• 한국정보디스플레이학회:학술대회논문집
• /
• 2002.08a
• /
• pp.487-490
• /
• 2002

In this paper, we report a novel way to evaluate the anticlinic interlayer coupling coefficient U between smectic layers of an antiferroelectric liquid crystal, by utilizing a small field-induced perturbation of the molecular orientation. U was found to exhibit an unusual "S-shaped" dependence on temperature, with values ranging between $0.4{\times}10^4$ and $0.4{\times}10^{-1}$ erg $cm^{-3}$ over a 10$^{\circ}C$ temperature range below smectic A-smectic $C_A$ phase transition temperature. The results are good agreement with estimates for U based upon the threshold field for the onset of solitary waves, and provide strong supporting the low-field regime for the single Fourier component model.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.11 no.2
• /
• pp.89-95
• /
• 2003

We consider a problem of application of analytical redundancy to engine synchronization process of spark ignition engines, which is critical to timing for every ECU process including ignition and injection. The engine synchronization process we consider here is performed using the pulse signal obtained by the revolution of crankshaft trigger wheel (CTW) coupled to crank shaft. We propose a discrete-time linear model for the signal, for which we construct FDI (Fault Detection & Isolation) system consisting residual generator and threshold based on linear observer.

• International Journal of Aeronautical and Space Sciences
• /
• v.7 no.1
• /
• pp.73-83
• /
• 2006

In this paper, a redundancy management system for aircraft is studied, and fault detection and isolation algorithms of inertial sensor system are proposed. Contrary to the conventional aircraft systems, UAV system cannot allow triple or quadruple hardware redundancy due to the limitations on space and weight. In the UAV system with dual sensors, it is very difficult to identify the faulty sensor. Also, conventional fault detection and isolation (FDI) method cannot isolate multiple faults in a triple redundancy system. In this paper, two FDI techniques are proposed. First, hardware based FDI technique is proposed, which combines a parity equation approach with a wavelet based technique. Second, analytic FDI technique based on the Kalman filter is proposed, which is a model-based FDI method utilizing the threshold value and the confirmation time. To provide the reference value for detecting the fault, residuals are calculated using the extended Kalman filter. To verify the effectiveness of the proposed FDI methods, numerical simulations are performed.

• International Journal of Aeronautical and Space Sciences
• /
• v.9 no.2
• /
• pp.9-17
• /
• 2008

When the stagnation temperature of the combustion chamber or ambient air increases, the specific heats and their ratio do not remain constant any more, and start to vary with this temperature. The gas remains perfect, except, it will be calorically imperfect and thermally perfect. A new generalized form of the Prandtl Meyer function is developed, by adding the effect of variation of this temperature, lower than the threshold of dissociation. The new relation is presented in the form of integral of a complex analytical function, having an infinite derivative at the critical temperature. A robust numerical integration quadrature is presented in this context. The classical form of the Prandtl Meyer function of a perfect gas becomes a particular case of the developed form. The comparison is made with the perfect gas model for aim to present a limit of its application. The application is for air.

• Journal of the Korean Chemical Society
• /
• v.23 no.6
• /
• pp.396-401
• /
• 1979

Measuring the reaction rate of bilirubin and oxodipyrromethenes with singlet oxygen, we have found oxodipyrromethenes to be better singlet oxygen trapping agents than diphenyl-isobenzofuran, the best such agent known so far. The photooxygenation rates of bilirubin and the model compounds, oxodipyrromethenes approached the diffusion control threshold. A new oxodipyrromethene is synthesized.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.27 no.4
• /
• pp.571-579
• /
• 1990

A dynamic relocation algorithm for non-deterministic process graph in distributed computer systems is proposed. A method is represented for determining the optimal policy for processing a process tree. A general database query request is modelled by a process tree which represent a set of subprocesses together with their precedence relationship. The process allocation model is based on operating cost which is a function fo selection of site for processing operation, data reduction function and file size. By using expected values of parameters for non-deterministic process tree, the process graph and optimal policy that yield minimum operating cost are determined. As process is relocated according to threshold value and new information of parameters after the execution of low level process for non-deterministic process graph, the assigned state that approximate to optiaml solution is obtained. The proposed algorihtm is heuristic By performing algorithm for sample problems, it is shown that the proposed algorithm is good in obtaining optimal solution.

• Wind and Structures
• /
• v.3 no.2
• /
• pp.73-81
• /
• 2000

Snowdrifts around buildings can cause serious problems when formed on undesirable places. The formation of snowdrifts is highly connected to the wind pattern around the building, and the wind pattern is again dependent on the building design. The shear stress on the surface and snowdrifting around different buildings are investigated through CFD analysis and compared to measurements. The computations of shear stress shows local minima in the same areas as snowdrifts are formed. The snowdrifting computations utilises a drift-flux model where a fluid with snow properties is allowed to drift through a fluid with air properties. An apparent dynamic viscosity of the snow/air mixture is defined and used as a threshold criterion for snowdrifting. The results from the snowdrifting computations show increased snow density where snowdrifts are expected, and are in agreement with previous large-scale snowdrift measurements. The results show that computational fluid dynamics can be a tool for planning building design in snowdrifting areas.

• Proceedings of the Korea Society for Industrial Systems Conference
• /
• 2001.05a
• /
• pp.232-236
• /
• 2001

In this paper, we consider the problem of estimation of average radar cross section (RCS) for Swerling 1 fluctuation model, based on the maximum likelihood (ML) estimation method. In a mathematical development we take into account the event that target strength is lower than detection threshold, or the target is not detected. Our ML estimation for the SWR uses the score function that is the joint probability-pdf of the events and random variables. The solution to the ML estimation reduces to an expression in the from of a contraction mapping. The computational efficiency of the contraction mapping theorem is significant in computing the ML estimation as compared with other root-finding algorithms fur most radar tracking conditions.

• Management Science and Financial Engineering
• /
• v.21 no.1
• /
• pp.25-29
• /
• 2015

Recently much research efforts have focused on how to manage carbon emissions in logistics operations. This paper formulates a model to determine an optimal shipment size with aims to minimize the total cost consisting not only of inventory and transportation costs but also cost for carbon emissions. Unlike the literature assuming carbon emission factors as a given condition, we consider the emission factors as decision variables. It is allowed to make an investment in improving carbon emission factors. The optimal investment decision is shown to be of a threshold type with respect to unit investment costs. Moreover, the findings in this work provide insights on the various elements of the investment decision and their impacts.

• The Bulletin of The Korean Astronomical Society
• /
• v.39 no.1
• /
• pp.71.1-71.1
• /
• 2014

To investigate physical properties of Solar pores, we use SDO/HMI data from 2010 to 2013. For this, we select single and isolated pores from the active region (Axx, Bxo, Bxi and Bxc-type) listed in Solar Region Summary. Pore is defined by connected pixels satisfying the intensity threshold from pixel of minimum intensity. We try to obtain area, intensity, magnetic field, and Doppler velocity of pores from HMI data. After removing the effects of orbital motion of the SDO satellite and differential rotation of the Sun, we identify that significant daily variations of Doppler velocity with non-zero ordinates still remain in the umbral region, and the artifact is quite dependent on the strength of magnetic field and radial component of velocity of SDO satellite. In this study we develope empirical model to remove the artifact. A preliminary result on the elimination of the artifact will be presented.