• Journal of the Korean Professional Engineers Association
• /
• v.18 no.3
• /
• pp.21-27
• /
• 1985

Earthen mass located beneth a sloping group surface, whether natural or manmade, have a tendency to move downward and outward under the influence of gravity. Unless this tendency is suitably counteracted by the Shearing resistances within the mass, a landslide occurs. Avoiding such instabilities is a major concern of the geotechnical engineer. The shearing behavior of a soil is determined empirically, i.e., by field tests or laboratory tests. This results are applied to the slope stability analysis. The factor of safety for slope stability analysis is much more sensitive to the choice of strength parameters as interpreted from soil tests than to the choice of the computational method of analysis. This paper was investigated the influence of the change in the factor of safety due to a change in one of the parameters, relative to the total change in the factor of safety due to change in all parameters. A conclusion may be reached with respect to the required precision definition of the different variables to limit uncertainties in the factor of safety to tolerable levels.

• Journal of Agricultural Extension & Community Development
• /
• v.16 no.1
• /
• pp.51-67
• /
• 2009

This study was carried out to investigate the major factors of the successful development of Doi Chaang Coffee Complex, Chiang Rai of Thailand. Data were gathered through field survey, library research and internet so on. Interviews were conducted with specialist, community leaders, board member of Doi Chaang Coffee Company from 14 to 19, January 2007. The major factors for the successful development observed were as follows: 1) Successful selection of crops and farming system(SALT) with regards of slopes and meteorological condition; 2) Leadership of the King of Thailand and the chief of Akha in terms of attitudinal change of hill-tribes in agriculture extension; 3) supporting by Royal Project Foundation; 4) Quality control through post harvest management by cooperative system; 5) Cooperation between the Coffee Producers' Cooperatives of Thailand and for the international Doi Chaang Coffee Corporation of Canada in terms of fair trade and so on.

• Journal of the Korean Society of Tobacco Science
• /
• v.15 no.1
• /
• pp.57-62
• /
• 1993

Ridger and vinyl mulcher for 8-10 PS power tiller which were distributed at the rate of one out of 2.3 farm households in Korea, was developed to ease the labor shortage of tobacco production. Devices wheel shaft extension by 30cm at both sides improved the stability of straight drive and enabled to save required labor hours by 50% for ridging at sloping field. Screw type blades were attached on center drive rotavator shaft, gear set was deviled to reverse the rotavator, and it was good at need to adjust the width and height for ridge. As the results, required labor hours for ridging and vinyl mulching could be saved by 90% as compared to conventional manual method after cattle plowing, and by 50% as compared to conventional power tiller method.

• 한국신재생에너지학회:학술대회논문집
• /
• 2011.11a
• /
• pp.160.1-160.1
• /
• 2011

In this study, the influence of methodology of assessing water levels on the discharge coefficient of sluice for tidal power generation was investigated. A physical experiment was performed in a planar open channel by installing 1/70 scale model of the sluice caisson in the planar open channel. In front of and behind the sluice model, sloping bathymetry was made to reproduce corresponding field condition. By analyzing the experimental results, it was found that the location of measuring water levels significantly affects the estimates of the discharge coefficient, due to the variability of the parameter according to the head difference between the measuring locations. Therefore, it is necessary to be careful in estimating and utilizing the discharge coefficient in the relevant study of a tidal power generation.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.6 no.3
• /
• pp.260-265
• /
• 1994

A new set of elliptic wave equations describing the deformations of irregular waves on a large-scale current field in water of irregular depth is given, and using finite difference scheme an efficient numerical method is also presented. The elliptic equations are solved in a similar way to Initial value problem. This method is extensively used for the calculation of wave spectral transformation. and computation results agree very well with experimental data (Hiraishi, 1991). Finally numerical examples are presented concerning the interactions between waves and currents over a mildly sloping beach and also over a mound.

• Journal of Navigation and Port Research
• /
• v.38 no.4
• /
• pp.421-427
• /
• 2014

In order to protect coastal facilities mainly from wave and current actions, the self-locking eco blocks constituting elements of protecting shore structures against scouring were designed. These blocks are adapted to the sloping bottom, coastal dunes, and submerged coastal pipelines, counteracting the destructive and erosive impulse action. A series of laboratory experiments has been conducted to investigate the reflection of water waves over and against a train of protruded or submerged shore structures and compare the reflecting capabilities of incident waves including wave forces. In this study the hydraulic model experiment was conducted to identify the performance of newly designed water affinity eco blocks to keep the coast slope and bottom mound from scouring by reduction of the wave reflection and to convince stability of the block placement. Revised design of each block element was also tested for field conditions. From the result of experiments, the field applicability of the developed blocks and placement was discussed afterward.

• Korean Journal of Soil Science and Fertilizer
• /
• v.43 no.6
• /
• pp.804-811
• /
• 2010

The lower portion of sloping paddy fields normally contains excessive moisture and the higher water table caused by the inflow of ground water from the upper part of the field resulting in non-uniform water content distribution. Four drainage methods namely Open Ditch, Vinyl Barrier, Pipe Drainage and Tube Bundle for multiple land use were installed within 1-m position from the lower edge of the upper embankment of sloping alluvial paddy fields. Knowledge of the spatial variability of soil water properties is of primary importance for management of agricultural lands. This study was conducted to evaluate the effect of drainage in the soil on spatial variability of soil water content using the geostatistical analysis. The soil water content was collected by a TDR (Time Domain Reflectometry) sensor after the installation of subsurface drainage on regular square grid of 80 m at 20 m paddy field located at Oesan-ri, Buk-myeon, Changwon-si in alluvial slopping paddy fields ($35^{\circ}22^{\prime}$ N, $128^{\circ}35^{\prime}$). In order to obtain the most accurate field information, the sampling grid was divided 3 m by 3 m unit mesh by four drainage types. The results showed that spatial variance of soil water content by subsurface drainage was reduced, though yield of soybean showed the same trends. Value of "sill" of soil water content with semivariogram was 9.7 in Pipe Drainage, 86.2 in Open Ditch, and 66.8 in Vinyl Barrier and 15.7 in Tube Bundle.

• The Journal of Korean Society for Radiation Therapy
• /
• v.8 no.1
• /
• pp.55-61
• /
• 1996

A radiation beam incident on irregular or sloping surface produces an inhomogeneity of absorbed dose. The use of a tissue compensator can partially correct this dose inhomogeneity. The tissue compensator should be made based on experimentally measured thickness ratio. The thickness ratio depends on beam energy, distance from the tissue compensator to the surface of patient, field size, treatment depth, tissue deficit and other factors. In this study, the thickness ratio was measured for various field size of $5cm{\times}5cm,\;10cm{\times}10cm,\;15cm{\times}15cm,\;20cm{\times}20cm$ for 4MV X-ray beams. The distance to the compensator from the X-ray target was fixed, 49cm, and measurement depth was 3, 5, 7, 9 cm. For each measurement depth, the tissue deficit was changed from 0 to(measurement depth-1)cm by 1cm increment. As a result, thickness ratio was decreased according to field size and tissue deficit was increased. Use of a representative thickness ratio for tissue compensator, there was $10\%$ difference of absorbed dose but use of a experimentally measured thickness ratio for tissue compensator, there was $2\%$ difference of absorbed dose. Therefore, it can be concluded that the tissue compensator made by experimentally measured thickness ratio can produce good distribution with acceptable inhomogeneity and such tissue compensator can be effectively applied to clinical radiotherapy.

• The Journal of Korean Society for Radiation Therapy
• /
• v.1 no.1
• /
• pp.63-69
• /
• 1985

High energy electron beams took effect for tumor radio-therapy, however, had a lot of problems in clinical application because of various conversion factors and complication of physical reactions. Therefore, we had experimentally studied the important properties of high energy electron beams from the linear accelerator, LMR-13, installed in Yonsei Cancer Center. The results of experimental studies on the problems in the 8, 10, 12 Mev electron beam therapy were reported as following. 1. On the measurements of the outputs and absorbed does, the ionization type dosimeters that had calibrated by $^{90}Sr$ standard source were suitable as under $3\%$ errors for high energy electrons to measure, but measuring doses in small field sizes and the regions of rapid fall off dose with ionization chambers were difficult. 2. The electron energy were measured precisely with energy spectrometer consisted of magnet analyzer and tele-control detector and the practical electron energy was calculated under $5\%$ errors by maximum range of high energy electron beam in the water. 3. The correcting factors of perturbated dose distributions owing to radiation field, energy and material of the treatment cone were checked and described systematically and variation of dose distributions due to inhomogeneous tissues and sloping skin surfaces were completely compensated. 4. The electron beams, using the scatters; i.e., gold, tin, copper, lead, aluminium foils, were adequately diffused and minimizing the bremsstrahlung X-ray induced by the electron energy, irradiation field size and material of scatterers, respectively. 5. Inproving of the dose distribution from the methods of pendulum, slit, grid and focusing irradiations, the therapeutic capacity with limited electron energy could be extended.

• Journal of Radiation Protection and Research
• /
• v.3 no.1
• /
• pp.6-22
• /
• 1978

High energy electron beams took effect for tumor radio-therapy, however, had a lot of problems in clinical application because of various conversion factors and complication of physical reactions. Therefor, we had experimentally studied the important properties of high energy electron beams from the linear accelerator, LMR-13, installed in Yonsei Cancer Center. The results of experimental studies on the problems in the 8, 10, 12 Mev electron beam therapy were reported as following. 1. On the measurements of the outputs and absorbed doses, the ionization type dosimeters that had calibrated by $^{90}Sr$ standard source were suitable as under 3% errors for high energy electrons to measure, but measuring doses in small field sizes and the regions of rapid fall off dose with ionization chambers were difficult. 2. The electron energy were measured precisely with energy spectrometer consisted of magnet analyzer and tele-control detector and the practical electron energy was calculated under 5% errors by maximum range of high energy electron beam in the water. 3. The correcting factors of perturbated dose distributions owing to radiation field, energy and material of the treatment cone were checked and described systematically and variation of dose distributions due to inhomogeneous tissues and sloping skin surfaces were completely compensated. 4. The electron beams, using the scatterers; ie., gold, tin, copper, lead, aluminium foils, were adequately diffused and minimizing the bremsstrahlung X-ray induced by the electron energy, irradiation field size and material of scatterers, respectively. 5. Inproving of the dose distribution from the methods of pendulum, slit, grid and focusing irradiations, the therapeutic capacity with limited electron energy could be extended.