• Transactions of the Society of Information Storage Systems
• /
• v.7 no.1
• /
• pp.19-24
• /
• 2011

Holographic Data Storage System, one of the next generation data storage devices, is a 2-dimensional page oriented memory system using volume holograms in writing and retrieving process. Recently photopolymer with disc type substrate was selected as a media for the Holographic Data Storage System. The disc tilt occurs when the media rotates and the external disturbance applies. The disc tilt causes the change of the angle between the reference beam and the media, the data cannot be retrieved with the right angle or other data page is retrieved. The tilt is generated in a 2-axis direction (tangential, radial). The tangential tilt direction is the same with the multiplexing plane, while the radial tilt direction is a perpendicular to the multiplexing plane. In this research we propose 2-axis tilt angle servo system. The tilt errors are measured by using external photo detector and the additional red laser. Then the tangential direction tilt is compensated by using the galvano mirror. Also the radial direction tilt is compensated by the rotating prism between the relay lens in the reference field. Finally we confirm the compensation results through the Signal to Noise Ratio(SNR) and Bit Error Rate(BER).

• The Bulletin of The Korean Astronomical Society
• /
• v.37 no.2
• /
• pp.219.2-219.2
• /
• 2012

We are developing Adaptive Optics (AO) system for 24 inch telescope at Seoul National University Observatory. It consists of the tip-tilt correction system and the residual wavefront error correction system with a deformable mirror and a wavefront sensor. We present the construction and performance measurements of the tip-tilt correction system. The tip-tilt component is the single largest contributor to wavefront error, especially for small telescope. The tip-tilt correction system consists of a quadrant photodiode, a tip-tilt mirror and a feed back loop. The collimated He-Ne laser beam is used for input light source and is artificially disturbed by air turbulence generated by a heat gun. Most of the turbulence is of low frequency less than 20 Hz, but extends to a few hundreds Hz. It is found that the closed loop system using proportional-integral-derivative (PID) control successfully corrects tip-tilt error at a rate as high as 300~400 Hz.

• Journal of Advanced Marine Engineering and Technology
• /
• v.37 no.2
• /
• pp.192-198
• /
• 2013

This paper presents the stabilization and design of a pan-tilt control part for the directional pan-tilt system for shipboard directional equipment. In order to control each control axis with compensation for ship motion, the 2 degree of freedom(2DOF) PID controller is designed and its parameters are tuned using a real-coded genetic algorithm(RCGA). Simulation demonstrates the effectiveness of the 2 DOF PID controller tuning.

• Current Photovoltaic Research
• /
• v.5 no.1
• /
• pp.38-42
• /
• 2017

PV system output is determined according to the weather conditions, the azimuth and tilt angle. Weather conditions are changing every moment and it seems to vary according to the daily, monthly, and annual basis. The azimuth and tilt angle is decided along the site conditions for the PV system installation. This paper analyzed the PV system output through the changing the weather conditions, the azimuth, and tilt angle. We compared the TMY data and analysis of the two major weather institutes which are KMA and METEONORM. PV system output trend were analyzed by changing the azimuth and tilt angle. We used simulation tool, which is named PVsyst for the entire PV system analysis.

• Journal of the Korean Society for Precision Engineering
• /
• v.15 no.7
• /
• pp.52-60
• /
• 1998

In optical disc system, 4-wire actuator has undesired tilt which degenerates the performance of RF signal. This tilt occurs from moment around the axis parallel to the tangential direction of the disk. The main reason of the moment is the coupling effect between focus driving system and tracking driving system. This paper constructed tilt mechanism and analyzed tilt quantity due to the moment based on structural analysis and magnetic field analysis. And the experiment about tilt was executed. The results were compared and discussed about the difference. Then, the design method for reducing tilt angle was suggested.

• Transactions of the Society of Information Storage Systems
• /
• v.3 no.1
• /
• pp.13-16
• /
• 2007

The purpose of this paper is real time tilt servo control of the holographic data storage system. Holographic data storage device is a next generation data storage device with high storage density, high transfer rate and short access time. This device is very sensitive to a disturbance due to the enormous storage density. As to the recording material changed disc type, the media continuously vibrates as the disc rotates. When disc rotates, deviation, eccentricity and unbalance disturbance are occurred. This disturbances cause disc tilt, finally reference beam does not illuminates to correct incidence angle. Therefore real time tilt servo control is essential. In this paper, the algorithm is proposed to make real time tilt detection in angle multiplexing of the holographic data storage system with an additional servo beam and the experiments are performed.

• Earthquakes and Structures
• /
• v.17 no.6
• /
• pp.635-647
• /
• 2019

Tests and theoretical studies for seismic responses of a transmission tower-line system under coupled horizontal and tilt (CHT) ground motion were conducted. The method of obtaining the tilt component from seismic motion was based on comparisons from the Fourier spectrum of uncorrected seismic waves. The collected data were then applied in testing and theoretical analysis. Taking an actual transmission tower-line system as the prototype, shaking table tests of the scale model of a single transmission tower and towers-line systems under horizontal, tilt, and CHT ground motions were carried out. Dynamic equations under CHT ground motion were also derived. The additional P-∆ effect caused by tilt motion was considered as an equivalent horizontal lateral force, and it was added into the equations as the excitation. Test results were compared with the theoretical analysis and indicated some useful conclusions. First, the shaking table test results are consistent with the theoretical analysis from improved dynamic equations and proved its correctness. Second, the tilt component of ground motion has great influence on the seismic response of the transmission tower-line system, and the additional P-∆effect caused by the foundation tilt, not only increases the seismic response of the transmission tower-line system, but also leads to a remarkable asymmetric displacement effect. Third, for the tower-line system, transmission lines under ground motion weaken the horizontal displacement and acceleration responses of transmission towers. This weakening effect of transmission lines to the main structure, however, will be decreased with consideration of tilt component.

• The Bulletin of The Korean Astronomical Society
• /
• v.38 no.1
• /
• pp.69.1-69.1
• /
• 2013

We are developing Adaptive Optics (AO) system for 1m telescope at Gwacheon National Science Museum Observatory. The beam spot of the Gwacheon 1m telescope. The tip-tilt correction system consists of a CMOS sensor, a tip-tilt mirror and a feed back loop. The beam spot location at the CMOS sensor indicates the tip-tilt components of the incoming light. The tip-tilt mirror is controlled by DAC output voltage calculated by proportional-integral-derivative (PID) controller. This system successfully corrects the tip-tilt motion of the spot.

• Journal of electromagnetic engineering and science
• /
• v.18 no.1
• /
• pp.13-19
• /
• 2018

Wireless power transfer (WPT) based on magnetic resonant coupling is a promising technology in many industrial applications. Efficiency of the WPT system usually depends on the tilt angle of the transmitter or the receiver coil. This work analyzes the effect of the tilt angle on the efficiency of the WPT system with horizontal misalignment. The mutual inductance between two coils located at arbitrary positions with tilt angles is calculated using a numerical analysis based on the Neumann formula. The efficiency of the WPT system with a tilted coil is extracted using an equivalent circuit model with extracted mutual inductance. By analyzing the results, we propose an optimal tilt angle to maximize the efficiency of the WPT system. The best angle to maximize the efficiency depends on the radii of the two coils and their relative position. The calculated efficiencies versus the tilt angle for various WPT cases, which change the radius of RX ($r_2=0.075m$, 0.1 m, 0.15 m) and the horizontal distance (y=0 m, 0.05 m, 0.1 m), are compared with the experimental results. The analytically extracted efficiencies and the extracted optimal tilt angles agree well with those of the experimental results.

• 제어로봇시스템학회:학술대회논문집
• /
• 1993.10a
• /
• pp.811-814
• /
• 1993

The development of fuzzy pan/tilt controller for remote handling in hostile environment is presented in this paper. In remote handling, control of the camera system is somewhat tedious and time consuming. Operators should do the two tasks of manipulating teleoperator and camera pan/tilt at the same time. By automating pan/tilt control, we expect operators could concentrate only on remote operation. When operators control camera pan/tilt they use simple linguistic rules such as "If the position of end effector on TV monitor is at the edge of the screen, control pan/tilt to display the end effector near the center of the screen." Such a rule is similar to fuzzy logic, so we used fuzzy logic controller to control camera pan/tilt. pan/tilt.