• 대한기계학회논문집B
• /
• 제23권2호
• /
• pp.218-225
• /
• 1999

Flow visualization study has been conducted to simulate the turbulent dispersion behavior of a crossflow jet physically under the conditions of various thermal stratification in a wind tunnel. A smoke jet with the constant ratio of the jet to freestream velocity is injected normally to the cross flow of the thermally stratified wind tunnel(TSWT) for flow visualization. The typical natures of the smoke dispersion under different thermal stratifications such as neutral, weakly stable, strongly stable, weakly unstable, strongly unstable and inversion layer are successfully reproduced in the TSWT. The Instantaneous velocity and temperature fluctuations are measured by using a cold and hot-wire combination probe. The time averaged dispersion behaviors, the centerline trajectories, the spreading angles and the virtual origins of the cross jet are deduced from the edge detected images with respect to the stability parameter. All the general characteristics of the turbulent dispersion behavior reveal that the definitely different dispersion mechanisms are inherent in both stable and unstable conditions. It is conjectured that the turbulent statistics obtained in the various stability conditions quantitatively demonstrate the vertical scalar flux plays a key role in the turbulent dispersion behavior.

• 한국화재소방학회논문지
• /
• 제16권2호
• /
• pp.38-42
• /
• 2002

ON-OFF 제트를 사용하여 plume의 주기성이 천장아래에 형성되는 연층에 미치는 정성적인 영향을 파악하였다. 사용된 연기는 가열에 의해 증발된 kerosene 입자를 섞은 질소가스이다. Laser sheet에 의해 산란된 유동장의 순간 상들은 디지털 비디오 카메라에 의해 녹화되었다. ON-OFF 제트와 연속제트의 연층형성 과정을 비교하므로서 화원근처에 형성되는 연층은 plume과 천장의 주기적인 충돌에 의해 지배됨을 확인하였다. 또한 plume의 주기적인 충돌은 연층을 두껍게하며, back-flow를 일으킴을 확인하였다.

• 대한공업교육학회지
• /
• 제32권2호
• /
• pp.87-103
• /
• 2007

본 연구는 중등학교 학생들에게 유동장 주위의 유체의 흐름을 정성적으로 설명할 수 있고 유체의 저항 개념을 쉽게 이해시키기 위해 학교 현장에 적용 가능한 교수-학습용 자료인 학습용 풍동의 연기 유동 가시화 장치를 개발하였다. 연구의 내용은 학습용 풍동의 연기 유동가시화 장치 개발과 이를 활용한 실험으로 이루어져 있다. 이 연구에서 얻은 주요 결과를 정리하면 다음과 같다. 첫째, 수송 영역에서 다양한 유체의 흐름 형태와 저항 개념을 이해시킬 수 있는 교수-학습 자료를 개발하였다. 둘째, 유동가시화 실험을 통하여 실험 모델에 따른 유체의 흐름은 이론적인 유동 패턴과 전체적으로 비슷한 경향성을 보였다. 셋째, 공기의 저항을 의미하는 후류 영역은 유선형 모델이 원형이나 사각형 모델에 비해 훨씬 작게 나타났다. 넷째, 유선형 모델의 받음각을 $20^{\circ}$로 하였을 때 앞전(leading edge)에 생기는 박리점과 넓은 영역의 후류를 관찰할 수 있었다. 다섯째, 골프공과 매끈한 공의 비교실험에서 딤플이 있는 골프공 모델 하류에 형성되는 후류영역의 폭(wake width)은 다소 좁아짐을 관찰할 수 있었다. 여섯째, 수송 영역에서, 자동차나 항공기에 대한 관심과 흥미를 증진 시킬 수 있는 실험 실습 교수-학습 자료로 활용할 수 있도록 개발하였다.

• Journal of Advanced Marine Engineering and Technology
• /
• 제27권7호
• /
• pp.879-888
• /
• 2003

Swirling air flow in a horizontal round tube was experimentally studied for its visualization. The present investigation deals with swirl angle, flow visualization studies and accompanying vortex core behavior by using oil smoke and a hot wire anemometer for Re = 40,000 and 50000 at X/D = 41, 59 and 71. In the swirl air flow, a vortex core was formed at high swirl intensity along the test tube. The swirl angle and the vortex core depended on the swirl intensity along the test tube. The results of swirl angles measured by flow visualization and hot wire reasonably agree with those of previous studies.

• 한국기계가공학회지
• /
• 제2권4호
• /
• pp.82-87
• /
• 2003

Flow angle with Swirl in a horizontal circular tube and a cylindrical annuli were experimentally studied for its visualization. This present investigation deals with flow angle, flow visualization studies and vortex core by using oil smoke and a hot wire anemometer for Re = 40,000 and 50000 at X/D = 41, 59 and 71 in a horizontal circular tube. In the swirl air flow, a vortex core was formed at high swirl intensity along the test tube. The flow angle and the vortex core depended on the swirl intensity along the test tube. The results of flow angles with swirl measured by flow visualization and hot wire reasonably agree with those of Sparrow One of the primary objectives of this research was to measure the flow angle with swirl in a cylindrical annuli along the test tube for different Reynolds numbers. The Reynolds number for these measurements ranged from 60,000 to 100,000 with L/D = a to 4.

• 한국가시화정보학회:학술대회논문집
• /
• 한국가시화정보학회 2002년도 추계학술대회 논문집
• /
• pp.89-95
• /
• 2002

An experimental investigation was performed to study the characteristics of turbulent swirling flow in an axisymmetric annuli. The swirl angle measurements were performed by flow visualization technique using smoke and dye liquid. Using the Particle Image Velocimetry method, this study found the time-mean velocity distribution and turbulent intensity with swirl for Re = 20,000, 30,000, 50,000, and 70,000 along longitudinal sections and the results appear to be physically reasonable.

• 한국항공운항학회지
• /
• 제12권3호
• /
• pp.13-24
• /
• 2004

It is easier to view flow visualization by using a water tunnel rather than a smoke wind tunnel because of low speed at same Reynolds number. Using a water tunnel also produces more definite flow visualization by the use of various color dyes. The flow uniformity in test section is very significant for accuracy of the test because most flow experiments elicit results through the installation of a model in uniform flow. The purpose of small-size desktop-type water tunnel is not to produce quantitative measurements, but rather to give a visualization of the fluid flow phenomenon. However, uniformity in the test section affects the accuracy of the results. Accordingly, this research estimates uniformity in a water tunnel test section by using the commercially available CFD code FLUENT. Results of the CFD analysis show that the flow uniformity of the test section is good.

• 한국가시화정보학회지
• /
• 제4권2호
• /
• pp.51-58
• /
• 2006

A boundary layer visualization was carried out in order to investigate the influence of Reynolds number on an oscillating airfoil. An NACA 0012 airfoil is sinusoidally pitched at the quarter chord point with oscillation amplitude of ${\pm}6^{\circ}$. A smoke-wire technique was employed to visualize the boundary layer and the near-wake. The freestream velocities are 1.98, 2.83 and 4.03m/s and corresponding chord Reynolds numbers are $2.3{\times}10^4,\;3.3{\times}10^4$, and $4.8{\times}10^4$, respectively. As the reduced frequency of K=0.1 is fixed, the corresponding frequency of an airfoil was adjusted in each case. The results reveal that the point at which the shear stress in an unsteady boundary layer separation disappears does not correspond with the position of the breakdown of the boundary layer, and that the breakdown of the boundary layer occurs further downstream.

• 항공우주시스템공학회지
• /
• 제8권3호
• /
• pp.1-5
• /
• 2014

An inner flow of a porous cylinder with partial slots was visualized to study fluidic phenomena in a solid rocket motor. A high-pressure chamber and an air supply system for high flow rate were used. In order to visualize the inner flow, the smoke generator with a cam-driven pump and heaters and high speed camera were adopted. The results of the cylinder type and the partial slot type were compared. As a result, the injected smoke flow in the partial slot type had circumferential fluctuations unlike the cylinder type. It was found that the circumferential flow induced from the partial slots could be the cause of combustion instability and roll torque.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2007년도 춘계학술대회 논문집
• /
• pp.444-447
• /
• 2007

The free flow of fine bubbles generated by electrolysis and smoke flow in a space enclosed by fire were recently found to show the same tendency thus leading to the introduction of a research technique. The research experimentally models smoke diffusion and flow in parallel and slanted tunnels using the fine hydrogen bubbles generated by electrolysis in a water tank. Visualization laser with wavelength of 532nm and output power of 1000mW is used to visualize effectively the cross section of fine hydrogen bubble flows generated in a model tunnel.