• 한국지반공학회논문집
• /
• 제16권1호
• /
• pp.191-201
• /
• 2000

본 연구에서는 굴착부지가 넓고 지하수위가 높은 점성토지반에 얕은 굴착시 종래에 널리 적용되었던 강널말뚝 흙막이공 대신 줄말뚝을 이용한 흙막이공을 제안하였다. 줄말뚝을 이용한 흙막이 구조물의 거동을 관찰하기 위하여 지하굴착기간 동안 경사계 및 지하수위계를 설치하여 말뚝과 지반의 수평변위와 지하수위 변화를 조사하였다. 현장계측결과 말뚝과 지반의 변형거동은 굴착면 기울기, 말뚝두부구속조건, 말뚝설치간격, 굴착지반의 안정수 등의 요소에 영향을 받는 것으로 나타났다. 그리고 줄말뚝을 이용한 흙막이공의 시공성과 안정성뿐만 아니라 근접시공의 문제점이 없는 연약지반에서는 강널말뚝 흙막이공보다 경제적인 공법임을 확인하였다.

• Geomechanics and Engineering
• /
• 제15권5호
• /
• pp.1039-1046
• /
• 2018

This paper presents a limit analysis of the series of construction stages of shallow tunneling method by investigating their respective safety factors and failure mechanisms. A case study for one particular cross-section of Beijing Subway Line 7 is undertaken, with a focus on the effects of multiple soil layers and construction sequencing of dual tunnels. Results show that using the step-excavation technique can render a higher safety factor for the excavation of a tunnel compared to the entire cross-section being excavated all at once. The failure mechanisms for each different construction stage are discussed and corresponding key locations are suggested to monitor the safety during tunneling. Simultaneous excavation of dual tunnels in the same cross-section should be expressly avoided considering their potential negative interactions. The normal and shear forces as well as bending moment of the primary lining and locking anchor pipe are found to reach their maximum value at Stage 6, before closure of the primary lining. Designing these struts should consider the effects of different construction stages of shallow tunneling method.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2000년도 봄 학술발표회 논문집
• /
• pp.87-92
• /
• 2000

In excavation of tunnels especially located in shallow depth, it is not rare to meet geological change in excavation progress worse than expected in the initial design stage. This paper present a case study on the re-design of excavation and support system of a shallow tunnel under construction where it meets the unexpected bad geological condition during excavation. The detailed geological investigation shows that the rock mass is heavily weathered and fractured with RMR value less than 20. Considering this geological condition, the design concept is focused on the reinforcement of the ground preceding the excavation of tunnel. Two design patterns, LW-grouting & forepoling with pilot tunnelling method and the steel pipe reinforced grouting method, are suggested. Numerical analysis by FLAC shows that these two patterns give the tunnel and roof ground stable in excavation process while the original design causes severe failure zone around the tunnel and floor heaving. In point of the mechanical stability and the degree of construction, the steel pipe reinforced grouting technique proved to be good for the reinforcement of heavily fractured rock mass in tunnelling. This assessment and design process would be a guide in the construction of tunnels in heavily weathered and fractured rock mass situation.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2006년도 춘계 학술발표회 논문집
• /
• pp.268-275
• /
• 2006

Excavation works of cylindrical shafts and tunnels for the construction of a variety of infrastructures have been frequently going on in the urban areas. When ground excavations of cylindrical shafts and shallow tunnels proceed in the ground condition of high water level and silt particle component, ground water drawdown involving soil particle migration causes loosening of ground around tunnels and shafts, causes settlement and deformation of ground. Damages due to ground sinking and differential settlement can occur in the adjacent ground and structures. The extent and possibility of damage relevant to ground water drawdown and soil particle migration can't be so precisely expected in advance that we will face terrible damages in case of minor carefulness. This paper introduces two examples of construction management where using incremental deformation graph of inclinometer, we noticed the possibility of soil migration due to ground water drawdown in the excavation process of vertical shaft and shallow tunnel, analysed a series of measurement data in coupled connection, properly prepared countermeasures, so came into safe and successful completion of excavation work without terrible damages. The effort of this article aims to improve and develop the technique of design and construction in the coming projects having similar ground condition and supporting method.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2005년도 지반공학 공동 학술발표회
• /
• pp.564-569
• /
• 2005

Usually, Steel pipe grouting method or cut and cover method has been applied to tunnel with very shallow overburden or it is situated in valley. However, in case of lack of overburden height to reinforcement tunnel crown which is very difficult to construction. Also, application of cut and cover method that do not consider surrounding site condition causes popular enmity generation and environmental damage. It is the best alternative method that reduces the amount of excavated soil and excavate tunnel under ground to solve these problems. The tunneling method using cover structure which is to prevent a tunnel from collapse because this method can be reduce excavation area and construct tunnel under ground after set a cover structure and backfill ground. In this study, to know more effective structure type, comparative analysis was performed to behavior characters of slab and arch type construction that can be used to cover structure. Also a 2D and 3D numerical analysis have been performed to verify the stability of ground during excavation. As the result, the tunneling method using cover structure that it can be good alternative method for tunnel with shallow overburden and it through valley

• Geomechanics and Engineering
• /
• 제31권1호
• /
• pp.1-14
• /
• 2022

Urban deep excavation will affect greatly on the deformation of adjacent existing buildings, especially those with shallow foundations. Isolation piles has been widely used in engineering to control the deformation of buildings adjacent to the excavation, but its applicability is still controversial. Based on a typical engineering, numerical calculation models were established and verified through monitoring data to study the influence characteristics of isolation piles on the deformation of existing shallow foundation buildings. Results reveal that adjacent buildings will increase building settlement δ_v and the deformation of diaphragm walls δ_h, while the isolation piles can effectively decrease these. The surface settlement curve is changed from "groove" type to "double groove" type. Sufficiently long isolation pile can effectively decrease δ_v, while short isolation piles will lead to a negative effect. When the building is within the range of the maximum settlement location P, maximum building rotation θ_m will increase with the pile length L and the relative position between isolation pile and building d/D increase (d is the distance between piles and diaphragm walls, D is the distance between buildings and diaphragm walls), instead, θ_m will decrease for buildings outside the location P, and the optimum was obtained when d/D=0.7.

• 한국지반환경공학회 논문집
• /
• 제13권11호
• /
• pp.69-79
• /
• 2012

선지보 네일공법은 터널의 굴착 전에 지반을 보강하므로 기존 지보시스템에 의한 NATM공법에 비해 굴착과정에서 변위를 최소화할 수 있어 안정성과 시공효율을 높일 수 있는 장점이 있다. 본 연구에서는 지하수위가 높고 미고결지반으로 구성된 천층터널에 대해 선지보 네일공법의 적용성을 현장계측관리 사례을 통해 연구하였으며, 지반보강개념에서 선지보 네일공법의 메카니즘과 기존 지보시스템의 메카니즘을 비교 분석하였다. 상하분할 굴착과정에서 굴착단계별 변위증폭이 뚜렷이 관찰되는 기존 지보시스템에 비해 선지보 네일공법은 초기변위 이후 단계굴착별 변위증폭량이 작고 이내 수렴되는 경향을 보여 다단굴착으로 인한 영향이 미미한 것으로 분석되었다. 선지보 네일공법은 종래 NATM공법과 비교할 때 단계굴착 시 응력변화에 대해 민감하고 아칭효과가 발생되지 않는 취약한 지반 즉, 토사터널인 천층터널에서 그 적용성이 뛰어난 것으로 판단된다.

• 터널과지하공간
• /
• 제15권6호
• /
• pp.400-410
• /
• 2005

토사지반에서 얕은 터널을 굴착하는 경우, 터널 막장부의 파괴 메카니즘이 터널 안정성에 큰 영향을 미친다. 본 논문에서는 일련의 굴진장을 고려한 2차원 종 방향 터널 모형 실험을수행하였다. 그 결과 얕은 터널의 파괴 메카니즘은 굴진장이 길어질수록 파괴모드 1에서 파괴모드 2로 변하는 것을 알 수 있었다. 또한, 모형실험결과와 수치해석을 비교하여 터널에 작용하는 최소 지보압과 진행성 파괴 거동에 대하여 분석하였다.

• 터널과지하공간
• /
• 제11권1호
• /
• pp.20-29
• /
• 2001

터널 굴착으로 인한 천반의 최종 변위는 내공변위 곡선을 시간과 거리에 따른 임의의 함수로 표현하여 예측할수 있다. 본 연구에서는 도심지 주변의 천층 광폭터널에서의 변위 예측식의 적합성을 검토하였다. 연구 대상 터널은 도심과 무등산 공원의 경계에 위치하여 터널 상부의 토피고가 낮고 폭이 넓은 터널이다. 연구 결과, 토피고가 낮은 갱구부에서 풍화암 지반이 강관다단 그라우팅 및 forepoling 보강에 의해 탄소성지반이 아닌 탄성지반에 준하는 특성을 나타내는 풍화암 내지 연암층으로 된 연구대상 터널의 경우 지수함수식이 더 적합한 것으로 나타났다.

• 한국터널지하공간학회 논문집
• /
• 제13권3호
• /
• pp.215-231
• /
• 2011

본 논문에서는 연직 불연속면을 포함하는 지반에서 얕은 심도 2-arch 터널 굴착에 따른 거동특성을 실험적으로 연구하였으며, 2-arch 터널 굴착에 따른 필러부 하중전이 특성을 관찰하였다. 연직 불연속면의 위치를 변화시키고, 2-arch터널 시공단계별로 모형실험을 수행하였다. 실험결과, 2-arch 터널 굴착에 따른 이완하중이 불연속면이 위치한 곳에 집중되었고, 불연속면에 차단되어 불연속면을 넘어서까지 하중이 전이되지는 않았다. 또한 인접한 터널의 하반을 굴착할 때보다 상반을 굴착할 때에 필러부와 지반변형에 더 큰 영향을 미치는 것으로 나타났다.