• 한국환경과학회지
• /
• 제11권3호
• /
• pp.235-240
• /
• 2002

The blocks using flyash were prepared in this study. The characteristic of sound absorption of flyash block was investigated. It was revealed that the chemical additives and flyash played an important role to determine the characteristic of sound absorption. Chemical additive affects the capability of sound absorption while flyash affects the characteristic of sound absorption, i.e. high value of the sound absorption coefficient at the specific frequencies(1KHz and 2KHz). The flyash block showed higher sound absorption coefficient than that of the commercial concrete block having carpet on the surface. It was also shown that the sound absorption coefficient increases with increase of the content of flyash in the block. However, it was found that the 70wt% of flyash in the flyash block was the optimum content to obtain the highest sound absorption coefficient.

• 소음진동
• /
• 제7권5호
• /
• pp.781-787
• /
• 1997

A new method is presented to determine two fundamental acoustic quantities of sound-absorbing materials such as characteristic impedance and propagation constant. In this study, the surface acoustic impedances of sound-absorbing materials are measured using the impedance tube and the anechoic chamber to determine the above acoustic quantities. The measured results are given for two typical sound-absorbing materials(glass wool and urethane foam) int the frequency range between 150 and 1, 600 Hz. The results are verified by other two known methods, which are Smith & Parrott method and Utsuno et al. method. The absorption coefficients calculated from the empirical models(Miki model for glass wool and Jung model for urethane foam) and two quantities by present method are in good agreement with the measured values.

• 한국항해항만학회:학술대회논문집
• /
• 한국항해항만학회 2004년도 춘계학술대회 논문집
• /
• pp.55-60
• /
• 2004

이 논문은 기적음이 선박 선교에 전달되는 음향전달특성의 측정기술에 관한 것이다. 실습선 ‘새누리호’를 대상으로 선교 내부에 전달되는 기적음을 선교문 개폐상태에 따라서 B＆K 2260D으로 측정한 후, B＆K 7830소프트웨어를 이용하여 주파수특성을 축출하였다. 측정한 주파수 특성을 이용하여 주파수 샘플링에 의한 FIR 필터 설계법으로 128차 FIR 필터를 구축하였다. 그리고, 기적원음과 FIR 필터의 콘볼류션 연산으로 실험음을 생성한 후, 6단계 평가지표를 이용하여 측정한 음향전달특성을 평가하였다. 평가결과, 실험음이 실제 선교에서 듣는 음과 '유사함'을 나타내는 A／sub s／=3.3∼4.7로 나타나서 본 연구에서 개발한 기법이 선교의 음향전달특성 측정기술로서 유효함을 확인하였다.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2012년도 춘계학술대회 논문집
• /
• pp.311-315
• /
• 2012

In these days, promising renewable energy, wind turbine is clean energy but has an environmental pollutant which is noise. Noise assessment is one of the major performance evaluations for wind turbine and nowadays, developing and research for measurement and method of the assessment considering environmental pollutants is being important. Object in this study is that figuring out sound power characteristic of the gearbox for wind turbine through measuring sound intensity. In back-to-back test, we can figure out the noise characteristic of the gearbox for wind turbine through comparing and measuring sound pressure level, sound power level in operating at the each load condition respectively.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2007년도 추계학술대회논문집
• /
• pp.1145-1148
• /
• 2007

Resilient materials are generally used for the floating floors to reduce the floor impact sound. Dynamic stiffness of resilient material, which has the most to do with the floor impact sound reduction. The resilient materials available in Korea include EPS (Styrofoam), recycled urethane types, EVA (Ethylene Vinylacetate) foam rubber, foam PE (Polyethylene), glass fiber & rock wool, recycled tire, foam polypropylene, compressed polyester, and other synthetic materials. In this study, we tested floor impact sound reduction characteristic to a lot of kinds of resilient material. The result of test showed that the amount of the heavy-weight impact sound reduction appeared by being influenced from this dynamic stiffness of resilient material. The dynamic stiffness looked like between other resilient materials, a similar to the amount of the heavy-weight impact sound reduction was shown.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2008년도 춘계학술대회논문집
• /
• pp.830-834
• /
• 2008

Resilient materials are generally used for the floating floors to reduce the floor impact sound. Dynamic stiffness of resilient material, which has the most to do with the floor impact sound reduction. The resilient materials available in Korea include EPS (Styrofoam), recycled urethane types, EVA (Ethylene Vinylacetate) foam rubber, foam PE (Polyethylene), glass fiber & rock wool, recycled tire, foam polypropylene, compressed polyester, and other synthetic materials. In this study, we tested floor impact sound reduction characteristic to a lot of kinds of resilient material. The result of test showed that the amount of the Light-weight impact sound reduction appeared by being influenced from this dynamic stiffness of resilient material. As the decreasing dynamic stiffness of resilient material, the impact sound reduction amount is increased, especially in the low frequency domain.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2005년도 봄학술 발표회 논문집(II)
• /
• pp.449-452
• /
• 2005

Sound absorption coefficient is affected by void in sound absorbing materials, therefore it is important to analyze properties of void pore. Also, it can be used to estimate performance of foamed concrete when it is applied to absorb sound. The purpose of this study is to analyze the sound absorption coefficient and void characteristic of foamed concrete using bottom ash. As a result of experiment, it was determined that an increase in sound absorption coefficient is achieved by increasing added amount of foam.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 1997년도 추계학술대회논문집; 한국과학기술회관; 6 Nov. 1997
• /
• pp.263-270
• /
• 1997

For a cylinder in a uniform flow stream, sound is generated by the fluctuating pressure on the cylinder surface due to the vortex shedding behind the cylinder. It is known that the major parameters to predict the sound pressure are the characteristic length of the flow along the cylinder axis and the fluctuating lift coefficient. These parameters strongly depend on the Reynolds number and the yaw angle of the cylinder to the free stream. In this experimental study the effects of yaw on the flow parameters, and consequently on the generated sound are investigated. The surface pressure and the radiated sound are measured simultaneously for different yaw angles and showed that the reduced normal velocity component to the cylinder axis reduces the unsteady lift fluctuation which results in lowered sound press-are level, However, experimental result shows that "the cosine law" which uses the normal velocity component as a characteristic velocity for noise Generation from a yawed cylinder needs to be carefully reviewed. reviewed.

• 만화애니메이션 연구
• /
• 통권20호
• /
• pp.87-104
• /
• 2010

애니메이션은 일반 영화와 마찬가지로 이미지와 사운드가 결합하여 의미와 감동을 만들어낸다. 유리 노르슈테인의 <이야기 속의 이야기>는 다양한 음악과 음향효과가 이미지와 잘 결합했다는 점에서, 애니메이션 사운드 분석의 좋은 사례가 되는 작품이다. 본 연구는 이 작품 속에서 사운드가 어떤 기능을 하면서 의미를 만드는가를 분석하는데 초점을 맞춘다. 일반적으로 사운드는 대사, 음악, 음향효과라는 세 개의 영역으로 나눠지며, 애니메이션은 각 영역에 독특한 미학적 특성이 있다. 대사에 사용되는 목소리는 캐릭터의 이미지에 맞춰 창조되며, 음악에서는 특별히 이미지와 리듬의 결합이 중요하다. 음향효과 면에서도 애니메이션에서는 단순한 소리의 모사가 아닌 움직임의 묘사라는 성격이 강하다. 본 연구는 이 세 가지 영역으로 나눠 사용된 사운드를 분석하되, 청점과 주관적 사운드, 사이음의 개념도 분석을 위해 사용했다. 작품에 사용된 러시아 자장가는 멜로디의 변주와 반복을 통해 전체 내러티브의 모티브로 기능을 한다. 아기와 늑대의 청점을 통한 주관적 사운드의 사용은 작품의 중심을 이루고 있는 캐릭터에 특별한 위상을 부여한다. 음악과 이미지의 반복적 결합, 음향효과의 언어적이고 주석적인 기능, 그리고 비교적 관습적인 음악과 음향사용은 작품의 가독성과 감동을 높여준다는 것들은 이 작품의 전체적 사운드사용의 특징이다.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2001년도 추계학술대회논문집 II
• /
• pp.1341-1346
• /
• 2001

In this study, the acoustic properties of steel-wire sound absorbing materials with different thickness and bulk density were investigated in terms of characteristic impedance, propagation constant, and absorption coefficient. The well-known two-cavity method was used for evaluating those acoustic parameter values in experiments. Also, in order to validate the experimentally measured values, the results were compared with the results obtained from Chung and Blaser's transfer function method and SWR method. The experimentally measured values of normal absorption coefficients were generally agreed well with the corresponding values from the transfer function method and the SWR method. Based on the experimental results, the following conclusions could be made. The magnitude of the absorption coefficient and the frequency range of the maximum absorption coefficient were controllable by changing the thickness and bulk density of the sound absorbing materials. Also, the magnitude of the absorption coefficient depended on the characteristic impedance and the propagation constant. As large as the air cavity depth at the rear side of the steel-wire sound absorbing materials, the maximum magnitude of the absorption coefficient occurred at the lower frequency ranges.