• 한국재료학회지
• /
• 제18권4호
• /
• pp.193-198
• /
• 2008

$WO_3$-doped $SnO_2$ thin films were prepared in a solution-deposition method and their gas-sensing characteristics were investigated. The doping of $WO_3$ to $SnO_2$ increased the response ($R_a/R_g,\;R_a$: resistance in air, $R_g$: resistance in gas) to $H_2$ substantially. Moreover, the $R_a/R_g$ value of 10 ppm CO increased to 5.65, whereas that of $NO_2$ did not change by a significant amount. The enhanced response to $H_2$ and the selective detection of CO in the presence of $NO_2$ were explained in relation to the change in the surface reaction by the addition of $WO_3$. The $WO_3$-doped $SnO_2$ sensor can be used with the application of a $H_2$ sensor for vehicles that utilize fuel cells and as an air quality sensor to detect CO-containing exhaust gases emitted from gasoline engines.

• 한국수소및신에너지학회논문집
• /
• 제14권3호
• /
• pp.268-275
• /
• 2003

The water-splitting process by the metal oxides using solar heat is one of the hydrogen production method. The hydrogen production process using the metal oxides (NiFe2O4/NiAl2O4,CoFe2O4/CoAl2O4, CoMnNiFerrite, CoMnSnFerrite, CoMnZnFerrite, CoSnZnFerrite) was carried out by two steps. The first step was carried out by the CH4-reduction to increase activation of metal oxides at operation temperature. And then, it was carried out the water-splitting reaction using the water at operation temperature for the second step. Hydrogen was produced in this step. The production rates of H2 were 110, 160, 72, 29, 17, $21m{\ell}/hr{\cdot}g-_{Metal\;Oxide}$ for NiFe2O4/NiAl2O4, CoFe2O4/CoAl2O4, CoMnNiFerrite, CoMnSnFerrite, CoMnZnFerrite, CoSnZnFerrite respectively in the second step. CoFe2O4/CoAl2O4 had higher H2 production rate than the other metal oxides.

• 센서학회지
• /
• 제10권4호
• /
• pp.222-231
• /
• 2001

$SnO_2$의 물성을 $Fe_2O_3$ 첨가량, 산소분압, CO 기체농도, 그리고 온도의 함수로서 관찰하였다. 시편은 후막인쇄 기법으로 알루미나 기판 위에 제조하였다. $700^{\circ}C$/6h 소성한 시편들의 $Fe_2O_3$첨가량에 따른 미세구조와 입자분포의 차이는 거의 없었다. $Fe_2O_3$를 첨가하지 않은 $SnO_2$의 전기적 성질은 소성온도가 낮은 경우와 산소분압이 낮은 경우에 전도성이 높게 측정되었다. $Fe_2O_3$를 첨가한 $SnO_2$의 전도성은 측정온도 증가로 증가하지만 $Fe_2O_3$ 첨가량 증가로 전도성은 감소하였다. 산소분압 의존성은 $Fe_2O_3$ 첨가로 감소하였다. CO 가스에 대한 기체 센서 특성 중 감도는 $350^{\circ}C$, 0.1 mol% $Fe_2O_3$를 첨가한 경우에 가장 높았고, 재현성 및 응답성도 양호하게 나타났다.

• 한국세라믹학회지
• /
• 제43권2호
• /
• pp.92-97
• /
• 2006

Dolomite type $BaSn(BO_3)_2$ ceramics with rhombohedral crystal structure has been synthesized via solid state reaction route. Dielectric properties were measured for the samples sintered at $1050\~1200^{\circ}C$ for 2 h in air. Dielectric constant, loss tangent, and temperature coefficient were increased with sintering temperature due to the evolution of $BaSnO_3$, secondary, phase. Optimum dielectric properties were obtained at the $BaSn(BO_3)_2$ ceramics sintered at $1100^{\circ}C.\;CuO/Bi_2O_3$ was added to $BaSn(BO_3)_2$ ceramics to lower the sintering temperature for LTCC application, then Co and Fe-based coloring agents were added for colorizing the LTCC tape. Typical dielectric properties of $BaSn(BO_3)_2$ ceramics with $5 wt\%\;CuO/Bi_2O_3\;and\;3wt\%$ Co-coloring agent that sintered at $900^{\circ}C$ were $\varepsilon_r=9.89,\;tan{\delta}=0.92\times10^{-3},\;and\;TCC=112ppm/^{\circ}C$. Thus obtained LTCC tape was co-fired with Ag paste for compatibility test and revealed no sign of Ag reaction with the ceramics.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2002년도 제4회 영호남학술대회 논문집
• /
• pp.25-30
• /
• 2002

The ternary semiconducting compounds of the $A_{4}BX_{6}$(A=Cd, Zn, Hg; B=Si, Sn, Ge; X=S, Se, Te) type exhibit strong fluorescence and high photosensitivity in the visible and near infrared ranges, so these are supposed to be materials applicable to photoelectrical devices. These materials were synthesized and single crystals were first grown by Nitsche, who identified the crystal structure of the single crystals. In this paper. author describe the undoped and $Co^{2+}$-doped $Zn_{4}SnSe_{6}$ single crystals were grown by the chemical transport reaction(CTR) method using iodine of $6mg/cm^{3}$ as a transport agent. For the crystal. growth, the temperature gradient of the CTR furnace was kep at $700^{\circ}C$ for the source aone and at $820^{\circ}C$ for the growth zone for 7-days. It was found from the analysis of x-ray diffraction that undoped and $Co^{2+}$-doped $Zn_{4}SnSe_{6}$ compounds have a monoclinic structure. The optical absorption spectra obtained near the fundamental absorption edge showed that these compounds have a direct energy gaps. These temperature dependence of the optical energy gap were closely investigated over the temperature range 10[K]~300[K]

• 한국세라믹학회지
• /
• 제46권6호
• /
• pp.545-547
• /
• 2009

An immiscible Si/Sn (=7/3 by volume) powder mixture was subjected to simple grinding and subsequent leaching process to give Sn nanopowder reinforced or dispersed in Si powder. Crystallite and their agglomerates of Si were ca. 15 nm and 100 nm, respectively. Sn remained at 4.5 vol% in Si powder after aqueous HCl leaching, dispersively occluded in Si matrix as confirmed by ICP analysis and cross sectional TEM observation.

• 한국세라믹학회지
• /
• 제38권12호
• /
• pp.1180-1186
• /
• 2001

고진공 저항 가열식 증발 증착기를 이용하여 약 1$mu extrm{m}$ 두께의 W $O_3$-Sn $O_2$박막 가스센서를 제작하였다. 50$0^{\circ}C$에서 4시간동안 공기중 열처리한 다음, 제조된 박막의 결정성과 미세구조를 관찰하였다. 100 ppm의 산화성 가스인 N $O_2$와 환원성 가스인 CO 가스에 대한 가스 감응 특성을 측정한 결과, N $O_2$가스에 대한 감도( $R_{gas}$/ $R_{air}$)는 기판온도 25$0^{\circ}C$에서 W $O_3$박막이 약 1000으로서 가장 높았으며, CO 가스 감도는 기판온도 15$0^{\circ}C$~25$0^{\circ}C$ 범위에서 약 0.25로 가장 양호하였다.하였다.

• 전기전자학회논문지
• /
• 제13권4호
• /
• pp.37-42
• /
• 2009

본 연구에서는 졸겔법으로 ZnO, 수열합성법으로 $SnO_2$ 나노분말을 제조하고 이들 나노분말에 Pd, Ru 등의 촉매를 첨가하였다. MEMS 기술로 제작된 히터 및 전극 구조 위에 나노 감지 분말을 도포하여 CO and $NO_2$ 가스 센서를 제작하였다. 0.1 wt% Pd 도핑된 $SnO_2$ 가스센서와 Ru 도핑된 ZnO 가스 센서는 각각 CO 30 ppm, $NO_2$ 1 ppm의 낮은 농도에서도 높은 감지 특성을 보였다.

• 한국표면공학회지
• /
• 제50권4호
• /
• pp.289-295
• /
• 2017

Detection of $CO_2$ gas in both indoor and outdoor atmospheres is now becoming an important issue because of greenhouse effect and climate crisis. In this study, gas sensors based on $SnO_2-Cr_2O_3$ composite nanofibers were fabricated by the electrospinning method to detect $CO_2$ gas. The gas sensors showed a response to ppm level of $CO_2$ gas from room temperature to $200^{\circ}C$ while the highest response was observed at $150^{\circ}C$. The gas response is enhanced by the catalytic property of $Cr_2O_3$. Selective $CO_2$ detection is obtained through the chemical reaction of $Cr_2O_3$ to chromium carbonate. All the results suggest the $SnO_2-Cr_2O_3$ composite material is promising for the use of $CO_2$ gas sensors.

• 대한화학회지
• /
• 제24권3호
• /
• pp.183-192
• /
• 1980

$SnO_2$, Sb-doped $SnO_2$>, 그리고 백금촉매하에서 일산화탄소의 산화반응을 연구하였다. $SnO_2$ 및 Sb-doped $SnO_2$ 촉매하에서 산화반응은 CO 및 $O_2$에 대해서 각각 1차, 백금 촉매하에서는 1/2차 반응에 따랐다. $SnO_2$에 소량의 Sb첨가(dopant composition : 0.05∼0.1mole%)는 반응속도를 증가시키고 그 이상의 첨가는 오히려 반응속도를 감소시켰다. 백금 촉매하의 산화반응에서는 일산화탄소의 농도가 증가함에 따라 반응속도가 오히려 감소하는 억제효과를 보여주었다. 각 촉매하에서 산화반응의 활성화에너지는 Sb-dopoped $SnO_2$ 촉매 (dopant compisito : 0.05 mole%)에서 5.7 kcal, 백금 촉매에서 6.4 kcal이었다. 실험적으로 얻은 반응차수와 doping 효과로부터 가능한 반응메카니즘을 제안하였다.