• 한국분무공학회지
• /
• 제7권1호
• /
• pp.36-42
• /
• 2002

The objective of this investigation was to obtain an excellent spray at the low injection pressure. When cavitation occurred in the nozzle hole the atomization of the liquid jet enhanced considerably. In this experiments, a acrylic nozzle which was installed the gap and installed the bypass in the nozzle hole was used to enhance the atomization of the liquid jet at the few injection pressure. The liquid flow in the nozzle hole was photographed by a transmitted light using a micro flash. The spray angle was measured by macroscope images of PMAS and the Sauter mean diameter was measured by PDA system. The pressure of the notate hole was measured by pressure transducer. It was found that enhanced atomization of the liquid jet at the low injection pressure was obtained by installing the gap and the bypass at the single hole nozzle.

• 한국통신학회논문지
• /
• 제21권3호
• /
• pp.763-770
• /
• 1996

In this paper, the Single-stage Transmission type Injectiong-Locked Oscillator(STILO) was designed and fabicated for the Active Integrated Phased Array Antenna(AIPAA) system. The STILO, which was designed and fabricated by injection-locked technique and hair-pin resonator, has the same 210MHz frequency tuning range of the Voltage Controlled Oscillator(VCO) used by varactor. The locking bandwidth of STILO with 11.5MHz bandwidth, is much better than that of the Injection-Locked Dielectric Resonator Oscillator(ILDRO), And the STILO has the improved noise characteristics in AM, FM, and PM. This STILO is useful for the AIPAA, the coupled VCO array, an the MMIC structure.

• Preventive Nutrition and Food Science
• /
• 제11권3호
• /
• pp.253-256
• /
• 2006

The purpose of this study was to develop a gas chromatographic (GC) method to analyze fatty acids in milk fat with a single injection. The single-injection GC method we developed for analyzing fatty acid composition can separate a wide range of fatty acid methyl esters from butyric acid to docosahexaenoic acid. It separated 6 isomers of 18:1 (cis-6, cis-9, cis-11, trans-6, trans-9 and trans-11), 4 isomers of 18:2 (cis-9-cis-12, trans-9-trans-12, cis-9-trans-12 and trans-9-cis-12), and 4 isomers of conjugated 18:2 (cis-9- trans-11, trans-9-cis-11, cis-10-trans-12 and trans-10-cis-12).

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1998년도 추계학술대회 논문집 학회본부A
• /
• pp.134-136
• /
• 1998

In this paper, we present harmonic reduction of a Single-Switch Three-Phase Boost Rectifier which is operated at 25kHz. A simulation result shows that input current harmonics of Single-Switch Three-Phase Rectifier are reduced by Harmonic-Injection Method. Sixth harmonic is used for Harmonic-Injection Method.

• The Korean Journal of Pain
• /
• 제23권2호
• /
• pp.131-136
• /
• 2010

Background: We prospectively evaluated the incidence and possible factors causing intramuscular injection during lumbar sympathetic ganglion block and compared the multiple needle technique to the single technique to obtain a profound and complete block effect. Methods: Among 83 patients, 58 patients (group A, n = 27, multiple needle technique and group B, n = 31, single needle technique) were reevaluated for the changes of skin temperature (Ts) and mean segment of longitudinal contrast spread. After injecting the contrast agent, the incidence of psoas muscle injection and the change of Ts was compared between two groups. Results: The incidence of psoas muscle injection was 21.3% (46/216) and it was associated with the level of injection (L2) significantly (${\chi}_2$ = 14.773, P = 0.001). $DT^{post}$ (postblock temperature difference between ipsilateral and contralateral great toe, $4.6{\pm}2.8^{\circ}C$, $1.8{\pm}1.6^{\circ}C$, P < 0.001 for group A and B) and $DT^{net}$ ($DT^{post}$ - $DT^{pre}$, $3.9{\pm}2.7^{\circ}C$, $1.5{\pm}1.5^{\circ}C$, P < 0.001 for group A and B) was significantly higher in group A. The mean segment of longitudinal contrast spread was $8.1{\pm}0.9$ for group A and $3.2{\pm}1.6$ for group B (P < 0.001). Conclusions: The LSGB at the L2 level showed the lowest incidence of psoas muscle injection of contrast. Multiple needle approach showed more significant increase of $DT^{net}$ and $DT^{post}$.

• 한국초전도학회:학술대회논문집
• /
• 한국초전도학회 2002년도 High Temperature Superconductivity Vol.XII
• /
• pp.36-36
• /
• 2002

• 한국자동차공학회논문집
• /
• 제12권6호
• /
• pp.9-15
• /
• 2004

The characteristics of combustion and emissions were investigated in a single cylinder DI diesel engine equipped with a common rail injection system. This study presents an experimental study of the effect of engine speed, injection timing, injection pressure and pilot injection timing on the combustion and exhaust emissions. The engine speeds were 1000 and 2000rpm and the corresponding injection pressures were 50 and 100MPa. Experimental results show that NOx emissions decrease with retarded injection timing, while HC and CO emissions increases. Higher injection pressure increases NOx with lower soot emissions. For the case with the pilot injection prior to main injection, the ignition delay is shortened and the premixed combustion ratio decreases. Also NOx and soot emissions are decreased with increase of pilot injection advance.

• 한국자동차공학회논문집
• /
• 제17권4호
• /
• pp.79-85
• /
• 2009

Low temperature combustion regime for the simultaneous reduction of nitrogen oxides ($NO_x$) and paticulate matter (PM) is demonstrated in single cylinder engine at various operating parameters, such as EGR rate, injection timing, EGR temperature, amount of fuel and swirl rate. Low temperature combustion is accomplished by high exhaust gas recirculation (EGR) rate in this study. Generally, the emission of $NO_x$ almost completely disappears and PM significantly increases in the first decreasing regime of oxygen concentration but after peaking about 10~12% oxygen concentration, PM then decreases regardless of fuel injection quantity. Low temperature combustion regime was extended by low EGR temperature, high injection pressure and low amount of fuel.

• 한국자동차공학회논문집
• /
• 제3권6호
• /
• pp.134-144
• /
• 1995

The solenoid actuated hydrogen injector and the capacitive peak-hold type driving circuit were designed and made, and the hydrogen supply system for in-cylinder injection was constructed with these. The performance of the injector was investigated through measuring the pintle lift profiles and the injection quantities, and the performance of the hydrogen supply system was confirmed through the experiments at the single cylinder engine. The injection quantity increased linearly as the duration of driving signal increased. At the single cylinder engine, the hydrogen injector was operated stably. The hydrogen flow rate of the injector with the peak-hold type driving circuit could be controlled precisely at high engine speed or low load condition only with the variation of signal duration.

• 한국수정란이식학회지
• /
• 제13권3호
• /
• pp.213-217
• /
• 1998

본 연구는 한우 다배란처리시 노동력을 절감하고 공란우의 스트레스를 방지하여 정상수정란을 안정적으로 생산할 수 있는 1회 주사시 FSH의 용해제의 종류와 농도를 선정하기 위하여 다양한 용매제에 용해시킨 1회 주사와 기존의 다회주사에 의한 난소반응을 비교 검토하였다. 1. 공란우에 다배란 처리후 발정유기는 처리 1과 7에서 100% 유기되었다. 2. 채란수와 정상수정란 수는 처리 1과 처리 7에서 (3.5, 2.9와 3.8, 3.5) 다른 처리구에 비해 유의하게 많았다(p〈0.05). 3. FSH 주사후 7일째 혈중 progesterone농도 역시 처리 1과 처리 7에서(6.19ng/ml, 7.54ng/ml) 다른 처리구에 비해 유의하게 높았다(p〈0.05).