• Korean journal of food and cookery science
• /
• v.11 no.1
• /
• pp.83-91
• /
• 1995

For the accurate interpretation and objective measurement of textural characteristics of fermented vegetables, first of all, the studies on the microstructure and chemical compositions of vegetable cell, and the changes in the textural properties of vegetables during salting, blanching and fermentation should be carried out. And the mechanical textural parameters were needed to compare with and analyze in relation to the sensory parameters. In this review, the thypical force-distance curves of fermented vegetables were obtained from the compression, cutting and puncture test. And it was showed that the compression force was a more effective textural parameter to express the hardness of fermented vegetables, and the sensory chewiness and toughness were related to the changes in cutting force. In the puncture test, the puncture force was related to the hardness and varied with the size and form of puncture probe; the changes in puncture force by small probe could express the decrease in hardness and crispness, whereas those by large probe could represent the changes in toughness. And the brittleness and crispness could be measured by the break point and the numbers of peak obtained from the force-distance curves.

• Asian-Australasian Journal of Animal Sciences
• /
• v.19 no.11
• /
• pp.1658-1664
• /
• 2006

The objective of this study was to investigate the effects of sodium alginate (SA) and pressurization levels on pH, water-binding and textural properties of pork muscle gels (PMG) containing salt. Ground lean pork with 1.0% NaCl and a given amount of SA (0.25, 0.5, 0.75 and 1.0%, respectively), was pressurized to 100, 200 or 300 MPa and subsequently gelled by heating. Results showed that addition of SA into pork muscle enhanced water-holding capacity (WHC) of PMG (p<0.05) as SA increased from 0.25% to 1.0%, with pH slightly increased (p>0.05). A decrease (p<0.05) was observed in all textural parameters (hardness, cohesiveness, springiness and chewiness). Pressurization had no effect on the tendency of WHC to increase or the decrease of the textural parameters. However, the effectiveness of pressurization to enhance textural properties of PMG was significant at some SA levels, especially ${\geq}200MPa$ and at ${\leq}0.75%$ SA levels. Different combinations of pressure and SA levels could bring about variation in textural properties of PMG while SA enhanced WHC of pork muscle. The multiformity of the texture will open up a wide range of technological possibilities for the manufacture of pork-based restructured low-fat products.

• Journal of the Korean Home Economics Association
• /
• v.25 no.4
• /
• pp.57-62
• /
• 1987

To obtain basic data for the decvelopment of Kimchi preservation method, optimal ripening Kimchi was air-packaged with polyethylene bag, and followed by the microbiological, firmness and sensory evaluations during storage at 5$^{\circ}C$. 1. Total aerobic count increased in the beginning of storage and then decreased slowly as the number of total Lactic bacteria(anaerobe) in creased. 2. Textural parameters were remarkably changed according to the elapse of storage period. 3. Sensory evaluation showed that the score was decreased considerably 10 days after storage.

• Fisheries and Aquatic Sciences
• /
• v.14 no.3
• /
• pp.161-167
• /
• 2011

This study investigated the effects of the number of washes and alkaline treatments ($NaHCO_3$ concentrations) and the concentration of potato starch on the quality of fish meat paste products prepared from sand lance Ammodytes personatus Girard. We found significantly (P<0.05) higher ratings for the all textural parameters (hardness, brittleness, elasticity, and cohesiveness) of the sand-lance meat paste products (SLMPPs) that were washed three times with a 0.5% $NaHCO_3$ concentration. We determined that an 8% concentration of potato starch leads to the best textural properties in SLMPPs. As the amount of potato starch was increased, the redness values of SLMPPs decreased significantly (P<0.05), but the differences in the sensory evaluation parameters (texture, flavor, taste, and overall acceptability) between the SLMPPs were not significant.

• Korean Journal of Food Science and Technology
• /
• v.53 no.1
• /
• pp.92-98
• /
• 2021

The effects of heat-moisture treatment (HMT) on rice flour (RF) have been investigated for possibility of texture modifier in protein-based foods matrix, tofu. The optimum condition for preparation of tofu with maximum textural parameters was investigated by using response surface methodology (RSM). Rice flour was subjected to moisture content (10-30%) and heating temperature (100-140℃). Based on the response surface and superimposed plots, the optimized conditions of hydrothermally treated rice flour was as followed: moisture content, 22%; temperature, 130℃, which showed lower swelling power as compared to native RF and became more stable during continuous heating and agitation than native one. Tofu, prepared with HMT-RF, showed a denser network structure than that with RF, thereby inducing an increase in textural parameters. From the above results, the addition of HMT-RF could preserve the quality of tofu and be useful for developing an acceptable protein-based food product.

• Food Science of Animal Resources
• /
• v.41 no.4
• /
• pp.739-747
• /
• 2021

This study examined the measurement conditions of the texture profile analysis (TPA) experiments that are typically used to measure the physical properties of sausage. As the measurement conditions (compression ratio and cross-head speed) were changed, the significant differences between the values of textural parameters (hardness, adhesiveness, springiness, cohesiveness, chewiness) of samples changed. Furthermore, among the measurement conditions, there was more variation in the significant difference between the value of samples due to a change in the compression ratio than due to a change in the cross-head speed. The highest variation in significant difference was observed between the values of cohesiveness of samples due to changes in measurement conditions, whereas the lowest variation in significant difference was observed between the values of springiness of samples due to change in measurement conditions. Therefore, it is desirable to provide a clear basis for setting specific measurement conditions for TPA test, since significant differences in the values of textural parameters of samples were caused by differences in cross-head speed or compression ratio, not by a difference in samples, when analyzing the cohesiveness of sausage, especially.

• The Korean Journal of Quaternary Research
• /
• v.7 no.1
• /
• pp.93-101
• /
• 1993

A sedimentation study of the Cheonripo intertidal beach sands and its related coastal dune sands, Cheonripo, Seosan Gun, Choongcheong Namdo, Korea has been carried out based on a series of several summer time field surveys. Each subenvironment in the Cheonripo coastal zone, that is, intertidal sand beach and coastal sand dune, could be differenciated in terms of textural parameters. The coastal dune sands are finer than the intertidal beach sands in mean grain size, and the sorting of dune sands is relatively poorer than that of intertidal beach sands. However, the skewness of intertidal beach and dune sands is commonly positive. Such textural parameters are characteristically differentiated on scatter diagrams. A series of megaripple bedform observations for 6 tidal cycle periods(August 13, 14 and 15, 1990) are interpreted to find out migration pattern of bedforms and its related sand migration. Such migration natures are shown on the tables and figures.

• Korean journal of food and cookery science
• /
• v.1 no.1
• /
• pp.57-64
• /
• 1985

This study was conducted to investigate the effect of fat on structure and texture of soybean curds by partial or whole replacement of soybean with defatted soy flour, The textural properties of soybean curd were examined by Instron universal testing machine, and the microscopic structure of soybean curds was examined by Scanning electron microscope(SEM). The results obtained were as follows ; 1. Textural parameters determined by Instron universal testing machine showed that hardness and gumminess of soybean curs were significantly increased as the fat contents of the samples decreased. On the while, springiness of the samples were significantly lowered as the fat content decreased. 2. Microscopic structure of soybean curds examined by SME demonstrated that samples with high fat had more fat globules and thinner network layer which were assumed to surround moisture with.

• Carbon letters
• /
• v.6 no.3
• /
• pp.141-147
• /
• 2005

The carbon sample "O", phosphoric acid-activated carbon "OP", zinc chloride-activated carbon "OZ", and two steam activated carbons "OS" and "OS2" with different burn-off of 25% and 58% respectively, were prepared from olive stones. The textural properties were determined from the results of nitrogen adsorption at 77 K and by analyzing these results through the application of different adsorption models. The chemistry of the carbon surfaces was determined from the base neutralization capacities, acid neutralization capacity and surface pH. The sorption of $Pb^{2+}$ ions on to the carbons prepared was followed under dynamic and equilibrium conditions. The differences between the values of the textural parameters were attributed to the inapplicability of some adsorption models and to the heterogeneity of the microporous carbons. The sorption of $Pb^{2+}$ ions is favored on carbon and activated carbons. However, chemically activated carbons are more effective compared with steam-activated ones. The sorption of $Pb^{2+}$ ions were related to the chemistry of the surface rather than to the textural properties.

• Journal of Animal Science and Technology
• /
• v.62 no.4
• /
• pp.577-586
• /
• 2020

This study was to investigate the effect of salt alone or in combination with phosphate on physicochemical and textural properties, and chemical interactions of low-fat model sausages. pH, color, expressible moisture (EM), cooking loss (CL), proximate analysis, textural profile analysis and low-vacuum scanning electron microscopy were performed. As salt content increased, color tended to decrease, as did EM and CL parameters, indicating that the ability to retain moisture was improved with increased salt levels (p < 0.05). In addition, textural hardness, gumminess and chewiness all increased with increasing salt (p < 0.05). Sausages with 0.3% salt showed the lowest cohesiveness compared to those with salt levels higher than 0.3% (p < 0.05). Addition of sodium tripolyphosphate (STPP) increased pH of sausages. Increasing salt and STPP did not affect lightness (p > 0.05), but did increase redness and yellowness (p < 0.05). The moisture content was higher when the salt and STPP contents were increased (p < 0.05), but no differences in the fat and protein contents (%) were observed (p > 0.05). EM and CL tended to decrease with increasing salt and STPP. In textural properties, the combination of 1.8% salt and 0.3% STPP was the best among other treatment (p < 0.05). Surface microstructure showed a flat and dense structure with increasing salt and STPP. Since the addition of salt and phosphate improved the functionality, textural and physicochemical properties of meat products in this study, meat products will need to be developed in line with consumer's preference.