• 한국자동차공학회논문집
• /
• 제15권6호
• /
• pp.94-101
• /
• 2007

This paper, we analyzed that the measured data of the radiated power spectrum of electromagnetic waves and the standing wave ratio(SWR) of the spark plug cable and spark plug. The measured data are the power strength of the electromagnetic waves radiated from the spark ignition system, the measured frequency ranges are 110 to 610MHz. The results show that the strength of radiated power spectrum and bandwidth have relation to the SWR of the the spark plug cable and spark plug, and the SWR of them is different because of the characteristics of resistor at the spark plug is different with the manufacturers. From the analyzed results, it can be concluded that the less SWR is little, the less maximum level of power spectrum is weak and bandwidth above the reference level is small.

• 대한전기학회논문지:전기물성ㆍ응용부문C
• /
• 제51권12호
• /
• pp.573-577
• /
• 2002

We designed wideband HTS antennas which consists of two triangle -radiation patches using a $YBa_2Cu_3O_{7-X}$ (YBCO) superconducting thin film. The major limitation of high-Tc superconducting (HTS) microstrip antennas is the narrow bandwidth due to the high Q and thin substrate. Defining bandwidth as the frequency range over which standing wave ratio (SWR) 2:1 or less, HTS antenna bandwidths are typically 0.85 % to 1.1 %. Thus considerable effort has been focused on developing antennas for broadband operation. To calculate input impedance and design of the broadband HTS antennas a moment method technique was used. The HTS antenna fabricated in this work was designed for K-band, which is useful band for satellite to satellite communications. The bandwidth obtained was a significant 6.7 % and the other measured performance of our HTS antenna, including the bandwidth, radiation Pattern, efficiency, standing wave ratio (SWR) and return losses was reported.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2002년도 하계학술대회 논문집
• /
• pp.523-526
• /
• 2002

We designed wideband HTS antennas which consists of two triangle-radiation patches using a YBa$_2$Cu$_3$O$\sub$7-x/ (YBCO) superconducting thin film. The major limitation of high-Tc superconducting (HTS) microstrip antennas is the narrow bandwidth due to the high Q and thin substrate. Defining bandwidth as the frequency range over which standing wave ratio (SWR) 2:1 or less, HTS antenna bandwidths are typically 0.85% to 1.1%. Thus considerable effort has been focused on developing antennas for broadband operation. To calculate input impedance and design of the broadband HTS antennas a moment method technique was used. The HTS antenna fabricated in this work was designed for K-band, which is useful band for satellite-to-satellite communications. The bandwidth obtained was a significant 6.7% and the other measured performance of our HTS antenna, including the bandwidth, radiation Pattern, efficiency, standing wave ratio (SWR) and return losses was reported.

• 한국자동차공학회논문집
• /
• 제16권1호
• /
• pp.45-51
• /
• 2008

This paper presents theoretical and experimental analysis on the characteristics of the power spectrum of electormagnetic waves radiating from the spark plug and their cables of a distributorless ignition system. The theoretical study was conducted applying the microwave transmission line theory and the antenna theory. The experimental works were carried out to measure the standing wave ratio(SWR) and the radiation power spectrum of this system. As a result, it has been found that a spark plug and its cable is working as a monopole antenna radiating elelctromagnetic waves. Because of its similar structure to a monopole antenna, the envelope of radiation power spectrum distribution has a bell shape which can be obtained from a monopole antenna operating as a series resonant circuit. The frequency characteristics from the SWR measurements show a similar frequency characteristics of power spectrum of the system studied. Also, it has been found that the density of the power spectrum of the system fitting a long time used spark plug is higher than that of fitting a new spark plug.

• Journal of electromagnetic engineering and science
• /
• 제5권2호
• /
• pp.97-103
• /
• 2005

This paper describes the measured results of sonobuoy transmitting antenna system for anti-submarine warfare (ASW). Since radiation pattern and power density depend on impedance matching between transmitting RF part and antenna with termination resistance, design of matching circuit is very important for sonobuoy system performance. Matching circuit is designed by Smith chart using control of L and C. In standing wave ratio(SWR) measurement using Network Analyzer, SWR of antenna with matching circuit observed 1.5 below at the assigned VHF band. It shows very excellent performance comparison with conversional product that is used for the same object. The measured vertical and horizontal radiation patterns are also shown the satisfaction of military specifications. A drop out of sonobuoy system on the sea is happened when angle of elevation direction is over 10 degrees, and it is conformed that it takes less than I second return to original signal level. The required electric power density is $83\;mW/m^2$ in the military specification, and measured electric power density is observed over average $110\;mW/m^2$ at all frequency bands.

• 한국정보통신학회:학술대회논문집
• /
• 한국해양정보통신학회 2004년도 춘계종합학술대회
• /
• pp.472-474
• /
• 2004

본 연구에서는 변형된 Folded 다이폴 안테나의 특성을 모멘트법을 이용하여 조사하였다. 안테나의 중심주파수는 200MHz, 도선의 반지름은 0.5mm이고 두 개의 선형 다이폴 사이의 간격은 2cm이다. 시뮬레이션 결과 18cm 정도의 내부 sub 변화와 4.5cm 정도의 외부 stub 변화는 SWR 기준으로 3 미만을 유지한다. 이는 변형된 Folded 다이폴 안테나가 추가적인 정합회로 없이 광대역 특성을 보이는 것을 의미한다.

• 한국초전도학회:학술대회논문집
• /
• 한국초전도학회 1999년도 High Temperature Superconductivity Vol.IX
• /
• pp.124-128
• /
• 1999

We report microwave properties of high-T$_c$ superconducting (HTS) microstrip antennas without impedance matching circuits, where the impedance mismatching is obvious under the critical temperature (T$_c$). The superconducting thin films used in this report were YBa$_2Cu_3O_{7-x}$ (YBCO) films deposited on MgO substrates produced by pulse laser deposition (PLD) technique. At around T$_c$, 86 K the reflection coefficient rapidly drops, and the standing wave ratio (SWR) becomes almost unity, and the characteristic impedance based on the Smith chart is nearly 50 ${\Omega}$. The reflection coefficient and the SWR of the HTS microstrip antenna were - 62.52 dB and 1.0015, respectively, at the resonant frequency of 11.812 CHz at 86 K.

• 한국전기전자재료학회논문지
• /
• 제17권7호
• /
• pp.770-775
• /
• 2004

Although $High-T_c $superconducting HTS antennas have high efficiency and high gain, narrow bandwidth due to the high Q is the major limitation for application of satellite communication and mobile communication. Defining bandwidth as the frequency range over which standing wave ratio (SWR) is 2:1 or less, HTS antenna bandwidths are typically less than 1 %. Thus considerable effort has been focused on developing HTS antennas for broadband operation. In this work the HTS antenna array, using the bipin antenna which consisted of two triangle-radiation patches, was designed and fabricated using a ${YBa}_2{Cu}_3{O}_7x (YBCO)$ superconducting thin film on a MgO substrate for broadband operation. Also gold antennas with the same dimension as our HTS antennas were fabricated on the MgO substrate for the comparison. Experimental results for both antennas were reported in terms of radiation patterns, return losses, bandwidths and other various characteristics. The center frequency of HTS antennas was 20.28 GHz and the bandwidth obtained was significant 10 %.

• 한국정보통신학회:학술대회논문집
• /
• 한국해양정보통신학회 2000년도 추계종합학술대회
• /
• pp.190-195
• /
• 2000

본 논문에서는 IMT-2000(International Mobile Telecommunication-2000) 휴대용 단말기 수신 주파수인 2.13 - 2.16 GHz 대역의 저잡음 중폭기(LNA ; Low Noise Amplifier)를 직렬 피드백과 저항결합 회로룰 이용하여 설계.구현하였다. 소스 리드에에 부가된 직렬 피드백은 중폭기의 저잡음 특성을 유지하면서 동시에 입력 반사계수를 작게 하고, 또한 대역내의 안정성을 향상시키는 역할을 하였다. 사용된 저항 결합회로는 저주파 영역의 신호를 정합 회로내의 저항을 통해 소모시킴으로써 저잡음 중폭기의 설계시 입력단 정함에 용이하였다. 저잡음 중폭기의 설계.제작에서 저잡음 증폭단에는 HP사의 GaAs FET인 ATF-10136을, 이득 증폭단에는 Mini-Circuit사의 내부 정합된 MMIC인 VNA-25를 사용하였다. 전원회로는 자기 바이어스(Self-bias) 회로를 사용하였고, 유전율 3.5인 테프론 기판 상에 장착하였다. 이렇게 제작된 저잡음 증폭기는 대역 내에서 30 dB 이상의 이득과 0.7 dB 이하의 잡음지수, $P_{ldB}$ 17 dB 이상, 그리고 입.출력 정재파비가 1.5 이하인 특성을 나타내었다.다.

• 한국항해학회지
• /
• 제25권1호
• /
• pp.53-60
• /
• 2001

본 논문에서는 IMT-2000 수신주파수인 2.13~2.16 GHz 대역에서 초고주파용 수신장치로 사용되는 저잡음증폭기를 ㅈㄱ렬 피드백 기법과 저항결합회로를 이용하여 구현하였다. GaAs FET(Field Effect Transistor)의 소스단에 부가한 직렬 피드백은 저잡음증폭기의 저잡음특성과 입력반사계수가 작아졌으며, 또 저잡음증폭기의 안정도도 개선되었다. 저항결합회로는 반사되는 전력이 정합 회로내의 저항에서 소모되므로 입력단정합이 용이하였다. 저잡음증폭기의 저잡음증폭단은 GaAs FET인 ATF-10136, 고득증폭단은 내부정합된 MMIC인 VNA-25를 사용하였으며, 알루미늄 기구물 안에 유전율 3.5인테프론 기판에 초고주파회로와 자기바이어스 회로를 함께 장착시켰다. 이렇게 제작된 저잡음증폭기는 30 dB이상의 이득, 0.7dB 이하의 잡음지수, 17 dB의 Pldb, 1.5 이하의 입출력 정재파비를 얻었다.