• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.1
• /
• pp.239-245
• /
• 2013

The temperature monitoring of power cable and cable junction point is the necessary link of the safe and reliable operation of the power system. Many kinds of cables and high voltage junction points are easy to exposed continuous vibrations and momentary impulse in industry field especially power plant industries. This system can predict the overheating of the electric cable interface and the possibility of all kinds of accident, and it helps for eliminating the hazards of electric cable interface and provides the effective guarantee for the safety operation. In order to avoid the faults of the inconvenience of installation and maintenance and the high cost of application, this system used small and contactless IR sensor module. The low power consumption is used in the system. The goal of this study is the low cost and on-line reliable monitoring of power cable and junction point temperature.

• Geophysics and Geophysical Exploration
• /
• v.18 no.3
• /
• pp.105-114
• /
• 2015

A long-term resistivity monitoring system has been developed for saturated cores in room temperature and humidity condition. A 3-channel water-pump continuously drops the water onto the top of saturated core sample surrounded by shrinkable tube as well as on the paper filters of the electrodes at both sides of the core sample, by which one can monitor the resistivity changes with maintaining full saturation of the rock core for a week or longer. Monitoring the resistivity changes has been performed with 3 kinds of rock samples including biotite gneiss, andesitic tuff, and shale for 9 days using the system. Consequently, it is proposed two hypothesis that conversion speed of temperature coefficient has close relation to the thermal properties of the rock sample and that the ratio of resistance between dry and saturated conditions for a rock sample can be related to the effective porosity of the sample. The ratio between dry and saturated resistance for the three rock types are 48, 705, and 2, while effective porosity was 3.7%, 3.3%, and 13.0%, respectively.

• The Plant Pathology Journal
• /
• v.34 no.3
• /
• pp.236-240
• /
• 2018

Crop yield is critically related to the physiological responses and disease resistance of the crop, which could be strongly affected by high temperature conditions. We observed the changes in the growth of barley under higher than ambient air-temperature conditions using a temperature gradient field chamber (TGFC) during winter and spring. Before the stem extension stage of barley growth, Cladosporium sp. spontaneously appeared in the TGFC. The severity of disease became serious under warmer temperature conditions. Further, the stomata closed as the severity of the disease increased; however, stomatal conductance at the initial stage of disease was higher than that of the normal leaves. This was likely due to the Iwanov effect, which explains that stressed plants rapidly and transiently open their stomata before longer-term closure. In this study, we tested three optical methods: soil-plant analysis development (SPAD) chlorophyll index, photochemical reflectance index (PRI), and maximum quantum yield (Fv/Fm). These rapid evaluation methods have not been used in studies focusing on disease stress, although some studies have used these methods to monitor other stresses. These three indicative parameters revealed that diseased barley exhibited lower values of these parameters than normal, and with the increase in disease severity, these values declined further. Our results will be useful in efficient monitoring and evaluation of crop diseases under future warming conditions.

• Korean Journal of Environmental Biology
• /
• v.22 no.1
• /
• pp.233-241
• /
• 2004

Chlorophyll fluorescence and antioxidative enzyme activity were investigated from leaves of Crinum asiaticum var. japonicum under the natural condition in winter, in order to monitor plant response and physiological states such as vitality, productivity and so on. In the O-J-I-P transients, the fluorescence intensity of J, I, P-step decreased remarkably depending on temperature drop in winter. The photochemical efficiencies of PSII, Fv/Fm, were significantly low in late winter with decrease of Fm. These results indicate that Crinum plants were affected by seasonal drop of temperature. The catalase activity significantly decreased depending on temperature drop in winter. However, the activity of superoxide dismutase ascorbate peroxidase and peroxidase slightly increased in winter while some isoenzymes appeared in winter. These results, with the remarkable decrease of Ev/Fm in winter, represent that Crinum plants were exposed to oxidative stress and subsequently damaged leading to cell death.

• Proceedings of the KSRS Conference
• /
• 1998.09a
• /
• pp.76-82
• /
• 1998

Increase of greenhouse gas due to $CO_2$ and CH$_4$ gases would cause the global warming in the atmosphere. According to the global circulation model, it is pointed out in the Okhotsk Sea that the large increase of atmospheric temperature might be occurredin this region by global warming due to the doubling of greenhouse effectgases. Therefore, it is very important to monitor the sea ice extents in the Okhotsk Sea. To improve the sea ice extents and concentration with more highly accuracy, the field experiments have begun to comparewith Airborne Microwave Radiometer (AMR) and video images installed on the aircraft (Beach-200). The sea ice concentration is generally proportional to the brightness temperature and accurate retrieval of sea ice concentration from the brightness temperature is important because of the sensitivity of multi-channel data with the amount of open water in the sea ice pack. During the field experiments of airborned AMR the multi-frequency data suggest that the sea ice concentration is slightly dependending on the sea ice types since the brightness temperature is different between the thin and small piece of sea ice floes, and a large ice flow with different surface signatures. On the basis of classification of two sea ice types, it is cleary distinguished between the thin ice and the large ice floe in the scatter plot of 36.5 and 89.0GHz, but it does not become to make clear of the scatter plot of 18.7 and 36.5GHz Two algorithms that have been used for deriving sea ice concentrations from airbomed multi-channel data are compared. One is the NASA Team Algorithm and the other is the Bootstrap Algorithm. Intrercomparison on both algorithms with the airborned data and sea ice concentration derived from video images bas shown that the Bootstrap Algorithm is more consistent with the binary maps of video images.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2011.02a
• /
• pp.105-105
• /
• 2011

ZnO is a promising material since it could be applied to many fields such as solar cells, laser diodes, thin films transistors and gas sensors. ZnO has a wide and direct band gap for about 3.37 eV at room temperature and a high exciton binding energy of 60 meV. In particular, ZnO features high sensitivity to toxic and combustible gas such as CO, NOX, so on. The development of gas sensors to monitor the toxic and combustible gases is imperative due to the concerns for enviromental pollution and the safety requirements for the industry. In this study, we investigated the effect of substrate temperature and post-annealing on structural and electrical properties of ZnO thin films. ZnO thin films were deposited by pulsed laser deposition (PLD) at various temperatures at from room temperature to $600^{\circ}C$. After that, post-annealing were performed at $600^{\circ}C$. To inspect the structural properties of the deposited ZnO thin films, X-ray diffraction (XRD) was carried out. For gas sensors, the morphology of the films is dominant factor since it is deeply related with the film surface area. Therefore, the atomic force microscopy (AFM) and field emission scanning electron microscopy (FE-SEM) were used to observe the surface of the ZnO thin films. Furthermore, we analyzed the electrical properties by using a Hall measurement system.

• Journal of the Institute of Convergence Signal Processing
• /
• v.7 no.1
• /
• pp.33-37
• /
• 2006

In this paper, we present a centralized monitoring system for infant incubator using Bluetooth. Conventional monitoring systems for incubators require large space and wire connection, which causes the spatial restrictions. To overcome this disadvantage, centralized monitoring system is proposed for infant incubators using Bluetooth. The implemented system consists mainly of transmission systems and receiver systems. There are temperature sensors, humidity sensors, ECG measurement units and Bluetooth modules in the transmission systems. For temperature, humidity and ECG data, the transmission systems acquire them from the measuring modules in the incubator and transmits the signals using Bluetooth. In the receiver system, users can see the status of the infant by accessing the central monitoring host computer. That is, one can monitor the information on the temperature and the humidity in the incubator and Infant's ECG without dependence to a conventional bulky system. Also, the system manager in the receiver system can maintain centralized monitoring of the situations in all incubators and infant. The developed system will be useful in remote diagnosis of infant incubator In various environments.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.33 no.6
• /
• pp.1068-1073
• /
• 2004

Response surface methodology (RSM) was used to monitor characteristics of hot water extracts from Hericium erinaceus. A central composite design was applied to investigate the effects of independent variables, extraction temperature (X$_1$), sample ratio (X$_2$) and extraction time (X$_3$) on dependent variables such as soluble solid (Y$_1$), total phenols (Y$_2$), crude protein (Y$_3$) and electron donating ability (Y$_4$) of the extracts. As the sample ratio increased, the soluble solid content increased, while extraction temperature played a minor role. As a whole total phenols and crude protein contents increased with increasing the sample ratio. Electron donating ability increased in proportion to extraction temperature and sample ratio, which didn't increase at certain period. Then ranges of optimum extraction conditions for maximized physicochemical properties were 91.5∼96.5$^{\circ}C$ in extraction temperature and 3.5∼4.2 g/100 mL in sample ratio. Predicted values at the optimized conditions were coincident with experimental values.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.26 no.4
• /
• pp.654-661
• /
• 1997

Response surface methodology was applied to monitor dynamic changes in free sugars and free amino acids associated with browning reaction during roasting of Polygonatum odoratum roots. Second-order model for qualities of water- soluble extracts was employed to generate contour maps and response surfaces. Browning color intensity of water-soluble extracts was increased with the roasting time up to around 14$0^{\circ}C$, but decreased in increasing temperature above L6O"C. Free sugars, mainly composed of sucrose and fructose, were remarkably decreased at roasting under the higher temperature and longer time, while glucose linearly increased with the increase of roasting temperature up to 15$0^{\circ}C$. Most of free amino acids was decreased in their amounts in Proportion to the roasting temperature and time, while threonine and lysine were insignificantly increased under the roasting conditions at above 17$0^{\circ}C$ and 60min.0min.

• Journal of Biosystems Engineering
• /
• v.43 no.4
• /
• pp.426-439
• /
• 2018

Purpose: To continuously monitor soil and climatic properties, a data acquisition system (DAQ) was developed and tested in plum farms (Gyewol-ri and Haechang-ri, Suncheon, Korea). Methods: The DAQ consisted of a Raspberry-Pi processor, a modem, and an ADC board with multiple sensors (soil moisture content (SEN0193), soil temperature (DS18B20), climatic temperature and humidity (DHT22), and rainfall gauge (TR-525M)). In the laboratory, various tests were conducted to calibrate SEN0193 at different soil moistures, soil temperatures, depths, and bulk densities. For performance comparison of the SEN0193 sensor, two commercial moisture sensors (SMS-BTA and WT-1000B) were tested in the field. The collected field data in Raspberry-Pi were transmitted and stored on a web server database through a commercial communications wireless network. Results: In laboratory tests, it was found that the SEN0193 sensor voltage reading increased significantly with an increase in soil bulk density. A linear calibration equation was developed between voltage and soil moisture content depending on the farm soil bulk density. In field tests, the SEN0193 sensor showed linearity (R = 0.76 and 0.73) between output voltage and moisture content; however, the other two sensors showed no linearity, indicating that site-specific calibration is important for accurate sensing. In the long-term monitoring results, it was observed that the measured climate temperature was almost the same as website information. Soil temperature information was higher than the values measured by DS18B20 during spring and summer. However, the local rainfall measured using TR 525M was significantly different from the values on the website. Conclusion: Based on the test results obtained using the developed monitoring system, it is thought that the measurement of various parameters using one device would be helpful in monitoring plum growth. Field data from the local farm monitoring system can be coupled with website information from the weather station and used more efficiently.