• 해양환경안전학회지
• /
• 제29권3호
• /
• pp.255-269
• /
• 2023

Surface water temperature of a bay (from the south to the north) increases in spring and summer, but decreases in autumn and winter. Due to shallow water depth, freshwater outflow, and weak current, the water temperature in the central to northern part of the bay is greatly affected by the land coast and air temperature, with large fluctuations. Water temperature variations are large in the north-east coast of the bay, but small in the south-west coast. The difference between water temperature and air temperature is greater in winter and in the south-central part of the bay than that in the north to the eastern coast of the bay where sea dykes are located. As the bay goes from south to north, the range of water temperature fluctuation and the phase show increases. When fresh water is released from the sea dike, the surrounding water temperature decreases and then rises, or rises and then falls. The first mode of empirical orthogonal function (EOF) represents seasonal variation of water temperature. The second mode represents the variability of water temperature gradient in east-west and north-south directions of the bay. In the first mode, the maximum and the minimum are shown in autumn and summer, respectively, consistent with seasonal distribution of surface water temperature variance. In the second mode, phases of the coast of Seosan~Boryeong and the east coast of Anmyeon Island are opposite to each other, bordering the center of the deep bay. Periodic fluctuation of the first mode time coefficient dominates in the one-day and half-day cycle. Its daily fluctuation pattern is similar to air temperature variation. Sea conditions and topographical characteristics excluding air temperature are factors contributing to the variation of the second mode time coefficient.

• 한국농림기상학회지
• /
• 제19권3호
• /
• pp.93-101
• /
• 2017

2011-2015년까지 경남 하동군 악양 집수역의 해발고도 8~1,073m 범위에 설치된 10개 무인기상관측기에서 0600, 1500 기온 관측값을 수집하여 월별 표준편차를 계산하고, 소기후모형으로부터 예측된 기온의 표준편차 결과를 함께 비교하여 미관측 지점의 추정기술에 실효성이 있는지 평가하였다. 소기후모형에 따른 예측값은 월별 0600, 1500 기온의 표준편차를 각각 88%, 86% 정도 설명할 수 있었지만, 전반적으로 과소추정하는 경향이었다. 겨울철과 여름철에 나타나는 낮은 고도 대비 해발고도가 높아질수록 변이가 작아지거나 커지는 방향성에 있어서 관측값과는 반대양상으로 나타나 당초 기대와는 다른 결과를 보였다. 또 다른방법으로 월별 기온 표준편차와 지형간의 관계를 정량화하여 임의지역의 지형특성과 종관규모 수준의 기온자료 만으로 표준편차 분포를 예측할 수 있을지 회귀분석을 수행하였다. 회귀모형은 해발고도편차에 따라 보정된 월별 기온 외에, 경사도와 경사향 등 기본적인 지형인자와 온난대효과와 냉기집적효과, 개방도 등의 기온과 관련된 변수들을 고려하여 월별로 표준편차를 가장 잘 설명할 수 있는 변수를 1~3개까지 선발하여 만들어졌으며, 월별 결정계수는 0.46부터 0.98 범위로 나타났다. 회귀모델을 이용해 기온이 관측되지 않는 임의지역의 표준편차를 지형변수의 최소-최대값 유효범위 내에서 월별로 예측한다면 70% 수준의 추정능력으로 공간변이 분포도를 나타낼 수 있을 것으로 예상된다.

• Journal of Advanced Marine Engineering and Technology
• /
• 제30권8호
• /
• pp.901-906
• /
• 2006

In this paper, the power amplifier using active bias circuits for LDMOS(Lateral Diffused Metal Oxide Semiconductor) MRF-21180 is designed and fabricated. According to change the temperature, the gate voltage of LDMOS is controlled by the fabricated active bias circuits which is made of PNP transistor to suppress drain current. The driving amplifier using MRF-21125 and MRF-21060 is made to drive the LDMOS MRF-21180 power amplifier. The variation of current consumption in the fabricated 60 watt power amplifier has an excellent characteristics of less than 0.1 A, whereas a passive biasing circuit dissipates more than 0.5 A. The implemented power amplifier has the gain over 9 dB, the gain flatness of less than $\pm$0.1 dB and input and output return loss of less than -6 dB over the frequency range 2.11 $\sim$ 2.17 GHz. The DC operation point of this power amplifier at temperature variation 0 $^{\circ}C$ to 60 $^{\circ}C$ is fixed by active bias circuit.

• 전자공학회논문지A
• /
• 제33A권12호
• /
• pp.39-46
• /
• 1996

In AlGaAs/GaAs HBT the temperature dependence of DC parameters was investigated over the temperature range between 95K and 580K. The temperature dependence of DC parameters depends on the relative contribution of each of the current components suc as emitter-injection-current, base-injection-current, bulk recombination current, interface recombination curretn, thermal generation ecurrent and avalanche current due to impact ionization within the collector space charge layer in a specific temperature. In this paper we investigated the temperature effects on DC parameters such as V$_{BE,ON}$ current gain, input and output characteristics, V$_{CE, OFF}$, R$_{E}$, R$_{C}$ and analyzed the origins, and extracted the qualitativ econditions for a stable HBTs against the temperature variation. Finally, in order to keep HBTs stable with respect to the variation of temperature, the valance-band-energy-discontinuity at emitter-base heterojunction should be large enough to enhance the effect of carrier suppression at a relatively high temperature. In addition the recombination centers, especially around collector junction, should be removed and the area of emitter and collector junction should be identical as well.

• 한국전기전자재료학회논문지
• /
• 제14권7호
• /
• pp.572-577
• /
• 2001

The electrical properties of Pr$_{6}$ O$_{11}$ -based ZnO varistors consisting of ZnO-Pr$_{6}$ O$_{11}$ -CoO-Cr$_2$O$_3$-Er$_2$O$_3$ ceramics were investigated with sintering temperature in the range of 1325~f1345$^{\circ}C$. As sintering temperature is raised., the nonlinear exponent was increased up to 1335$^{\circ}C$, reaching a maximum 70.53, whereas raising sintering temperature further caused it to decrease, reaching a minimum 50.18 and the leakage current was in the range of 1.92~4.12 $\mu$A. The best electrical properties was obtained from the varistors sintered at 1335$^{\circ}C$, exhibiting a maximum (70.53) in the nonlinear exponent and a minimum (1.92 $\mu$A) in the leakage current, and a minimum (0.035) in the dissipation factor. On the other hand, the donor concentration was in the range of (0.90~1.14)x10$^{18}$ cm$^{-3}$ , the density of interface states was in the range of (2.69~3.60)x10$^{12}$ cm$^{-2}$ , and the barrier height was in the range of 0.77~1.21 eV with sintering temperature. With raising sintering temperature, the variation of C-V characteristic parameters exhibited a mountain type, reaching maximum at 134$0^{\circ}C$. Conclusively, it was found that the V-I, C-V, and dielectric characteristics of Pr$_{6}$ O$_{11}$ -based ZnO varistors are affected greatly by sintering temperature.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2001년도 추계학술대회논문집A
• /
• pp.349-354
• /
• 2001

The split Hopkinson pressure bar has been used for a high strain rate impact test. Also it has been developed and modified for compression, shear, tension, elevated temperature and subzero tests. In this paper, SHPB compression tests have been performed with pure titanium at elevated temperatures. The range of temperature is from room temperature to $1000^{\circ}C$ with interval of $200^{\circ}C$. To raise temperature of the specimen, a radiant heater which is composed of a pair of ellipsoidal cavities and halogen lamps is developed at high temperature SHPB test. There are some difficulties in a high temperature test such as temperature gradient, lubrication and prevention of oxidation of specimen. The temperature gradient of specimen is affected by the variation of temperature. Barreling occurred at not properly lubricated specimen. Stress-strain relations of pure titanium have been obtained in the range of strain rate at $1900/sec{\sim}2000/sec$ and temperature at $25^{\circ}C{\sim}1000^{\circ}C$.

• 환경영향평가
• /
• 제22권1호
• /
• pp.19-26
• /
• 2013

The propose of this study is to analyze the optimum spatial resolution of the urban spatial thermal environment structure and to evaluate of the possibility detection using aerial photographs and thermal satellite images. The proper techniques of the optimum spatial resolution for the urban spatial thermal environment structure were analyzed. Thermal infrared satellite image of Seoul city were used for the change rate of surface temperature variation and suggested to the spatial extent and effects of urban surface characteristics and spatial data was interpreted as regions. To extract the surface temperature, Landsat thermal infrared satellite image compared with an automatic weather station data and in the field of the measured temperature and surface temperature by thermal environment affects, the spatial domain has been verified. The surface temperature of the satellite images to extract after adjusting surface temperature isotherms were constructed. The changes in surface temperature from 2008 to 2012 the average surface temperature observation images of changing areas were divided into space. The results of this study are as follows: Through analysis of satellite imagery, Seoul city surface temperature change due to extraction comfort indices were classified into four grades. The comfort index indicative of the temperature of Gangnam-gu, $23.7{\sim}27.2(^{\circ}C)$ range and Songpagu, a $22.7{\sim}30.6(^{\circ}C)$ respectively, the surface temperature of Yeouido $25.8{\sim}32.6(^{\circ}C)$ were in the range.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2002년도 하계종합학술대회 논문집(2)
• /
• pp.189-192
• /
• 2002

In this work, a Voltage-to-Frequency Converter.(VFC) in which the output frequency is proportional to the input voltage is proposed. To obtain temperature stable characteristics the VFC is designed by using two bandgap references. The difference between simulated and calculated values is less than about 5% in output characteristics. In the VFC using BiCMOS the temperature variation of sample output frequencies is less than $\pm$0.5% in the temperature range -$25^{\circ}C$ to 75$^{\circ}C$. And the CMOS VFC has error less than $\pm$0.8% in the temperature range -$25^{\circ}C$ to 75'$^{\circ}C$.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2000년도 하계학술대회 논문집
• /
• pp.132-135
• /
• 2000

This paper present the results of measured Thermally Stimulated Current of EPR(Ethylene Propylene Rubber) sheet material with variation of bias temperature range of -35~80[$^{\circ}C$], the quality of the material of electrode, condition. The origins of these peaks are that, low temperature peak seems to result from dipole, and high temperature peak from the orientation electronic trap.

• 생물환경조절학회지
• /
• 제19권3호
• /
• pp.165-170
• /
• 2010

본 연구는 감나무 생육 및 과실 특성의 연차 변이에 대한 주요 기온 요인을 알아보고자 수행하였다. 연차 변이는 3월과 4월의 평균기온, 적산일수 빛 적산온도에서 가장 컸다. 25개 기온 요인 중 제1주성분으로는 연 평균 기온 요인들 14개, 제2주성분으로는 4월 기온요인들 3개로 추출되었으며 그 누적 기여율은 52.2%이었다. 제1주성분에 양의 영향력을 크게 받은 연도는 1990년, 음의 영향력을 크게 받은 연도는 1980년과 1986년으로 나타났다. 감나무의 전엽일, 개화일 및 과실 성숙일의 연간 편차는 4.0~6.7일 범위였으며 변이계수는 개화일, 전엽일에서 개화일까지의 일수가 가장 켰다. 그리고 파실 특성 중 과중, 당도, 경도는 연차 변이가 적었으나, 종자수는 평균 4.0개, 연간 편차 1.3개, 변이계수가 32.8로 연차 변이가 가장 컸다. 감나무 생육 및 과실 특성과 기온 요인들 간 다중회귀분석 결과, 개화일에서 과실 성숙일까지의 일수는 10월의 평균기온 및 적산일수, 전엽일에서 개화일까지의 일수는 4월 평균기온, 과중은 3월 평균기온과 10월 평균기온의 영향을 가장 크게 받은 것으로 나타났다.