• Journal of Korean Society of Environmental Engineers
• /
• v.36 no.3
• /
• pp.198-205
• /
• 2014

The present paper investigates the leaching property of coal fly ash (FA) using distilled water as solvent and its performance of mineral carbonation. The highest leaching efficiency is obtained at 100 min after leaching begins and the overall leaching efficiencies of Ca and Na via five consecutive leachings were calculated to be 25.37% and 7.40%, respectively. In addition, because $Ca(OH)_2$ produced during the leaching reacts with $SiO_2$ which is the major component of FA, the Pozzolanic reaction may occur and thus reduces leaching efficiency. Total carbonation capacity of FA by absorbing $CO_2$ into FA leachates is 6.08 mg $CO_2/g$ FA and the contribution of alkali substances such as Ca, Na, Mg and K to this value is calculated to be 5.19 mg $CO_2/g$ FA. Carbonation efficiencies of Ca and Na based on leachates are 85.62% and 77.70%, respectively. On the other hand, the ratios of Ca and Na in raw FA to participate in carbonation are calculated to be 9.04% and 5.26%, respectively.

• Journal of the East Asian Society of Dietary Life
• /
• v.25 no.5
• /
• pp.887-892
• /
• 2015

Jerusalem artichoke is often stored poorly after harvesting due to its delicate skin. For this reason, Jerusalem artichoke is mainly distributed in the market as a dried material. In order to improve utilization of dried Jerusalem artichoke, we made Jangachi and analyzed physiochemical characteristics with raw Jerusalem artichoke Jangachi during storage. Raw Jerusalem artichoke was sliced into 7 and 10 mm slices and dried in hot air. After aging, we analyzed rehydration capacity, pH, hardness, salinity, sugar content, and fructan content of both. Dried Jerusalem artichoke sliced into 10 mm slices took over twice as long (420 min) to be rehydrated over 90% than 7 mm sliced (200 min) Jerusalem artichoke. In the case of raw Jerusalem artichoke, hardness showed a tendency to decline. Relatively, hardness of dried Jerusalem artichoke was measured consistently. After 4 weeks, salinity and sugar content were 3.63% and $41.23^{\circ}Brix$ in raw Jerusalem artichoke Jangachi, 3.47% and $37.05^{\circ}Brix$ in 7 mm dried Jerusalem artichoke, and 3.77% and $39.15^{\circ}Brix$ in 10 mm dried sample, respectively. As a result of this study, the possibility of dried Jerusalem artichoke as a pickle was confirmed.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.39 no.6
• /
• pp.725-733
• /
• 2019

Sand dams are structures that can be used as auxiliary water resources in case of drought as sand accumulates due to barriers crossing valley rivers and valley water is stored in the voids, increasing the water level. This structure, which is mainly used in arid regions such as Africa, has not been installed in Korea. In Korea, there are only a few cases where water is taken from debris barriers that prevent debris flow. The purpose of this study is to evaluate the effect of water supply when the sand dam is installed downstream of the existing intake barrier in Seosang-ri valley, Chuncheon. For this purpose, modeling was performed by linking the basin hydrologic model and reservoir routing model. Changes in the water level, storage and discharge in the sand dam reservoir according to the size and intake of the sand dam are presented on a case-by-case basis. As a result of application, it was found that the water supply capacity due to the sand dam installation was improved at 95% reliability. Especially, when the size is L × B × H_o = 25 m × 15 m × 1 m and the pumping rates from intake barrier and sand dam are (Q₁, Q₂) = (30, 20), (35, 15) ㎥/day, the efficiency was the best for water supply of 50 ㎥/day.

• Journal of Korea Water Resources Association
• /
• v.50 no.4
• /
• pp.223-232
• /
• 2017

The ability to defend against floods in urban areas was weakened, because the increase in the impervious rate of urban areas due to urbanization and industrialization and the increase in the localized torrential rainfall due to abnormal climate. In order to reduce flood damage in urban areas, various runoff reduction facilities such as detention ponds and infiltration facilities were installed. However, in the case of domestic metropolitan cities, it is difficult to secure land for the installation of storm water reduction facilities and secure the budget for improving the aged pipelines. Therefore, it is necessary to design a storage system (called the detention pond in trunk sewer) that linked the existing drainage system to improve the flood control capacity of the urban area and reduce the budget. In this study, to analyze the effect of reducing runoff amounts according to the volume of the detention pond in trunk sewer, three kinds of virtual watershed (longitudinal, middle, concentration shape) were assumed and the detention pond in trunk sewer was installed at an arbitrary location in the watershed. The volume of the detention pond in trunk sewer was set to 6 cases ($1,000m^3$, $3,000m^3$, $5,000m^3$, $10,000m^3$, $20,000m^3$, $30,000m^3$), and the installation location of the detention pond in trunk sewer was varied to 20%, 40%, 60%, and 80% of the detention pond upstream area to the total watershed area (DUAR). Also, using the results of this study, a graph of the relationship and relational equation between the volume of the detention pond in trunk sewer and the installation location is presented.

• Journal of the Korean Electrochemical Society
• /
• v.18 no.1
• /
• pp.17-23
• /
• 2015

$Li_4Ti_5O_{12}$ (LTO) have attracted much attention of researchers in the field of energy storage, because of their excellent stability for electric vehicle application. A main drawback of LTO is however their insulating nature due to the wide bandgap, which should be addressed to enhance the battery performance. In this study, we investigated the effect of water solubility of dopant precursor on the electrochemical characteristics of conducting LTO prepared by doping with $Cr^{3+}$ ions with the well-known wet-mixing method. The solubility of dopant precursor directly affected the morphology and the phase of doped LTO, and therefore their battery performance. In the case of employing the most soluble dopant precursor, $Cr(NO_3)_2$, the doped LTO demonstrated a markedly enhanced discharge capacity at high C-rate (130mAh/g @ 10C), which is about 2 times higher value than that of bare LTO.

• Journal of the Korean Solar Energy Society
• /
• v.36 no.6
• /
• pp.25-35
• /
• 2016

In this study, the evaluation of the dynamic behavior and thermal performance of the "Façade integrated Natural circulation Solar Water Heating System" installed in the residential house was carried out. Experimental tests were performed during the all year around in the rural houses of $166m^2$ in size. Facade integrated solar collector of $5m^2$ were installed on the south-facing. Electrical heater of 1 kW capacity as an auxiliary heater was installed at the upper part of the heat storage tank. The analyzing results are as follows. (1) Monthly average solar fraction was 51 to 87% and yearly average value is 64%. (2) Hot water supply temperature in December which has the lowest solar altitude is 37 to $76^{\circ}C$. The highest working fluid temperature of solar collector in this period was below $84^{\circ}C$. The temperature difference of working fluid between the collector inlet and outlet has been shown to be around 9 to $26^{\circ}C$. (3) Overheating which is one of the biggest problems during summer did not appear at all, but rather had hot water supply temperature is rather low as $30{\sim}47^{\circ}C$ in summer than winter, which is supplied by a small solar load. The solar collecting temperature has been shown to maintain below $55^{\circ}C$. (5) The thermal performance of Facade integrated solar collector can be increase due to the reduction of heat loss to the back of the collector wall integration of the collector is reduced. As a conclusion, Facade integrated natural circulation type Solar Water Heating System is a well-functioning without any pumps or controllers, and it was found that the disadvantages of conventional solar water heaters, hot water or hot water system can be greatly improved.

• Journal of Soil and Groundwater Environment
• /
• v.8 no.3
• /
• pp.37-44
• /
• 2003

Fuel oxygenates, such as Methyl tertiary Butyl Ether (MTBE) is additive in gasoline used to reduce air pollution. Gasoline components and fuel additives can leak: form underground storage tanks. MTBE is far more water soluble than gasoline hydrocarbons like BTEX then it travels at essentially the same velocity as groundwater. MTBE in drinking water causes taste and odor problems. Therefore, the purpose of the this study is to examine the ability of ground tire to sorb MTBE in water. The study consisted of running both batch and column tests to determine the sorption capacity, the required sorption equilibration time, and the flow through utilization efficiency of ground tire. The batch test result indicated that ground tire can attain equilibrium sorption capacities about 0.5 mg of MTBE. The result of column test indicate that ground tire has on the 36% utilization rate. Finally, it is clear that ground tire represented an attractive and relatively inexpensive sorption medium for a MTBE. Authors thought that to determine the economic costs of ground tire utilization, the cost to sorb a given mass of contaminant by ground tire will have to be compared to currently accepted sorption media. The cost comparison will also have to include regeneration and disposal cost.

• Korean Journal of Medicinal Crop Science
• /
• v.8 no.1
• /
• pp.14-20
• /
• 2000

This experiment was conducted to investigate the effects of length of storage period under low temperature, $CO_2$ enrichment and addition of plant growth regulators in Murashige and Skoog medium on the plant regeneration of Korean ginseng (Panax ginseng C. A. Meyer). Seeds were treated for 60 and 80 days respectively under $5^{\circ}C$ environment. 2500ppm of $CO_2$ was enriched by ventilation. Three plant growth regulators added to the medium were Indolbutyric acid, Benzyladenin and Gibberellic acid (GA3). The result indicated that : The capacity of differentiation was higher in the aged cotyledons from the seeds treated for 80 days under low temperature condition than in those treated for 60 days. $CO_2$ enrichment had stimulating effects on the growth and development of shoot primordium significantly but less effects on the formation of adventitious buds. From one zygotic embryo hundreds of plantlets were differentiated. $CO_2$ enrichment had effects on the formation of both indirect somatic embryo and direct somatic embryo. Indirect somatic embryo showed little growth and differentiation, being undifferentiated vascular stele and epicotyl. Direct somatic embryos were formed on the epidermis of backside basal part of cotyledon. Those embryos developed to whole plant having latent bud.

• Maxillofacial Plastic and Reconstructive Surgery
• /
• v.11 no.1
• /
• pp.117-129
• /
• 1989

The commercial availability of processed heterogenous bone has provided the surgeons with almost unlimited supply, avoidance of additional operation and prevention of the postoperative complications. In addition to these merits, unnecessary bone bank, easy availibility and storage have been achieved. The purpose of this study was to compare and examine the healing capacity of Kiel bone, Pyrost and Osteovit which used as the processed heterografts for the reconstruction of bony defect. Twenty rabbits weighing about 1.7-2.0 Kg were selected and divided into two groups. In experimental group A, the left mandibular defect was allowed to fill with blood, and the right defect was filled with Kiel bone. In experimental group B, the left defect was grafted with Pyrost, and the right with Osteovit. The experimental animals were sacrified after 1, 2, 4 and 8 weeks and the grafted site was studied histologically. To evaluate the strength of healed bone, 2 rabbits from each experimental group and a nonoperated control were sacrified at the 6th week after implantation and used for biometric testing on universal testing machine. The results obtained were as follows : 1. It was considered that these heterogenous bone grafts has feeble or absent immunogenicity since all of them appeared to evoke little inflammatory or forign body reaction. 2. In all experimental groups, new bone formation began from the adjacent region of host bone and extended progressively into the defect sites. New bone was partly formed within the intertrabecular space of the implant and gradually united with the bone that formed at the margin of the host bone. 3. With Pyrost bone formation was rapid and prominent comparing with other graft materials. 4. Osteovit was begun to be absorbed from 2 weeks, and Kiel bone from 4 weeks, however Pyrost was remained to be intact until the end of 8 weeks. 5. As the results of tensile test, the mean values of maximum tensile stress were 1.11${\uparrow}$ $Kgf/mm^{2}$ in Pyrost implanted specimens, 0.85 $Kgf/mm^{2}$ in Osteovit, 0.42 $Kgf/mm^{2}$ in Kiel bone, 0.66 $Kgf/mm^{2}$ in blood filled specimens and 1..13 $Kgf/mm^{2}$ in control. These results indicate that heterogenous bones grafted have little antigenicity to the host tissue, and that they mediate effectively osteoconduction by providing the scaffold for the bone formation. Pyrost and Osteovit appeared to be suitable for the clinical use.

• Journal of the Korean Electrochemical Society
• /
• v.20 no.2
• /
• pp.34-40
• /
• 2017

Electric double layer capacitors (EDLC: electric double layer capacitors) have drew attention as an energy storage device for the next generation because of their outstanding power capability and durability. But their usage is somewhat limited due to low energy density over secondary batteries. One of methods to improve the energy of EDLC is expanding the voltage window of cell operation by increasing the charge cut-off voltage. In this study, $SBP-BF_4$ (spirobipyrrolidinium tetrafluoroborate), $TEA-BF_4$ (tetraethylammonium tetraflouroborate) and $EMI-BF_4$ (1-ethyl-3-methylimidazolium tetrafluoroborate) in AN (acetonitrile) were selected to evaluate the possibility of application at high voltage environment. The LSV (linear sweep voltammetry) measurements showed that the 1.5M SBP-BF4/AN electrolyte was stable over a wide potential window and showed the best electrochemical performance compared to other combinations of electrolytes at high voltage environments (over 3.0 V). Furthermore, TMSP (tris(trimethylsilyl) phosphite) was applied to 1.5M SBP-BF4/AN in order to maintain stable performance at high voltage for the long period of time. The electrolyte with TMSP additive showed the capacity retention of 93% after 10,000 cycles at 3.3 V.