• Microbiology and Biotechnology Letters
• /
• v.29 no.2
• /
• pp.122-126
• /
• 2001

Eleven bacterial strains which were able to utilize terephthalic acid as a carbon and an energy source for growth were isolated from the soil of 7 water quality evaluation points in Kyonggi area of Korea. According to the report from the authorities, biochemical oxygen demands of the water at 4 points were reported over 20 ppm but those of 3 points were repOlted less than 2 ppm in 1997. Optimum temperatures of growth and terephthalic acid degrading activity of some isolates were not identical but optimum growth temperature was 30$^{\circ}$C. Most of the isolates utilized one or two of the phthalate isomers as a carbon source for growth and the isolates from the 4 contaminated points showed higher terephthalic acid degrading activity than those from the 3 clean points.

• Journal of Environmental Health Sciences
• /
• v.27 no.3
• /
• pp.43-48
• /
• 2001

Terephthalic acid and ethylene glycol resulting form the weight-reduction process of polyester make trouble in the operation of activated sludge process. Also, polyester weight loss wastewater shows high pH, high organic strength and wide variation of organic loading. Therefore, this study was conducted in order to improve treatment efficiency by activated sludge process with Pseudomonas sp degrading components of polyester weight loss wastewater. The CO $D_{Mn}$ and BO $S_{5}$ of the waste wastewater were 560~3,000 mg/$\ell$ and 8000~3,000 mg/$\ell$, respectively. pH was 11.8~12.3. COD removal efficiency by activated sludge-coagulation process with Pseudomonas sp was 94.1~95.8% for 35 hr of hydraulic retention time. Total organic carbon removal efficiency was 97.1%. Ethylene glycol and terephthalic acid in the wastewater were completely degraded during 32 hr of hydraulic retention time.e.

• 한국생물공학회:학술대회논문집
• /
• 2002.04a
• /
• pp.359-360
• /
• 2002

A bacterial strain able to degrade terephthalic acid (TPA) was isolated and identified to belong to the Corynebacterium sp. It was named Corynebacterium sp. YT-14. When stirred loop bioreactor was used in a batch type system for removing terephthalic acid from weight loss treatment wastewater and complex dyeing process wastwater, the removal efficiency of terephthalic acid was 85.4% after 7 days of treatment of the weight loss treatment wastewater, while no residual terephthalic acid was detected after 3 days of treatment of the complex dyeing process wastewater

• Microbiology and Biotechnology Letters
• /
• v.31 no.2
• /
• pp.177-181
• /
• 2003

Eleven bacterial strains which are able to utilize terephthalic acid as a carbon and an energy source for growth were isolated from the soil of 7 water quality evaluation points in Kyonggi area of Korea. Phthalic acid isomer degrading activity of the isolates from the 4 contaminated points was higher than those from the 3 clean points. Among 11 isolates, 4 isolates which have high terephthalic acid degrading activity and degrade two phthalic acid isomers were identified by partal 16S rDNA sequence determination. One of them was identified as Pseudomonas putida, and the others as Comamonas testosteroni. Thus a large number of phthalic acid isomer degrading bacteria in domestic soil were inferred as C. testosteroni. On the basis of these results, the PCR detection of C. testosteroni in soil was applied to monitor soil contamination by phthalic acid isomers. The DNA of C. test-osteroni extracted from 4 g soil was directly detected by PCR with C. testosteroni specific primer pair. The amount of PCR products was different according to sampling sites and more PCR products were obtained from contaminated sites than those from clean sites (Gulpo-chun＞Anyang-chun＞Hwangguji-chun>Shin-chun＞Huk-chun＞Pukhan-river>Kapyeong-chun). This result was coincided with that of the viable cell counts for terephthalic acid degrading bacteria.

• Korean Chemical Engineering Research
• /
• v.57 no.6
• /
• pp.790-803
• /
• 2019

The dioctyl terephthalic acid (DOTP) process produces plastic plasticizers by esterification of terephthalic acid with powder in the form of octanol. In this study, the dust explosion characteristics of terephthalic acid directly injected into the manhole in the form of powder in the presence of flammable solvent or vapor in the reactor of this process were investigated. Dust particle size and particle size distribution dust characteristics were investigated, and pyrolysis characteristics of dust were investigated to estimate fire and explosion characteristics and ignition temperature. Also, the minimum ignition energy experiment was performed to evaluate the explosion sensitivity. As a result, the average particle size of terephthalic acid powder was $143.433{\mu}m$. From the thermal analysis carried out under these particle size and particle size distribution conditions, the ignition temperature of the dust was about $253^{\circ}C$. The lower explosive limit (LEL) of the terephthalic acid was determined to be $50g/m^3$. The minimum ignition energy (MIE) for explosion sensitivity is (10 < MIE < 300) mJ, and the estimated minimum ignition energy (Es) based on the ignition probability is 210 mJ. The maximum explosion pressure ($P_{max}$) and the maximum explosion pressure rise rate $({\frac{dP}{dt}})_{max}$ of terephthalic acid dust were 7.1 bar and 511 bar/s, respectively. The dust explosion index (Kst) was 139 mbar/s, corresponding to the dust explosion grade St 1.

• Bulletin of the Korean Chemical Society
• /
• v.16 no.1
• /
• pp.17-21
• /
• 1995

A new series of polyarylate copolyesters were prepared by melt polycondensation of 1,4-diacetoxy-2,5-(α-phenylisopropyl)benzene with mixture of terephthalic acid and isophthalic acid in varying ratio. And their general properties such as the glass transition temperature, crystalline melting temperature, crystallinity and solubility were studied. The intrinsic viscosity values of the present polymers measured in a mixed solvent of phenol/p-chlorophenol/1,1,2,2-tetrachloroethane ranged from 0.45 to 0.66 depending on the composition and molecular weight. The copolyesters containing greater than 20 mole % of isophthalic acid were found to be amorphous, whereas the homopolymer derived from terephthalic acid was semicrystalline with a melting point of 414℃. The glass transition temperatures of the polymers ranged from 165 to 180℃ depending on the composition. The copolyesters containing 50 mole % and greater of isophthalic acid moiety were soluble at room temperature in such common solvents as tetrahydrofuran, chloroform and N,N-dimethylformamide.

• Microbiology and Biotechnology Letters
• /
• v.27 no.2
• /
• pp.118-123
• /
• 1999

A bacterial strain, designated T116, degrading terephthalic acid (TPA) was isolated from the soil around Taegu industrial area into which dye works wastewater flow. The isolate was identified as pseudomonas sp. based on its morphological and physiological characteristics. Degradation of TPA by the strain T116 was confirmed with UV scanning and HPLC. About 90% and 98% of TPA were degraded after 36 and 60 hours, respectively, during the culture in a liquid medium containing 0.1% TPA. Addition of KH2PO4 at a final concentration of 100ppm enhanced the chemical oxygen demand (COD) removal rate about 50% from dye works wastewater by Pseudomonas sp. T116. Optimum pH and temperature for COD reduction from wastewater were 7.0 and 3$0^{\circ}C$, respectively. The bacterium was applied to the continuous culture for the treatment of dye works wastewater whose TPA concentration and CODMn were 2,200ppm and 1,620ppm, respectively. It was observed that 90-95% of COD was eliminated after 4 days culture in the continuous culture with a retention time of 37 or 47 hours.

• Journal of Environmental Health Sciences
• /
• v.21 no.4
• /
• pp.44-48
• /
• 1995

26 bacterial strains capable of growing on Terephthalic acid (TPA) in minimal medium were isolated from soil and wastewater by selective enrichment culture, and among them, one isolate which was the best in the cell growth and TPA degradation was selected and identified as Pseudomonas sp. T-1 by its characteristics. Cell growth almost revealed a stationary phase at 24 hrs after cultivation. Cell growth dramatically increased in a minimal medium containing 0.1% of TPA as a sole carbon source and TPA was not detected any more at 80 hrs after cultivation. Therefore, it is suggested that Pseudomonas sp. T-1 could be effectively used for the biological treatment of wastewater containing TPA.

• YAKHAK HOEJI
• /
• v.22 no.2
• /
• pp.83-86
• /
• 1978

A colorless sublime needles (A), $C_{10}H_{10}O_{4}$, mp$142~143\circ$ was isolated from the fresh flowers of Chrysanthemun sinense Sabine in 0.16% yield. Its ir, nmr and mass spectral data suggested that it may have an aromatic methylester structure. Hydrolysis of this substane with 10% sodium hydroxide solution yielded terephthalic acid and methanol. This substance was confirmed as dimethyl terephthalate by comparison of ir and nmr spectra, and TLC and GC behaviors of an authentic sample which was prepared from terephthalic acid by methylation. This is the first report that dimethly terephthalate was isolated in the Composite plants.

• Korean Chemical Engineering Research
• /
• v.45 no.6
• /
• pp.648-655
• /
• 2007

UV/H_2O_2$, $O_3$, $O_3/H_2O_2$, $UV/H_2O_2/O_3$ processes were tested for the removal of COD and color from terephthalic acid wastewater. COD removal efficiencies were 10, 48, 56, 63% in the $UV/H_2O_2$, $O_3$, $O_3/H_2O_2$, $UV/H_2O_2/O_3$ process respectively. Color removal efficiency of $UV/H_2O_2$ process was 80% and $O_3$, $O_3/H_2O_2$, $UV/H_2O_2/O_3$ processes were almost more than 99%. Terephthalic acid, isophthalic acid and benzoic acid were completely destructed in terephthalic wastewater within 120 min by $UV/H_2O_2/O_3$ process and shows high COD and color removal efficiencies. The optimum concentration of $H_2O_2$ dosage was found to be 0.5 M, 25 mM and 5 mM for $UV/H_2O_2$, $O_3/H_2O_2$ and $UV/H_2O_2/O_3$ processes respectively, Organic destruction efficiency was enhanced and also reducing the consumption of $H_2O_2$ dosage by combining UV, $H_2O_2$ and $O_3$ process.