• Journal of the Korean earth science society
• /
• v.42 no.2
• /
• pp.195-200
• /
• 2021

Orientation corrections for the total of 268 accelerograph stations of the Korea Meteorological Administration (KMA) were estimated using ambient noise cross-correlation. As this method uses ambient noise data instead of teleseismic waveforms from earthquakes under certain conditions, reliable orientation corrections can be obtained using only two-month long continuous seismic data from dense seismic networks in the Korean peninsula.Three-component continuous data recorded at the 268 accelerograph stations from January to February 2020 were used to estimate orientation corrections. The results are comparable to the previous results obtained from teleseismic waveforms; the overall standard deviations of the orientation corrections are less than 5°. Therefore, orientation corrections for the accelerograph station network can be tracked periodically by the ambient-noise method and the result can be used in various studies using the horizontal-component of acceleration data.

• Journal of Advanced Navigation Technology
• /
• v.25 no.3
• /
• pp.194-202
• /
• 2021

Ionosphere, one of the largest error sources, can pose potentially harmful threat to single-frequency GNSS (global navigation satellite system) user even after applying ionospheric corrections to their GNSS measurements. To quantitatively assess ionospheric impacts on the satellite navigation-based applications using simulation, the standard deviation of residual ionospheric errors is needed. Thus, in this paper, we determine conservative statistical quantity that covers typical residual ionospheric errors for nominal days. Extensive data-processing computes TEC (total electron content) estimates from GNSS measurements collected from the Korean reference station networks. We use Klobuchar model as a correction to calculate residual ionospheric errors from TEC (total electron content) estimate. Finally, an exponential delay model for residual ionospheric errors is presented as a function of local time and satellite elevation angle.

• Journal of Advanced Navigation Technology
• /
• v.26 no.2
• /
• pp.63-71
• /
• 2022

Barometers have been used to calculate altitude, and with the development of technology, barometer which had a large volume have now been reduced to about centimeter-level. The altitude calculation using barometer is proceeded using the relationship between reference sea level pressure and the pressure obtained by barometer, and for this, pre-calibration of the barometer is essential. In addition, the barometer has a certain level of bias from actual pressure due to production, and many smartphone manufacturers correct it during the manufacturing process, but it is difficult to correct errors caused by environmental variables. In this paper, we extended methodology of correcting barometer using static reference station to moving drone, and it was possible to calculate the altitude more accurately.

• Journal of Advanced Navigation Technology
• /
• v.27 no.4
• /
• pp.396-409
• /
• 2023

In the field of autonomous vehicles, where high accuracy and reliability are critical, various satellite navigation augmentation systems have been developed to improve system performance. These systems generate correction and integrity information based on measurements and navigation data collected from ground reference stations, enhancing user positioning accuracy. Thus, the performance of the system heavily relies on the deployment and spacing of reference stations. To construct an effective satellite navigation augmentation system, careful consideration must be given to the installation points of reference stations. This paper presents a user positioning performance modeling formula and proposes a method for selecting the installation points of new reference stations. The proposed method involves selecting a candidate group area that can optimize the user's positioning performance. By utilizing this method, the system's performance can be improved, ensuring high accuracy and reliability for autonomous vehicle applications.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2021.06a
• /
• pp.319-319
• /
• 2021

유량측정은 측정방법에 따라 측정위치가 변동된다. 도섭법은 관측자가 직접 하천을 횡단하며 측정하는 방법이며 수심이 얕은 경우 가능하다. 보트법의 경우 상대적으로 공간적 제약을 덜 받으며 교량법의 경우 이용 가능한 교량이 있어야 한다. 따라서 교량법은 현장여건에 따라 관측소와 멀리 떨어져 있는 경우가 있으며 이 경우 측정된 유량을 이용하여 수위-유량관계곡선식을 개발한다면 그 정확도가 떨어질 수 있다. 미국지질조사국(USGS)에서는 관측소와 측정위치가 멀리 떨어진 경우 측정된 유량을 보정하도록 규정하고 있다. 우리나라의 경우 유량 보정을 실시하지 않는 것으로 파악되었다. 하지만 이는 수위-유량관계곡선식, 특히 외삽부분에서 큰 오류를 유발할 수도 있어 신중할 필요가 있다. 본 연구에서는 수위관측소와 측정위치가 현저하게 먼 경우 유량 보정방법을 살펴보고 실측유량과 보정유량의 차이를 확인하였다. 대상지점인 낙동강 유역의 안동시(운산리) 지점은 홍수측정위치와 수위관측소 위치가 약 1.7km 이격되어 있으며, 2020년 측정성과(부자)를 이용하여 이를 보정하고 그 차이를 확인하였다. 보정결과 실측유량과 보정유량이 최고 5.0%, 평균 3.7% 차이를 보이는 것으로 확인되었다. 안동시(운산리)지점은 2020년 측정 최고수위가 3.35m이며, 이는 평수위에서 약 2.00m 가량 상승한 것으로 최고 홍수위로 보기는 어렵다. 즉 이보다 더 큰 홍수 사상이 발생하여 수위가 더 상승한다면 실측유량과 보정유량의 차이는 더 커질 것으로 예상된다. 또한 수위관측소와 측정위치가 이격된 경우 측정된 성과가 루프(Loop) 형태를 보일 수 있어 보정이 필요한 것으로 판단된다.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.66 no.4
• /
• pp.41-50
• /
• 2024

Precipitation is an important component of the hydrological cycle and a key input parameter for many applications in hydrology, climatology, meteorology, and weather forecasting research. Grid-based satellite rainfall products with wide spatial coverage and easy accessibility are well recognized as a supplement to ground-based observations for various hydrological applications. The error properties of satellite rainfall products vary as a function of rainfall intensity, climate region, altitude, and land surface conditions. Therefore, this study aims to evaluate the commonly used new global grid-based satellite rainfall product, Climate Hazards Group InfraRed Precipitation with Station data (CHIRPS), using data collected at different spatial and temporal scales. Additionally, in this study, grid-based CHIRPS satellite precipitation data were used to evaluate the 2022 extreme drought. CHIRPS provides high-resolution precipitation data at 5 km and offers reliable global data through the correction of ground-based observations. A frequency analysis was performed to determine the precipitation deficit in 2022. As a result of comparing droughts in 2015, 2017, and 2022, it was found that May 2022 had a drought frequency of more than 500 years. The 1-month SPI in May 2022 indicated a severe drought with an average value of -1.8, while the 3-month SPI showed a moderate drought with an average value of 0.6. The extreme drought experienced in South Korea in 2022 was evident in the 1-month SPI. Both CHIRPS precipitation data and observations from weather stations depicted similar trends. Based on these results, it is concluded that CHIRPS can be used as fundamental data for drought evaluation and monitoring in unmeasured areas of precipitation.

• Journal of the Korean earth science society
• /
• v.39 no.2
• /
• pp.139-153
• /
• 2018

The sea surface wind field has long been obtained from satellite scatterometers or passive microwave radiometers. However, the importance of satellite altimeter-derived wind speed has seldom been addressed because of the outstanding capability of the scatterometers. Satellite altimeter requires the accurate wind speed data, measured simultaneously with sea surface height observations, to enhance the accuracy of sea surface height through the correction of sea state bias. This study validates the wind speeds from the satellite altimeters (GFO, Jason-1, Envisat, Jason-2, Cryosat-2, SARAL) and analyzes characteristics of errors. In total, 1504 matchup points were produced using the wind speed data of Ieodo Ocean Research Station (IORS) and of Korea Meteorological Administration (KMA) buoys at Marado and Oeyeondo stations for 10 years from December 2007 to May 2016. The altimeter wind speed showed a root mean square error (RMSE) of about $1.59m\;s^{-1}$ and a negative bias of $-0.35m\;s^{-1}$ with respect to the in-situ wind speed. Altimeter wind speeds showed characteristic biases that they were higher (lower) than in-situ wind speeds at low (high) wind speed ranges. Some tendency was found that the difference between the maximum and minimum value gradually increased with distance from the buoy stations. For the improvement of the accuracy of altimeter wind speed, an equation for correction was derived based on the characteristics of errors. In addition, the significance of altimeter wind speed on the estimation of sea surface height was addressed by presenting the effect of the corrected wind speeds on the sea state bias values of Jason-1.

• Korean Journal of Agricultural and Forest Meteorology
• /
• v.11 no.1
• /
• pp.13-18
• /
• 2009

Accurate solar radiation data are critical to evaluate major physiological responses of plants. For most upland crops and orchard plants growing in complex terrain, however, it is not easy for farmers or agronomists to access solar irradiance data. Here we suggest a simple method using a sun-slope geometry based topographical coefficient to estimate daily solar irradiance on any sloping surfaces from global solar radiation measured at a nearby weather station. An hourly solar irradiance ratio ($W_i$) between sloping and horizontal surface is defined as multiplication of the relative solar intensity($k_i$) and the slope irradiance ratio($r_i$) at an hourly interval. The $k_i$ is the ratio of hourly solar radiation to the 24 hour cumulative radiation on a horizontal surface under clear sky conditions. The $r_i$ is the ratio of clear sky radiation on a given slope to that on a horizontal reference. Daily coefficient for slope correction is simply the sum of $W_i$ on each date. We calculated daily solar irradiance at 8 side slope locations circumventing a cone-shaped parasitic volcano(c.a., 570m diameter for the bottom circle and 90m bottom-to-top height) by multiplying these coefficients to the global solar radiation measured horizontally. Comparison with the measured slope irradiance from April 2007 to March 2008 resulted in the root mean square error(RMSE) of $1.61MJ\;m^{-2}$ for the whole period but the RMSE for April to October(i.e., major cropping season in Korea) was much lower and satisfied the 5% error tolerance for radiation measurement. The RMSE was smallest in October regardless of slope aspect, and the aspect dependent variation of RMSE was greatest in November. Annual variation in RMSE was greatest on north and south facing slopes, followed by southwest, southeast, and northwest slopes in decreasing order. Once the coefficients are prepared, global solar radiation data from nearby stations can be easily converted to the solar irradiance map at landscape scales with the operational reliability in cropping season.

• Korean Journal of Remote Sensing
• /
• v.40 no.4
• /
• pp.387-396
• /
• 2024

Most very high-resolution (VHR) satellite images provide rational polynomial coefficients (RPC) data to facilitate the transformation between ground coordinates and image coordinates. However, initial RPC often contains geometric errors, necessitating correction through matching with ground control points (GCPs). A GCP chip is a small image patch extracted from an orthorectified image together with height information of the center point, which can be directly used for geometric correction. Many studies have focused on area-based matching methods to accurately align GCP chips with VHR satellite images. In cases with seasonal differences or changed areas, edge-based algorithms are often used for matching due to the difficulty of relying solely on pixel values. However, traditional edge extraction algorithms,such as canny edge detectors, require appropriate threshold settings tailored to the spectral characteristics of satellite images. Therefore, this study utilizes deep learning-based edge information that is insensitive to the regional characteristics of satellite images for matching. Specifically,we use a pretrained pixel difference network (PiDiNet) to generate the edge maps for both satellite images and GCP chips. These edge maps are then used as input for normalized cross-correlation (NCC) and relative edge cross-correlation (RECC) to identify the peak points with the highest correlation between the two edge maps. To remove mismatched pairs and thus obtain the bias-compensated RPC, we iteratively apply the data snooping. Finally, we compare the results qualitatively and quantitatively with those obtained from traditional NCC and RECC methods. The PiDiNet network approach achieved high matching accuracy with root mean square error (RMSE) values ranging from 0.3 to 0.9 pixels. However, the PiDiNet-generated edges were thicker compared to those from the canny method, leading to slightly lower registration accuracy in some images. Nevertheless, PiDiNet consistently produced characteristic edge information, allowing for successful matching even in challenging regions. This study demonstrates that improving the robustness of edge-based registration methods can facilitate effective registration across diverse regions.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.9 no.4
• /
• pp.45-59
• /
• 2006

In this study, the effects of the surface topographical characteristics on the meteorological fields are examined in a mesoscale meteorlolgical model. We calculated the direct solar radiation using the illumination angle considering the inclination of topography and tried to find out its effect on meteorological fields. In above experiments, we selected two cases for the clear day and the cloudy day to show the effect of weather and represented the results for two cases. In the correction of the direct solar radiation, the results of two cases indicate that there are obvious differences on the steep Taeback and Soback mountains. And on the time-series analysis the east-facing slope of these mountains receives the more direct solar radiation about $10-60W/m^2$ in the morning hours but lesser in the afternoon hours than the horizontal surface while it is opposite on the west-facing slope. And the results mentioned above are more obvious at clear day. With the same analysis method, at clear day, the surface skin temperature is higher at all hours than that on horizontal surface on the both of slope. At cloudy and rainy day, the surface skin temperature on the east-facing slope is higher in the morning hours but lower in the afternoon hours than that on horizontal surface. But on the west-facing slope, it is higher at all hours than that on horizontal surface. In the two cases, the temperature considering the slope of surface is almost higher than that on the horizontal surface. The wind is stronger than that on the horizontal surface with increasing pressure gradient force according as increasing temperature gradient around the Taeback and the Soback mountains.