• The Journal of Korean Institute for Practical Engineering Education
• /
• v.2 no.1
• /
• pp.42-46
• /
• 2010

One way of engineering education fiber optic splicing loss was introduced. To make high sensitivity fiber optic sensor it is required low loss of splicing. Hence in this paper splicing loss was selected in the experiments and the splicing loss was evaluated based on the engineering education. After trials in the experiments fiber optic splicing loss depended upon the experimental attitude and its environments.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.18 no.6
• /
• pp.841-847
• /
• 1993

The evaluation methods of the splicing loss in attenuation characteristics of optical fiber were measured and analyzed presently, the splicing loss of single mode optical fiber is measured by the cut-back technique and the backscattering technique. Comparing the splicing loss measured by above two technique, evaluation method of splicing loss measured by backscattering technique (OTDR) shall be calculated by the splicing loss is occurred due to difference of the backscattering coefficient in the spliced fibers. Thus. this analysis of the splicing loss is certainly applied in installation of the optical fiber cables for management of the data.

• Korean Journal of Optics and Photonics
• /
• v.19 no.3
• /
• pp.169-174
• /
• 2008

In this paper, we have presented techniques to reduce the splicing loss between standard single mode fiber and high ${\Delta}$ single mode fiber based on the mode expanding and mode evolution induced by thermal treatment of the fibers. The experimental results show that mechanical splicing loss can be reduced from 2.3 dB to 0.1 dB through proper thermal treatment of the high ${\Delta}$ fiber. Meanwhile, we achieved $0.2{\sim}0.4dB$ of low splicing loss between two fibers by heating the splicing region using electric arcing or an oxygen flame.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.46 no.7
• /
• pp.15-21
• /
• 2009

We proposed a fusion splicing method for low splicing loss between a single-mode fiber(SMF) and two different photonic crystal fibers(PCFs) such as a photonic bandgap fiber(PBGF) and highly nonlinear photonic crystal fiber(NL-PCF). The splicing loss between the SMF and PBGF is affected by air-hole collapse. Therefore, we optimized fusion splicer and reduced a splicing loss below 1.22 dB. We also inserted a Intra High Numerical Aperture(UHNA) fiber between the SMF and NL-PCF to achieve a splicing loss of below 2.59 dB.

• 한국정보통신설비학회:학술대회논문집
• /
• 2006.08a
• /
• pp.105-110
• /
• 2006

The most sensitive part of the installed optical cable is the optical loss variation of the splicing point according to the environmental changes. This paper presents the details of the experimental results of the external environmental changes on optical loss, such as bending, temperature variation, temperature variation after water osmosis and variation. Through the bending test of optical fiber, rapid increase of optical loss was measured within the diameter of 30mm. The result of optical loss variation within the temperature range of $-30^{\circ}C{\sim}60^{\circ}C$ is less than 0.02dB. It was confirmed that the maximum optical loss increased up to 0.2dB in case of water osmosis within the temperature range of $-40^{\circ}C{\sim}80^{\circ}C$. There is small optical loss variation of 0.01dB under the 1mm vibration test. The experimental results of this paper can be used as the reference data for the design of the optical fiber cable splicing enclosure to protect the optical loss variation due to environmental changes.

• Journal of Microbiology
• /
• v.33 no.2
• /
• pp.160-164
• /
• 1995

The splicing activity of T4 phage td intron RNA has been examined with various Mg$^{2+}$ ions such as MGCl$_{2}$, MgS $O_{4}$ and magnesium acetate using various splicing conditions such as different incubation time and temperature. The maximum splicing of td intron RNA occurred at the concentration of 5 mM MgCl$_{2}$. Raising the Mg$^{2+}$ concentration up to 15 mM appeared to promote P2 delection mutant to overcome the loss of some splicing activity. In both wild type and mutant, a complete hydrolysis of RNA occurred at 30 mM MgCI$_{2}$ MgS $O_{4}$ and magnesium acetate exhibited the rate and pattern of RNA splicing identical to MGCI$_{2}$. The optimal splicing conditions involve the incubation of RNA with 5 mM MgCI$_{2}$ at 58 .deg.C for 15 min. The results suggest that Mg$^{2+}$ may play a key role in the catalytic mechanism of td intron RNA.n RNA.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.11 no.2
• /
• pp.349-357
• /
• 2007

The most sensitive part of the installed optical fiber fable is the optical loss variation of the splicing part according to the environmental changes. This paper presents the details of the experimental results of the external environmental changes on optical loss, such as bending, temperature variation, temperature variation after water osmosis and vibration. Through the bending test of optical fiber, rapid increase of optical loss was measured within the radius of 30mm. The result of optical loss variation within the temperature range of $-30^{\circ}C{\sim}60^{\circ}C$ is less than 0.02dB. It was confirmed that the maximum optical loss increased up to 0.2dB in case of water osmosis within the temperature range of $-40^{\circ}C{\sim}80^{\circ}C$. There is small optical loss variation of 0.01dB under the 1mm vibration test. The experimental results of this paper can be used as the reference data for the design of the optical fiber cable splicing enclosure to protect the optical loss variation due to environmental changes.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.48 no.9
• /
• pp.6-12
• /
• 2011

In this paper, we propose a design method for a reliable and improved field-installable optical connectors(FIOC) which are needed for long-distance and low loss FTTH configuration. To this end, we optimize the angle of splicing between the inner fiber and the field fiber of the FIOC, so that the low loss connection of optical fibers is possible without using any angle alignment tools as well as angled cleavers. More precisely, we set the cutting angle of the inner filber and the field fiber to be $2^{\circ}$ by using an angled cleaver and $0^{\circ}{\sim}1^{\circ}$ by using a general fiber cutter, respectively. Splicing these two optical fibers without any further adjustment, we can keep the insertion loss within 0.3dB and the reflection loss within -60dB.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.16 no.12
• /
• pp.1266-1273
• /
• 1991

Attenuation losses and repeater spans of single-mode optical fibers installed in the long hual optical transmission line were measured and analyzed. The average loss including splicing points was appeared to be 0.55 0.05dB/km and 0.59 0.01dB/km at 1300nm and 1550nm, respectively, and showed lager value at 1550nm window, The cause of loss increase at 1550nm range from the OTDR measurement was due to the inappropriate treatment of extra length of fiber at the splicing points. And average repeater span of domestic long haul line was 24 7km and 90% of total sampled repeater spans was within 31 km.

• BMB Reports
• /
• v.44 no.11
• /
• pp.725-729
• /
• 2011

We report a novel mechanism of a CDH1 splicing mutation in a patient with signet ring cell carcinoma of the stomach. A 27-year-old man complaining of aggravated dyspepsia was diagnosed with signet ring cell carcinoma. Both his father and uncle had died of stomach cancer at a young age. DNA sequencing analysis of the CDH1 gene revealed a splice site mutation (c.833-2A>G). By RNA/cDNA sequencing analysis, CDH1 c.833-2A>G generated a new acceptor site within intron 6, causing the insertion of a 79-bp intronic sequence between exon 6 and 7 (r.833-79_833-1ins), and resulting in a frame shift. E-cadherin immunohistochemical staining revealed a loss of CDH1 expression. This study reveals the disease-causing mechanism of this splicing mutation, and emphasizes the need for functional studies using RNA samples for the accurate interpretation of detected splicing variant. This is the first reported case of a CDH1 mutation in a Korean patient.