• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.2
• /
• pp.521-527
• /
• 2020

In offshore structures, the mean viscous drift force due to drag is considered to be a design part that has not been considered until recently. In particular, it is most important to calculate the drift force acting on a vertical cylinder considering both waves and currents in the low frequency region. This paper presents a process for deriving analytical solutions for the drift forces acting on a fixed vertical cylinder considering waves and currents. The area of the cylinder was considered by dividing it into a splash zone above the free surface and a submerged zone below the free surface. The presence of waves is considered only in the Splash Zone, and in the case of waves and currents, the equations were obtained for both the splash and submerged zones. The results show that drift forces occur due to the significant viscous effects in both the splash zone and the submerged zone. Therefore, the analytical solutions derived in this study can be used to calculate the drift force using the given design variables and form a theoretical basis for judging whether the magnitude of the drift force in each case has a dominant influence within a specific physical range.

• Journal of Korean Society of Water and Wastewater
• /
• v.20 no.6
• /
• pp.857-865
• /
• 2006

The submerged barrier, employed in a reactor, divided a reactor into sludge settling zone and mixing zone according to flow type. In spite of mixing in the mixing zone, the lower part of sludge settling zone than the top of barrier was in a steady flow due to the barrier, which prevented the turbulent flow, produced from the mixing zone, from being diffused into the sludge settling zone. Therefore, the sludges in the mixing zone flowed backward over the barrier into the upper part of the sludge settling zone by turbulent flow and settled down in the sludge settling zone by the force of gravity. When barrier/water level ratio was 0.5, most sludges almost did not settle down in tile sludge settling zone because the sludges were directly affected by the turbulent flow, generated from mixer in the mixing zone. At 0.63 of barrier/water level ratio, sludge in the middle part of sludge settling zone rocked from side to side weakly. And sludge in the lower part became piled up on the bottom over this ratio. After 10minutes of sludge settling, the lower part of sludge settling zone was over 5000mg/L of sludge concentration although intial sludge concentration was 2300mg/L. By using the submerged barrier and the flow types, it could transfer sludge from this to that.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.3
• /
• pp.503-509
• /
• 2020

In offshore floating structures, the viscous mean drift force due to drag is considered a design part that has not been considered until recently. In this paper, an analytical solution for the viscous mean drift forces on a floating vertical cylinder considering the waves and currents was obtained. The area was considered by dividing it into a splash zone above the free surface and a submerged zone below the free surface. In the case of waves, only the splash zone was considered; in the case of waves and currents, equations were obtained in both the splash zone and the submerged zone. The RAO results of previous studies were used to compare the calculated results with the drift forces acting on the fixed cylinder. Except for the case in only waves in the splash zone, the viscous mean drift force acting on the floating cylinder was larger than the drift force acting on the relatively fixed cylinder in most frequencies. In particular, the increase was greater when the currents were considered to be more important. Therefore, these results provide the inference for the viscous drift force due to drag in the design of floating offshore structures.

• Korean Journal of Ecology and Environment
• /
• v.45 no.1
• /
• pp.52-61
• /
• 2012

Distribution, abundance and biomass of submerged macrophytes were assessed using a double-headed rake and an echo-sounder in the Keumpoong Reservoir to investigate the temporal and spatial variations of submerged macrophytes in a small agricultural reservoir located upstream. Slope steepness and water depth in the littoral zone were important controlling factors on flora and vegetation structure of submerged macrophytes. Biodiversity of submerged macrophytes was increased at a gentle slope of the littoral zone. The results of DCA (detrended correspondence analysis) showed that the structure of submerged vegetation depended on the depth of water. Submerged macrophytes were distributed at the maximum water depth of 2.8 m in the Keumpoong Reservoir. The area occupied by the submerged macrophytes was estimated at only 6% of the total reservoir area because of the steep slope of the littoral zone and the large annual water-level fluctuation of 3.5 m. The increase of water level and inflow of turbid water in the rainy season might reduce the biomass of submerged macrophytes in the reservoir. It may be concluded that submerged vegetation in the Keumpoong Reservoir, a small agricultural reservoir located at the upstream, appears to be particularly susceptible to water level fluctuations and slope steepness of the littoral zone.

• Proceedings of the Korean Society of Coastal and Ocean Engineers Conference
• /
• 2002.08a
• /
• pp.14-23
• /
• 2002

Wave breaking and breaking wave-induced hydrodynamics are very important subjects in the field of coastal and ocean hydrodynamics and engineering. In the coastal zone, a submerged breakwater has been increasingly popular, since it is one of nature-matching structures with multi- functions such as (1) wave energy dissipation by wave breaking and friction, (2) oxygen supply to sea by wave breaking and breaking wave, (3) water purification by entrained air bubbles, (4) keeping. good seascape. and (5) good habitat for sea livings. Recently, the breaking wave-induced high frequency pressure over a submerged breakwater is said to have a function of gathering sea livings around the structure, which has encouraged the construction of the submerged breakwater in coastal zone. (omitted)

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.28 no.3B
• /
• pp.345-354
• /
• 2008

In this present study, we made a first attempt to investigate physical transformations of incident waves in surf and swash zone and hydrodynamic phenomena of detached and submerged breakwaters. For an accurate simulation of the complicated wave deformation, Three-Dimensional numerical model with Large Eddy Simulation has been developed recently and expanded properly for the current applications, which is able to simulate an accurate and direct WAve Structure Sandy seabed interaction (hereafter, LES-WASS-3D). LES-WASS-3D has been validated through the comparison with experimental results for limited cases, and has been used for the simulation of wave run-up on sandy beach, mean fluid flows over and around submerged structures and swash zone (alongshore/rip current), and spatial distribution of wave height in wide fluid regions. In addition, a strategy of efficient deployment ($Y/L_i=1.50{\sim}1.75$, $W/L_r=0.50$) of the submerged breakwaters has been discussed.

• Journal of Ocean Engineering and Technology
• /
• v.36 no.5
• /
• pp.326-339
• /
• 2022

Recently, not only Korea but also the world has been suffering from problems related to coastal erosion. The hard defense method has been primarily used as a countermeasure against erosion. However, this method is expensive and has environmental implications. Hence, interest in other alternative methods, such as the eco-friendly vegetation method, is increasing. In this study, we aim to analyze the hydraulic characteristic of submerged rigid vegetation according to the cross-sectional change through a hydraulic experiment and numerical simulation. From the hydraulic experiment, the reflection coefficient, transmission coefficient, and energy dissipation coefficient were analyzed according to the density, width, and multi-row arrangement of the vegetation zone. From numerical simulations, the flow field, vorticity distribution, turbulence distribution, and wave distribution around the vegetation zone were analyzed according to the crest depth, width, density, and multi-row arrangement distance of the vegetation zone. The hydraulic experiment results suggest that the transmission coefficient decreased as the density and width of the vegetation zone increased, and the multi-row arrangement condition did not affect the hydraulic characteristics significantly. Moreover, the numerical simulations showed that as the crest depth decreased, the width and density of vegetation increased along with vorticity and turbulence intensity, resulting in increased wave height attenuation performance. Additionally, there was no significant difference in vorticity, turbulence intensity, and wave height attenuation performance based on the multi-row arrangement distance. Overall, in the case of submerged rigid vegetation, the wave energy attenuation performance increased as the density and width of the vegetation zone increased and crest depth decreased. However, the multi-row arrangement condition did not affect the wave energy attenuation performance significantly.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2013.11a
• /
• pp.60-61
• /
• 2013

For reinforced concrete structures located in a sea environment, the Impressed Current Cathodic Protection (ICCP) is mostly used as a signature method to prevent steel corrosion. For this research, specimens to which the ICCP is applied were manufactured under the assumption of two following cases the specimens are exposed to various salt damage environments (submerged zone, tidal zone), and deteriorative factors (crack) occur in concrete. For the specimens manufactured, an enhancement experiment for deterioration was conducted through regular cycle change under the temperature between 15 ~ 70℃ with 70 ~ 90% humidity. Afterwards, the method effect was verified through a half-cell method and application of the ICCP derived from salt damage environments was investigated.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.23 no.4
• /
• pp.32-40
• /
• 1981

A lot of submerged tunnels which cross revers and channels have been constructed in the USA, European countries and Japan. It is very important to consider anti-seismicity of the tunnels when they are located in active seismic zone. Fortunately, the submerged tunnels have never been damaged by earthquakes, however a umber off surveys and experiments to examine the anti-seismicity of the submerged tunnels have been carried out from various points of view. the dynamic characteristics of the submerged tunnels which are buried in the ground and have long total length from that of the structures above ground. 'Specificitions of Earthquake Resistant Desion of Submerged Tunnels' was established by the Japan Society of Civil Engineers in 1975. These specifications greatly promote the construction of the submerged tunnels. In this technical paper, the outline of the construction and a few methods of earthquake resistant designs for the tunnels: earthquakes observations, indoor experiments by shaking table, and numerical analysis by computer are also mentioned.

• Journal of Industrial Technology
• /
• v.18
• /
• pp.209-216
• /
• 1998

Some mechanical properties of the submerged arc-welded(SAW) zone between different kinds of metal (SS400+SB450) are investigated and compared with that between same kinds of metal (SS400+SS400 and SB450+SB450). The analysis of the chemical components and observation of the micro-structure by SEM of the weld zone are also carried out. And the effect of the stress relief annealing is examined by comparing tensile strength, elongation, toughness add hardness of SAW specimens before and after the heat treatment.