il-gon, examines moments of sage which is what Eliade described as 'hierophanic time'. These productions, which can be seen as movies that seek after the truth, show important paradoxical ideas and expressions in those moments. This is because symbolic messages from unrealistic and out of ordinary images are specifically shown. If they had to be compared, through the film by Tarkovsky, the technical civilization of contemporary society in an apocalyptic view is criticized and saved, or the prophetic will to not give up the desire for salvation is shown. In the process, the short shots which forces to show hierophanic time not only diversely visualized the author's ideological self-consciousness towards the conversion of the new world, but it also fulfills the metahistorical meanings mentioned by Eliade. However, in the film by Song, Il-gon, the realistic personal sufferings of three women is specifically shown first in extreme. They overcome their unsolvable problems through mysterious rituals and belief in miracles. In the scenes that include hierophanic time, there are many cases that cover Christian faith and the meaning of salvation. In other words, we can say that hierophanic time in , are related to conviction which led to moments of miracles in order to overcome reality. Therefore, even though there is a difference in the way authors use hierophanic time, the scenes that show it in the two movies display individuality of mythical imaginations disclosed by Eliade. This is because the general hope for reproduction, or meaningful symbols related to the ideal conversion of affairs are revealed.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.23 no.7
• /
• pp.816-821
• /
• 2019

A counter-type time-to-digital converter was designed using a dual edge T flip-flop. The time-to-digital converter was designed with a $0.18{\mu}m$ CMOS process at a supply voltage of 1.5 volts. In a typical time-to-digital converter, when the period of the clock is T, a conversion error corresponding to the period of the clock occurs due to the asynchronism between the input signal and the clock. However, the clock of the time-to-digital converter proposed in this paper is generated in synchronization with the start signal which is the input signal. As a result, conversion errors that may occur due to asynchronization of the start signal and the clock do not occur. The flip-flops constituting the counters are composed of dual-edge flip-flops operating at the positive and negative edges of the clock to improve the resolution.

• KIPS Transactions on Software and Data Engineering
• /
• v.7 no.8
• /
• pp.287-296
• /
• 2018

In the recent commercial DBMS market, as the users' burden and complaint which are related to high price licensing policy and late technical support service are increasingly rising, the concern for use of open source DBMS which has no problem with compatibility or stability is escalating. Due to the fact, the cases saving the cost are growing by converting Oracle Corporation's applications, which has about 60% share in the DBMS market, to an open source DBMS. However, in converting non-interchange sentences to an ANSI standard-based open source DBMS because of the use of PL/SQL in Oracle Corporation provides, a lot of manual work accompanies, so there is a lot of loss of time and money. Therefore, a tool that automatically converts PL/SQL to standard SQL is required. The proposed automation tool for the conversion of applications converts PL/SQL to Java Stored Procedure, an open source DBMS-based ANSI standard programming language. Through carrying out a test on the automation tool, it is proved that the tool will contribute to shortening time and saving cost by verifying the identity of input-output data and its reliability after correcting errors in converting to Java Stored Procedure.