• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.35D no.1
• /
• pp.72-78
• /
• 1998

Polarization mode converters have been produced by utilizing Ti:LiNbO$_{3}$ channel waveguide and strain-optic effect. Shear strain for periodic perturbations of optical channel waveguides and phase matching can be obtained by an evaporated periodic SiO$_{2}$ thin film at 300.deg. C. The electrodes located on the either side of waveguide provide a means to electro-optically tune the wavelength for maximum polarization conversion via the electrooptic effect. The maximum conversion effeciency was observed at 21.deg. C for V=0 and 46.deg. C for V=30V aro the device having 7 .mu.m waveguide wiith and 350 periodic pads. The dependence of the number of pads on conversion efficiency was observed experimentally.fficiency was observed experimentally.

• Journal of information and communication convergence engineering
• /
• v.8 no.1
• /
• pp.107-111
• /
• 2010

This paper has presented the dependence of the threshold voltage on back gate bias and drain voltage for FinFET. The FinFET has three gates such as the front gate, side and back gate. Threshold voltage is defined as the front gate bias when drain current is 1 micro ampere as the onset of the turn-on condition. In this paper threshold voltage is investigated into the analytical potential model derived from three dimensional Poisson's equation with the variation of the back gate bias and drain voltage. The threshold voltage of a transistor is one of the key parameters in the design of CMOS circuits. The threshold voltage, which described the degree of short channel effects, has been extensively investigated. As known from the down scaling rules, the threshold voltage has been presented in the case that drain voltage is the 1.0V above, which is set as the maximum supply voltage, and the drain induced barrier lowing(DIBL), drain bias dependent threshold voltage, is obtained using this model.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2000.10a
• /
• pp.485-489
• /
• 2000

본 논문에서는 단일 PLL을 사용하여 400MHz 대역의 트랜시버를 구현하였다. 일반적인 트랜시버의 경우, 송수신부에 각각 한 개의 PLL과 수신부에 2단의 믹서를 사용하여 구현되어진다. 이러한 구성은 트랜시버의 가격과, 부피에 상당히 큰 영향을 미친다. 본 논문에서는 기존의 방식을 탈피하여 단일 PLL방식의 데이터 전송용 특정 소출력 무선기기의 송, 수신단의 회로설계, 제작 및 특성측정을 하였다. 설계된 트랜시버의 주파수 대역은 424.7-424.95MHz이고, Low Side Injection방식을 사용하여 450KHz의 If 주파수로 변환(Conversion)하였고, 반이중(Semi duplex Communication) 통신방식, PLL Synthesized, 21 Channel, 12.5KHz Channel BandwidttL FSK Modulation / Demodulation 방식을 사용하였다.

• ETRI Journal
• /
• v.28 no.4
• /
• pp.533-536
• /
• 2006

A distributed Bragg reflector (DBR) laser and a high speed electroabsorption modulator (EAM) are integrated on the basis of the selective area growth technique. The typical threshold current is 4 to 6 mA, and the side mode suppression ratio is over 40 dB with single mode operation at 1550 nm. The DBR laser exhibits 2.5 to 3.3 mW fiber output power at a laser gain current of 100 mA, and a modulator bias voltage of 0 V. The 3 dB bandwidth is 13 GHz. A 10 Gbps non-return to zero operation with 12 dB extinction ratio is obtained. A four-channel laser array with 100 GHz wavelength spacing was fabricated and its operation at the designed wavelength was confirmed.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.4A
• /
• pp.361-370
• /
• 2008

Cooperative relaying permits one or more relay to transmit a signal from the source to the destination, thereby increasing network coverage and spectral efficiency. The performance of cooperative relaying is often measured as outage probability. However, appropriate measure for the channel quality is outage capacity. Although the outage probability for cooperative relaying protocol has been analyzed before, very little research has been addressed for the outage capacity. This paper is the first of its kind to derive a closed-form analytical solution of outage capacity using fixed decode and forward relaying and amplify and forward relaying in dissimilar Rayleigh fading channels, considering channel coefficients known to the receiver side. The analytical results show a tradeoff between the SNR and the number of relays for specific outage capacity. A comparison between decode and forward relaying and amplify and forward relaying shows that decode and forward relaying outperforms amplify and forward relaying for a large number of relays.

• Proceedings of the IEEK Conference
• /
• 2008.06a
• /
• pp.305-306
• /
• 2008

In this paper, we measured the wireless feedback channel near a highway, and analysis results from the measured sample data are described. For characterizing the channel properties, W-CDMA signal of 2GHz frequency, 5MHz bandwidth and 10ms period are used. The scattering function, delay power profile, delay spread, and Doppler spread are measured.

• Journal of Photoscience
• /
• v.3 no.3
• /
• pp.133-136
• /
• 1996

Calcium modulates the activity of guanylate cyclase and plays a key role in dark and light adaptation in the visual system. We have measured the Ca$^{2+}$, K$^+$ and Na$^+$ concentration in dark and light adapted bullfrog's (Rana catesbeiana) vitreous humor by using the atomic absorption spectrophotometer. The calcium concentration of the light adapted bullfrog's vitreous humor was higher than that of the dark adapted bullfrog's vitreous humor. This means that ion activity between the photoreceptor and vitreous humor side is light dependent and we have found that a Ca$^{2+}$ channel and Na$^+$ - Ca$^{2+}$ exchanger exist in the vitreous humor.

• Journal of Advanced Marine Engineering and Technology
• /
• v.24 no.5
• /
• pp.119-124
• /
• 2000

A finite element method is applied to investigate the characteristics of the fluid flow and heat transfer performance in a channel in terms of the various effects of baffle cuts, baffle angles, and leakages. The results show that the decrease of a baffle cut gives a good heat transfer enhancement. However, it also increases pressure drop. In the case of an inclined baffle, the result shows that the pressure drop decreases with a reasonable heat transfer performance. But a steeply inclined baffle gives adverse effects on the performance of the channel. The clearances between baffle-to-shell and tube-to-baffle affect the overall performance. The effects of these parameters are discussed in details.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.10 no.5
• /
• pp.2166-2180
• /
• 2016

We investigate the opposite of artificial noise (AN)-assisted communication in multiple-input-multiple-output (MIMO) wiretap channels for the multiuser case by taking the side of the eavesdropper. We first define a framework for an AN-assisted multiuser multiple-input-multiple-output (MU-MIMO) system, for which eavesdropping methods are proposed with and without knowledge of legitimate users' channel state information (CSI). The proposed method without CSI is based on a modified joint approximate diagonalization of eigen-matrices algorithm, which eliminates permutation indetermination and phase ambiguity, as well as the minimum description length algorithm, which blindly estimates the number of secret data sources. Simulation results show that both proposed methods can intercept information effectively. In addition, the proposed method without legitimate users' CSI performs well in terms of robustness and computational complexity.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.10B
• /
• pp.1793-1802
• /
• 2000

In this paper we propose an efficient implementation technique for cyclic extension in VDSL(Very High bit-rate Digital Subscriber Line) systems using Zipper duplexing and analyze its performances under typical telephone channel environments. In Zipper-based VDSL systems each DTM(discrete-multitone) block is appended by both cyclic prefix(CP) and cyclic suffix(CS). The CP is inserte to prevent both intersymbol interference (ISI) and iterchannel interference (ICI) while the CS is appended to ensure orthogonality between the upstream and downstream carriers thus preventing near-end crosstalk (NEXT). However in order to implement the CP in the transmitter side of the VDSL system an additional hardware is required to append the latter part of each DMT symbol to the beginning of the DMT symbol. In this paper we propose a VDSL system with Zipper duplexing using only CS to reduce hardware complexity (memory and processing delay) required for implementation of CP. It is shown by computer simulation that the proposed approach has the same capacity under typical channel environments as the previous Zipper-based VDSL system using both CP and CS. even with a significantly lower hardware complexity.