• Journal of Environmental Health Sciences
• /
• v.35 no.1
• /
• pp.58-63
• /
• 2009

This study investigated improvement to sludge dewaterability and coagulation for sewage treatment plant sludge by using sodium hypochlorite solution (NaOCl), ferric sulfate [$Fe_2(SO_4)_3$] and zeolite. The specific resistance to filtration(SRF), chloride, pH and turbidity were used to evaluate the sludge dewatering behaviors. The results of study were as follows: By varying the amount of NaOCl added the optimum result in terms of enhancement for pretreatment occurred when 34 mg/l of NaOCl was injected. When the total solids concentration of the sludge was 10,000 mg/l, the optimum ferric sulfate dosage for the sludge dewaterability was 150 mg/l and the corresponding SRF was $1.7{\times}10^7sec^2/g$. It was observed that injecting zeolite into sludge was effective in improving the dewaterability of sludge.

• Membrane and Water Treatment
• /
• v.10 no.5
• /
• pp.381-385
• /
• 2019

Surface modification is very efficient and scalable approach to achieve improved membrane performance. We treated Reverse Osmosis Thin Film Composite (TFC RO) membrane with various concentrations of Polyethylene Glycol (PEG), a hydrophilic polymer after activation with sodium hypochlorite. This treatment resulted in an increment of the water flux by 43% and the salt rejection by 2.36% for the 3000 mg/l PEG-treated membrane. Further, these PEG-treated membranes were exposed to a mixture of 3000 mg/l PEG and 1000 mg/l sodium hypochlorite for 1 hour. Further modification of this membrane by PEG and sodium hypochlorite mixture increased the water permeance up to 133% when compared with the virgin TFC RO membrane. We characterized the treated membranes to understand the changes in wettability by contact angle analysis, changes in surface morphology and roughness by scanning electron microscope (SEM) and atomic force microscope (AFM) analysis.

• Journal of the Korean earth science society
• /
• v.35 no.4
• /
• pp.259-266
• /
• 2014

This study was carried out to find an environmental friendly and effective way to leach Au and Ag from scrap of Printed Circuit Boards (PCBs) using sodium-hypochlorite solution. In an EDS analysis, valuable metals such as Cu, Sn, Sb, Al, Ni, Pb and Au were all found in PCBs. The highest leaching rates obtained were 1% of pulp density with a chlorine:hypochlorite of 2:1 and a concentration of NaCl at 2M. The highest Au recovery was observed with the addition of sodium metabisulfite to make a 3M solution. It is confirmed that the leaching agent (chlorine-hypochlorite) could effectively leach Au and Ag from Printed Circuit Boards (scrap parts) and the additive reagent sodium metabisulfite could easily precipitate Au from the chlorine-hypochlorite solution.

• Restorative Dentistry and Endodontics
• /
• v.33 no.1
• /
• pp.54-65
• /
• 2008

The purpose of this study was to determine the effect of sodium hypochlorite and steam autoclaving on the cyclic fatigue of nickel-titanium endodontic files. Two types of files with a .06 taper and #30 were used, $K3^{(R)}$ (SybronEndo, Glendora, California, USA) and Hero $642^{(R)}$(Micro-Mega, BesanCon, France). The files were divided into 6 experimental groups containing 10 files each group depending the soaking time in 6% sodium hypochlorite solution and number of cycles of steam autoclave. After sterilization, a cyclic fatigue test was performed on each file, and the fracture time was recorded in seconds. The control group underwent the cyclic fatigue test only. After the test, the surface characteristics of the files were observed using scanning electron microscopy (SEM). All groups containing the Hero 64~ files showed a similar cyclic fatigue fracture time. However, the cyclic fatigue fracture time with the $K3^{(R)}$ files was significantly shorter in groups which were treated with sodium hypochlorite than in the control group (P < 0.05), SEM revealed both Hero $642^{(R)}$ and $K3^{(R)}$ files to have significant corrosion on the file surface in groups treated with sodium hypochlorite, compared with the sharp and regular blades of the control group. $K3^{(R)}$ files showed more corrosion than the Hero $642^{(R)}$ files. Bluntness of the blades of the $K3^{(R)}$ file was observed in groups treated with steam autoclave. Although there was no obvious destruction on the surface of steam autoclaved Hero $642^{(R)}$ files, slight bluntness was observed. Sterilizing with a steam autoclave is much less destructive to $K3^{(R)}$ files than sodium hypochlorite. The longer time exposed to sodium hypochlorite, the more destructive pattern was shown on the blades of the files. Therefore, when using sodium hypochlorite solution, the exposure time should be as short as possible in order to prevent corrosion and increase the cyclic fatigue fracture time.

• The Korean Journal of Mycology
• /
• v.22 no.2
• /
• pp.190-195
• /
• 1994

Studies were conducted to determine the potential of sodium hypochlorite(SHC) on the control of bacterial yellow blotch in cultivated oyster mushroom, Pleurotus ostreatus. SHC at the concentration of 80 ppm was effective on the control of Pseudomonas agarici causing yellow blotch in oyster mushroom except number 916 isolate. In vitro the mycelial growth was slightly inhibited at the concentration higher than 100 ppm of sodium hypochlorite, but retardation of the mycelial growth was soon recovered. Spray of SHC solution at the concentration of 40-50 ppm per day significantly reduced the incidence of the yellow blotch without impairing the growth of oyster mushroom in field culture. However, the higher concentration of SHC(67 ppm) induced yellow brown or dark gray in color and deformed cap and elongated stripe in morphology of fruiting body. Results indicate that periodical spray of sodium hypochlorite seems to be the recommendable method for protection against bacterial yellow blotch disease in oyster mushroom without reducing food quality.

• Korean Journal of Food Science and Technology
• /
• v.30 no.1
• /
• pp.42-48
• /
• 1998

Physicochemical properties of waxy maize starch and oxidized waxy maize starch with sodium hypochlorite $(0{\sim}60\;mg\;CL_2/g\;starch,40^{\circ}C,\;pH\;10,\;3.0\;hr)$ were studied. As sodium hypochlorite concentration was increased, the content of crude lipid and crude protein of the oxidized starch were decreased. And crude protein content and whiteness was considered to show negative regression. However, the crude ash content of the oxidized starch increased significantly with oxidation and bore a positive regression to the chlorine content. There was a progressive increase in the carboxyl content with increasing oxidant level. After pasting in hot water and cooling, viscosity of the oxidized starches were drastically lower than that of native starch . As carboxyl contents of the oxidized starch increased, the solubility and swelling power was increased. When waxy maize starch treated with 0, 1.5, 3.0 and 6.0% sodium hypochlorite, temperature of initial gelatinization of oxidized starch was shown to 65, 65, 60 and $50^{\circ}C$, respectively. The oxidized waxy maize starches also form clearer pastes. Water binding capacity of the oxidized starch decreased as the degree of carboxyl group substitution increased. Waxy maize starch has polygonal and some round granules which range from about 3.7 to $20\;{\mu}m$ in diameter. Surface appearance of the waxy maize starch became rough when oxidized with sodium hypochlorite. When homogenate of the oxidized waxy maize starch solution and corn germ oil was stored under room temperature for 24 hours, the emulsion stability was considered to depend on starch concentration and degree of substitution.

• Journal of agriculture & life science
• /
• v.44 no.3
• /
• pp.1-6
• /
• 2010

The influence of sodium hypochlorite and ethephon on the germination of narrow-leaved purple coneflower (Echinacea angustifolia) was investigated. Treatment of seeds with ethephon (1 mM) for 2 h followed by soaking in 0.525% sodium hypochlorite greatly increased germination (>90%). The treatment of seed with a combination of sodium hypochlorite and ethephon shortened number of days required to reach 50% of the final germination ($T_{50}$) from 4.2 days in control to 1.1 days. Seedlings grown from ethephon-treated seeds had shorter and thicker hypocotyls and roots with higher dry weights compared to the control. The same trend was observed during seedling emergence from soil. Ethephon treatment longer than 2 h resulted in weaker seedlings, probably due to leaf senescence. Anthocyanin content in seedling leaves increased linearly from 0.04 mg/g fresh weight in control to 3.72 mg/g fresh weight in 24 h treatment as the time of seed exposure to ethephon increased. Seed treatment with bleach and ethephon may well be practiced to facilitate the establishment of E. angustifolia in the field.

• Bulletin of the Korean Chemical Society
• /
• v.7 no.2
• /
• pp.111-113
• /
• 1986

The axial alcohol in trans-3,3,5-trimethylcyclohexanol was oxidized more readily than the equatorial alcohol in cis-3,3,5-trimethylcyclohexanol by NBS in aqueous dioxane. On the contrary, the equatorial alcohol was preferentially oxidized to the axial one by 10% aqueous sodium hypochlorite in the presence of tetrabutylammonium hydrogen sulfate (TBHS). The specificity indicates the presence of two different mechanism. In acidic medium, the cleavage of C-H bond is rate determining step while the reactivity of the alcohol is important in the presence of TBHS. The mechanism in basic medium without TBHS will be discussed.

• Clinical and Experimental Pediatrics
• /
• v.46 no.2
• /
• pp.198-202
• /
• 2003

Of all toxic inhalant exposures, chlorine is one of the most common toxic chemical inhalants. When acutely inhaled, it can be responsible for symptoms ranging from upper air way irritation to more serious respiratory effects. It can also deteriorate lung function and lead to death. Chlorine and its compounds such as chlorinated cyanurates and hypochlorites are commonly used in water disinfection. The chemical agents discussed in this article are sodium dichloroiso cyanurate and calcium hypochlorite which are the two most popular products for swimming pool chlorination. They are both strong oxidizing agents which are soluble in water. Between the above two alkali agents, acid-base interaction occurred and generated heat. And the acid drove the combination of hypochlorous and chloride ions to form chlorine gas. We have experienced, two boys who had inhalation injuries caused by an accidental explosion which occurred in a swimming pool by mixing two different chlorinating agents : sodium dichloroiso cyanurate and calcium hypochlorite. The children suffered from respiratory difficulties after the exposure. They both required intensive care management and one needed the support of mechanical ventilation.

• Journal of Environmental Health Sciences
• /
• v.8 no.2
• /
• pp.33-46
• /
• 1982

This experiment was carried out for the purpose of reducing alkaloid in reconstituted tobacco sheet and effluent of reconstituted tobacco sheet manufacturing company by treating oxidizing agents such as ozone, sodium hypochlorite, perchloric acid and hydrogen peroxide to tobacco extract created from the manufacturing process of reconstituted tobacco sheet. The effect of alkaloid reduction in tobacco extract by the volume added, time of treatment and pH of oxidizing agents were as follows: 1. When the solid rate of tobacco extract stood at 10 percent, the content of alkaloid, total sugar, total nitrogen and chlorine was 1,600mg/l, 11,000mg/l, 3,200mg/l and 4,000mg/l, respectively. 2. The effect of alkaloid reduction through ozone treatment was in proportion to time of ozone treatment. Alkaloid showed a 31.2 percent reduction under 8 hours' ozone treatment and 0.23g ozone consumed to remove lmg alkaloid. 3. Alkaloid reduction through sodium hypochlorite treatment was influenced by quantity of chlorine in sodium hypochlorite solution. To remove lmg alkaloid, 36.3mg chlorine was used. Reduction of alkaloid was not affected by time of sodium hypochlorite treatment, while showed the best reaction under pH 5-7. 4. The effect of alkaloid reduction by perchloric acid was under the control of the volume added and time of treatment of perchloric acid. The volume of perchloric acid required to remove alkaloid was on the decrease as time of treatment was getting longer. lmg alkaloid was removed by 0.15g perchloric acid under 8 hours' perchloric acid treatment. 5. Alkaloid reduction reacted slowly to the volume added and time of treatment of hydrogen peroxide. Under 8 hours' hydrogen peroxide treatment, it showed maximum removal, registering 10 percent alkaloid reduction.