• 한국태양에너지학회:학술대회논문집
• /
• 한국태양에너지학회 2008년도 춘계학술발표대회 논문집
• /
• pp.142-147
• /
• 2008

Limited fossil fuels and unstable energy supply are considered as one of the critical problems in architecture requiring large amounts of energy. In order to this challenge, environment-friendly architecture design is required. Especially, Application of solar energy as a clean energy source and one kind of renewable energy. Many sites however are mainly concentrated in the developed countries, and are scarcer within the developing world. Simple radiation estimation models using meteorologically observed input parameters are often used in the applications requiring rough estimations of solar radiation. In this paper, measurements of global solar radiation and cloud data hours in climatological locations in South Korea are used to develop an estimation in solar radiation. The results of measured data are compared with the results obtained from equations, internationally accepted correlations.

• 한국태양에너지학회 논문집
• /
• 제32권6호
• /
• pp.44-52
• /
• 2012

In all building's energy simulation applications, solar radiation must be calculated on inclined surfaces. Various solar radiation models based on measured data of specific region were used in building simulation programs. Therefore, we should choose the appropriate solar radiation model for Seoul. The purpose of this study is to compare four solar radiation models on inclined surfaces that are widely used in building energy simulations. In this case, it can be said the appropriate model in Seoul is the Isotropic model.

• Journal of Power Electronics
• /
• 제14권6호
• /
• pp.1281-1292
• /
• 2014

Photovoltaic (PV) solar systems with series-connected module integrated converters (MICs) are receiving increased attention because of their ability to create high output voltage while performing local maximum power point tracking (MPPT) control for individual solar panels, which is a solution for partial shading effects in PV systems at panel level. To eliminate the partial shading effects in PV system more effectively, sub-MICs are utilized at the cell level or grouped cell level within a PV solar panel. This study presents the results of a series-output-connection MPPT (SOC-MPPT) controller for sub-MIC architecture using a single sensor at the output and a single digital MPPT controller (sub-MIC SOC-MPPT controller and architecture). The sub-MIC SOC-MPPT controller and architecture are investigated based on boost type sub-MICs. Experimental results under steady-state and transient conditions are presented to verify the performance of the controller and the effectiveness of the architecture.

• 한국태양에너지학회 논문집
• /
• 제25권1호
• /
• pp.65-78
• /
• 2005

The objective of this paper is to develop a automatic computation module for optimum stories in apartment buildings in order to assure the solar access right for neighboring areas. Compared to the existing solar access right analysis programs, the proposed solar access right analysis program is more improved and expanded by automating the computing process of optimum stories in apartment buildings. With the result of this research, it would be possible to furnish advanced information for an amicable settlement against the civil petition and disputes, to reduce waste of the time and money, and to improve the efficiency of solar access right analysis works.

• Advances in Computational Design
• /
• 제3권4호
• /
• pp.319-338
• /
• 2018

High-performing architecture should be designed by taking into account the mutual dependency between the new building and the local context. The performative architecture plays an important role to avert any unforeseen failures after the building has been built; particularly ones related to the microclimate impacts that affect the human comfort. The use of the concept of solar envelopes helps designers to construct the developable mass of the building design considering the solar access and the site obstruction. However, the current analysis method using solar envelopes lack in terms of integrating the detailed information of the existing context during the simulation process. In architectural design, often the current site modelling not only absent in preserving the complex geometry but also information on the surface characteristics. Currently, the emerging applications of point clouds offer a great possibility to overcome these limitations, since they include the attribute information such as XYZ as the position information and RGB as the color information. This study particularly presents a comparative analysis between the manually built 3D models and the models generated from the point cloud data. The modelling comparisons focus on the relevant factors of solar radiation and a set of simulation to calculate the performance indicators regarding selected portions of the models. The experimental results emphasize an introduction of the design approach and the dataset visibility of the 3D existing environments. This paper ultimately aims at improving the current architectural decision of support environment means, by increasing the correspondence between the digital models for performance analysis and the real environments (context of design) during the conceptual design phase.

• KIEAE Journal
• /
• 제7권6호
• /
• pp.23-28
• /
• 2007

Limited fossil fuels and unstable energy supply are considered as one of the critical problems in architecture requiring large amounts of energy. In order to this challenge, environment-friendly architecture design is required. Clear data should be prepared to apply solar energy to architecture aggressively and properly. This study used FS statistical analysis data regarding average daily solar radiation of Seoul observed over 20 years to find out standard year and standard daily solar radiation. This study also aims to compare and evaluate an appropriate method of selecting a standard year which is too close to measurement value through comparison and analysis with daily solar radiation acquired by applying overseas researchers' suggesting weight factor. As a result, the data nearest to measurement value of daily solar radiation was UK CIBSE TRY(TYPE 2) displaying 0.100in t-statistic index. For UK CIBSE TRY(TYPE 2), weight factor was applied to three climatic elements except relative humidity. TYPE 1 and TYPE 3 recorded 0.343 and 0.367, respectively, showing higher record of t-statistic than TYPE 2. TYPE 1 was calculated through FS statistical value of single data about daily solar radiation with other climatic elements excluded. For TYPE 3, relative humidity was added to TYPE 2. In particular, since TYPE 2 was closer to the measurement value compared to the others, it is necessary to consider relationship with other climate elements if other climate elements are added.

• 대한조선학회논문집
• /
• 제44권6호
• /
• pp.635-646
• /
• 2007

Human Powered Vessel Festival (HPVF) hosted by the College of Engineering of Chungnam National University, the Society of Naval Architects of Korea and the Korea Ocean Research & Development Institute has been held annually in Daejon since 1999. Solar boat powered by solar energy appeared for the first time in 2006, and it is expected that more new teams will enter this competition in the coming years. In this paper it is described that design procedures and manufacture processes of the solar boat named EPISODE. Firstly, It is aimed to understand compositions of the electric system and their performance properties and to show the design procedures using commercial design packages line WAVIS, CATIA, HCAD etc. Through the trial test, we confirmed ship speed, maneuverability, durability and operation condition of the electric system and found some problems. We plans to make reported problems go away and install hydrofoils for more improved speed performance.

• 한국태양에너지학회 논문집
• /
• 제36권3호
• /
• pp.1-7
• /
• 2016

The objective of this study is to present and to analyze preliminary orientation design factors in the design stage of sustainable architecture in the viewpoint of technocentrism. Typically people interpret solar energy system architecture as simply being part of a mechanical system. Yet, even before considering energy-consuming physical systems in buildings, it is very important to consider the outer parameters of sustainable design factors and the design process itself for the effective and suitable energy-saving design methodology. By analyzing the evolving phases and history of technocentrism and solar energy systems in sustainable architecture through examples and case studies, this paper focuses on and proposes preliminary orientation design factors that should be considered when starting the architectural design process in the viewpoint of technocentrism.

• KIEAE Journal
• /
• 제3권3호
• /
• pp.19-25
• /
• 2003

The Address No.0 of Eco-friendly Architecture offers unique experience for those who visit the place to envisage the future architecture where nature, human and building exist in harmony. It is open to the general public including the students of elementary and secondary schools. This house has been built to provide opportunities for the general public to experience eco-friendly architecture. It's floor area is 42 pyung($140m^2$) and the overall site has the area of 180 pyung($600m^2$). The following illustrates some of its prominent features : ${\bullet}$ Remodeling of a traditional Korean residence ${\bullet}$ Application of passive solar systems ${\bullet}$ Use of clerestory windows and daylighting systems(washroom and machine room) ${\bullet}$ Operation of solar water heaters with flat plate collectors ${\bullet}$ Construction of Biotop(small ecological world) ${\bullet}$ Water circulation for Biotop by photovoltaic(150W) and wind power(400W) generation ${\bullet}$ Outdoor hot water supplied by all-glass evacuated solar tubes. Through this Address No.0 of Eco-friendly Architeture conclusions are as followings. 1. The array of tubes in collector has the best nice in that the number of tube is nine and the tilt angle is the latitude $+20^{\circ}$. 2. The thermal performance of the all-glass solar vacuum collector was excellent than of the flate-plate solar collector. 3. The adaption of new small wind power systems to buildings were proved to produce a profit if it is considered the expense of environment improvement and the wind speed increasing according to rise of building hight.

• 한국태양에너지학회:학술대회논문집
• /
• 한국태양에너지학회 2009년도 춘계학술발표대회 논문집
• /
• pp.43-48
• /
• 2009

In this study, through case studies, solar energy systems were coordinated with architectural plan elements and the others in apartment complex, and the energy performance was evaluated quantitatively through computer simulation PVSYST and RETScreen. As a results, in plan process of the application of solar energy systems in apartment complex, solar energy system should be considered as not only energy reducing technical element but also part of architectural plan element. And it must be considered with architectural plan elements, composition methods, energy storage methods, technical elements from the early basic plan stage. Photovoltaic system was installed on the wall facing the south and rooftop. The energy ratio of electric load was shown to be 5.5%. The result showed 7.2% when adding it to shading device additionally, and 6.4% in case of putting extra translucent module on windows. Active solar collecting system was applied on roof with the angle of 45. Maximum number of solar collector was 10 in a row, and the total solar collecting area was $915.00m^2$. The energy ratio of domestic water heating load by active solar hot water system is shown to be 11.4%.