• Structural Engineering and Mechanics
• /
• 제54권4호
• /
• pp.771-792
• /
• 2015

In the paper we study dynamic response of a finite, simply supported Timoshenko beam subject to a moving continuously distributed forces. Three problems have been considered. The dynamic response of the Timoshenko beam under a uniform distributed load moving with a constant velocity v has been considered as the first problem. Obtained solutions allow to find the response of the beam under the interval of the finite length a uniformly distributed moving load. Part of the solutions are presented in a closed form instead of an infinite series. As the second problem the steady-state vibrations of the beam under uniformly distributed mass $m_1$ moving with the constant velocity has been considered. The vibrations of the beam caused by the interval of the finite length randomly distributed load moving with constant velocity is considered as the last problem. It is assumed that load process is space-time stationary stochastic process.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2001년도 전력전자학술대회 논문집
• /
• pp.252-255
• /
• 2001

In this paper, a mathematical model of permanent magnet synchronous motor (PMSM) fed by inverter with Direct Torque Control (DTC) Dynamic and steady state characteristics of PMSM is simulated and analyzed: electro-magnetic torque response, speed response, locus of the stator flux linkage. It is mathematically proven that the increase of electromagnetic torque in a permanent magnet motor is proportional the increase of the angle between the stator and rotor flux linkages, and, therefore, the fast torque response can be obtained by adjusting the rotating speed of the stator flux linkage as fast as possible. The simulation results verify the proposed control and also show that the torque response under DTC is much faster than the PWM current controlled drive.

• 제어로봇시스템학회논문지
• /
• 제9권12호
• /
• pp.1065-1070
• /
• 2003

We present a power control with variable state feedback gain (VFPC) to improve outage convergence rate of distributed constrained power control. The variable state feedback gain includes the information of the desired SIR changes and must be a decreasing sequence for the convergence. The proof of the convergence is given. The proposed algorithm can improve the outage convergence rate and SIR (Signal to Interference Ratio) response at transient as well as at steady state. The simulation results are given to demonstrate the feasibility of the proposed scheme.

• 한국정밀공학회지
• /
• 제19권10호
• /
• pp.130-138
• /
• 2002

This paper presents the modeling and analysis of dynamic characteristics of hydraulic snubber in electric power plant. The nonlinear state-space model of 14th order to describe the dynamics of the snubber was established by Simulink. The simulation results show that the hydraulic snubber reacts as like the conventional shock absorbers against the high pulse shock load. The snubber also shows the peculiar characteristics to the small step load, which temporarily lock the control valves up, however maintain same steady-state pressures of all internal chambers in the long run. Two case studies for the analysis of the snubber were addressed. Practical pulse testing method was also proposed to identify the frequency response characteristics of the snubber.

• 연구논문집
• /
• 통권31호
• /
• pp.89-99
• /
• 2001

This paper presents the modeling and analysis of dynamic characteristics of hydraulic snubber in electric power plant. The nonlinear state-space model of 14th order to describe the dynamics of the snubber was established by Simulink. The simulation results show that the hydraulic snubber reacts as like the conventional shock absolvers against the high pulse shock load. The snubber also shows the peculiar characteristics to the small step load, which temporarily lock the control valves up, however maintain same steady-state pressures of all internal chambers in the long run. Two case studies for the analysis of the snubber are addressed. Practical pulse testing method was also proposed to identify the frequency response of the snubber.

• Journal of Power Electronics
• /
• 제18권6호
• /
• pp.1760-1770
• /
• 2018

This paper presents a control bandwidth extension method for inverters with a low carrier ratio. The bandwidth is extended at the price of decreasing the phase margin. Then the phase margin is compensated by introducing an extra leading angle into an inverse Park transformation. The model of the controller with the proposed method is established. The magnitude and phase characteristics are also analyzed. Then the influence on system stability when the leading angle is introduced is analyzed. The proposed method is applied to design an inverter controller with both a large bandwidth and a desired phase margin, and the experimental results verify that the controller performs well in the steady-state and in terms of transient response.

• Korean Chemical Engineering Research
• /
• 제51권3호
• /
• pp.370-375
• /
• 2013

상업용 막전극접합체를 사용하여 제작한 고분자전해질 연료전지의 CO poisoning 및 air bleeding 효과가 스택의 셀전압 성능에 미치는 영향을 분석하였다. 실험을 통해 확보한 동적 응답 데이터에 일차 미분방정식으로 표현되는 일차계 모델을 적용하여 정상상태 이득과 시간상수를 계산하는 방법으로 스택 셀전압의 응답 특성을 정량화하였다. 연료전지 개질기로부터 공급되는 개질 가스에 포함된 CO 농도가 1 ppm 증가할 때마다 셀전압은 1.3~1.6 mV 저하되고, CO 농도의 변화폭이 클수록 정상상태에 도달하기까지 걸리는 시간이 점점 짧아지는 것으로 분석되었다. CO poisoning에 의해 저하된 스택 성능을 회복시키기 위해 air bleeding을 수행할 경우, 주입하는 공기의 농도를 증가시킬수록 셀전압 상승폭(정상상태 이득)이 커지고 회복시간(시간상수)은 짧아지나, 1% 수준의 air bleeding만으로도 CO poisoning이 일어나기 전 셀전압의 87%~96%를 1~30 min 이내에 회복시킬 수 있는 것으로 분석되었다.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 1996년도 창립기념 전력전자학술발표회 논문집
• /
• pp.31-34
• /
• 1996

A new analysis method is presented for the steady state response of electronic ballast circuit. Comparisons and examination among self exited LCC, LLCC resonant converter of electronic ballast for fluorescent lamp in expect of soft starting, component stress shot of are presented. In this paper, the theoretical discussions and analysis are verified by experimental measurements

• 한국정밀공학회:학술대회논문집
• /
• 한국정밀공학회 1993년도 추계학술대회 논문집
• /
• pp.299-304
• /
• 1993

A 1/4 car model(2 DOF system) is employed to evaluate the performance included a quadratic cost functional in frequency domain. The design procedure of feedback control to optimize the performance index results in a modified Linear-Quadratic-Gaussian problem and cultivates a quite simple control algorithm. Computer simulation result is shown that the LQG method using frequency shaped performance index is outstanding in ride comfort and its response converges to the steady state very rapidly in comparison with the known passive suspension, classical design methods LQR/ and LQG.

• 한국음향학회:학술대회논문집
• /
• 한국음향학회 1998년도 학술발표대회 논문집 제17권 1호
• /
• pp.477-481
• /
• 1998

This paper describes the application of a coupled finite element-boundary element method to obtain the steady-state response of a hydrophone. The particular structure considered is a flooded piezoelectric spherical shell. The hydrophone is three-dimensionally simulated to transduce an incident plane acoustic pressure onto the outer surface of the sonar spherical shell to electrical potentials on inner and outer surfaces of the shell. The acoustic field formed from the scattered sound pressure is also simulated. And the displacement of the shell caused by the externally incident acoustic pressure is shown in temporal motion. The coupled FE-BE method is described in detail.