• Journal of Communications and Networks
• /
• 제10권4호
• /
• pp.430-436
• /
• 2008

Recent studies have convinced that network coding can improve the performance of live media streaming in terms of startup delay, resilience to peer dynamics, as well as reduced bandwidth cost on dedicated streaming servers. However, there still exist some strategy drawbacks and neglected problems which need to be further researched. In addition to the commonly used evaluation parameters of the network and user experiences mentioned above, we focus on additional key factors, playback lag and switch lag, which have not been fully explored in previous work. In this paper, we present SonicStream, a novel and fully implemented live peer to peer (P2P) media streaming system with consideration of rich user experiences, including startup delay, playback continuity, playback lag, switch lag, etc. In pursuit of a further enhanced user experience, we revise traditional peer selection/data scheduling methods. Through a series of experimental evaluations and a cautious comparison with the latest similar work $R^2$, the superior performance of SonicStream has been preliminarily verified.

• Journal of Power Electronics
• /
• 제7권2호
• /
• pp.109-117
• /
• 2007

In this paper, a novel proposal for a utility-interactive three-phase soft commutation sinewave PWM power conditioner with an auxiliary active resonant DC-link snubber is developed for fuel cell and solar power generation systems. The prototype of this power conditioner consists of a PWM boost chopper cascaded three-phase power conditioner, a single two-switch auxiliary resonant DC-link snubber with two electrolytic capacitors incorporated into one leg of a three-phase V-connection inverter and a three-phase AC power source. The proposed cost-effective utility-interactive power conditioner implements a unique design and control system with a high-frequency soft switching sinewave PWM scheme for all system switches. The operating performance of the 10 kW experimental setup including waveform quality, EMI/RFI noises and actual efficiency characteristics of the proposed power conditioner are demonstrated on the basis of the measured data.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2002년도 하계학술대회 논문집 B
• /
• pp.1110-1113
• /
• 2002

A Single-Stage Single-Switch power-factor- correction(PFC) AC/DC Converter with universal input is presented in this paper. The PFC Converter can be achieved based upon the continuous current mode(CCM). The switch has less current and voltage stresses over a wide range of load variation so that a low voltage rating device can be used. The presented converter features high power factor high efficiency, and low cost. An 90W prototype was implemented to show that it has 70% efficiency with low voltage stress over universal line input.

• 대한산업공학회지
• /
• 제34권2호
• /
• pp.205-215
• /
• 2008

convergence networks (BcN). The problem seeks to minimize the total cost of switch and cable while satisfying the requirement of demand and quality of service (QoS). We develop mixed integer programming models to obtain the optimal switch location of the access network. We develop a Tabu Search (TS) heuristic algorithm for finding a good feasible solution within a reasonable time limit. We propose real networks with up to 25 nodes and 180 demands. In order to demonstrate the effectiveness of the proposed algorithm, we generate lower bounds from nonlinear QoS relaxation problem. Computational results show that the proposed heuristic algorithm provides upper bounds within 5% optimality gap in 10 seconds.

• 대한전기학회논문지:전기기기및에너지변환시스템부문B
• /
• 제50권8호
• /
• pp.392-401
• /
• 2001

This paper presents the single-stage high power factor AC to DC converter operated in active-clamp mode. The proposed converter is added active-clamping circuit to boost-flyback single-stage power factor corrected power supply. The active-clamping circuit limits voltage spikes, recycles the energy trapped in the leakage inductance, and provides a mechanism for achieving soft switching of the electronic switches to reduce the switching loss. The auxiliary switch of active-clamping circuit uses the same control and driver circuit as the main switch to reduce the additional cost and size. To verify the performance of the proposed converter, a 100W converter has been designed. The proposed converter gives good power factor correction, low line current harmonic distortions, and tight output voltage regulation, as used unity power factor.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 1999년도 전력전자학술대회 논문집
• /
• pp.323-326
• /
• 1999

For decrease the harmonic current components of the power source, a first method is insert the choke coil that used the choke input type rectifier, the booster chopper circuit and buck chopper circuit. And the several method are studying like as the PWM(Pulse Width Modulation) converter and the active filter type which is used the high frequency switching and the sinusoidal wave formed input current. In this type, there are many problem as a low efficiency, increased the noise, the high leakage current and cost up by the high frequency switching. For improve this problems, the partial resonan method is used on the booster inducter and lossles snubber condenser. This method decreased the distortion factor has lower harmonic components than the hard switching and there is no switching loss by the ZCS(Zero Current Switching) at switch turn-on and the ZVS(Zero Voltage Swithcing) at switch turn-off

• Transactions on Control, Automation and Systems Engineering
• /
• 제3권4호
• /
• pp.236-241
• /
• 2001

Teach pendant is the most widely used means of robot teaching at present. Despite the difficulties of using the motion command buttons on the teach pendant, it is an economical, robust, and effective device for robot teaching task. This paper presents the development of a force/moment direction sensor named COSMO that can improve the teach pendant based robot teaching. Robot teaching experiment of a six axis commercial robot using the sensor is described where operator holds the sensor with a hand, and move the robot by pushing, pulling, and twisting the sensor in the direction of the desired motion. No prior knowledge of the coordinate system is required. The function of the COSMO sensor is to detect the presence f force and moment along the principal axes of the sensor coordinate system. The transducer used in the sensor is micro-switch, and this intuitive robot teaching can be implemented at a very low cost.

• JSTS:Journal of Semiconductor Technology and Science
• /
• 제6권3호
• /
• pp.136-145
• /
• 2006

Two major processing technologies of GaAs HBT and pHEMT have been released in production at Win Semiconductors corp. to address the strong demands of power amplifiers and switches for both handset and WLAN communications markets. Excellent performance with low processing cost and die shrinkage features is reported from the manufactured MMICs. With the stringent tighter manufacturing quality control WIN has successfully become one of the major pure open foundry house to serve the communication industries. The advancing of both technologies to include E/D-pHEMTs and BiHEMTs likes for multifunctional integration of PA, LNA, switch and logics is also highlighted.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2005년도 전력전자학술대회 논문집
• /
• pp.529-531
• /
• 2005

This paper proposes a compact pulse generator fur NOx removal application for diesel automotive. The rising time is important factor to increase NOx removal efficiency in pulsed corona discharge method. Manufacturing cost and compactness of the pulse power generator should be satisfied for automotive application. The proposed pulse power uses a low voltage thyristor, a pulse transformer with the function of saturated magnetic switch, and series connected general diodes as opening switch to satisfy that requirements. With 200 resistor load, the experiment results show that the output voltage is 21kV, the rising time is about 21ns, and the pulse width (FWHM) is about 42ns.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2000년도 하계학술대회 논문집 B
• /
• pp.1215-1217
• /
• 2000

For the application of soft-switching technique to single Phase-full bridge inverter. in this paper ZCT(Zero Current Transition) and ZVT(Zero Voltage Transition) techniques proposed previously are compared and discussed the merit and demerit of both. Both have a excellency that can reduce the number of auxiliary switch and resonant circuit compared to other techniques and achive soft-switching in auxiliary switch itself. Therefore, it has enabled us to have benifits of realizing high efficiency and reliability, low EMI for high switching frequency and reducing the cost as well as size of device.