• Journal of the Korean Society of Clothing and Textiles
• /
• v.12 no.1 s.26
• /
• pp.81-91
• /
• 1988

The purpose of this study is to investigate the physiolosical responses and subjective wear sensation to the clothes with different cellulose composition. The experimental garments were four types of cellulosic fabrics, respectively composed of $100\%$-cotton, $100\%$-Rayon, cotton/Flax 85/15, and rayon/Flax 85/15 (weft blended), were sewn in blouses with half-length sleeves. Four healthy women were chosen for this experiment. The condition of the experimental room were in two environments: Temp., $25{\pm}1^{\circ}C$, R.H. $60{\pm}3\%$ and Temp., $30{\pm}1^{\circ}C$, R.H. $70{\pm}3\%$, and air velocity was maintained at 0.25 m/sec. The results are as follows. 1) At $25^{\circ}C$, rayon blouse showed the pleasantest feeling because of its excellent humidity sensation and tactile sensation. At $30^{\circ}C$, rayon and flax blended blouse showed most comportable sensation. In both environments, blouse of $100\%$ cotton showed the least pleasant because of high vapor pressure inside the blouse and bad tactile sensation. 2) Vapor pressure inside the blouse and tactile sensation play the most impotant role in comfort. Consequantly the blouse made of $100\%$-cotton which bring low air permeability, moisture regain and water vapor permearbility showed more unpleastness than rayon blouse because it raises temperature, relative humidity and vapor pressure inside the blouse under the hot circumstances In the conditions with much sweat, rayon and flax blended blouse with high stiffness increases comfort better than $100\%$ rayon because the former prevents sticking to the skin.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.23 no.5
• /
• pp.523-531
• /
• 2020

Extraction and anti-solvent crystallization were proposed to recover octahydro-1,3,5,7-tetranitro-1,3,5,7-tetrazocine (HMX) from pressed polymer bonded explosives(PBXs). DXC-57 and DXC-59, whose polymeric binders are Estane and HyTemp with dioctyl adipate plasticizer, respectively, were used as pressed PBX models. Estane of DXC-57 was removed by washing with tetrahydrofuran prior to extraction, which enabled the crystallization of HMX at a low degree of supersaturation, sufficient to obtain β-form HMX. Using dimethyl sulfoxide and ethanol as the extraction solvent and the anti-solvent for crystallization, respectively, HyTemp and dioctyl adipate in DXC-59 were separated from HMX. The purity of recovered β-form HMX was higher than 99 %.

• Journal of Fisheries and Marine Sciences Education
• /
• v.29 no.3
• /
• pp.702-710
• /
• 2017

Recently, in many reptiles (14 genera of turtles in five families), common characteristics of incubation temperatures are known to determine the sexes of hatchlings in many species of turtles, including the map turtles, painted turtles and snapping turtles, emys turtle, etc. According to many researcher's reports, in general, incubation at $25^{\circ}C$ (cooler temperatures) produces all or mostly males, however, incubation at $31^{\circ}C$ (higher temperatures) or higher produces all or mostly females. Exceptionally, even cooler temperature ($20^{\circ}C$) produce females, they produced all or mostly females. Accordingly, it is well-known that incubation temperature is the sex determining agent in these turtles. However, this paper presents study of the sex ratio and nest ecology in natural spawning nest: Observations on hatching sex ratios of eggs collected from natural nests of T. sinensis are similar to a previous report of the same genus Trionyx in the soft-shelled turtles. However, this genus (or species) showed some different phenomena to other kinds of turtles such as various kinds turtles mentioned above. After collection of naturally spawned eggs (17 eggs of T. sisnensis) on the natural nests, a laboratory experiment by the constant incubation temperatures was conducted with natural fluctuating soil temperatures in the natural nest with the soft-shelled turtle, T. sinensis. And also laboratory experiments were conducted using constant incubation temperatures of $25^{\circ}C$ (cooler temp.) and $30^{\circ}C$ (higher temp.) with the turtle, T. sinensis. Exceptionally, it was confirmed that the first and second incubation temperatures can't control sex-determination in the freshwater soft-shelled turtle, T. sinensis. The sex ratio approximated 1:1 (${\chi}^2=0.06$, P>0.05 (the Ist experiment). And the sex ratio approximated 1:1 independently of incubation temperature (${\chi}^2=0.33$, P>0.05 (the 2nd experiment). Consequently, temperature has no effect on sex determination in the genus Trionyx in a soft-shelled turtle.

• Korean Journal of Agricultural Science
• /
• v.41 no.4
• /
• pp.291-298
• /
• 2014

Plastic film houses are directly associated with increases in plant growth and yield of vegetable crops through a year round cultivation, however, at the same time temperature stresses are one of fates which are difficult to avoid during crop growth. The objective of this study was to examine the translocation and distribution of minerals (N, P, K) and carbohydrates as well as seasonal fluctuation of mineral uptake and carbohydrate production in cucumber plant grown under moderately high temperature. The temperature treatments consisted of 2-layers film houses (optimal temp.) and 3-layers (high temp.). Shoot growth of cucumber plants were linearly increased until 14 weeks after transplanting (WAT) without any significant difference between both temperatures, and the slowdown was observed from 16 WAT. The level of soluble sugar and starch was slightly greater in optimal temperature compared to the high. Cumulative accumulation of soluble sugar was significantly different before and after 12 WAT in both treatments, whereas starch level represented a constant increase. Monthly production of soluble sugar reached the peak between 12 to 16 WAT, and starch peaked between 4 to 8 WAT and 12 to 16 WAT. Total uptake of N, P and K in optimal and high temperature conditions was $18.4g\;plant^{-1}$ and 17.6 for N, 4.7 and 5.1 for P, and 37.7 and 36.2 for K, respectively, and the pattern of monthly N uptake between optimal and high temperatures was greater in early growth stage, whereas was greater in mid growth stage in both P and K. Thus, this study suggests that moderately high temperature influences much greater to photosynthesis and carbohydrate production than plant biomass and mineral uptake. On the basis of the present result, it is required to indentify analysis of respiration rates from plant and soil by constantly increasing temperature conditions and field studies where elevated temperatures are monitored and manipulated.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.19 no.6
• /
• pp.703-711
• /
• 2016

The purposes of this study is to identify the problems arising from current Test & Evaluation process of the naval ship acquisition program and to suggest methods to increase the acquisition efficiency. Considering that the present rule of developmental test &evaluation(DT&E) and operational test & evaluation(OT&E) has caused an inefficiency effect on the acquisition procedures due to the limited practices on it, the DT&E and OT&E procedures through test & evaluation master plan(TEMP) is proposed based on the selective practices of the defense instruction articles. Also, considering characteristics of naval ship acquisitions, efficient procedure systems are derived through case analysis results by comparing each performances of the system. The suggested methods are able to meet the requirements of the changed acquisition environments and also increase efficiency of acquisition systems by adoption of DT&E and OT&E combined test scheme.

• Journal of IKEEE
• /
• v.20 no.2
• /
• pp.205-208
• /
• 2016

In this paper, different types of touch screen silver pastes for bonding in conductive pattern formed over the ito film by bonding each sample of 5 was dried. The dry conditions, the oxidation of the ito film is a condition that does not occur. Reliability testing constant temp and humidity, cold-hot impact test is in progress. Each test will check the status of five sheets conductive pattern bonding. Conductive pattern bonding, after each 240,480,615 hours to check the status of silver pattern bonding. Reliability testing these through different silver pastes can see that the change in the adhesion and conductivity deterioration of the quality can be prevented, and reliability testing low temperature curing from the surface of silver pastes that can come as soon as the discoloration was unknown.

• Applied Chemistry for Engineering
• /
• v.29 no.3
• /
• pp.270-277
• /
• 2018

The adsorption of Eosin Y by the activated carbon (WCAC) prepared from waste citrus peel was investigated by using response surface methodology (RSM) and Box-Behnken design (BBD) statistical procedures. Experiments were carried out as per BBD with three input parameters, the Eosin Y concentration (Conc. : 30~50 mg/L), the solution temperature (Temp. : 293~313 K), and the adsorbent dose (Dose : 0.05~0.15 g/L). Regression analysis showed a good fit of the experimental data to the second-order polynomial model with coefficients of the determination ($R^2$) value of 0.9851 and P-value (Lack of fit) of 0.342. An optimum dye uptake of 59.3 mg/g was achieved at the dye concentration of 50 mg/L, the temperature of 333 K, and the adsorbent dose of 0.1056 g. The adsorption process of Eosin Y by WCAC can be well described by the pseudo second order kinetic model. The experimental data followed the Langmuir isotherm model.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.28 no.2
• /
• pp.131-136
• /
• 1995

An attempt was made to elucidate the stability of serum metabolites and enzyme activities in blood samples taken from rockfish(Sebastes schlegeli), Israeli carp(Cyprinus carpio) and rainbow trout Oncorhynchus mykiss) under different storing conditions. The concentrations of total protein(TP), albumin(ALB), triglyceride(TG), cholesterol(CHOL) glucose(GLC), phosphorus(P) and sodium(Na), and the activities of alanine aminotransferase(ALT) and aspartate aminotransferase(AST) in serum were investigated for 16 days at $15^{\circ}C$(room temp.) and $4^{\circ}C$ (refrigerative) condition, or frozen at $-20^{\circ}C$ for period of 30 days. Though there was a little difference between fish species, the concentrations of TP, ALB, GLC, P, Na in serum were stable at all storing temperatures, while those of TG, CHOL, ALT and AST were not stable, particularly even at the normal temperature. In general, serum components were more stable at refrigerative and frozen conditions than at room temp. storing. However, it was noticeable that the stability of CHOL in rockfish serum was found to be more unstable at $-20^{\circ}C$ than kept at $15^{\circ}C$ or$4^{\circ}C$.

• Transactions of Materials Processing
• /
• v.27 no.5
• /
• pp.281-288
• /
• 2018

This study deals with the microstructure and tensile properties of 600 and 700 MPa-grade high-strength seismic reinforced steel bars. High-strength seismic resistant reinforced steel bars (SD 600S and SD 700S) were fabricated by TempCore process, especially the SD 700S specimen was more rapid cooled than the SD 600S specimen during the TempCore process. Although two specimens had microstructure of tempered martensite in the surface region, the SD 600S specimen had ferrite-degenerated pearlite in the center region, whereas the SD 700S specimen had bainite-ferrite-degenerated pearlite in the center region. Therefore, their hardness was highest in the surface region and revealed a tendency to decrease from the surface region to the center region because tempered martensite has higher hardness than ferrite-degenerated pearlite or bainite. The SD 700S specimen revealed higher hardness in the center region than SD 600S specimen because it contained a larger amount of bainite as well as ferrite-degenerated pearlite. On the other hand, tensile test results indicated the SD 600S and SD 700S specimens revealed continuous yielding behavior because of formation of degenerated pearlite or bainite in the center region. The SD 600S specimen had a little higher tensile-to-yield ratio because the presence of ferrite and degenerated pearlite in the center region and the lower fraction of tempered martensite enhance work hardening.

• Journal of the Korean housing association
• /
• v.17 no.5
• /
• pp.9-16
• /
• 2006

The researches on the environmental friendly buildings have carried out on the materials, environmental property, technical elements and etc., and various buildings with these green materials have built and under construction nowadays and became a new trend of the green building. And recently, new building technique which builds the wall with the soil and wood and very easy to construct (called M Earthen House) was introduced as the green building and rapidly propagated. But the research on the indoor climatic characteristics, the ability to control the environmental comfort and the influence to the human beings of these buildings are not sufficiently identified yet. In this paper, the indoor environmental characteristics and the temperature controlling ability of these buildings in summer season were measured and analysed by the Portable Indoor Air Quality Monitor(BABUC/A, LSI) measuring equipments, ana the subjective test on the thermal environment of the subjects were carried out to evaluate the thermal comfort. The results can be summarized as follows; 1) Compared to the outdoor dry bulb temp.($15.4{\sim}28.7^{\circ}C$), the indoor temp. was $19.5{\sim}26.8^{\circ}C$. It showed the temperature controlling ability of the M earthen house was outstanding. And the indoor relative humidity, compared to the outdoor($45.4{\sim}100%$), was $58.1{\sim}76.4%$, it showed the humidity controlling ability of the M earthen house was also outstanding. 2) The thermal environment was evaluated as 'comfort'(neutral-slightly warm) and the humidity was also evaluated as 'comfort'(neutral-slightly humid). So, the results of the physical and subjective evaluation on the indoor thermal comfort in summer season were 'neutral' and 'comfort' coincidently, it was confirmed that the controlling ability of the indoor temperature and humidity of the M earthen house was very excellent.