• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.35D no.11
• /
• pp.70-77
• /
• 1998

Ni/SiC Schottky diodes have been fabricated using epitaxial 4H-SiC and 6H-SiC wafers. The epitaxial n-type layers were grown on $n^{+}$ substrates, with a doping density of 4.0$\times$10$^{16}$ c $m^{-3}$ and a thickness of 10${\mu}{\textrm}{m}$. Oxide-termination has been adopted in order to obtain high breakdown voltage and low leakage current. The fabricated Ni/4H-SiC and Ni/6H-SiC Schottky barrier diodes show excellent rectifying characteristics up to the measured temperature range of 55$0^{\circ}C$. In case of oxide-terminated Schottky barrier diodes, breakdown voltage of 973V(Ni/4H-SiC) and 920V(Ni/6H-SiC), and a very low leakage current of less than 1nA at -800V has been observed at room temperature. On non-terminated Schottky barrier diodes, breakdown voltages were 430V(Ni/4H-SiC) and 160v(Ni/6H-SiC). At room temperature, SBH(Schottky Barrier Height), ideality factor and specific on-resistance were 1.55eV, 1.3, 3.6$\times$10$^{-2}$ $\Omega$.$\textrm{cm}^2$ for Ni/4H-SiC Schottky barrier diodes, and 1.24eV, 1.2, 2.6$\times$10$^{-2}$$\Omega$.$\textrm{cm}^2$/ for Ni/SH-SiC Schottky barrier diodes, respectively. These results show that both Ni/4H-SiC and Ni/6H-SiC Schottky barrier diodes are very promising for high-temperature and high power applications.s..

• Journal of the Korean Vacuum Society
• /
• v.10 no.1
• /
• pp.104-111
• /
• 2001

B-doped hydrogenated amorphous silicon carbide (a-SiC:H) thin films were prepared by plasma-enhanced chemical-vapor deposition in a gas mixture of $SiH_4, CH_4,\;and\; B_2H_6$. Physical and chemical properties of a-SiC:H films grown with varing the ratio of $B_2H_6/(SiH_4+CH_4)$ were characterized with various analysis methods including scanning electron microscopy (SEM), X-ray diffractometry (XRD), Raman spectroscopy, Fourier-transform infrared (FTIR) spectroscopy, secondary ion mass spectroscopy (SIMS), UV absorption CH_4spectroscopy and electrical conductivity measurements. With the B-doping concentration, the doping efficiency and the micro-crystallinity were decreased and the film became amorphous when $B_2H_6/(SiH_4{plus}CH_4)$ was over $5{\times}10^{-3}$. The addition of $B_2H_6$ gas during deposition decreased the H content in the film by lowering the quantity of Si-C-H bonds. Consequently, the optical band gap and the activation energy of a-SiC:H films were decreased with increasing the B-doping level.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.19 no.6
• /
• pp.52-54
• /
• 1982

p·Si-전해질 접합을 전해질로 6N H2SO4, 6N H2SO4(Ti3+), 6N H2SO4(Ti4+), 6N H2SO4(Ti4+/Ti3+)을 사용하여 만들었다. 이들 전해질중 6N H2SO4(Ti4-/Ti3+)을 사용할 때 p·Si 광음극이 안정하게 동학하며 높은 광전 감도를 가지고 있었다. p·Si-electrolyte junction are prepared by using p·Si photocatode in four different electrolytes such as 6N H2SO4, 6N H2SO4(Ti3+), 6N H2SO4(Ti4+), 6N H2SO4(Ti4+/Ti3+) respectively. Among those electrolytes 6N H2SO4(Ti4-/Ti3+) shows very good results, in which p·Si photocathode is stable.

• Journal of the Korean Vacuum Society
• /
• v.18 no.1
• /
• pp.15-23
• /
• 2009

Saturation-coverage silyl, $-SiH_3(a)$, overlayers were prepared from $Si_2H_6$ adsorption on three comparative surfaces: clean unmodified; D-precovered; and atomically roughened Si(100). Together with its precursor-mediated adsorption behavior, the surface reactivity of $Si_2H_6$ was found to be the highest on the unmodified Si(100)-$2{\times}1$ surface. This was correlated with its dissociative adsorption mechanism, in which both the $H_3Si-SiH_3$ bond scission and the dual surface $Si-SiH_3(a)$ bond formation require a surface dangling bond 'pair'. The unusually high thermal stability of $-SiH_3(a)$ on the unmodified surface was ascribed to a nearly close-packed $-SiH_3(a)$ coverage of ${\sim}0.9$ monolayer and the consequent lack of dangling bonds on the silyl-packed surface.

• Journal of the Korean Vacuum Society
• /
• v.4 no.4
• /
• pp.350-357
• /
• 1995

SiH4와 Si2H6를 1-3 Torr 정도의 저압에서 열분해시켰을 때, 반응물의 농도 변화를 살펴보고 이로부터 열분해의 반응 기구를 예측하였다. 분석기로는 질량 분석기를 이용하였으며, 분해 온도 범위는 SiH4의 경우는 $350~475^{\circ}C$, Si2H6의 경우는 275-375$^{\circ}C$이었다. SiH4의 분해 양상은 1차 비가역 반응에 잘 들어 맞았으며, 그 속도 상수는 문헌에 보고되어 있는 상압에서의 속도보다 작았다. Si2H6는 낮은 온도 범위에서도 잘 분해되었으며, 중간 생성물로 많은 양의 SiH4를 만들었다. 그리고, SiH4는 고분자화되는 반응을 거치지 않고 고체실리콘을 생성하지만, Si2H6는 중간 생성물로 만들어진 SiH4와 SiH2에 의하여, 고분자화 반응을 거쳐서 고체실리콘을 만들 수 있음을 알았다.

• Journal of the Korean Vacuum Society
• /
• v.5 no.3
• /
• pp.239-244
• /
• 1996

We firstly report that formation of $SiO_2$ layer on Si surface can be effectively prevented by flowing the $Si_2H_6$ gas during the heating-up procedure for amorphous Si depositions. In this way, amorphously deposited Si layer onto crystalline Si substrates can be grown epitaxially during the post-deposition heat treatments. The suppression of surface $SiO_2$ can be explained in terms of adsorption of SiHx adspecies, instead of oxygen from residual gases in the reactors, to Si surfaces after desorption of hydrogen from H-passivated Si surfaces. Employing $Si_2H_6$ flowing and soild phase epitaxial growth, high-quality epitaxial Si layer can be obtained at low temperatures below $600^{\circ}C$ without conventional high temperature cleaning procedures.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.7 no.3
• /
• pp.393-399
• /
• 1997

H-SiC single crystals were successfully grown by the sublimation method and the optimum growth conditions were established. The grown SiC crystals were about 33 mm in diameter and 11 mm in length. The micropipe density of the polished SiC wafers was 400/$\textrm{cm}^2$, and the planar defect density was 50/$\textrm{cm}^2$. Raman spectroscopy and DCXRD analysis were used to examine the crystallinity of Acheson seeds and the 6H-SiC wafers. As a result, the crystallinity of the 6H-SiC wafers was better than that of Acheson seeds. For examination of the electrical properties of the undopped 6H-SiC wafers Hall measurements were applied. According to the measurements the carrier concentration was estimated to be $3.91{\times}10^{15}/\textrm {cm}^3$ and doping type of the undopped. 6H-SiC wafers was n-type.

• 한국신재생에너지학회:학술대회논문집
• /
• 2009.06a
• /
• pp.28-30
• /
• 2009

이종접합태양전지에서 p a-Si:H/c-Si의 p a-Si:H의 증착 조건인 $H_2/SiH_4$ 비율, $B_2H_6$의 농도를 변화 시키며 실험하여 이 따라 계면 특성 변화를 연구하였다. pa-Si:H의 $H_2/SiH_4$ 비율이 상승할수록 carrier lifetime이 증가하다 다시 감소하는 경향을 나타내었다. 이는 $H_2/SiH_4$의 비율 중 효과적으로 웨이퍼표면을 효과적으로 passivation하는 지점이 있는 것으로 보인다. $B_2H_6$의 농도는 상승할수록 carrier lifetime이 줄어드는 경향을 보였다. $B_2H_6$에서 농도가 올라감에 웨이퍼 표면의 defect로 작용했을 것으로 생각된다. 이에서 몇몇의 조건으로 태양전지를 제작한 결과 $H_2/SiH_4$ 비율에 따라서는 carrier lifetime은 효율에 그 영향이 미미한 것으로 조사되었고, $B_2H_6$의 농도가 낮을수록 개방전압은 상승하는 결과를 얻어 도핑 농도가 효율에 직접적인 형향을 주는 것으로 나타났다.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.10 no.1
• /
• pp.5-12
• /
• 2000

As a semiconductor material for electronic devices operated under extreme environmental conditions, silicon carbides (SiCs) have been intensively studied because of their excellent electrical, thermal and other physical properties. The growth characteristics of single- crystalline 6H-SiC homoepitaxial layers grown by a thermal chemical vapor deposition (CVD) were investigated. Especially, the successful growth condition of 6H-SiC homoepitaxial layers using a SiC-uncoated graphite susceptor that utilized Mo-plates was obtained. The CVD growth was performed in an RF-induction heated atmospheric pressure chamber and carried out using off-oriented ($3.5^{\circ}$tilt) substrates from the (0001) basal plane in the <110> direction with the Si-face side of the wafer. In order to investigate the crystallinity of grown epilayers, Nomarski optical microscopy, transmittance spectra, Raman spectroscopy, XRD, Photoluninescence (PL) and transmission electron microscopy (TEM) were utilized. The best quality of 6H-SiC homoepitaxial layers was observed in conditions of growth temperature $1500^{\circ}C$ and C/Si flow ratio 2.0 of $C_3H_8$ 0.2 sccm & $SiH_4$ 0.3 sccm.

• Journal of the Korean Vacuum Society
• /
• v.4 no.S1
• /
• pp.1-6
• /
• 1995

Polycrystalline Si films have been used in many applications such as thin film transistors(TFT), image sensors and LSI applications. In this research deposition of Si films at low temperatures with remote plasma enhanced CVD from Si2H6-SiF4-H2 on SiO2 was studied and their crystallinity was investigated. It was condluded that growth of crystalline Si films was favorable with (1) low Si2H6 flow rates, (2) moderate plasma power, (3) moderate SiF4 flow rates, (4) moderate substrate temperature, and (5) suitable method of surface cleaning.