• The Transactions of the Korean Institute of Power Electronics
• /
• v.6 no.1
• /
• pp.27-33
• /
• 2001

This paper presents a digital instrument for a DSP based power quality analysis in three phase power system where current waveform is non-sinusoidal. it is based on stand alone type TMS320C31 DSP(digital signal processor)board and on a special high-speed data acquisition system. Power quality of low power motor drives are analyzed and processed by using a simple average power algorithm, and result of power analysis are displayed by LCD in the proposed system. This paper also goes on to discuss the performance of an instrument prototype, both in terms of accuracy and speed of measurement under the transient and steady state condition.

• Journal of Power Electronics
• /
• v.14 no.5
• /
• pp.980-988
• /
• 2014

This paper proposes an online gain tuning algorithm for a robust sliding mode speed controller of surface-mounted permanent magnet synchronous motor (SPMSM) drives. The proposed controller is constructed by a fuzzy neural network control (FNNC) term and a sliding mode control (SMC) term. Based on a fuzzy neural network, the first term is designed to approximate the nonlinear factors while the second term is used to stabilize the system dynamics by employing an online tuning rule. Therefore, unlike conventional speed controllers, the proposed control scheme does not require any knowledge of the system parameters. As a result, it is very robust to system parameter variations. The stability evaluation of the proposed control system is fully described based on the Lyapunov theory and related lemmas. For comparison purposes, a conventional sliding mode control (SMC) scheme is also tested under the same conditions as the proposed control method. It can be seen from the experimental results that the proposed SMC scheme exhibits better control performance (i.e., faster and more robust dynamic behavior, and a smaller steady-state error) than the conventional SMC method.

• The Transactions of the Korean Institute of Electrical Engineers B
• /
• v.51 no.10
• /
• pp.587-594
• /
• 2002

A low frequency square wave electronic ballast for the high intensity discharge(HID) lamps using fuzzy logic controller is developed. This electronic ballast consists a buck converter, a low frequency square wave full bridge inverter, a high voltage pulse generator for the HID lamp ignition, an over current protection circuit and an 8-bit microcontroller. The ballast system is operated on the constant current mode during the HID lamp start-up process and the system is operated on the constant power mode during steady state. Experimental results show that the fuzzy logic control operation is carried out successfully by the 8-bit microcontroller PIC16F877 In this electronic ballast system, in spite of the limited control bandwidth caused by low operating speed of the microcontroller, the good performance in the constant lamp current characteristic is obtained. Acoustic resonance of the HID lamps can be effectively avoided because the instantaneous In lamp power is fully constant due to the low frequency square wave drive.

• Proceedings of the KIEE Conference
• /
• 1999.07a
• /
• pp.154-156
• /
• 1999

A Linear Stepping Motor(LSM) can operate open loop control mode similarly to a rotary stepping motor. The linear motion without any mechanical linkage in the LSM results in several advantages for precise positioning actuators. However, to realize the more stable and higher speed control without hunting, it is necessary to derive an equivalent circuit to explain the steady-state and transisent characteristics in order to find an adequate control rule for high performance control of the LSM. In this paper, magnetic equivalent circuit is obtained, based on the structure of the LSM, and then the electric equivalent circuit of the LSM is derived by solving equations for the magnetic equivalent circuit. The 1-step response characteristic of the LSM is analyzed by the ACSL with the voltage equations, the force equations, the force equations and the kinetic equation.

• Proceedings of the KIEE Conference
• /
• 1999.07a
• /
• pp.232-234
• /
• 1999

A 30kVA superconducting generator (S.G.) has been designed, developed and successfully tested in KERI before the end of last year. The design is based on 2-dimensional electromagnetic field analysis of cylindrical coordinate. The field winding of rotor has been wound with superconducting wire of Nb-Ti alloy and tested after assembled with other rotor components. The stator has air-gap type armature windings which allow higher terminal voltage and more sinusoidal voltage waveform than conventional iron cored machines. Steady-state open & short-circuit test and lamp load test have been conducted also. The results of tests are given in this paper and compared with design quantities. Moreover the cooling scheme and characteristics of test system is included.

• Composites Research
• /
• v.23 no.6
• /
• pp.47-54
• /
• 2010

Thermal vibration characteristics of a thin walled composite beam attached on spacecraft are investigated in this paper. The composite beam is assumed to have a thin CUS(circumferentially uniform stiffness) wall and modeled with several composite materials which are already space qualified such as T300/Epoxy, YS90AEpoxy. Steady state angle and peak to peak error in spacecraft attitude angle and tip displacement of composite beams are evaluated as a performance index for thermal vibration characteristics. Evaluation results shows that composite beam made out of YS90A has nearly 2 times better than T300 in terms of peak to peak attitude error angle.

• Membrane and Water Treatment
• /
• v.2 no.2
• /
• pp.91-103
• /
• 2011

The flux behavior in the separation of equimolar bovine serum albumin (BSA) and bovine hemoglobin (HB) in aqueous solutions by cross-flow ultrafiltration (UF) was investigated, in which polyacylonitrile membrane with a molecular weight cut-off (MWCO) of 100 kDa was used. BSA and HB have comparable molar mass (67,000 vs. 68,000) but different isoelectric points (4.7 vs. 7.1). The effects of process variables including solution pH (6.5, 7.1, and 7.5), total protein concentration (1.48 and 7.40 ${\mu}M$), transmembrane pressure (69, 207, and 345 kPa), and solution ionic strength (with or without 0.01 M NaCl) on the separation were examined. It was shown that the ionic strength had a negligible effect on separation performance under the conditions studied. Although BSA and HB are not rigid bodies, the flux decline in the present cross-flow UF did not result from the mechanism of cake filtration with compression. In this regard, the specific cake resistance when pseudo steady-state was reached was evaluated and discussed.

• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.42 no.6
• /
• pp.177-186
• /
• 2005

This paper introduces nonlinear estimators with reduced complexity, and proposes the Bussgang blind equalization algorithm employing the nonlinear estimators. The proposed algorithm utilized the facts that the Bayesian estimator is well approximated to the sigmoid estimator in initial stage of equalization with closed eye and is well approximated to the threshold estimator under open eye condition. The proposed method adopts selectively one of the two nonlinear estimators, i.e., the sigmoid estimator and the threshold estimator, according to channel distortion level at each iteration. As a result, by using the sigmoid estimator with reduced constellation, the proposed scheme, as it is applied to blind equalization of high-order QAM signals, simplifies the computational complexity extremely, and enhances the blind convergence capability and steady-state performance.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.20 no.4
• /
• pp.10-15
• /
• 1983

In this paper effective methods of demodulation and equalization in a 9600 bps modem have been studied. To reduce the number of multiplications required per symbol in demodula-tion, the method of using a decimation filter is presented. In the equalizer the optimum step size and the steady state mean-squared error (MSE) are obtained from computer simulation results. The performance of the first-order carrier phase tracking loop is compared with that of the second-order loop when carrier frequency offset exists. In addition, the finite word length effects in the equalizer are studied.

• Journal of IKEEE
• /
• v.15 no.4
• /
• pp.293-298
• /
• 2011

In the paper, we propose a new CMF(Constant Modulus Fourth) algorithm for WCDMA(Wideband Code Multiple Access) RF(Radio Frequency) Repeater. CMF algorithm is proposed by modifying the CMA(Constant Modulus Algorithm) algorithm and improved performances are achieved by properly adjusting step size values. The steady state MSE(Mean Square Error) performance of the proposed CMF algorithm with step size of 0.35 is about 4dB better than that of the conventional CMA algorithm. And the proposed CMF algorithm requires 400~1100 less iterations than the LMS(Least Mean Square) and NLMS(Normalized Least Mean Square) algorithms at MSE of -25dB.