• IE interfaces
• /
• v.22 no.3
• /
• pp.214-222
• /
• 2009

In the early design stage, system reliability must be estimated from life testing data at the component level. Previously, a point estimate of system reliability was obtained from the unbiased estimate of the component reliability after assuming that the number of failed components for a given time followed a binomial distribution. For deriving the confidence interval of system reliability, either the lognormal distribution or the normal approximation of the binomial distribution was assumed for the estimator of system reliability. In this paper, a new estimator is used for the component level reliability, which is biased but has a smaller mean square error than the previous one. We propose to use the beta distribution rather than the lognormal or approximated normal distribution for developing the confidence interval of the system reliability. A numerical example based on Monte Carlo simulation illustrates advantages of the proposed approach over the previous approach.

• Journal of Communications and Networks
• /
• v.11 no.1
• /
• pp.42-46
• /
• 2009

Superimposed training (SIT) design for estimating of time-varying multipath channels is investigated for mobile orthogonal frequency division multiplexing (OFDM) systems. The design of optimum SIT consists of two parts: The optimal SIT sequence is derived by minimizing the channel estimates' mean square error (MSE); the optimal power allocation between training and information data is developed by maximizing the averaged signal to interference plus noise ratio (SINR) under the condition of equal powered paths. The theoretical analysis is verified by simulations. For the metric of the averaged SINR against signal to noise ratio (SNR), the theoretical result matches the simulation result perfectly. In contrast to an interpolated frequency-multiplexing training (FMT) scheme or an SIT scheme with random pilot sequence, the SIT scheme with proposed optimal sequence achieves higher SINR. The analytical solution of the optimal power allocation is demonstrated by the simulation as well.

• Journal of Biomedical Engineering Research
• /
• v.5 no.2
• /
• pp.133-142
• /
• 1984

The EMG signal can be considered as a signal source that expresses the intention of man because it is a electrical signal generated when the man contracts muscles. For proportional control of prostheses, the control signal proportional to the mousle contraction level must be estimated. Typically a foul-wave rectifier and low-pass filter are used to estimate the proportional control signal from the EMG signal. In this paper, it is proposed to use a logarithmic transformation and a linear minimum mean square error estimator. A logarithmic transformation maps the myoelectric signal into an additive control signal-plus-noise domain and the Kalman filter is used to estimate the control signal as a linear minimum mean square error estimator. The performance of this estimator is verified by the computer simulation and the estimator is applied to the EMG obtained from the biceps brachii muscle of normal subjects.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2006.05a
• /
• pp.113-114
• /
• 2006

Vibration of a non-linear system under random excitations was evaluated by probabilistic methods. The non-linear characteristic terms of a system structure were quasi-linearized and excitation terms were remained as they were. An analytical method where the square mean of error was minimized was used. An alternative method was an energy method where the damping energy and restoring energy of the linearized system were equalized to those of the original non-linear system. The numerical results were compared with those obtained by Monte Carlo simulation. The comparison showed the results obtained by Monte Carlo simulation located between those by the analytical method and those by the energy method.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.29 no.12
• /
• pp.969-975
• /
• 2018

The main function of the tracking radar is to automatically track the target. The amplitude-comparison monopulse radar utilizes a monopulse radar to estimate the angular components of a target. In this paper, the operating performance of the amplitude-comparison monopulse radar is quantitatively analyzed via the MSEs, with considerations on additive noise. The performance of the amplitude comparison monopulse radar can be predicted by comparing it with an approximated estimate.

• Journal of the Korean Society for Precision Engineering
• /
• v.23 no.12 s.189
• /
• pp.72-79
• /
• 2006

Vibration of a non-linear system under random parametric excitations was evaluated by probabilistic methods. The non-linear characteristic terms of a system structure were quasi-linearized and excitation terms were remained as they were An analytical method where the square mean of error was minimized was used An alternative method was an energy method where the damping energy and restoring energy of the linearized system were equalized to those of the original non-linear system. The numerical results were compared with those obtained by Monte Carlo simulation. The comparison showed the results obtained by Monte Carlo simulation located between those by the analytical method and those by the energy method.

• Journal of Communications and Networks
• /
• v.14 no.3
• /
• pp.273-279
• /
• 2012

In this paper, we propose an iterative interstream interference cancellation technique for system with frequency selective multiple-input multiple-output (MIMO) channel. Our method is inspired by the fact that the cancellation of the interstream interference can be regarded as a reduction in the magnitude of the interfering channel. We show that, as iteration goes on, the channel experienced by the equalizer gets close to the single input multiple output (SIMO) channel and, therefore, the proposed SIMO-like equalizer achieves improved equalization performance in terms of normalized mean square error. From simulations on downlink communications of $2{\times}2$ MIMO systems in high speed packet access universal mobile telecommunications system standard, we show that the proposed method provides substantial performance gain over the conventional receiver algorithms.

• Journal of the Korean Data and Information Science Society
• /
• v.23 no.6
• /
• pp.1271-1277
• /
• 2012

In this paper, we propose an estimation method of the parameter in an exponential distribution based on a progressive Type I interval censored sample with semi-missing observation. The maximum likelihood estimator (MLE) of the parameter in the exponential distribution cannot be obtained explicitly because the intervals are not equal in length under the progressive Type I interval censored sample with semi-missing data. To obtain the MLE of the parameter for the sampling scheme, we propose a method by which progressive Type I interval censored sample with semi-missing data is converted to the progressive Type II interval censored sample. Consequently, the estimation procedures in the progressive Type II interval censored sample can be applied and we obtain the MLE of the parameter and survival function. It will be shown that the obtained estimators have good performance in terms of the mean square error (MSE) and mean integrated square error (MISE).

• Journal of Korean Society for Quality Management
• /
• v.38 no.3
• /
• pp.408-412
• /
• 2010

In this note, we deal with a design problem for determining the levels of noise factors in the Taguchi method. Recently, Ree(2009) proposed a new method to determine the levels of noise factors that is dependent on the distribution of the noise factors. We discuss the original suggestion from Taguchi method, propose a way to compare the two methods and investigate the performance(mean square error) of two proposals by examples.

• Journal of the Korean Society of Systems Engineering
• /
• v.16 no.1
• /
• pp.58-67
• /
• 2020

A big data processing method to predict solar power generation using systems engineering approach is developed in this work. For developing analytical method, linear model (LM), support vector machine (SVN), and artificial neural network (ANN) technique are chosen. As evaluation indices, the cross-correlation and the mean square root of prediction error (RMSEP) are used. From multi-variable comparison test, it was found that ANN methodology provides the highest correlation and the lowest RMSEP.