• Journal of the Korean Wood Science and Technology
• /
• 제34권2호
• /
• pp.1-9
• /
• 2006

The structural wooden members of the ancient building are deteriorated by fungi and termite over time. The deteriorate of the members causes the decrease of the specific gravity and the strength of it, so the stability of the building is threatened. Therefore, in this study, the evaluation of the specific gravity, which is correlated with the strength of the wood, was conducted in the post member using Nondestructive Evaluation (NDE) - Drilling Resistance Test (DRT). For the purpose of it, the specific gravity and drilling resistance of small specimens was measured to obtain the correlation between the specific gravity and the drilling resistance. And then, the drilling resistance test of the post members, which were expected to have the deteriorated parts, was performed. Consequently, the correlation between the specific gravity and the drilling resistance was very high ($R^2=0.89$) and the distributions of the specific gravity were evaluated for the each member. Also, the results were verified by the visual inspection of the cross section of it. Especially, the various variations of the wood member such as the deteriorated parts with termite or fungi and the crack could be detected exactly but the knot couldn't because the drill could pass by or could not penetrate the knot.

• Journal of the Korean Wood Science and Technology
• /
• 제18권3호
• /
• pp.6-16
• /
• 1990

The objectives of this study were to investigate the relative effects of specific gravity and particle size on internal bond and tensile strengths and fracture toughness of particleboard and to compare mechanical strength with fracture toughness. The particleboard was manufactured with three different particle sizes at specific gravity levels of 0.6, 0.7, and 0.8 with a resin content of 10% based on oven dry weight. The results were summarized as follows: 1. Internal bond strength. fracture toughness in internal bond test. maximum tensile strength, and fracture toughness in tension test increased with the increase of specific gravity of particleboard. 2. As partcle size increased, internal bond strength, fracture toughness. maximum tensile strength. and fracture toughness in tension test increased. 3. The maximum tensile strength and fracture toughness appeared to be in a direct relationship, and then maximum tensile strength could be used for predicition of fracture toughness for tension test. 4. The fracture toughness in internal bond test was somewhat independent on induced crack length.

• 한국가구학회지
• /
• 제23권3호
• /
• pp.324-331
• /
• 2012

The domestic pine was used to investigate the change of specific gravity, moisture contents, color and anatomical structure by accelerated weathering test (AWT). According to visual inspection, a few knot separation and looseness as well as considerable surface discoloration was found out. However, the crack and split of surface texture have been never occurred till the last step of AWT. On the whole, as the time of accelerated weathering test has increased, the specific gravity has decreased. Finally, after the 9th week of AWT, the specific gravity was 0.38 that reached to 82% compared to the control specimen. In case of moisture content (MC), it showed rising trend in its early stages, however, after 3th week of AWT it have displayed steady state. A deterioration of cell-wall components was not remarkably observed by scanning electron microscope (SEM), however the ray fractures of AWT specimen were observed more than those of control specimen. The full fracture of epithelial cell around resin canal was observed by optical microscope. The fracture of ray of 2th cycle AWT specimen was first, followed by 1th week and control group. A distortion of tracheid for early spring wood and fracture of epithelial cell were generally observed by a similar level, regardless of duration time of AWT. Therefore, it is obvious that increasing duration time of AWT does not affect the deterioration of micro-structure for wood members from this study. Although a considerable change of anatomical properties was not found, there is a need of further research to understand how will the changes of specific gravity and MC on the physical properties of wood member.

• 유체기계공업학회:학술대회논문집
• /
• 유체기계공업학회 1999년도 유체기계 연구개발 발표회 논문집
• /
• pp.90-96
• /
• 1999

In contracts for sales of natural gas between sellers and buyers, it is not suncient to only measure a volumetric quantity of gas in flowing conditions in metering station. Therefore the measured volumetric quantity must be converted to that of reference conditions. The density of the natural gas required in such a calculation can be measured directly or estimated from the equation of sate or any other experimental methods. The specific gravity meter is the apparatus used to measure the density of fluids under the reference conditions and it can be widely used in industrial areas, especially in massive flow rate natural gas industry. This study has been carried out in an attempt to improve measurement accuracy of natural gas flow rate calculation, providing the adequate installation and proper operation conditions of specific gravity meter. The test results are 1) the density measurement errors in case of using methane and standard gas as calibration gases are smaller than using methane and nitrogen gas, 2) the periodical calibration to maintain accurate density measurements is essential, and 3) the specific gravity meter is sensitive to changes of environmental conditions, especially environmental temperature surrounding the specific gravity meter.

• 콘크리트학회지
• /
• 제9권2호
• /
• pp.137-144
• /
• 1997

발수제의 유무와 알루미늄분말의 분말도 및 첨가량을 조절하여 비중을 0.4에서 0.7로 변화시켜 비중과 ALC의 기초물성, 내동해성 및 내구성과의 관계를 조사하였다. 압축 및 인장강도는 비중이 0.4에서 0.7로 증가함에 따라 발수제의 첨가량에 관계없이 증가하였고 발수제의 첨가량이 증가하면 내동해성은 개선되었으며 흡수율은 감소하였다. 입경이 작은 AI분말을 이용항 제조한 ALC의 박리에 의한 체적감소율은 낮게 나타났으며 일면동결지속시험 및 기중동결수중융해시험에서도 내동해성이 우수한 것으로 나타났다.

• 화약ㆍ발파
• /
• 제22권2호
• /
• pp.45-54
• /
• 2004

본 연구논문에서는 우리나라 주요 석재인 마천석 원석을 경남 함양군 마천면 기흥리에 위치한 마천석재, 덕우석재을 방문하여 원석과 판석을 색상, 조직, 구성광물, 입도의 차이에 따라 마천석 원석 17개를 채취하였다. 본 현장에서 채취한 시료에 대한 비중. 공극율. 흡수율. Point Load Test, 삼축압축시험, Brazilian Test, 암석학적 시험 및 분석, 화학적 시험 및 분석을 통해 마천석 원석의 물리적 특성을 규명하여 석재의 용도에 따른 타당성을 파악하는데 목적이 있다.

• 청정기술
• /
• 제8권2호
• /
• pp.67-76
• /
• 2002

Dewatered sludge of 400,000t/y from water treatment plants in Korea is being disposed through landfill and ocean dumping. However, the disposal is posing more and more serious environmental problems at the same time not only because of landfill site shortage in municipal suburbs, but because of the concern it will contaminate the oceans. In this study, the research on utilizing the sludge dried by flash dryer as covering soil in the landfill sites was carried out to solve these problems on environmental affinity. Both dewatered and dried sludge were exposed to the natural condition and observed according to the atmospheric changes. An experiment of soil engineering characteristics of the dried sludge and tests on mixed sludge(silty sandy soil : dried sludge = 10:90 ~ 30:70) such as particle size distribution, liquid and plastic limit, moisture content, specific gravity and compaction test were carried out. According to the compaction test, the compaction was confirmed as the optimum water content ratio was observed in the condition of SM-silty sand of particle size distribution, NP of liquid and plastic limit, 101.4% of moisture content, 2.04~2.12 of specific gravity. The results showed that dried sludges mixed with at least 30% of natural soil could be used as daily covering soil in the landfill sites.

• Korean Chemical Engineering Research
• /
• 제40권6호
• /
• pp.676-680
• /
• 2002

기준 밀도계는 기준 조건하에서 밀도를 측정하는 기기로서, 산업계에서 특히 대유량 천연가스 계량에 폭 넓게 사용된다. 본 연구에서는 기준 밀도계의 적정 설치 및 운영방안을 제시하여 천연가스 유량 측정 정확도를 향상시키고자 현장 실험을 수행하였다. 실험 결과, 교정가스로 메탄과 질소가스 대신 메탄과 표준가스로 교정한 실험결과가 작은 밀도오차를 발생하고, 정확한 밀도 측정을 위해서는 정기적인 교정이 필수적이며, 또한 기준 밀도계는 주위 조건에 민감하게 반응하여, 주위 온도가 높으면 오차가 증가하는 것도 확인되었다.

• 동아시아식생활학회지
• /
• 제7권2호
• /
• pp.159-165
• /
• 1997

The primary objective of this study was to learn the effect of various sugar particle size and level on cookie spread, The effect of sugar particle size and level on sugarsnap cookie spread was studied. Three different particle sized sugars; powered sugar, granulated sugar and sanding sugar, were used for the cookie test baking with five different sugar levels; 30, 45, 60, 75 and 90% based on the weight of flour. In mixing process, 5 minutes of creaming time was used for cream making and then the specific gravity of cream was measured on the basis of each different sugar particle size and level. In the result, the specific gravity of cream was influenced by sugar particle size and sugar level. However, the specific gravity of cream had no influence on cookie dough specific gravity. Cookie spread was influenced by sugar particle size and sugar level. Greater cookie spread was obtained by decreasing sugar particle size and increasing sugar level resulted in increased spread. Therefore, selection of suitable sugar particle size and its use level can be factors in controlling spread and imparting desired packaging characteristics.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2010년도 추계 학술발표회
• /
• pp.951-954
• /
• 2010

There are lots of soft ground improvement methods which is consist of different materials. In the analysis and design, composite ground method is usually regarded. Composite ground method considers the area replacement ratio as a key parameter to combine the physical and mechanical characteristics of tow different material. In this study, using composite material consist of three different materials which have different diameters, series of specific gravity test were performed according to KS F 2308, to investigate the applicability of composite ground method. As a result, it is found that composite material which is consist of fine grained soil and granular soil has a high applicability of composite ground method. This result means that, in estimating of ground properties of composite material which is consist of similar fine grained material such as cement mixing etc., composite ground method has a less applicability.