• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.29 no.4 s.235
• /
• pp.435-440
• /
• 2005

In this paper, slurry fluid motion, abrasive particle motion, and roles of groove patterns on the pads are numerically investigated in the 2D and 3D geometries. The simulation results are analyzed in terms of experimental removal rate and WIWNU (Within Wafer Non-Uniformity) for ILD (Inter Level Dielectric) CMP process. Numerical investigations reveal that the grooves in the pad behave as uniform distributor of abrasive particles and enhance the removal rate by increasing shear stress. Higher removal rate and desirable uniformity are numerically and experimentally observed at the pad with grooves. Numerical analysis is very well matched with experimental results and helpful fur understanding polishing mechanism and local physics.

• Korean Journal of Environmental Agriculture
• /
• v.28 no.1
• /
• pp.47-52
• /
• 2009

The aim of this study was to evaluate the effect of yeast(Saccharomyces exiguus SJPAF1, referred to as SA) addition on odor emission and contaminants reduction in piggery sluny. Four different rates of yeast addition were compared: no addition(SA0), 0.7L(SA0.7), 1.0L(SA1.0), and 1.5L(SA1.5) to one tone of piggery slurry. Odor emission tended to decrease with increasing the yeast application with concurrent effects of changes in temperature on outside of reactors. Particularly, reduction in ammonia emission was proportional to the yeast application rate; it reduced from 161.1 ppm in SA0 to 47.1 ppm in SA1.5 after 6 days of treatment Decomposition of piggery shiny by yeast increased to 13.8% more in SA1.5, and total amounts of piggery slurry decreased to 12.5% in SA1.5. Total coliforms were detected below 30MPN $ml^{-1}$ in SA1.5, while $8.3{\times}10^3$ MPN $ml^{-1}$ of Total coliforms were found in SA0. However, the effect of yeast addition in piggery slurry seemed to have no influence on the removal efficiency of contaminants such as BOD, COD, $NO_3^{-}-N$, $NH_4^{+}-N$, $PO_4^{-}P$. Consequently, the yeast(Saccharomyces exiguus SJPAF1) addition of 1.5% in the piggery sluny seems to have potential applicability for improving agent of pig-farm environment.

• Journal of The Korean Society of Grassland and Forage Science
• /
• v.14 no.3
• /
• pp.230-237
• /
• 1994

This experiment was carried out to determine the effects of cattle sluny and zeolite application for the improvement of germination and establishment of grasses in infertile slopped land. The best establishment and winter survival of grasses were observed in the plot of cattle slurry application. The dry matter yield of grasses was increased by 12% in the plot of compaction + cattle slurry application when compared with control. Alteration effect of soil pH was v q high and the content of organic matter was increased by addition of the soil conditioner.

• Journal of The Korean Society of Grassland and Forage Science
• /
• v.20 no.1
• /
• pp.41-48
• /
• 2000

This study was conducted to investigate the effects of the application rate of fermented swine manure and additional mineral fertilizer on productivity and nutritive value of corn(Zea mays L.) for silage. Swine manures used in this study were the compost of swine manure fermented with sawdust(SMFWS) and swine sluny(SS). This study was arranged in split-split plot design. Main plots were the types of swine manure, subplots were the application rate of swine manure, such as 100, 200 and 400kgN/ha, and sub-subplots were the application rate of mineral fertilizer, such as 50 and 100kgNiha. Corn DM(dry matter) and TDN(tota1 digestible nutrient) yields increased as application rate of SMFWS and SS increased. DM and TDN yields in SS treatments were higher than those in SMFWS treatments. The effect of fermented swine manure improved positively as application rate of urea increased. Net energy for lactation(NE1) and TDN content in corn decreased as application rate of SMFWS and SS increased, but crude protein(CP) content increased by the application of SMFWS and SS. NE, and TDN contents in SMFWS treatments were lower than those in SS treatments, but CP content in SMFWS was higher than that in SS. The growth and nutritive value of corn were improved by the application of mineral fertilizer. (Key words : Swine manure, Swine sluury, Compost, Zea may, TDN, Net energy)

• Journal of The Korean Society of Grassland and Forage Science
• /
• v.21 no.4
• /
• pp.203-210
• /
• 2001

To establish the recycling system of animal manure(AM) for environmental preservation and improve the utilization of AM, this study was to investigate the effects of the types and nitrogen application rate of AM on herbage productivity, efficiency of nitrogen utilization, nutritive value and an increase of soil fertility and in mixed grassland. This sudy was arranged in split plot design. Main plots were the types of AM(Cattle feedlot manure, CFM; Pig manure fermented with sawdust, PMFS; cattle sluny, CS) and subplots were the application rate of animal manure, such as 100, 200 and 300kgNiha. I. DM yields of herbage were the highest with CS and decreased by application over ZOOkgNiha AM. 2. Crude protein(CP) ontent was the highest with CFM and followed by CS, and the lowest with PMFS, and increased as application rate of AM increased. 3. Nitrogen(N) yields of CS treatment was higher than that of CFM and CS. and increased significantly as application rate of AM increased(P<0.05). 4. The contents of NDF, ADF and TDN was hardly influenced by the types and application rate of AM. 5. Organic matter(0M) content in the soil was the highest with PMFS and followed by CFM and the lowest with CS. OM content increased significantly as application rate of AM increased(P<0.05). 6. Total nitrogen content of the soil was not affected by the type of AM, but increased significantly as application rate of AM increased(P<0.05). (Key words : Animal manure, Grassland, Cattle feedlot manure, Pig manure fermented with sawdust, Cattle slurry, Soil fertility)

• Journal of The Korean Society of Grassland and Forage Science
• /
• v.15 no.1
• /
• pp.52-60
• /
• 1995

This experiment was carried out to determine the effect of nitrogen application level of cattle sluny(T1:150, T3:250, T53.50 kglha) and chemical fertilizer(T2:150, T4:250, T6:350 kg/ha) on the growth characteristics, dry matter yield and chemical soil property of Sorghum-Sudangrass hybrid [Sorghum bicolor L. Moench]. The results obtained are summarized as follows: Mean stem diameter was significantly increased by increasing nitrogen application level of cattle slurry and chemical fertilizer. Especially, T6 treatment was the highest as 11.1 mm, while T1 treatment w a the lowest as 0.3 mrn. According to the same level of nitrogen application, cattle slurry treaunent(T1, T3 and T5) were showed a lower mean stem hardness than chemical fertilizer treatment(T2, T4 and T6). Especially, T3 treatment was the softest at 0.7 kg/$cm^2$. The dead stubble and tiller number were increased by increasing nitrogen level of cattle slurry and chemical fertilizer(P

• Journal of the Korean Electrochemical Society
• /
• v.3 no.3
• /
• pp.136-140
• /
• 2000

A stainless steel separator for a molten carbonate fuel cell is usually coated with aluminum diffusive layer to protect its surface against corrosion by the molten carbonate at high temperatures. In this study, a relatively simple method was devised to form the aluminum diffusive layer on a stainless steel substrate. Slurry coating of aluminum on the substrate followed by heat treatment under reducing atmosphere at $650\~800^{\circ}C$ produced the aluminum diffusive layer of $25\~80{\mu}m$ thickness. The thickness of aluminum diffusive layer increased with increasing the temperature or duration of the heat-treatment. The corrosion resistance against molten carbonate under oxidizing atmosphere was significantly improved by aluminum diffusive layer formed by the sluny painting and heat treatment method. Moreover, the sample prepared in this study showed corrosion behavior similar to the sample with aluminum diffusive layer prepared by ion vapor deposition and heat treatment.

• Journal of the Korean Electrochemical Society
• /
• v.6 no.1
• /
• pp.41-47
• /
• 2003

For the development of low temperature anode-supported planar solid oxide fuel cell, the planar anode supports with the thickness of 0.8 to 1 mm and the area of 25, 100 and $150\;cm^2$ were fabricated by the tape casting method. The strength, porosity, gas permeability and electrical conductivity of the planar anode support were measured. The porosity of anode supports sintered at $1400^{\circ}C$ and then reduced in$H_2$ atmosphere was increased from $45.8\%\;to\;53.9\%$. The electrical conductivity of the anode support was $900 S/cm\;at\; 850^{\circ}C$ and its gas permeability was 6l/min at 1 atm in air atmosphere. The electrolyte layer and cathode layer were fabricated by slurry dip coating method and then had examined the thickness of $10{\mu}m$ and the gas permeability of 2.5 ml/min at 3 atm in air atmosphere. As preliminary experiment, cathode multi-layered structure consists of LSM-YSZ/LSM/LSCF. At single cell test using the electrolyte layer with thickness of 20 to $30{\mu}m$, we achieved $300\;mA/cm^2$ and 0.6V at $750^{\circ}C$

• Journal of The Korean Society of Grassland and Forage Science
• /
• v.15 no.3
• /
• pp.175-185
• /
• 1995

This experiment was carried out to investigate the optimum rates of animal excreta(cattle slurry-N) for the highest dry matter production and improve the nutritive values of reed canarygrass with different cutting frequency. The results are summarized as follows; The highest relative dry matter yields for annual dry matter yield were 42.2% and 45.2% at 3rd cut in 3 and 4 cuttings, and 34.7% at 4th cut in 5 cuttings, respectively. The annual dry matter yields of non slurry-N application plot showed were from 6.8 tons to 8.0 tons/ha in all cutting frequencies. The highest annual dry matter yield obtained was in 3 cuttings. The annual dry matter yield increased with an increase of applied rates of slurry-N in all cutting frequencies. Annual dry matter yield was produced by 3.3 tons/ha at rates of 90 kg N/ha/cut in 3 cuttings, and more 1.7 tonsha and 2.4 tons/ha at rates of 30 kg N/ha/cut in 4 and 5 cuttings than that of non slurry-N application plots. The contents of crude protein were 12.01% and 15.0% at rates of 90 kg N/ha/cut in 3 and 4 cuttings, and 16.59% at rates of 120 kg N/ha/cut in 5 cuttings, respectively. On the contrary, the content of acid detergent fibre(ADF) showed the lowest values at same rates of slurry-N application in each cutting. J. The average content of crude protein was significantly increased with cutting frequencies, and they were 11.43%, 13.53% and 15.53% in 3, 4 and 5 cuttings, respectively. The average contents of acid detergent fibre(ADF) were 40.27%, 40.53% and 37.06% in 3, 4 and 5 cuttings. The values of 5 cuttings were significantly lower than other cutting frequencies, but the values of acid detergent fibre(ADF) was not significantly different between 3 and 4 cuttings. 6. The efficiency of dry matter production to slurry-N application rates showed the highest values of 18.9 kg and 15.7 kg DM/kg N at rates of 30 kg N/ha/cut in 3 and 5 cuttings, and 16.3 kg DM/kg/ N at rates of 90 kg N/ ha/cut in 4 cuttings. The efficiency of total nitrogen yield to slurry-N application rates were the highest values of 0.51 kg and 0.43 kg W k g N at rates of 30 kg N/ha/cut in 4 and 5 cuttings, and 0.52 kg TN/kg N at rates of 90 kg N/ha/cut in 3 cuttings, respectively. 7. The ranges of economic slurry-N rates were estimated as the 107.2-151.0 kglha, 359.1-375.7 kgha and 160.3-236.9 kg/ha in 3, 4 and 5 cuttings, and marginal dry matter yields were 9.6-10.0 tons/ha, 12.4-12.6 tons/ha and 9.0-9.7 tons/ha in 3, 4 and 5 cuttings, respectively. 8. The limiting sluny-N application rates to maintain the highest dry matter yields were estimated to be 420.0 kg/ ha, 440.6 kg/ha and 666.3 kg/ha in 3, 4 and 5 cuttings.