• 한국항공우주학회지
• /
• 제44권12호
• /
• pp.1017-1026
• /
• 2016

두 가지의 비표면 가시화 기법과 이들 기법의 와류 적용 예를 기술한다. 두 가지 가시화 기법 중 하나는 전통적인 연기선 기법이고, 또 다른 하나는 가정용 초음파 가습기에서 발생하는 미세 수적을 사용하는 기법이다. 연기선 기법은 공기 흐름 속도에 제한이 있으며(0.07 mm 지름의 연기선의 경우 약 5 m/sec), 오염의 문제점이 있지만 매우 정교하고 선명한 연기 유맥선 시트를 발생시킬 수 있다. 이 기법은 3차원 날개의 날개 끝 와류의 가시화에 적용되었다. 초음파 가습기 미세 수적 기법은 연기선 기법에 비하여 공기 흐름 속도를 보다 크게 할 수 있으며(10 m/sec 이상), 독성과 오염의 문제를 해결할 수 있다. 초음파 가습기 미세 수적 기법은 정점 스트레이크를 가지는 이중 삼각날개에서 발생하는 복잡한 와류 시스템의 가시화에 성공적으로 적용되었다.

• 한국가시화정보학회:학술대회논문집
• /
• 한국가시화정보학회 2005년도 추계학술대회 논문집
• /
• pp.50-53
• /
• 2005

The turbulent flow around a sphere was investigated in a streamwise meridian plane using two experimental techniques: smoke-wire flow visualization in wind tunnel at Re=5,300 and PIV measurements in a circulating water channel at Re=7,400. The smoke-wire visualization shows flow separation points near an azimuthal angle of $90^{\circ}$, recirculating flow, transition from laminar to turbulent shear layer, evolving vortex roll-up and fully turbulent eddies in the sphere wake. In addition, the mean flow pattern extracted by particle tracing method in water tunnel at Re= 14,500 reveals two distinct comparable toroidal(not closed) vortices in the recirculation region. The mean velocity field measured using a PIV technique demonstrates the detailed wake configuration of close symmetric recirculation and near-wake configuration with two toroidal vortices, reversed velocity zone and vorticity contours.

• 한국화재소방학회논문지
• /
• 제24권2호
• /
• pp.178-184
• /
• 2010

본 연구에서는 화재로 인하여 발생되는 연기 또는 열을 무선화재감지기에서 감지하여, 유선이 아닌 무선장치를 이용하여 수신장치까지 전송하고, 이 감지신호를 유선을 통하여 메인서버로 전송하는 유무선통합감지시스템을 제안한다. 또한 무선 열/연감지기, 무선모듈, 펌웨어, 유무선통합수신반 등을 개발하였으며, 유무선장치의 성능과 실용성에 관한 검증을 위하여 송신탑, 주상복합건물, 지하철역사 등에서 실제 현장적용 실험을 수행하였다. 실험결과, 제안한 시스템은 모든 실험대상물에서 정상적으로 동작하였으며 향후 현장적용이 가능함을 확인할 수 있었다.

• 한국철도학회논문집
• /
• 제10권1호
• /
• pp.67-73
• /
• 2007

Experiments were carried out to investigate smoke movement in platform of a subway station which currently is in service in Pusan, the second largest city in Korea. The recently constructed underground station of the "bank type" (two platforms on both sides of track) which is the popular layout of platforms in Korea, is chosen in Pusan. The smoke generator and heater are used for simulating the smoke movement at the fire break in the platform located in the 2nd basement of the station. Video recordings were used to monitor smoke lowering. In this study, the movements of smoke in the underground station are investigated under various smoke-control operating modes. Three tests wire conducted according to its operating mode of the ventilation systems in the platform: no operation of any ventilation systems, smoke extraction mode in occurrence of fire (presently running mode) and full capacity of smoke extraction where all vents are activated in the platform. The results can be used for comparing with the numerical prediction results of fire subway stations.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2001년도 추계학술대회 논문집 Vol.14 No.1
• /
• pp.251-254
• /
• 2001

In this paper, we analyzed the properties change of electric wire when the thermal stress was applied to NFR-8 and FR-PVC 600[V] wire. Messurement is made of the attenuation of a light beam by smoke accumulating with in a closed chamber due to nonflaming pyrolytic decomposition and flaming combustion. Results are expressed in terms of specific optical density which is derived from a geometrical factor and the measured optical density a measurement characteristic of the concentration of smoke. Referenced documents were ASTM E662 standard test method for specific Ds genalated by solid materials. The furnace control system shall maintain the required irradiance level under steady-state condition with the chamber door closed of $2.5{\pm}0.04[w/cm^{2}]$ for 20 min. According to the results of the smoke density analysis of NFR-8 and FR-PVC the highest decomposition flaming smoke density range of NFR-8 and FR-PVC were 25.2 to 37.5 and 51.1 respectively. Nonflaming smoke density range of NFR-8 and FR-PVC were 100.4 to 112.2 and 126.5 to 398.8. The amount of carbon monoxide generated was found to be much higher in FR-PVC decomposition than in NFR-8 due to incomplete combustion of FR-PVC which has high content of carbon in compound.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2001년도 추계학술대회 논문집
• /
• pp.251-254
• /
• 2001

In this paper, we analysed the properties change of electric wire when the thermal stress was applied to NFR-8 and FR-PVC [600] wire. Measurement is made of the attenuation of a light beam by smoke accumulating with in a closed chamber due to nonflamining pyrolytic decomposition and flaming combustion. Results are expressed in terms of specific optical density which is derived from a geometrical factor and the measured optical density a measurement characteristic of the concentration of smoke. Referenced documents were ASTM E662 standard test method for specific Ds generated by solid materials. The furnace control system shall maintain the required irradiance level under steady-state condition with the chamber door closed of 2.5${\pm}$0.04[w/$\textrm{cm}^2$] for 20 min. According to the results of the smoke density analysis of NFR-8 and FR-PVC the highest decomposition flaming smoke density range of NFR-8 and FR-PVC were 7.2 to 77.5 and 51.1 respectively. Nonflaming smoke density range of NFR-8 and FR-PVC were 100.4 to 112.2 and 126.5 to 398.8. The amount of carbon monoxide generated was found to be much higher in FR-PVC decomposition than in NFR-8 due to incomp1ete combustion of FR-PVC which has high content of carbon in compound.

• 대한기계학회논문집
• /
• 제10권1호
• /
• pp.96-101
• /
• 1986

본 연구에서는 2차원 충돌분류에 있어서 전열면상에 비교적 큰 스케일을 가진 트랜스버스 리브(transverserib)형의 피형돌기를 만들고 충돌영역을 포함하여 통상열전달율이 현저하게 낮아지는 하류역까지의 넓은 영역에 걸쳐 전달회진을 목적 으로 전달특성을 실험적으로 조사하고 전보에서 다룬 거형의 트랜스버스 리브를 갖는 전열면에서의 결과와 비교 검토하였다. 한편 돌기면상의 유동형태의 상세를 smoke wire법에 의해 충돌분류 특유의 종과류와 그 신장에 대하여 조사하고 표면부유법 (surface floating method)에 의해 비교적 큰 스케일의 돌기에 따른 흐름의 박이 및 재부착에 관해서 조사하여 이들과 전열기구와의 관계를 정성적으로 검토하였다.

• 한국대기환경학회지
• /
• 제25권3호
• /
• pp.237-247
• /
• 2009

The combustion characteristics of car components have been investigated, The combustion parameters like heat release rate, smoke production, yield of carbon dioxide and carbon monoxide and mass loss rate were analyzed by cone-calorimeter for representative samples (seat, carpet, headrest, rubber mat, dash board and electric wire) collected from a used car. The results from sample combustion showed that cover and sponge in seat more quickly ignited and flamed than other parts. The heat released from the combustion of dash board sample was 144.29$kw/m^2$ and the smoke produced by the wire combustion was 6896.4 $m^2/m^2$. The yields of carbon dioxide and carbon monoxide were in the ranges of 1.09${\sim}$2.76 kg/kg and 0.0262${\sim}$0.1008 kg/kg, respectively.

• 유체기계공업학회:학술대회논문집
• /
• 유체기계공업학회 2006년 제4회 한국유체공학학술대회 논문집
• /
• pp.401-402
• /
• 2006

The turbulent flow around a sphere was investigated using two experimental techniques: smoke-wire flow visualization in wind tunnel at Re=5300, 11000 and PIV measurements in a circulating water channel. The smoke-wire visualization shows flow separation points near an azimuthal angle of $90^{\circ}$, recirculating flow, transition from laminar to turbulent shear layer, evolving vortex roll-up and fully turbulent eddies in the sphere wake. The mean velocity field measured using a PIV technique in x-y center plane demonstrates the detailed near-wake structure such as nearly symmetric recirculation region, two toroidal vortices, laminar separation, transition and turbulent eddies. The PIV measurements of turbulent wake in y-z planes show that a recirculating vortex pair dominates the near-wake region.

• 한국가시화정보학회지
• /
• 제4권2호
• /
• pp.51-58
• /
• 2006

A boundary layer visualization was carried out in order to investigate the influence of Reynolds number on an oscillating airfoil. An NACA 0012 airfoil is sinusoidally pitched at the quarter chord point with oscillation amplitude of ${\pm}6^{\circ}$. A smoke-wire technique was employed to visualize the boundary layer and the near-wake. The freestream velocities are 1.98, 2.83 and 4.03m/s and corresponding chord Reynolds numbers are $2.3{\times}10^4,\;3.3{\times}10^4$, and $4.8{\times}10^4$, respectively. As the reduced frequency of K=0.1 is fixed, the corresponding frequency of an airfoil was adjusted in each case. The results reveal that the point at which the shear stress in an unsteady boundary layer separation disappears does not correspond with the position of the breakdown of the boundary layer, and that the breakdown of the boundary layer occurs further downstream.