• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1994년도 하계학술대회 논문집 C
• /
• pp.1523-1525
• /
• 1994

This paper describes a proposed very fast transient overvoltages(VFTO) measurement system suited for established gas insulated switchgear(GIS). The detecting system consists of a shield electrode connected to a buffer amplifier, and the transmission of the detected signal to an oscilloscope is made through an optical fiber. The bandwidth of the measurement system is 5 Hz to 30MHz. When determining the voltage dividing ratio by use of the commercial frequency voltage, the error is less than 0.5 %. Also, the data were obtained by the electric field probe and the high voltage probe, and their deviation for voltage dividing ratio were less than 1 %.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 1997년도 봄 학술발표회 논문집
• /
• pp.544-550
• /
• 1997

In this study, the advanced on-sided stress wave velocity measurement method was applied to investigate the effects of composition, age and moisture content in concrete. Two concrete specimens that have different composition were used to figure out the change of the Longitudinal and Surface wave velocity due to different composition. The other concrete specimen was cast and the Longitudinal and Surface wave velocity was monitored during curing process. After 28-day old, the effect of moisture content in the concrete specimen to the stress wave velocity is presented in this paper during the time period 43-74 days after casting. For drying process. an aggregate drying oven was used. A conventional ultrasonic through transmission method was used to compare with the results determined by the one-sided method.

• 한국위성정보통신학회논문지
• /
• 제10권4호
• /
• pp.83-86
• /
• 2015

본 논문에서는 수처리 시설용 광대역 통합망 연계 실시간 계측관리 시스템 UI 개발을 제안한다. 수처리시설용 광대역 통합망을 통해 서버로 수신된 센서 및 영상 데이터를 Web과 연동하기 위한 프로그램을 개발하며, 이와 별도로 독립적으로 운영이 가능한 UI를 개발한다. 전송된 센서 및 영상데이터를 원격 모니터링 하기 위한 웹 서버를 구축하며 센서 데이터, 영상 데이터를 Web기반의 UI를 통해 감시 및 제어가 가능하도록 개발하였다. 제안하는 수처리 시설용 광대역 통합망 연계형 실시간 계측관리 시스템을 통하여 센서를 통한 측정시간, 농도, 수심 계면 등의 현재 상태를 파악할 수 있으며 영상 모니터링을 통하여 실시간으로 수처리 시설의 정상적인 동작여부와 보안 및 화재 등의 인명피해 여부를 확인 할 수 있다. 뿐만 아니라 실시간 계측 관리 시스템을 실시간으로 모니터링 할 수 있는 UI 개발로 인해 실시간으로 정보를 한눈에 볼 수 있다.

• 대한임베디드공학회논문지
• /
• 제17권1호
• /
• pp.9-17
• /
• 2022

As the COVID-19 pandemic situation worsens, the time spent indoors increases, and the exposure to indoor environmental pollution such as indoor air pollution and noise also increases, causing problems such as deterioration of human health, stress, and discord between neighbors. This paper designs and implements a system that measures and monitors indoor air quality and noise, which are representative evaluation criteria of the indoor environment. The system proposed in this paper consists of a particulate matter measurement subsystem that measures and corrects the concentration of particulate matters to monitor indoor air quality, and a noise measurement subsystem that detects changes in sound and converts it to a sound pressure level. The concentration of indoor particulate matters is measured using a laser-based light scattering method, and an error caused by temperature and humidity is compensated in this paper. For indoor noise measurement, the voltage measured through a microphone is basically measured, Fourier transform is performed to classify it by frequency, and then A-weighting is performed to correct loudness equality. Then, the RMS value is obtained, high-frequency noise is removed by performing time-weighting, and then SPL is obtained. Finally, the equivalent noise level for 1 minute and 5 minutes are calculated to show the indoor noise level. In order to classify noise into direct impact sound and air transmission noise, a piezo vibration sensors is mounted to determine the presence or absence of direct impact transmitted through the wall. For performance evaluation, the error of particulate matter measurement is analyzed through TSI's AM510 instrument. and compare the noise error with CEM's noise measurement system.

• 문화기술의 융합
• /
• 제10권2호
• /
• pp.525-530
• /
• 2024

환경정보를 실시간으로 획득하여 정보를 제공하는 환경 모니터링 시스템 필요성이 확대되고 있다. 특히 공공수역 수질관리의 경우 법적으로 수동측정과 자동측정을 통해 상시 관리를 진행해야 하며, 대기오염도 탄소중립 실현과 연관하여 미세먼지, 배기가스 저감을 위한 상시 측정 및 관리가 필요한 실정이다. 본 연구에서는 수질오염 및 대기오염 정보를 실시간으로 측정하여 모니터링을 할 수 있는 시스템을 구현하였다. 측정을 위한 도구로 육상과 수상을 동시에 이동 가능한 호버크래프트를 활용하였다. 호버크래프트 본체에 수질측정 및 대기오염측정 센서를 장착하고 그 정보를 실시간으로 모니터링 시스템으로 전송할 수 있는 통신 모듈을 장착하였다. 환경측정용 호버크래프트의 구조를 설계하였으며, 실시간 정보전달 통신 모듈로는 저전력 장거리 통신이 가능한 LoRa 모듈을 적용하였다. 실제 하드웨어 구현을 통해 제안한 시스템의 동작 성능을 확인하였다.

• 비파괴검사학회지
• /
• 제28권6호
• /
• pp.504-511
• /
• 2008

This paper proposes an ultrasonic measurement method for measurement of linear interfacial stiffness of contacting surface between two steel plates subjected to nominal compression pressures. Interfacial stiffness was evaluated by using shear waves reflected at contact interface of two identical solid plates. Three consecutive reflection waves from solid-solid surface are captured by pulse-echo method to evaluate the state of contact interface. A non-dimensional parameter defined as the ratio of their peak-to-peak amplitudes are formulated and used to calculate the quantitative stiffness of interface. Mathematical model for 1-D wave propagation across interfaces is developed to formulate the reflection and transmission waves across the interface and to determine the interfacial stiffness. Two identical plates are fabricated and assembled to form contacting surface and to measure interfacial stiffness at different states of contact pressure by means of bolt fastening. It is found from experiment that the amplitude of interfacial stiffness is dependent on the pressure and successfully determined by employing pulse-echo ultrasonic method without measuring through-transmission waves.

• 전기학회논문지
• /
• 제56권11호
• /
• pp.1879-1884
• /
• 2007

In the electric power industry, it is important that the supply of energy must be guaranteed. Many power utilities control and supervise the transmission line to avoid power failures. In case of underground tunnel, some troubles are reported in cable joint. To stabilize the power, it is needed to monitor the cable joint. Many researches of cable joint monitoring have been going on by partial discharge measurement and temperature measurement using optical cable. These methods need much cost to install and maintain, so it is only used in critical transmission line. In this research, we use wireless sensor technology, because of its low cost and easy installation. We develop the temperature monitoring system for cable joint. Temperature sensor is installed on the surface of cable joint and sends data to server through router node using wireless network. Generally Ad hoc routing is searched in wireless network. However, in this research, we design the static linear routing mechanism, which is suitable for electric power line monitoring and analyze the life time of the sensor node by measuring the amount of the battery consumption.

• 전기학회논문지
• /
• 제65권12호
• /
• pp.2113-2118
• /
• 2016

The precise detection of electric leakage point of underground power cable is very important to reduce cost and time of maintenance and prevent electric shock accident through expedite repair of electric leakage point. This paper proposes a electric leakage point detection system underground power cable using of half-period modulated transmission waveform and earth electric potential measurement. The developed system is composed of transmitter to generate the wanted pulse waveform, receiver to measure and display earth electric potential by the transmitted pulse in electric leakage point and PC Software program to display of GPS coordinate on detection cable line. The performance of the electric leakage point detection system was tested in the constructed underground cable leakage detection test bed. The test results on signal generation voltage precision of signal transmitter, mean detection earth voltage, mean detection leakage current and electric leakage point detection error showed the developed system can be used in electric leakage point detection underground power cable.

• Current Optics and Photonics
• /
• 제3권5호
• /
• pp.466-472
• /
• 2019

A system for continuous-wave coherent Doppler lidar (CW lidar), made up of all-fiber structures and a coaxial transmission telescope, was set up for wind measurement in Hefei (31.84 N, 117.27 E), Anhui province of China. The lidar uses a fiber laser as a light source at a wavelength of $1.55{\mu}m$, and focuses the laser beam on a location 80 m away from the telescope. Using the CW lidar, radial wind measurement was carried out. Subsequently, the spectra of the atmospheric backscattered signal were analyzed. We tested the noise and obtained the lower limit of wind velocity as 0.721 m/s, through the Rayleigh criterion. According to the number of Doppler peaks in the radial wind spectrum, a classification retrieval algorithm (CRA) combining a Gaussian fitting algorithm and a spectral centroid algorithm is designed to estimate wind velocity. Compared to calibrated pulsed coherent wind lidar, the correlation coefficient for the wind velocity is 0.979, with a standard deviation of 0.103 m/s. The results show that CW lidar offers satisfactory performance and the potential for application in wind measurement.

• 한국방사선학회논문지
• /
• 제2권1호
• /
• pp.11-16
• /
• 2008

방사선은 의학, 이공학, 농학, 기타 산업분야 등에서 사용영역이 매우 넓고 방사선이용기술의 개발로 방사선의 이용 빈도는 계속 증가되고 있다. 방사선의 인류에 대한 공헌은 지대하지만 생체에 미치는 영향으로 인하여 방사선에 의한 장해 또한 간과할 수 없는 부분이다. 방사선을 유효적절하게 이용하면서 장해를 방지하기 위해서는 방사선을 정확하게 계측하여야 하며 이에 따른 연구와 교육이 철저하게 이루어 져야만 한다. 본 연구에서는 유비쿼터스 컴퓨팅기술을 이용하여 생체에 유해한 작용을 하는 방사선을 방사선선원에 접근하지 않고 무선으로 시간과 장소에 제한 없이 방사선을 계측할 수 있는 방안을 제안하였다. 제안된 방안의 구현은 무선전송 기술은 CDMA망을 이용하였고, 임베디드시스템(embedded system)을 PDA에 내장한 후, 고정된 IP를 가지는 방사선계측시스템에 PDA를 CDMA망에 접속하여 계측값을 디스플레이 하였다. 본 연구에서 제안된 방안을 이용한다면 인간이 유해한 방사선선원에 접근하지 않고 선원에 배치된 고정된 IP를 가지고 있는 방사선계측시스템을 통하여 CDMA망으로 PDA에 표시된 계측값을 읽을 수 있게 될 것이다.