• Proceedings of the KWS Conference
• /
• 2006.05a
• /
• pp.146-147
• /
• 2006

In order to prevent the environmental pollution, the dryers are commonly used to treat sludge that one of sewages is polluting the quality of water. Rotary dryer is a good apparatus to treat them. The rotary dryer is the way that is to make substance transmission and heat using hot air between sludge particle and heated gas. In this paper, a numerical analysis was performed for the structural analysis of the 3-pass rotary dryer through the finite elemeny method and an experiment was done for the structural stability. And reasonable relation was found between analysis and experiment.

• Environmental engineer
• /
• s.182
• /
• pp.62-67
• /
• 2001

본 연구에서는 기존의 로터리 방식이나 플래시 방식 등의 직접열에 의한 건조방식이 2차 공해 유발 및 폭발이나 화재의 위험을 항상 내포하는 등 여러 가지 단점이 있으므로 이러한 문제점을 연속 감압식 간접열 방식의 건조장치를 개발하여 근원적으로 해결하고자 하였다. 본 연구의 목표는 50kg/hr용량의 연속 감압식 간접열 방식의 디스크 건조장치를 개발하여 건조효율을 70$\%$ 이상 향상시키며(기존의 제품은 50$\%$

• Journal of Urban Science
• /
• v.8 no.1
• /
• pp.45-49
• /
• 2019

The land treatment of sewage sludge is necessary because sewage sludge is increasing year by year. Therefore the research of sewage sludge solidification is underway as one of the land treatment methods. However, the problem with existing sewage sludge solidification is that the moisture content of sewage sludge is high and the dewaterability is low. Because of high drying cost the efficiency of energy production is low and the calorific value is insufficient. So the disposer is supplied with a filtration and caloric aid for improving dewaterability and calorific value. In this study, it is aimed to improve the fuel value of sewage sludge by confirming the feasibility of waste wood as a filtration and caloric aid. The dewaterability was measured by CST-test and the calorific value was measured by bomb calorimeter. As a result the dewaterability and calorific value are improved in all of the samples. The dewaterability was improved as the waste wood was added in the sewage sludge. By adjusting the waste wood adding rate into the sewage sludge the dewaterability and calorific value of sewage sludge will be improved. This study confirmed possibility of the waste wood used as filtration and caloric aid.

• Journal of Environmental Science International
• /
• v.13 no.7
• /
• pp.681-687
• /
• 2004

This study was focused on the manufacturing method of a dewatering aid, which would reduce the water content of the sludge cake by enhancing the dewaterability of sewage sludge. The pretreatment technology for sludge by using radiation and among diverse discarded resources were starfish selected as the material to manufacture the dewatering aid. Starfish went through the process of washing, drying, and pulverizing. The starfish powder made in this process was applied to the digested sludge generated at the sewage treatment plant of D City, and its effects were investigated. The starfish powder that was 300 ${\mu}m$ in particle size was added to the irradiated digested sludge. After the application of the condensation process, the sludge with the starfish powder added was dewatered using the belt press and centrifuge, which were the traditional pressure dewatering devices. As the result, it reduced the water content of the sludge 20% higher than the dewatered cake with no dewatering aid added and irradiation. When the powder was added, it contributed to less use of the coagulant added. The more irradiation dose, the lower water content did the dewatered cake have and the more coagulant was needed for condensation, which seems to be a disadvantage that can be compensated for by the starfish dewatering aid. A small-scaled treatment of the study to a radiation technology and dewatering aid using a discarded resource confirmed the potential of dewaterability. Based on the results saying that the dewatering aid and radiation technology can improve dewatering effects using the traditional dewatering devices, this pretreatment technology will be expected to be applied to sewage treatment plants.

• Applied Chemistry for Engineering
• /
• v.18 no.6
• /
• pp.575-579
• /
• 2007

Sludge disposal technology has been studied with many researchers since disposal of sewage sludge has been a social problem. The current technologies include incineration, carbonization, pyrolysis, landfilling and fertilization. However, all of these processes require a dry process, because sewage sludge with more than 80% high water content is difficult to be used as a raw material. This study has the purpose to establish the optimal operation conditions and the technology as changing the variables: kiln residence time, sludge load, dryer temperature, by using the previous study that is rotary kiln type dryer designed as a numerical simulation study. As the results, optimum conditions are determined as follows: kiln residence time, sludge load, dryer temperature are $62.5kg/m^3{\cdot}hr$, 26.2 min, $330^{\circ}C$, respectively. Content of water, drying efficiency, weight loss, volume loss show that the results are $10{\pm}2$, 88, 80, 60%, and the dried sludge is released by a dryer below 10 mm.

• Transactions of the Korean hydrogen and new energy society
• /
• v.27 no.2
• /
• pp.192-200
• /
• 2016

A characteristics of microwave drying-gasification was analyzed for converting a dewatered sewage sludge generated a wastewater treatment plant. Gas (60%) was the largest component of the product of microwave gasification, followed by sludge char (33%) and tar (2%). The main components of the producer gas were hydrogen (33%) and carbon monoxide (40%), and there was some methane and hydrocarbons ($C_2H_4$, $C_2H_6$, $C_3H_8$). Larger nitrogen and smaller oxygen amounts were generated. Gravimetric tar generated $414g/m^3$. This means a total tar which is a heavy hydrocarbons from the volatile organic substance in the sewage sludge. Selected light tars were benzene, anthracene, naphthalene, pyrene, showing lower concentrations as 2.62, 0.37, 0.49, $0.28g/m^3$, respectively. Sludge char has larger meso pores which is a mean pore size of $50.85{\AA}$ and has high adsorptivity. An amount of adsorption was $228.71cm^3/g$, showing higher quantity than acommercial adsorbers. This indicates that the gas obtained from the microwave gasification of wet sewage sludge can be used as fuel, but the heavy tar in the gas must be treated. Sludge char can be used as a tar reduction adsorbent in the process, and then burns as a solid fuel.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.20 no.4
• /
• pp.61-74
• /
• 2012

Industrial complexes in Korea have been vigorously established by economic development plan and development policy of industry in 1960s. Recently, Korean government has promoted Eco Industrial Park (EIP) project to recycle by-products and wastes in industrial park In this study, we analyzed the physical and chemical properties for the sludges discharged from A industrial complex. And we investigated the economic feasibility and environmental impact of sludge to energy facilities. The analysis results indicated that the petrochemical industry were 92% in sludge production, the highest treatment amount was landfill, followed by incineration and recycling and then ocean disposal. Wastewater sludge and process sludge samples are collected and analyzed to use as basic data on economic feasibility and environmental impact. Weighted average heating value of sludge samples was 3,891kcal/kg. Based on this data, installation and operation costs, operation returns of operating the drying facility are estimated, compared with cogeneration facility. And this study examines how the payback period of each simulation(total 8 case) with the important parameter changes. As a result, it was found that what needs the shortest payback period is 3years with connection of drying facility and cogeneration facility based on the government's financial subsidy system.

• Proceedings of the Korea Concrete Institute Conference
• /
• 1994.10a
• /
• pp.105-110
• /
• 1994

This study is applying to the concrete with the variation of the variation of the sludge contents, to analyze the properties of the fresh concrete and the mechanical properties of hardened concrete give the reference data of actual ready mixed concrete. To the result of this study in the condition of W/C 60%. As a result of this experiment and considering the drying shrinkage, it is thought that in using sludge, the less amount of sludge than 4% can produce of good quality concrete.

• Journal of Power System Engineering
• /
• v.10 no.2
• /
• pp.36-40
• /
• 2006

In order to prevent the environmental pollution, the dryers are commonly used to treat sludge that one of sewages is polluting the quality of water. Generally, the drying method is various as to the property of material and use. Rotary dryer is a good apparatus to treat them. It is the way that is to make substance transmission and heat using hot air between sludge particle and heated gas. In this paper, we developed a 3-pass rotary dryer for a design program for the 3-pass rotary dryer with various conditions. The working conditions of dryer are a raw sludge feed rate, input & output water content and operation time etc.

• Resources Recycling
• /
• v.28 no.2
• /
• pp.31-39
• /
• 2019

The pelletizing of printed circuit board (PCB) sludge was researched for copper recovery in pyrometallurgical process. This pelletizing was carried out by using self-manufactured compression-type apparatus after pre-treatments (drying, water scrubbing, size classification) were proceeded. The physical properties (compression strength and drop-breakage test) were tested with a change of sludge sizing and the number of compression. In the case of using the undersized sludge of #140, its properties were improved to 0.6 MPa and 9.3 times. Moreover, they increased to 0.82 MPa and 19.0 times by using the #140 ~ 325 sludge. These imply that the packing density increases due to the elimination of large-sized sludge (#140), and also the weight of required binder decreases by the removal of fine-sized sludge (#325).