• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.24 no.8
• /
• pp.605-611
• /
• 2012

The objective of this study is to investigate the influence of the cooling performance for a water-to-water 10 RT ground source heat pump by using the water switching and refrigerant switching method. The test of water-to-water ground source heat pump was measured by varying the compressor speed, load side inlet temperature, and ground heat source side temperature. The cooling capacity and refrigerant mass flow rate of the heat pump increased with increasing ground heat source temperature. But COP of the heat pump decreased with increasing ground heat source temperature. As a result, the water switching method with counter flow, compared to a refrigerant switching method, improves the cooling capacity and COP by approximately 6~9% in average, respectively.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2008.11a
• /
• pp.337-338
• /
• 2008

We have studied electro-optic characteristics of a high performance liquid crystal display using Fringe In-plane field Switching (FIS) mode. The strong electric fields cause more liquid crystals to reorient almost in plane above and between the pixel electrodes. As a result, the operation voltage is lower and transmittance is higher than those of Fringe Field Switching (FFS) and In-Plane Switching (IPS) modes. Apparently, the transmittance depends on voltage applied at the configurations of FIS mode which are proposed. Therefore, we have studied certain length of between electrodes for maximum transmittance and light intensity.

• Journal of Power Electronics
• /
• v.6 no.2
• /
• pp.95-103
• /
• 2006

In this paper, a novel prototype of auxiliary switched capacitor assisted voltage source soft switching PWM Single-Ended Push Pull (SEPP) series capacitor compensated load resonant inverter with two auxiliary edge resonant lossless inductor snubbers is proposed and discussed for small scale consumer high-frequency induction heating (IH) appliances. The operation principle of this inverter is described by using switching mode equivalent circuits. The newly developed multi resonant high-frequency inverter using trench gate IGBTs can regulate its output AC power via constant frequency edge-resonant associated soft switching commutation by using an asymmetrical PWM control or duty cycle control scheme. The brand-new consumer IH products which use the newly proposed edge-resonant soft switching PWM-SEPP type series load resonant high-frequency inverters are evaluated using power regulation characteristics, actual efficiency vs. duty cycle and input power vs. actual efficiency characteristics. Their operating performance compared with some conventional soft switching high-frequency inverters for IH appliances is discussed on the basis of simulation and experimental results. The practical effectiveness of the newly proposed soft switching PWM SEPP series load resonant inverter is verified from an application point of view as being suitable for consumer high-frequency IH appliances.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.8 no.1
• /
• pp.66-79
• /
• 2008

Several oxides have recently been reported to have resistance-switching characteristics for nonvolatile memory (NVM) applications. Both binary and ternary oxides demonstrated great potential as resistive-switching memory elements. However, the switching mechanisms have not yet been clearly understood, and the uniformity and reproducibility of devices have not been sufficient for gigabit-NVM applications. The primary requirements for oxides in memory applications are scalability, fast switching speed, good memory retention, a reasonable resistive window, and constant working voltage. In this paper, we discuss several materials that are resistive-switching elements and also focus on their switching mechanisms. We evaluated non-stoichiometric polycrystalline oxides ($Nb_2O_5$, and $ZrO_x$) and subsequently the resistive switching of $Cu_xO$ and heavily Cu-doped $MoO_x$ film for their compatibility with modem transistor-process cycles. Single-crystalline Nb-doped $SrTiO_3$ (NbSTO) was also investigated, and we found a Pt/single-crystal NbSTO Schottky junction had excellent memory characteristics. Epitaxial NbSTO film was grown on an Si substrate using conducting TiN as a buffer layer to introduce single-crystal NbSTO into the CMOS process and preserve its excellent electrical characteristics.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.48 no.12
• /
• pp.777-784
• /
• 1999

Since the ultra-high voltage power apparatus are recommended to withstand switching surge generated from the electric power system, the switching impulse voltage is generally used to verify this requirement at the testing laboratories. Recently, the international standard(IEC 60060-2) related to the high voltage measurement techniques is revised requiring a traceability of measuring system for high voltage measurements. In this paper, a reference divider for switching impulse voltage is developed satisfying the revised. IEC standard and the possibility of applications has been investigated. Therefore, the characteristics of the high and low voltage side resistor and the shielding ring have been analyzed including the step response characteristics of the prototype divider. Throughout various efforts, it is confirmed that our measuring device has shown compatible characteristics as a reference divider.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.20 no.4
• /
• pp.313-320
• /
• 2015

This study deals with a bidirectional interleaved soft switching DC-DC converter for a wide range of input voltages. The proposed converter operates in complementary switching with the purpose of inductor size reduction and zero-voltage switching (ZVS) operation. The current ripple related to complementary switching is minimized by three-phase interleaved operation. The main characteristics of the proposed topology are its soft-switching method of operation and its simple structure. The soft-switching operation and the system efficiency of the proposed converter are verified by experimental results.

• The Journal of the Korea Contents Association
• /
• v.16 no.4
• /
• pp.301-312
• /
• 2016

The purpose of this study is the findings of the effects of the experiential consumption characteristics in the hotel business on customers' revisiting and switching Intention. Also, this study is to examine revisiting and switching intention in accordance with visit frequency. For this study, the author analyzed empirically 534 copies of questionnaires. The first finding of this study discovered that playfulness, symbolism, usefulness and aesthetics had positive effects on revisiting intention. Second, symbolism, usefulness and aesthetics had negative effects on switching intention. Especially, symbolism had more significant effect on revisiting and switching intention than other variables. And finally, visit frequency had moderating effects between the experiential consumption characteristics and revisiting intention, switching intention. The hotel companies are possible to obtain several strategic implications on the basis of this empirical results.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.8 no.1
• /
• pp.145-164
• /
• 2014

Network virtualization provides a promising tool to allow multiple heterogeneous virtual networks to run on a shared substrate network simultaneously. A long-standing challenge in network virtualization is the Virtual Network Embedding (VNE) problem: how to embed virtual networks onto specific physical nodes and links in the substrate network effectively. Recent research presents several heuristic algorithms that only consider single topological attribute of networks, which may lead to decreased utilization of resources. In this paper, we introduce six complementary characteristics that reflect different topological attributes, and propose three topology-aware VNE algorithms by leveraging the respective advantages of different characteristics. In addition, a new KS-core decomposition algorithm based on two characteristics is devised to better disentangle the hierarchical topological structure of virtual networks. Due to the overall consideration of topological attributes of substrate and virtual networks by using multiple characteristics, our study better coordinates node and link embedding. Extensive simulations demonstrate that our proposed algorithms improve the long-term average revenue, acceptance ratio, and revenue/cost ratio compared to previous algorithms.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.17 no.6
• /
• pp.86-92
• /
• 1980

This paper dealt with an oscillator which can be integrated and 1 he switching characteristics of the transistor as a component of multistage switching circuits . The switching characteristics were analyzed by utilizing the base voletare and the charactistics of the minit step function. Taking the storage time of the transistor into consideration, the transistor is considered as a time delay device, and an integrable time delay circuit an osicillator are realized.

• Proceedings of the KIEE Conference
• /
• 1998.07f
• /
• pp.2039-2041
• /
• 1998

In this paper, Operation characteristics of the active clamp(ACL) zero-voltage-switching(ZVS) forward converter(FC) and active clamp hard- switching(HS) forward converter are compared with respect to loss analysis. The losses of semiconductor (including conduction losses and switching losses), transformer(containing the core loss and copper loss) and parasitic element of passive element (capacitor, inductor) are measured and compared for each type. For an experiment we have built 50W ACL ZVS-FC and ACL HS-FC, in which the switching frequency is 200kHz, and test it. The experimental results show that both types of operation have nearly same characteristics.