• 한국태양에너지학회:학술대회논문집
• /
• 한국태양에너지학회 2011년도 춘계학술발표대회 논문집
• /
• pp.25-30
• /
• 2011

In this paper, we analyzed the electrical characteristics with Micro-cracks in Photovoltaic module. Micro cracks are increasing the breakage risk over the whole value chine from the wafer to the finished module, because the wafer or cell is exposed to mechanical stress. And The solar cells have to with stand the stress under out door operation in the finished module. Here the mechanical stress is induced by temperature changes and mechanical loads from wind and snow. So, we experimentally analyze the direct impact of micro-cracks on the module power and the consequences after artificial aging. The first step, we made micro-cracks in PV module by mechanical load test according to IEC 61215. Next, PV modules applied the thermal cycling test, because micro-cracks accelerated aging by thermal cycling test, according to IEC61215. Before every test, we checked output and EL image of PV module. As the result of first step, we detected little power loss(0.9%). But after thermal cycling test increased power loss about 3.2%.

• 대한전기학회논문지:전기물성ㆍ응용부문C
• /
• 제53권6호
• /
• pp.293-299
• /
• 2004

In this paper, thermal and mechanical properties of electric epoxy with water aging were discussed. We made elastic epoxy specimen adding a ratio of 0〔phr〕20〔phr〕, 35〔phr〕 and 53〔phr〕 with modifier to existing epoxy. We studied mechanical property of elastic resin after absorption in water from 0 to 484 hours. As a result, diffusion factor of elastic epoxy showed 20-21${\times}$10$^{-4}$ $\textrm{mm}^2$/s and general epoxy showed 9.5${\times}$10$^{-4}$ $\textrm{mm}^2$/s. Elastic property increased linearly according to addiction and decreased according to water absorption. Tensile strength was reduced according to addition. It was affected by water absorption of micro-void of elastic epoxy. Hardness inclined to decrease after increasing according to absorbed time. In water-absorption state, it was experimented a change of heat flow by temperature of elastic epoxy and change of thermal expansion coefficient. DSC (Differential Scanning Calorimetry) and TMA (Thermomechanical Analysis) equipments were used to measure Tg. A temperature ringe of DSC was from -0($^{\circ}C$) to 200($^{\circ}C$). One of TMA was from -0($^{\circ}C$) to 350($^{\circ}C$). In addition, we investigated structural analysis of water absorbed specimen using SEM (Scanning Electron Microscope).

• 한국전기전자재료학회논문지
• /
• 제29권1호
• /
• pp.17-22
• /
• 2016

The activation energy of a material is an important factor that significantly affects the lifetime and can be used to develop a degradation model. In this study, a thermal analysis was carried out to evaluate and collect quantitative data on the degradation of insulation materials like EPR and CSP used for nuclear power plant cables. The activation energy was determined from the relationship between log ${\beta}$ and 1/T based on the Flynn.Wall.Ozawa method, by a TGA test. The activation energy was also derived from the relationship between ln(t) and 1/T based on isothermal analysis, by an OIT test. The activation energy of EPR derived from thermal analysis was used to calculate the accelerated aging time corresponding to the number of years of use, employing the Arrhenius equation, and determine the elongation corresponding to the accelerated aging time.

• 대한기계학회논문집A
• /
• 제38권12호
• /
• pp.1431-1434
• /
• 2014

가스터빈에 적용되는 열차폐코팅은 가동 중 반복적인 열피로에 의하여 파손되므로, 열차폐코팅의 내구성평가가 필요하다. 고온 환경에 노출된 열차폐코팅의 내부에는 열생성산화물(TGO)이 성장하게 되는데, 이러한 열생성산화물(TGO)의 성장은 열차폐코팅의 주요 파손 원인으로 알려져 있다. 따라서 TGO의 성장을 고려한 열차폐코팅의 내구성평가는 반드시 선행되어야 하는 연구이다. 본 연구에서는 김대진등의 연구 결과로부터 열화시간에 따른 TGO 성장을 고려하여 유한요소해석을 수행하였으며, 이로부터 응력과 열화시간 사이의 관계를 도출하였다. 또한 열화시간에 따른 유한요소해석 결과와 김대진 등의 접착강도 시험 결과의 비교를 통하여 열차폐코팅의 내구성을 평가하였다.

• 한방안이비인후피부과학회지
• /
• 제37권1호
• /
• pp.17-28
• /
• 2024

Objectives : This study was conducted to reveal the scientific mechanism of the anti-skin aging activity of Kyung-Ok-Ko(KOK), which is highly useful as a Korean traditional medicine and functional food. Methods : The skin wrinkle and aging inhibitory activity of KOK was confirmed through in vitro experiments of human dermal fibroblast neonatal cell(HDFn) and in vivo of C. elegans, and hairless mouse(SKH-1). Results : The amount of the C-terminus of the collagen precursor in the HDFn cell culture medium treated with KOK using an enzymes-linked immunoassay kit. The group treated with KOK 200㎍/㎖ was a 28.3% increase of collagen precursor compared to the control group. KOK showed inhibitory activity of MMP-1 compared to the control group at a concentration of 200㎍/㎖. In addition, KOK 200㎍/㎖ showed significant inhibitory activity of thermal stress and an oxidative stress compared to the control group in C. elegans. Furthermore, KOK showed a concentration-dependent(100mg/kg and 500mg/kg) anti-wrinkle formation effect in UV-irradiated hairless mouse(SKH-1). Additionally, when KOK was administered to UV-irradiated hairless mice, an increase in procollagen -1 and -3 genes expression was observed, and mmp-1 and mmp-9 genes, which increase collagen decomposition, decreased with the administration of KOK. Conclusions : The skin aging inhibition mechanism of Kyung-Ok-Ko(KOK) is presumed to be achieved through suppressing thermal stress and oxidative stress, suppressing mmp-1 and mmp-9 genes, and increasing procollagen-1 and procollagen-3.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2003년도 춘계학술대회 논문집 센서 박막재료 반도체 세라믹
• /
• pp.204-207
• /
• 2003

The flip chip bonding utilizing self-aligning characteristic of solder becomes mandatory to meet to tolerances for the optical device. In this paper, a parametric study of aging condition and pad size of sample was conducted. A TiW/Cu UBM structure was adopted and sample was aging treated to analyze the effect of intermetallic compound with time variation. After aging treatment, the tendency to decrease in shear strength was measured and the structure of the fine joint area was observed by using SEM, TEM and EDS. In result, the shear strength was decreased of about 20% in the $100{\mu}m$ sample at $170^{\circ}C$ aging compared with the maximum shear strength of same pad size sample. In the case of the $120^{\circ}C$ aging treatment, 17% of decrease in shear strength was measured at the $100{\mu}m$ pad size sample. Also, intremetallic compound of $Cu_6Sn_5$ and $Cu_3Sn$ were observed through the TEM measurement by using an FIB technique that is very useful to prepare TEM thin foil specimens from the solder joint interface.

• 대한기계학회논문집A
• /
• 제20권5호
• /
• pp.1372-1381
• /
• 1996

As recieved boiler tuve steel was aged artificially at $650^{\circ}C$ and$690^{\circ}C$ for various time duration to simulate the material deterioration which could be occurred during the operation of fossiol power plants. And the tensile tests, the microhardness tests and the characterization of carbides formed in the aging process were performed to asses the relationship between the mechanical properties and the effect of thermal aging. Furthernore, the amout of Mo-rich carbide were investigated by ondestructive method by noticing the fact that formation of Mo-rich carbide were investigated by ondestructive melthod by noticing the fact that formation of Mo-rich carbides($Mo_6C$) which stabilizes lastly affects the mechanical properties. It was known that the microhardness results of service exposed materials were similar to the ones which are aged at $650^{\circ}C$. The room temperature measurement showed small variation in the yield points and ultimate strength in materials aged at $650^{\circ}C$. Those properties at $540^{\circ}C$ showed the abrupt decrease compared with as received material even if short aging time. And it was found that $650^{\circ}C$ $690^{\circ}C$ aging cause different effects on mechanical properties, although the temperature time parameters(LMP;Larson-Miller parameter) are same. And it was concluded that the aigng at $650^{\circ}C$ is more appropriate to simulate the service exposed condition. Finally, the relationship between high temperature tensile properties and Ip values were established, which offers a potential way of reliability tests onthe power plant components.

• Composites Research
• /
• 제22권3호
• /
• pp.35-43
• /
• 2009

본 연구에서는 카본블랙이 충전된 ethylene-propylene dine monomer(EPDM) 고무에 대한 가교밀도 측정법을 확립하고 EPDM 고무호스에 대해 열가속 및 산소스트레스를 가하여 가교밀도 변화를 측정하였다. 노화 초반에는 산화황가교의 형성으로 고무의 가교밀도측정값이 약간 저하하였다가 노화시간이 지남에 따라 일부 미반응 황 분자들의 가황반응으로 추가적인 가교 결합을 형성하면서 가교밀도측정값은 점차 증가하였다. 이들 가교밀도 변화거동은 인장강도의 거동과 유사하였다. $180^{\circ}C$의 고온노화에서는 노화시간이 길어짐에 따라 노화에 따른 가교밀도의 증가폭은 그다지 크지 않았으나, 인장강도와 신장률은 크게 저하하였다. 즉, 온도가 높을 수록 EPDM 고무의 가교밀도의 변동보다는 EPDM 분자사슬에서의 산화물(carbonyl groups) 형성과, 가교점의 산화황 생성으로 기계적 물성의 열화가 일어난 것이다.

• 한국추진공학회지
• /
• 제26권4호
• /
• pp.28-43
• /
• 2022

고에너지 물질의 노화로 인하여 성능 감소를 최소화하기 위해 현재 노화 연구가 활발하게 진행되고 있지만, 개별 재료에 집중한 연구가 대부분이며 일반적인 노화 메커니즘 파악에는 미흡한 상태이다. 본 연구에서는 이러한 맹점을 해결하기 위해서 금속(W, Ti, Zr)과 KClO₄ 산화제를 기반으로 하는 고에너지 물질에 대하여 열/표면 분석을 수행하였으며, 이를 통해 고습도-고온 조건하에 노화된 해당 물질에서 보인 열역학적 특성 및 화학반응인자의 변화를 확인하였다. 그 결과, 금속 원소의 상태가 화학반응인자의 상당한 변화를 결정하였다. 즉, 금속의 산화 및 산화막 두께의 증가는 활성화에너지 평균값의 상승을 초래하였으며, 금속 원자의 전기음성도는 활성화에너지 값의 표준편차의 변화를 이끌어냈다.

• 대한기계학회논문집
• /
• 제18권3호
• /
• pp.670-680
• /
• 1994

The thermophysical properties of Non-Newtonian fluid as the function of the temperature and the concentration are needed in many rheological heat transfer and fluid mechanics problems. The present work investigated the effects of the concentration and the temperature on the thermophysical properties of purely-viscous Non-Newtonian fluids such as the isobaric thermal expansion coefficient, density, zero-shear-rate viscosity, and zero-shear-rate dynamic viscosity within the experimental temperature range from $25^{\circ}C$ to $55^{\circ}C$. The densities of the test fluids were determined as the function of the temperature by utilizing a reference density and the least square equation for the measured isobaric thermal expansion coefficient. As the concentration of purely-viscous Non-Newtonian fluid was increased up to 10,000 wppm, the densities were proportionally increased up to 0.4%. The zero-shear-rate viscosities of test fluids were measured before and after the measurements of the first thermal expansion coefficients and the densities of Non-Newtonian fluid. Even though they were changed up to approximately 22% due to thermal aging and cycling, they had no effects on the thermal expansion coefficients and the densities of Non-Newtonian fluid. The zero-shear-rate dynamic viscosities for purely-viscous Non-Newtonian fluids were compared with the values for distilled water. They showed the similar trend with the zero-shear-rate viscosities due to small differences in the densities for both distilled water and purely-viscous Non-Newtonian fluid.