• Journal of Radiation Industry
• /
• v.6 no.4
• /
• pp.323-328
• /
• 2012

In this study, a facile method to fabricate superhydrophobic surfaces on perfluoroalkoxy (PFA) films using ion implantation was developed. PFA films were implanted at 100 keV with a fluence ranging from $4{\times}10^{16}$ to $7{\times}10^{16}ions\;cm^{-2}$. The surface properties of the implanted films were investigated in terms of their surface morphology, wettability, and chemical composition. As the fluence increased to $6{\times}10^{16}ions\;cm^{-2}$, the surface morphology and surface roughness of the PFA films were dramatically changed. The PFA surface implanted at a fluence of $6{\times}10^{16}ions\;cm^{-2}$ showed a maximum contact angle (CA) of $157.1^{\circ}$, while the control CA of the smooth PFA surface was $103.6^{\circ}$. Thus, the superhydrophobic surface was successfully fabricated by ion implantation.

• The Magazine of the Society of Air-Conditioning and Refrigerating Engineers of Korea
• /
• v.5 no.3
• /
• pp.178-197
• /
• 1976

Based on the measurement data on Radiation on a Horizontal Surface at 84 different areas in South Korea which were collected and recorded by the Central Meteorological Office, the average values in the period of 5 years from 1971 thru 1975 at 12 particular areas of Gangreung, Gyeongju, Gwangju, Gimhae, Mogpo, Seoul, Iri, Jeju, Jinju, Cheongju and Chungju are indicated in this report. For above 12 areas the following data have been obtained and are indicated in each tables. Annual totalization of Radiation on a Horizontal Surface and its yearly averaged daily totalization$cdots$Table 1. Monthly totalization of Radiation on a Horizontal Surface and its monthly averaged daily totalization$cdots$Table 2 Maximum and minimum values of daily totalization of Radiation on a Horizontal Surface$cdots$Table 3 Daily variation of monthly averaged Radiation on a Horizontal Surface$cdots$Table 4 thru 15 Decade averaged Radiation on a Horizontal Surface$cdots$Table 16 thru 27

• Solar Energy
• /
• v.15 no.3
• /
• pp.39-52
• /
• 1995

This study is investigated numerically on the heat transfer characteristics of surface radiation-natural convection interactions in a two dimensional enclosure assumed Ondol cavity. Mean Nusselt number of the bottom surface with surface radiation is increased by increasing wall emissivity and by decreasing dimensionless thickness of adiabatic wall. and is greater than that without radiation. Mean Nusselt number of the bottom surface for convection only with surface radiation is slightly smaller than that without surface radiation with decrease dimensionless thickness of adiabatic wall.

• Journal of Radiation Industry
• /
• v.4 no.4
• /
• pp.341-345
• /
• 2010

The surface functionalization of a fluoropolymer by ion beam-induced graft polymerization was described in this research. The surface of poly(tetrafluoroethylene) (PTFE) films were irradiated by a 150 keV $H^+$ ions, and 4-vinyl pyridine (4VP) as a functional monomer was then thermally graft polymerized on the irradiated surface. The surface properties of poly(4-vinyl pyridine) (P4VP)-grafted PTFE films were investigated in terms of grafting degree, wettability, chemical structure, and morphology. The results revealed that the surface of PTFE films was successfully functionalized by ion beam-induced graft polymerization of 4VP.

• 한국연소학회:학술대회논문집
• /
• 2014.11a
• /
• pp.157-159
• /
• 2014

This article describes an investigation of basic combustion characteristics of radiant burner with various firing rate and equivalence ratios in porous metal. As a main experimental condition, firing rates and equivalence ratios each were adjusted from 204 to $408kW/m^2$ and 0.6 to 1.3. The purpose of this study is to investigate radiation efficiency using two experiment methods. The first way is to calculate the radiation efficiency by measuring the temperature of the burner surface, and the second is to compute the radiation efficiency by measuring the radiation intensity of the burner surface with a radio meter. The value of the radiation efficiency did not exactly match in the two cases. But we figured out that in accordance with increasing heat power, radiation efficiency was decreased. And additional complementary experiment on the relationship between these values is needed.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2014.10a
• /
• pp.236-239
• /
• 2014

Most naval underwater weapon system can be simplified to a circular cylindrical structure which has vibrating machineries inside. In order to predict efficiently the total acoustic radiation power of cylindrical structure, surface velocity is measured and radiation efficiency of surface element is calculated. Then, they are substituted to the surface pressure in the simplified Helmholtz integral equation which assumes acoustic far-field and plane-wave approximation at the surface. Surface velocity and total acoustic radiation power for a submerged cylinder are measured in water-tank. In this example, it is found that total acoustic power output obtained from the prediction is in good agreement with that of measurement in mid-high frequency range.

• The Journal of the Acoustical Society of Korea
• /
• v.36 no.2
• /
• pp.108-114
• /
• 2017

We have experimentally analyzed the self-radiation impedance of an ultrasonic transducer with a square radiation surface that is used as a vibrator in underwater ultrasonic detection systems. The radiation reactance and the radiation resistance were measured in the range from 1 to 3 of ka that is the product of a wave number and a length of the edge of the square vibrator. By comparing the measured results with those of theoretical calculation of the radiation impedance using a series, we confirmed the validity of the experimental method and experimentally confirmed the variation trend in the radiation impedance of the square radiation surface.

• Journal of Radiation Industry
• /
• v.12 no.4
• /
• pp.333-336
• /
• 2018

Natural lacquer was cured at room temperature at a relative humidity of 60% at $27^{\circ}C$ to obtain a lacquer film. Photolysis of lacquer was investigated by irradiating 1~75 kGy of gamma ray to this lacquer film. No significant changes were observed in the range of 1~10 kGy radiation. As the radiation doses were increased, the white spots were increased in the scanning electron microscope photographs. The increase of the white dots of the lacquer surface shows that the lacquer is degradation by radiation. As a result of IR spectral analysis of the lacquer surface with increasing irradiation dose, there was no significant change in $3,445cm^{-1}$ hydroxide group, $2,900cm^{-1}$ hydrocarbon group, and $993cm^{-1}$ triene group. However, the $1,745cm^{-1}$ carbonyl group was found to increase, and the $1,715cm^{-1}$ unsaturated hydrocarbon group and the $1,463cm^{-1}$ methylene group showed a tendency to decrease.

• Journal of Radiation Industry
• /
• v.6 no.4
• /
• pp.317-322
• /
• 2012

In this study, the preparation of a temperature-responsive poly(N-isopropylacrylamide) (PNIPAAm)-grafted surface was performed using an eco-friendly and biocompatible ion beam-induced surface graft polymerization. The surface of a perfluoroalkoxy (PFA) film was activated by ion implantation and N-isopropylacrylamide (NIPAAm) was then graft polymerized selectively onto the activated regions of the PFA surfaces. Based on the results of the peroxide concentration and grafting degree measurements, the amount of the peroxide groups formed on the implanted surface was dependant on the fluence, which affected the grafting degree. The results of the FT-IR-ATR, XPS, and SEM confirmed that the NIPAAm was successfully grafted onto the implanted PFA. Moreover, the contact angle measurement at different temperatures revealed that the surface of the PNIPAAm-grafted PFA film was temperature-responsive.

• Atmosphere
• /
• v.16 no.2
• /
• pp.111-124
• /
• 2006

This study examines seasonal variability of the surface energy balance at the King Sejong Station, Antarctica, using measurements and estimates of the components related to the balance for the period of 1996 to 2004. Annual average of downward shortwave radiation at the surface is 81 $Wm^{-2}$ which is 37% of the extraterrestrial value, with the monthly maximum of 188 $Wm^{-2}$ in December and the minimum of 8 $Wm^{-2}$ in June. These values are relatively smaller than those at other stations in Antarctica, which can be attributed to higher cloudy weather conditions in Antarctic front zone. Surface albedo varies between ~0.3 in the austral summer season and ~0.6 in the winter season. As a result, the net shortwave radiation ranges from 117 $Wm^{-2}$ down to 3 $Wm^{-2}$ with annual averages of 43 $Wm^{-2}$. Annual average of the downward longwave radiation shows 278 $Wm^{-2}$, ranging from 263 $Wm^{-2}$ in August to 298 $Wm^{-2}$ in January. The downward longwave radiation is verified to be dependent strongly on the air temperature and specific humidity, accounting for 74% and 79% of the total variance in the longwave radiation, respectively. The net longwave radiation varies between 25 $Wm^{-2}$ and 40 $Wm^{-2}$ with the annual averages of 30 $Wm^{-2}$. Accordingly, the annual average energy balance is dominated by radiative warming of a positive net all-wave radiation from September to next March and radiative cooling of a negative net all-wave radiation from April to August. The net all-wave radiative energy gain and loss at the surface is mostly balanced by turbulent flux of sensible and latent heat. The soil heat flux is of negligible importance in the surface energy balance.