• Journal of Power Electronics
• /
• 제16권2호
• /
• pp.643-653
• /
• 2016

The conventional methods used to evaluate battery state-of-charge (SOC) cannot accommodate the chemistry nonlinearities, measurement inaccuracies and parameter perturbations involved in estimation systems. In this paper, an impedance-based equivalent circuit model has been constructed with respect to a LiFePO₄ battery by approximating the electrochemical impedance spectrum (EIS) with RC circuits. The efficiencies of approximating the EIS with RC networks in different series-parallel forms are first discussed. Additionally, the typical hysteresis characteristic is modeled through an empirical approach. Subsequently, a methodology incorporating an H-infinity observer designated for open-circuit voltage (OCV) observation and a hysteresis model developed for OCV-SOC mapping is proposed. Thereafter, evaluation experiments under FUDS and UDDS test cycles are undertaken with varying temperatures and different current-sense bias. Experimental comparisons, in comparison with the EKF based method, indicate that the proposed SOC estimator is more effective and robust. Moreover, test results on a group of Li-ion batteries, from different manufacturers and of different chemistries, show that the proposed method has high generalization capability for all the three types of Li-ion batteries.

• Mass Spectrometry Letters
• /
• 제8권2호
• /
• pp.29-33
• /
• 2017

Understanding the mechanisms that control and concentrate the observed electrospray ionisation (ESI) response from peptides is important. Controlling these mechanisms can improve signal-to-noise ratio in the mass spectrum, and enhances the generation of intact ions, and thus, improves the detection of peptides when analysing mixtures. The effects of different mixtures of aqueous: organic solvents (25, 50, 75%; v/v): formic acid solution (at pH 3.26) compositions on the ESI response and charge-state distribution (CSD) during mass spectrometry (MS) were determined in a group of biologically active peptides (molecular wt range 1.3 - 3.3 kDa). The ESI response is dependent on type of organic solvent in the mobile phase mixture and therefore, solvent choice affects optimal ion intensities. As expected, intact peptide ions gave a more intense ESI signal in polar protic solvent mixtures than in the low polarity solvent. However, for four out of the five analysed peptides, neither the ESI response nor the CSD were affected by the volatility of the solvent mixture. Therefore, in solvent mixtures, as the composition changes during the evaporation processes, the $pK_b$ of the amino acid composition is a better predictor of multiple charging of the peptides.

• 한국태양에너지학회 논문집
• /
• 제24권2호
• /
• pp.1-7
• /
• 2004

In this paper, the new improved method for photovoltaic system was studied available for a lighting load by measuring the state of charge of lead-acid batteries. Photovoltaic systems has been evaluated as one of the most new and renewable energy and especially, the Stand-Alone Photovoltaic system has been used to a street light, a road sign light, an air caution light, an emergency call. Many Stand-Alone PV system are installed by a group. Although the pre-installation cost of PV system is high and it has not been operated due to the absence of optimal management standards. In this paper, it is proposed a new operating method by the measurement of lead-acid battery's SOC with a Ah balancing.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2018년도 전력전자학술대회
• /
• pp.156-158
• /
• 2018

The inconsistencies between paralleled battery cells are becoming more considerable issue in high capacity battery applications like electric vehicles. Due to differences in state-of-charge (SOC) and internal resistance within individual cells in parallel, charging or discharging current is not appropriately balanced to each cell in terms of SOC, which may shorten the lifetime or sometimes cause safety issues. In this paper, an intelligent cell-balancing algorithm is proposed to overcome the inconsistency issue especially for paralleled battery cells. In this scheme, SOC information collected in the sub-BMS module is sent to the main-BMS module, where the number of parallel cells to be connected to DC bus is continuously updated based on the suggested SOC comparison rule. To verify the method, operation of the algorithm on 4 paralleled battery cells are simulated on Matlab/Simulink. The simulation result shows that the SOCs of paralleled cells are evenly redistributed. It is expected that the proposed algorithm provides high reliable and prolong the life cycle and working capacity of the battery pack.

• Journal of Power Electronics
• /
• 제11권2호
• /
• pp.237-243
• /
• 2011

Lithium batteries are widely used in mobile electronic devices due to their higher voltage and energy density, lighter weight and longer life cycle when compared to other secondary batteries. In particular, a high demand for lithium batteries is expected for electric cars. In the case of the lithium batteries used in electric cars, driving distance must be calculated accurately and discharging should not be done below a level that makes it impossible to crank. Therefore, accurate information on the state-of-charge (SOC) becomes an essential element for reliable driving. In this paper, a novel method for estimating the SOC of lithium polymer batteries using AC impedance is proposed. In the proposed method, the parameters are extracted by fitting the measured impedance spectrum on an equivalent impedance model and the variation in the parameter values at each SOC is used to estimate the SOC. Also to shorten the long length of time required for the measurement of the impedance spectrum, a novel method is proposed that can extract the equivalent impedance model parameters of lithium polymer batteries with the impedance measured at only two specific frequencies. Experiments are conducted on lithium polymer batteries, with similar capacities, made by different manufacturers to prove the validity of the proposed method.

• 조명전기설비학회논문지
• /
• 제28권11호
• /
• pp.77-83
• /
• 2014

The Estimation of State of Charge(SOC) for batteries is an important aspect of a Battery Management System(BMS). A method for estimating the SOC is proposed in order to overcome the individual disadvantages of the current integral and Open Circuit Voltage(OCV) estimation methods by combining them using Extended Kalman filter(EKF). The non-linear characteristics of the Li-Ion RC battery model used in this study is also solved through EKF. The proposed method is simulated in a Matlab environment with a Li-Ion Kokam battery (3.7V, 1,500mAh). Results showed that there is an improvement in the estimation error when using the proposed model compared to the conventional current integral method.

• 한국응용과학기술학회지
• /
• 제25권1호
• /
• pp.52-57
• /
• 2008

In the present study, impedance characteristics for AgO-Zn cell at various State-of-Charge (SoC) has been studied. The impedance measurements of AgO-Zn cell at various SoC were made over the frequency range from 100kHz to 10mHz with an amplitude 5mV. The impedance parameters have been evaluated by the analysis of the data using an equivalent circuit and a Non-linear least squares (NLLS) fitting method. The total resistances reflects the SoC of the cell. This indicates that the total resistance is important parameter for predicting SoC of AgO-Zn cell.

• 한국지능시스템학회논문지
• /
• 제22권3호
• /
• pp.300-304
• /
• 2012

본 논문은 리튬 폴리머 배터리 셀의 잔존충전용량을 추정하기 위한 비선형 관측기의 설계방법을 제시한다. 배터리 셀의 동적방정식은 비선형 전압원을 갖는 간단한 RC 전기회로로 모델하고 파라메터는 비선형 최적화기법을 이용하여 구한다. 관측기 이득은 제곱합 분해기법을 사용하여 오차의 동적방정식이 점근적으로 안정하고 추정오차 감소율이 설계자가 지정한 값 이하가 되도록 설계한다. 관측기의 성능을 입증하기 위하여 UDDS 전류 프로파일을 사용한 실험 데이터를 이용하여 모의실험을 수행하였다.

• Bulletin of the Korean Chemical Society
• /
• 제15권6호
• /
• pp.465-468
• /
• 1994

The charge transfer compounds $(TTF)_4FeCl_3{\cdot}CH_3OH,\;(TTF)_4SbCl_4\;and\;(TTF)_5(SbBr_4)_2{\cdot}CH_3COCH_3$ were prepared from reactions of the TTF (tetrathiafulvalene) and metal halides. The compounds were characterized by spectroscopic (UV,IR, EPR and XPS) methods, magnetic susceptibility and electrical conductivity measurements. The d.c electrical conductivities of the pressed pellets are in the order of $10^{-1}-10^{-3} Scm^{-1}$, which lies in the range of semiconductor region at room temperature. It means that the partially ionized TTF has stacked in low-dimensional chain in each compound. Spectroscopic properties also indicate that TTF molecules are partially ionized and charge transfer has occurred from (TTF)n to Fe(III) center in $(TTF)_4FeCl_3{\cdot}CH_3OH$ whereas to the $-SbX_4^-$ entity in $(TTF)_4SbCl_4\;and\;(TTF)_5(SbBr_4)_2{\cdot}CH_3COCH_3$. The EPR g values are consistent with TTF radical formation and EPR linewidths suggest the delocalization of unpaired electrons along TTF stacks. A signal arised from metal (Fe and Sb) ions were not detected in EPR spectra, indicating that metal ion is in the diamagnetic state in each compound. The diamagnetic state was also examined by the magnetic susceptibility measurement. The magnetic properties reveal the significant interaction between the $TTF^+$ radical cations in the stacks. The oxidation state of metal ions was also investigated by XPS spectra.

• 전력전자학회논문지
• /
• 제12권4호
• /
• pp.324-331
• /
• 2007

본 연구에서는 슬라이딩 모드 관측기를 사용한 리튬 배터리의 충전량 예측방법에 대해서 논의한다. 배터리의 비선형 회로 모델링 기법이 소개되고 슬라이딩 모드 관측기를 사용한 충전량 예측기의 설계 방법이 논의된다. 기존의 복잡한 배터리 모델링 방법 대신, 단순화된 저항-커패시터 모델링 방법이 본 연구에서 사용되었다. 단순화된 모델에 의해 발생되는 오차나 불확실성은 슬라이딩 모드 관측기에 의해 보상되었다. 슬라이딩 모드 관측기의 구조는 단순하지만, 모델링 에러나 외란에 대해서 강인한 특성을 보여준다. 제안된 제어기의 수렴성은 등가제어 방법에 의해서 증명되었다. 제안된 시스템의 성능은 UDDS (Urban Dynamometer Driving Schedule) 시험에 의해서 증명되었다. 시험 결과 제안된 시스템은 실제 주행 환경에서도 우수한 추적 성능을 보여주었다.